Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Zero-crossing shapiro step in a three-junction SQUID magnetically coupled with two phase-shifted RF signals

Yoshinao Mizugaki, Jian Chen, S. Nishikata, K. Sugi, Kensuke Nakajima, Tsutomu Yamashita

Published Jun 1, 2003• 3 citations
Publisher

Abstract

We demonstrate a zero-crossing Shapiro step in a three-junction SQUID (3J-SQUID) coupled with two phase-shifted RF signals. The operation is based on periodic flux quantum transitions in the 3J-SQUID under the zero- and negatively-biasing conditions. A test circuit is fabricated using a Nb/AlO/sub x//Nb junction technology. When we feed RF signals up to 10.5 GHz, we observe a Shapiro step crossing the zero-current axis at the voltage position of the 1st order. The experimental current-voltage characteristics are quantitatively reproduced by simulation. Zero-crossing conditions for the DC offset flux and the RF power are obtained experimentally, which is also confirmed by simulation. A programmable Josephson voltage standard is discussed as one of the possible applications.

DOI
10.1109/tasc.2003.814084

Related papers

Zero-Crossing Shapiro Step in Asymmetric Two-Junction Superconducting Quantum Interference Device

Yoshinao Mizugaki, Kazuyuki Katoh, Masataka Moriya +2 more

We demonstrate a zero-crossing Shapiro step in an asymmetric two-junction superconducting quantum interference device (SQUID) driven by one sinusoidal RF signal. The operation is based on the imbalanced evolution of the junction phases due to the tilted interference diagrams. A test circuit was fabricated using Nb/AlO x /Nb junction technology. When we applied an RF signal of 10 GHz, we observed a Shapiro step crossing the zero-current axis at the voltage position of the first order. The polarity of the step voltage was switched by a DC control flux to the SQUID loop. The experimental current–voltage curves were quantitatively reproduced by simulation.

Japanese Journal of Applied Physics•Jun 16, 2006•3 citations

Zero-crossing Shapiro step generated in a niobium in-line Josephson gate

Yoshinao Mizugaki, Haruna Takahashi, Hiroshi Shimada

We demonstrate a zero-crossing Shapiro step generated in a magnetically-coupled Josephson gate, where a long Josephson junction and a control line are placed in-line. The operation is based on the imbalanced evolution of the junction phases owing to the different amplitudes of the positive and negative critical current. A test circuit was fabricated using a Nb/AlOx/Nb junction technology. When we applied a rf signal of 15.2GHz, we observed a Shapiro step that crossed the zero-current axis at the voltage position of the 1st order. The experimental results were quantitatively reproduced by simulation.

IEICE Electronics Express•Jan 1, 2014•2 citations

Zero-crossing Shapiro step generated in an asymmetric and nonhysteretic rf-current-driven two-junction superconducting quantum interference device

Yoshinao Mizugaki, Kazuyuki Katoh

A zero-crossing Shapiro step (ZCSS) in an asymmetric and nonhysteretic two-junction superconducting quantum interference device (SQUID) driven by one sinusoidal rf signal is presented. The operation is based on imbalanced evolution of the junction phases owing to the tilted interference diagrams. Dependence of ZCSS generation upon the frequency and amplitude of a rf signal was numerically obtained. A test circuit was designed and fabricated using a Nb∕AlOx∕Nb junction technology. When we irradiated a rf signal of 10GHz, a ZCSS at the voltage position of the first order was observed. The polarity of the step voltage was switched by a dc control flux to the SQUID loop. The experimental bias-current versus voltage and control-current versus voltage curves were quantitatively reproduced by numerical simulation.

Journal of Applied Physics•Sep 15, 2006•6 citations

Single-flux-quantum pump based on a three-junction superconducting quantum interference device

Yoshinao Mizugaki, Jian Chen, Satoshi Nishikata +3 more

We demonstrate the operation of a single-flux-quantum (SFQ) pump that is electromagnetically dual to the single-electron pump. The circuit is composed of a three-junction superconducting quantum interference device with three control lines. By applying two phase-shifted rf signals magnetically, the SFQ-pump transfers one SFQ per one cycle of the rf signals even at zero- and negatively-biased condition. The circuit was fabricated using a Nb/AlOx/Nb Josephson junction technology. When we fed rf signals of 4.5 GHz, we observed a Shapiro step crossing the zero-current axis. Periodic dependence of voltage at the zero-biasing state upon dc offset flux was also confirmed.

Applied Physics Letters•Jun 17, 2002•6 citations

Bipolar Quantum Voltage Generator Based on Zero Crossing Shapiro Steps in Asymmetric 2J-SQUIDs

Masataka Moriya, Naoki Kondo, Yoshinao Mizugaki

On an asymmetric two-junction superconducting quantum interference device (2J-SQUID) driven by one sinusoidal rf signal, the observation of zero-crossing Shapiro steps have been reported. In this paper, the loop inductance, L and the ratio of critical currents of Josephson junctions of the 2J-SQUID were optimized by a simulation. Using three voltage states those this asymmetric 2J-SQUID has, the bipolar quantum voltage generator that has three asymmetric 2J-SQUIDs and two control lines, was designed based on obtained parameters. Within the bias current -voltage curves with seven different combinations of the control currents, seven quantized voltages were obtained at the zero bias current.

