Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Josephson voltage standard circuit operation with a pulse tube cooler

G. Wende, M. Schubert, T. May, Ludwig Fritzsch, H.‐G. Meyer, Günter Thummes, Y. Kucukkaplan, Limin Qiu, J. Kohlmann, J. Niemeyer, H. Hofmeister, J. Scheerer

Published Jun 1, 2003• 19 citations
Publisher

Abstract

For a more wide-spread use of Josephson voltage standards, cryogen-free operation, by means of an appropriate closed-cycle refrigerator, is highly desirable. In this work we present a low-noise pulse tube cooler (PTC) that is capable to cool the voltage standard circuits to temperatures below 4 K. As a low loss dielectric waveguide with a very small thermal conductivity a Teflon strip was used for the microwave transmission. The matched transition from the WR12 rectangular waveguide to the Teflon strip and vice versa was made using special exponential tapers. Programmable 1 Volt 14 bit SINIS and 10 Volt SIS arrays assembled in the PTC operated well, i.e., demonstrated a similar performance to that measured in liquid helium. The Josephson junction arrays were integrated in coplanar strips instead of the commonly used microstriplines for the microwave transmission lines. The 1 Volt SINIS array contained 8192 Josephson junctions (JJs). It generated an inherently stable Josephson voltage step of 1.19 V at a driving microwave frequency of 70 GHz. The step width was 150 /spl mu/A and the critical current of the junctions was 550 /spl mu/A. Similar results were obtained under liquid helium cooling conditions. In another experiment a 10 Volt voltage standard chip with 19700 SIS JJs was installed. It was possible to generate stable Shapiro steps at the 10 V level.

DOI
10.1109/tasc.2003.814081

Related papers

A dry-cooled AC quantum voltmeter

M. Schubert, M. Starkloff, Katja Peiselt +9 more

Abstract The paper describes a dry-cooled AC quantum voltmeter system operated up to kilohertz frequencies and 7 V rms. A 10 V programmable Josephson voltage standard (PJVS) array was installed on a pulse tube cooler (PTC) driven with a 4 kW air-cooled compressor. The operating margins at 70 GHz frequencies were investigated in detail and found to exceed 1 mA Shapiro step width. A key factor for the successful chip operation was the low on-chip power consumption of 65 mW in total. A thermal interface between PJVS chip and PTC cold stage was used to avoid a significant chip overheating. By installing the cryocooled PJVS array into an AC quantum voltmeter setup, several calibration measurements of dc standards and calibrator ac voltages up to 2 kHz frequencies were carried out to demonstrate the full functionality. The results are discussed and compared to systems with standard liquid helium cooling. For dc voltages, a direct comparison measurement between the dry-cooled AC quantum voltmeter and a liquid-helium based 10 V PJVS shows an agreement better than 1 part in 10 10 .

Superconductor Science and Technology•Sep 15, 2016•14 citations

A new microwave circuit and a new cryoprobe for Josephson voltage standards

M. Schubert, G. Wende, T. May +2 more

We present a new type of microwave circuits for Josephson voltage standards. Coplanar strips (CPS) are used instead of microstriplines or coplanar waveguides (CPW) to integrate the Josephson junctions in a microwave transmission line. Compared to microstripline and CPW circuits the CPS design doubles the scale of integration and simplifies the fabrication technology. Well-operating 10 V circuits in CPS design with 17,000 SIS junctions and 1 V SINIS circuits were tested in a new cryoprobe. In this cryoprobe a low loss dielectric waveguide consisting of a teflon strip is used for the microwave transmission in the 70 GHz frequency range. The dielectric waveguide together with a fibreglass-reinforced plastic supporting tube reduces the contribution of the cryoprobe to the liquid helium boil-off rate drastically. This paper was presented at the 8th International Superconductive Electronics Conference, Osaka, Japan, 19–22 June 2001.

Superconductor Science and Technology•Dec 19, 2001•5 citations

Cryogen-free operation of programmable Josephson voltage standard with a closed-cycle refrigerator

Yonuk Chong, Mun-Seog Kim, Wan-Seop Kim +1 more

We report operation of a programmable Josephson voltage standard on a closed-cycle refrigerator. NIST 1V PJVS chip is used, and we operate the chip with the fingerboard that is adopted from the existing liquid helium dipping probe. We demonstrate operation at 5.5 K of chip temperature, with a flat Shapiro step in the sub-array of the chip.

Conference on Precision Electromagnetic Measurements•Jun 1, 2008•0 citations

SINIS Josephson junctions for programmable Josephson voltage standard circuits

H. Schulze, F. Muller, Ralf Behr +3 more

Nonhysteretic Josephson junctions with a superconductor-insulator-normal metal-insulator-superconductor (SINIS) structure fabricated using the reliable Nb-AlO/sub x/ technology have been used for the design and fabrication of a 1-V inherently stable Josephson voltage standard. The superconducting circuit can be driven at the same microwave frequencies as conventional SIS circuits. The microwave-induced 1-V step is suitable for calibration purposes. The successful operation of the 1-V circuit is due to an internal, phase-locked oscillation of all SINIS junctions which are embedded in a low-impedance strip-line. The microwave power required for exciting the coherent oscillation is very low and allows the integration of low power sources. Even operation without any external microwave source appears to be possible.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•51 citations

Josephson voltage standard microwave circuit driven at 10 GHz

H.‐G. Meyer, Heiner Kohler, G. Wende +5 more

We have investigated a new type of microwave circuit for the generation of frequency-scaled Josephson voltages useful for the representation of highly accurate reference voltages. The circuit consists of a superconducting microstrip resonator and series arrays of Josephson junctions integrated within its rf current antinodes. The circuit is designed to operate at low frequencies of about 10 GHz to simplify the microwave techniques. At a resonator circuit with four Josephson junctions driven at 10.9 GHz we have obtained stable overlapping Shapiro steps up to 4.6 mV at a step width of about 70 µA. A more advanced double-resonator circuit with altogether 216 junctions allows to generate scaled reference voltages up to 0.16 V at steps of about 25 µA in width and at a microwave frequency of 11.1 GHz.

