Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)

Reducing light-shift effects in optically-pumped gas-cell atomic frequency standards

C. Affolderbach, G. Mileti, C. Andreeva, Dimitar G. Slavov, Todor S. Karaulanov, S. Cartaleva

Published Jul 8, 2004• 5 citations
Publisher

Abstract

We investigate a novel method to suppress the light-shift effect in laser-pumped passive rubidium frequency standards. The reduction of the light-shift due to additional frequency components in the pumping light is studied theoretically and compared to experimental results obtained with a frequency-modulated DBR laser diode as a pumping light source. In this way, a reduction of the light shift by a factor of 55 was successfully demonstrated. Complete cancellation of the light shift can be reached with a suitably adjusted modulation index and frequency.

DOI
10.1109/freq.2003.1274980

Related papers

Light shift reduction in atomic clocks

C. Affolderbach, C. Andreeva, S. Cartaleva +3 more

In this paper we present a detailed description of a method for reduction of the light shift in laser-pumped gas-cell atomic clocks. The method consists in using a multi-frequency optical pumping obtained through frequency modulation of the laser spectrum with precisely controllable parameters. Experimental evidence of a strong reduction of the frequency dependence of the LS in an optical pumping Rb gas-cell clock is demonstrated in a large frequency interval, which is in a very good agreement with the numerical estimations reported.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jun 21, 2004•0 citations

Simple method of light-shift suppression in optical pumping systems

B. H. McGuyer, Yuan‐Yu Jau, W. Happer

We report a simple method to suppress the light shift in optical pumping systems. This method uses only frequency modulation of a radio frequency or microwave source, which is used to excite an atomic resonance, to simultaneously lock the source frequency to the atomic resonance and lock the pumping light frequency to suppress the light shift. We experimentally validate the method in a vapor-cell atomic clock and verify the results through numerical simulation. This technique can be applied to many optical pumping systems that experience light shifts. It is especially useful for atomic frequency standards because it improves long-term performance, reduces the influence of the laser, and requires less equipment than previous methods.

arXiv:1302.4160•Applied Physics Letters•Jun 22, 2009•56 citations

Reducing the light-shift in the diode laser pumped rubidium atomic clock

James C. Camparo

One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock's output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock's output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Dec 24, 2002•6 citations

1996 IEEE INTERNATIONAL FREQUENCY CONTROL SYMPOSIUM REDUCING THE LIGHT-SHIFT IN THE DIODE LASER PUMPED RUBIDIUM ATOMIC CLOCK

James C. Camparo

One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock‘s output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock‘s output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.

•Jan 1, 1996•0 citations

Analysis of the light shift effect in the /sup 87/Rb frequency standard

F. Levi, Carlo Novero, A. Godone

The /sup 87/Rb cell frequency standard, optically pumped by a laser diode, is of great interest in the development of high short-term stability oscillators. We report experiments performed on a rubidium cell prototype aiming at evaluate the transfer of the laser noise to the hyperfine clock transition via the light shift effect, which appears to be the main contribution to the observed short term frequency stability in this kind of standard. Pulsed optical pumping will also be examined in order to strongly reduce the light shift effect and to achieve the theoretical limit never approached up to now despite the strong detected microwave signals.

Conference on Precision Electromagnetic Measurements•Dec 24, 2002•0 citations

New method for light-shift elimination

B. H. McGuyer, Yuan‐Yu Jau, W. Happer

We present a new method to eliminate the light shift in atomic frequency standards and other optical pumping systems. This method uses only frequency modulation of a radio frequency or microwave source in order to simultaneously lock the source frequency to an atomic resonance and lock the pumping light to eliminate the light shift. In contrast, conventional stabilization of both sources requires two individual modulation schemes and feedback loops, adding complexity. Our method kills two birds with one stone. The method uses fewer additional components and offers improved performance, reduced cost, and easier miniaturization than previous methods. In particular, few modifications are required for implementation in conventional vapor-cell atomic clocks. We believe this technique will be useful for atomic frequency standards and other optical pumping systems that experience the light shift.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Apr 1, 2009•2 citations
We investigate a novel method to suppress the light-shift effect in laser-pumped passive rubidium frequency standards. The reduction of the light-shift due to additional frequency components in the pumping light is studied theoretically and compared to experimental results obtained with a frequency-modulated DBR laser diode as a pumping light source. In this way, a reduction of the light shift by a factor of 55 was successfully demonstrated. Complete cancellation of the light shift can be reached with a suitably adjusted modulation index and frequency.
In this paper we present a detailed description of a method for reduction of the light shift in laser-pumped gas-cell atomic clocks. The method consists in using a multi-frequency optical pumping obtained through frequency modulation of the laser spectrum with precisely controllable parameters. Experimental evidence of a strong reduction of the frequency dependence of the LS in an optical pumping Rb gas-cell clock is demonstrated in a large frequency interval, which is in a very good agreement with the numerical estimations reported.
We report a simple method to suppress the light shift in optical pumping systems. This method uses only frequency modulation of a radio frequency or microwave source, which is used to excite an atomic resonance, to simultaneously lock the source frequency to the atomic resonance and lock the pumping light frequency to suppress the light shift. We experimentally validate the method in a vapor-cell atomic clock and verify the results through numerical simulation. This technique can be applied to many optical pumping systems that experience light shifts. It is especially useful for atomic frequency standards because it improves long-term performance, reduces the influence of the laser, and requires less equipment than previous methods.
One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock's output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock's output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.
One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock‘s output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock‘s output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.
The /sup 87/Rb cell frequency standard, optically pumped by a laser diode, is of great interest in the development of high short-term stability oscillators. We report experiments performed on a rubidium cell prototype aiming at evaluate the transfer of the laser noise to the hyperfine clock transition via the light shift effect, which appears to be the main contribution to the observed short term frequency stability in this kind of standard. Pulsed optical pumping will also be examined in order to strongly reduce the light shift effect and to achieve the theoretical limit never approached up to now despite the strong detected microwave signals.
We present a new method to eliminate the light shift in atomic frequency standards and other optical pumping systems. This method uses only frequency modulation of a radio frequency or microwave source in order to simultaneously lock the source frequency to an atomic resonance and lock the pumping light to eliminate the light shift. In contrast, conventional stabilization of both sources requires two individual modulation schemes and feedback loops, adding complexity. Our method kills two birds with one stone. The method uses fewer additional components and offers improved performance, reduced cost, and easier miniaturization than previous methods. In particular, few modifications are required for implementation in conventional vapor-cell atomic clocks. We believe this technique will be useful for atomic frequency standards and other optical pumping systems that experience the light shift.