Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Instrumentation and Measurement

All-optical microwave frequency standard: a proposal

Normand Cyr, M. Têtu, Marc Breton

Published Apr 1, 1993• 157 citations
Publisher

Abstract

A simple method to produce a clock transition with purely optical means by modulated pumping is described. The field-independent ground state resonance of /sup 87/Rb atoms using sinusoidal modulation of the injection current of an AlGaAs laser diode emitting at 780 nm (FM modulation) is observed. The 6.835 GHz resonance with a subharmonic modulation frequency of 1.139 GHz is detected. A high-contrast resonance peak is observed and a condition for zero light shift is found. The linewidth is 3 kHz (at 6.835 GHz) in this preliminary experiment, due to the small size of the light beam ( approximately 2 mm diameter) and the low buffer gas pressure (680 Pa) that was used. A theoretical model that explains the main features of the experiment is described.>

DOI
10.1109/19.278645

Related papers

Study on an all-optical microwave frequency standard

Normand Cyr, M. Têtu, Marc Breton

We describe a simple method to produce a clock transition with purely optical means through modulated pumping. We observe the field-independent ground state resonance of 87Rb atoms using sinusoidal modulation of the injection current of an AlGaAs laser diode emitting at 780 nm (FM modulation). We detect the 6.835 GHz resonance with a modulation frequency of 1.139 GHz. A high contrast resonance peak is observed and a condition for zero light shift is found. With a beam radius of approximately 3 mm and a buffer gas (N2) pressure of 680 Pa (5.1 Torr), a minimal linewidth of 290 Hz is observed. A theoretical study of the excitation of hyperfine coherences by a modulated laser beam is given.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 30, 1993•3 citations

Analysis of the light shift effect in the /sup 87/Rb frequency standard

F. Levi, Carlo Novero, A. Godone

The /sup 87/Rb cell frequency standard, optically pumped by a laser diode, is of great interest in the development of high short-term stability oscillators. We report experiments performed on a rubidium cell prototype aiming at evaluate the transfer of the laser noise to the hyperfine clock transition via the light shift effect, which appears to be the main contribution to the observed short term frequency stability in this kind of standard. Pulsed optical pumping will also be examined in order to strongly reduce the light shift effect and to achieve the theoretical limit never approached up to now despite the strong detected microwave signals.

Conference on Precision Electromagnetic Measurements•Dec 24, 2002•0 citations

Experiments on a semiconductor laser pumped rubidium atomic clock

Minoru Hashimoto, Motoichi Ohtsu

Experiments were carried out to evaluate the performances of a semiconductor laser pumped rubidium (87Rb) atomic clock. Two kinds of Rb gas cells were used and their performances were compared [gas cell A (natural rubidium (87Rb/85Rb =\frac{3}{7}) and buffer gases) and gas cell B (87Rb and buffer gases)]. The highest microwave frequency stabilities were estimated as3.4 \times 10^{-12} \tau^{-1/2}and2.7 \times 10^{-12} \tau^{-1/2}at the optimal gas cell temperatures of 60°C and 48°C for the gas cellsAandB, respectively (τ: integration time). The light shift, i.e., microwave frequency shift induced by laser light, was measured as -0.50 Hz/MHz and -0.11 Hz/MHz for the gas cellsAandBat their optimal operating conditions given above. As an improved experiment by utilizing high temporal coherence of the laser, a novel double resonance spectral line shape with a drastically narrower linewidth was demonstrated. A technique, similar to FM laser spectroscopy, was employed for this purpose by utilizing laser FM sidebands which are induced by microwave frequency modulation and nonlinear susceptibility of three-level87Rb atoms. The minimum linewidth obtained was 20 Hz, which can be used as a sensitive frequency discriminator for an improved87Rb atomic clock.

IEEE Journal of Quantum Electronics•Apr 1, 1987•61 citations

Frequency-modulation spectroscopy of rubidium atoms with an AlGaAs diode laser

Shunsuke Nakanishi, H. Ariki, Hiroshi Itoh +1 more

Frequency-modulation (FM) spectroscopy has been performed on the D(2) transitions of rubidium atoms with an AlGaAs diode laser at 780 nm. Doppler-broadened hyperfine-structure transitions of (85)Rb and (87)Rb were resolved with no residual amplitude-modulation-induced background signal by modulating the injection current of the laser diode at a low frequency (20-50 MHz) compared with the Doppler width. To obtain Doppler-free spectra, we combined FM spectroscopy with saturation spectroscopy. The results show that the FM spectroscopy technique is sensitive and should be useful for high-resolution spectroscopy, although the resolution was instrument limited and unusual double peaks were observed.

Optics Letters•Nov 1, 1987•10 citations

Properties of Rb CPT Atomic Clock at Subharmonic Microwave Modulation Frequencies

Daba A. Radnatarov, Sergey M Kobtsev, Valeriy Andryushkov +3 more

This letter presents for the first time a systematic study of an atomic frequency standard based on coherent population trapping (CPT) effect in87Rb vapour optically pumped with a multifrequency laser radiation formed with sidebands of a single-frequency laser whose injection current is modulated at a subharmonic frequency (1/2-1/6) relative to the frequency of hyperfine ground state splitting. Measured are the CPT resonance parameters and the atomic clock short-term stability at different subharmonic frequencies of microwave modulation. The possibility of CPT resonance light shift suppression is experimentally demonstrated at modulation frequencies between 1/3 and 1/5 of the resonant frequency for continuous wave optical pumping of the87Rb vapour D1 line. Analyzed are the capabilities and potential of reduced energy consumption of atomic clocks when CPT resonance in rubidium vapour is excited at subharmonic modulation frequencies.