Physics Procedia•Jan 1, 2012•0 citations

Numerical investigation for the frequency dependence of Shapiro steps in an RF-field-driven SQUID

Yoshinao Mizugaki

Shapiro steps in an RF-field-driven dc-SQUID (RFDS), where an RF signal is coupled to the SQUID loop magnetically, are numerically investigated. We calculate the current–voltage characteristics of RFDSs under no dc offset flux, which show the enhancement of the even-order Shapiro steps. First, the maximum second (the lowest even-order) step height is evaluated as a function of the normalized frequency Ω. In the case of the inductance parameter βL ≥ 1.0, the maximum second step height is maintained at a certain value in the low frequency region. In the case of βL < 1.0, on the other hand, the maximum step height decreases in the low frequency region of Ω < 0.10. The dependence of the current positions of the step upon the RF signal amplitude shows that the voltage transition at the non-superconductive area between the superconducting interference lobes limits the upper current position of the step.

Superconductor Science and Technology•Nov 5, 2003•2 citations
We demonstrate a zero-crossing Shapiro step in a three-junction SQUID (3J-SQUID) coupled with two phase-shifted RF signals. The operation is based on periodic flux quantum transitions in the 3J-SQUID under the zero- and negatively-biasing conditions. A test circuit is fabricated using a Nb/AlO/sub x//Nb junction technology. When we feed RF signals up to 10.5 GHz, we observe a Shapiro step crossing the zero-current axis at the voltage position of the 1st order. The experimental current-voltage characteristics are quantitatively reproduced by simulation. Zero-crossing conditions for the DC offset flux and the RF power are obtained experimentally, which is also confirmed by simulation. A programmable Josephson voltage standard is discussed as one of the possible applications.
We demonstrate a zero-crossing Shapiro step in an asymmetric two-junction superconducting quantum interference device (SQUID) driven by one sinusoidal RF signal. The operation is based on the imbalanced evolution of the junction phases due to the tilted interference diagrams. A test circuit was fabricated using Nb/AlO x /Nb junction technology. When we applied an RF signal of 10 GHz, we observed a Shapiro step crossing the zero-current axis at the voltage position of the first order. The polarity of the step voltage was switched by a DC control flux to the SQUID loop. The experimental current–voltage curves were quantitatively reproduced by simulation.
We demonstrate a zero-crossing Shapiro step generated in a magnetically-coupled Josephson gate, where a long Josephson junction and a control line are placed in-line. The operation is based on the imbalanced evolution of the junction phases owing to the different amplitudes of the positive and negative critical current. A test circuit was fabricated using a Nb/AlOx/Nb junction technology. When we applied a rf signal of 15.2GHz, we observed a Shapiro step that crossed the zero-current axis at the voltage position of the 1st order. The experimental results were quantitatively reproduced by simulation.
A zero-crossing Shapiro step (ZCSS) in an asymmetric and nonhysteretic two-junction superconducting quantum interference device (SQUID) driven by one sinusoidal rf signal is presented. The operation is based on imbalanced evolution of the junction phases owing to the tilted interference diagrams. Dependence of ZCSS generation upon the frequency and amplitude of a rf signal was numerically obtained. A test circuit was designed and fabricated using a Nb∕AlOx∕Nb junction technology. When we irradiated a rf signal of 10GHz, a ZCSS at the voltage position of the first order was observed. The polarity of the step voltage was switched by a dc control flux to the SQUID loop. The experimental bias-current versus voltage and control-current versus voltage curves were quantitatively reproduced by numerical simulation.
We demonstrate the operation of a single-flux-quantum (SFQ) pump that is electromagnetically dual to the single-electron pump. The circuit is composed of a three-junction superconducting quantum interference device with three control lines. By applying two phase-shifted rf signals magnetically, the SFQ-pump transfers one SFQ per one cycle of the rf signals even at zero- and negatively-biased condition. The circuit was fabricated using a Nb/AlOx/Nb Josephson junction technology. When we fed rf signals of 4.5 GHz, we observed a Shapiro step crossing the zero-current axis. Periodic dependence of voltage at the zero-biasing state upon dc offset flux was also confirmed.
On an asymmetric two-junction superconducting quantum interference device (2J-SQUID) driven by one sinusoidal rf signal, the observation of zero-crossing Shapiro steps have been reported. In this paper, the loop inductance, L and the ratio of critical currents of Josephson junctions of the 2J-SQUID were optimized by a simulation. Using three voltage states those this asymmetric 2J-SQUID has, the bipolar quantum voltage generator that has three asymmetric 2J-SQUIDs and two control lines, was designed based on obtained parameters. Within the bias current -voltage curves with seven different combinations of the control currents, seven quantized voltages were obtained at the zero bias current.
Shapiro steps in an RF-field-driven dc-SQUID (RFDS), where an RF signal is coupled to the SQUID loop magnetically, are numerically investigated. We calculate the current–voltage characteristics of RFDSs under no dc offset flux, which show the enhancement of the even-order Shapiro steps. First, the maximum second (the lowest even-order) step height is evaluated as a function of the normalized frequency Ω. In the case of the inductance parameter βL ≥ 1.0, the maximum second step height is maintained at a certain value in the low frequency region. In the case of βL < 1.0, on the other hand, the maximum step height decreases in the low frequency region of Ω < 0.10. The dependence of the current positions of the step upon the RF signal amplitude shows that the voltage transition at the non-superconductive area between the superconducting interference lobes limits the upper current position of the step.