IEEE photonics journal•Jun 26, 2019•2 citations

A laser optically-pumped Rubidium vapour-cell frequency standard using a DFB laser diode

C. Affolderbach, G. Mileti, Fabien Droz

A laser optically-pumped vapour-cell atomic frequency standard ("Rb clock") using a DFB laser diode as pump light source is presented. The Rb clock is based on probing the ground-state hyperfine "clock" transition at 6.8 GHz of atomic87Rb, by optical-microwave double-resonance technique. The frequency stability of the clock is measured.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 1, 2007•0 citations
A simple method to produce a clock transition with purely optical means by modulated pumping is described. The field-independent ground state resonance of /sup 87/Rb atoms using sinusoidal modulation of the injection current of an AlGaAs laser diode emitting at 780 nm (FM modulation) is observed. The 6.835 GHz resonance with a subharmonic modulation frequency of 1.139 GHz is detected. A high-contrast resonance peak is observed and a condition for zero light shift is found. The linewidth is 3 kHz (at 6.835 GHz) in this preliminary experiment, due to the small size of the light beam ( approximately 2 mm diameter) and the low buffer gas pressure (680 Pa) that was used. A theoretical model that explains the main features of the experiment is described.>
We describe a simple method to produce a clock transition with purely optical means through modulated pumping. We observe the field-independent ground state resonance of 87Rb atoms using sinusoidal modulation of the injection current of an AlGaAs laser diode emitting at 780 nm (FM modulation). We detect the 6.835 GHz resonance with a modulation frequency of 1.139 GHz. A high contrast resonance peak is observed and a condition for zero light shift is found. With a beam radius of approximately 3 mm and a buffer gas (N2) pressure of 680 Pa (5.1 Torr), a minimal linewidth of 290 Hz is observed. A theoretical study of the excitation of hyperfine coherences by a modulated laser beam is given.
The /sup 87/Rb cell frequency standard, optically pumped by a laser diode, is of great interest in the development of high short-term stability oscillators. We report experiments performed on a rubidium cell prototype aiming at evaluate the transfer of the laser noise to the hyperfine clock transition via the light shift effect, which appears to be the main contribution to the observed short term frequency stability in this kind of standard. Pulsed optical pumping will also be examined in order to strongly reduce the light shift effect and to achieve the theoretical limit never approached up to now despite the strong detected microwave signals.
Experiments were carried out to evaluate the performances of a semiconductor laser pumped rubidium (87Rb) atomic clock. Two kinds of Rb gas cells were used and their performances were compared [gas cell A (natural rubidium (87Rb/85Rb =\frac{3}{7}) and buffer gases) and gas cell B (87Rb and buffer gases)]. The highest microwave frequency stabilities were estimated as3.4 \times 10^{-12} \tau^{-1/2}and2.7 \times 10^{-12} \tau^{-1/2}at the optimal gas cell temperatures of 60°C and 48°C for the gas cellsAandB, respectively (τ: integration time). The light shift, i.e., microwave frequency shift induced by laser light, was measured as -0.50 Hz/MHz and -0.11 Hz/MHz for the gas cellsAandBat their optimal operating conditions given above. As an improved experiment by utilizing high temporal coherence of the laser, a novel double resonance spectral line shape with a drastically narrower linewidth was demonstrated. A technique, similar to FM laser spectroscopy, was employed for this purpose by utilizing laser FM sidebands which are induced by microwave frequency modulation and nonlinear susceptibility of three-level87Rb atoms. The minimum linewidth obtained was 20 Hz, which can be used as a sensitive frequency discriminator for an improved87Rb atomic clock.
Frequency-modulation (FM) spectroscopy has been performed on the D(2) transitions of rubidium atoms with an AlGaAs diode laser at 780 nm. Doppler-broadened hyperfine-structure transitions of (85)Rb and (87)Rb were resolved with no residual amplitude-modulation-induced background signal by modulating the injection current of the laser diode at a low frequency (20-50 MHz) compared with the Doppler width. To obtain Doppler-free spectra, we combined FM spectroscopy with saturation spectroscopy. The results show that the FM spectroscopy technique is sensitive and should be useful for high-resolution spectroscopy, although the resolution was instrument limited and unusual double peaks were observed.
This letter presents for the first time a systematic study of an atomic frequency standard based on coherent population trapping (CPT) effect in87Rb vapour optically pumped with a multifrequency laser radiation formed with sidebands of a single-frequency laser whose injection current is modulated at a subharmonic frequency (1/2-1/6) relative to the frequency of hyperfine ground state splitting. Measured are the CPT resonance parameters and the atomic clock short-term stability at different subharmonic frequencies of microwave modulation. The possibility of CPT resonance light shift suppression is experimentally demonstrated at modulation frequencies between 1/3 and 1/5 of the resonant frequency for continuous wave optical pumping of the87Rb vapour D1 line. Analyzed are the capabilities and potential of reduced energy consumption of atomic clocks when CPT resonance in rubidium vapour is excited at subharmonic modulation frequencies.