Journal de Physique IV (Proceedings)•Jun 1, 1994•0 citations

Performance of a Cryocooled Nb DC Programmable Voltage Standard at 4 K

Robert J. Webber, Charles J. Burroughs, Masoud Radparvar

We report on the performance of a 1-V dc programmable Josephson voltage standard (PJVS) operating on a commercially available Gifford-McMahon cryocooler at 4 K. The NIST-fabricated niobium superconductor-normal metal-superconductor junction chip has been shown to operate successfully as integrated with this cryopackage, generating 1.229 V at the maximum operating frequency of 19.364 GHz with Shapiro steps at constant voltage that are flat to within less than 100 nV. Because of the large operating margin (greater than 1 mA), these steps were highly stable and immune from noise. Differences in behavior of the PJVS in liquid helium and on the cryocooler are discussed. This demonstration paves the way towards automated warming and cooling of the Josephson device and a fully automated voltage standard system.

IEEE Transactions on Applied Superconductivity•Dec 1, 2007•8 citations
For a more wide-spread use of Josephson voltage standards, cryogen-free operation, by means of an appropriate closed-cycle refrigerator, is highly desirable. In this work we present a low-noise pulse tube cooler (PTC) that is capable to cool the voltage standard circuits to temperatures below 4 K. As a low loss dielectric waveguide with a very small thermal conductivity a Teflon strip was used for the microwave transmission. The matched transition from the WR12 rectangular waveguide to the Teflon strip and vice versa was made using special exponential tapers. Programmable 1 Volt 14 bit SINIS and 10 Volt SIS arrays assembled in the PTC operated well, i.e., demonstrated a similar performance to that measured in liquid helium. The Josephson junction arrays were integrated in coplanar strips instead of the commonly used microstriplines for the microwave transmission lines. The 1 Volt SINIS array contained 8192 Josephson junctions (JJs). It generated an inherently stable Josephson voltage step of 1.19 V at a driving microwave frequency of 70 GHz. The step width was 150 /spl mu/A and the critical current of the junctions was 550 /spl mu/A. Similar results were obtained under liquid helium cooling conditions. In another experiment a 10 Volt voltage standard chip with 19700 SIS JJs was installed. It was possible to generate stable Shapiro steps at the 10 V level.
Abstract The paper describes a dry-cooled AC quantum voltmeter system operated up to kilohertz frequencies and 7 V rms. A 10 V programmable Josephson voltage standard (PJVS) array was installed on a pulse tube cooler (PTC) driven with a 4 kW air-cooled compressor. The operating margins at 70 GHz frequencies were investigated in detail and found to exceed 1 mA Shapiro step width. A key factor for the successful chip operation was the low on-chip power consumption of 65 mW in total. A thermal interface between PJVS chip and PTC cold stage was used to avoid a significant chip overheating. By installing the cryocooled PJVS array into an AC quantum voltmeter setup, several calibration measurements of dc standards and calibrator ac voltages up to 2 kHz frequencies were carried out to demonstrate the full functionality. The results are discussed and compared to systems with standard liquid helium cooling. For dc voltages, a direct comparison measurement between the dry-cooled AC quantum voltmeter and a liquid-helium based 10 V PJVS shows an agreement better than 1 part in 10 10 .
We present a new type of microwave circuits for Josephson voltage standards. Coplanar strips (CPS) are used instead of microstriplines or coplanar waveguides (CPW) to integrate the Josephson junctions in a microwave transmission line. Compared to microstripline and CPW circuits the CPS design doubles the scale of integration and simplifies the fabrication technology. Well-operating 10 V circuits in CPS design with 17,000 SIS junctions and 1 V SINIS circuits were tested in a new cryoprobe. In this cryoprobe a low loss dielectric waveguide consisting of a teflon strip is used for the microwave transmission in the 70 GHz frequency range. The dielectric waveguide together with a fibreglass-reinforced plastic supporting tube reduces the contribution of the cryoprobe to the liquid helium boil-off rate drastically. This paper was presented at the 8th International Superconductive Electronics Conference, Osaka, Japan, 19–22 June 2001.
Nonhysteretic Josephson junctions with a superconductor-insulator-normal metal-insulator-superconductor (SINIS) structure fabricated using the reliable Nb-AlO/sub x/ technology have been used for the design and fabrication of a 1-V inherently stable Josephson voltage standard. The superconducting circuit can be driven at the same microwave frequencies as conventional SIS circuits. The microwave-induced 1-V step is suitable for calibration purposes. The successful operation of the 1-V circuit is due to an internal, phase-locked oscillation of all SINIS junctions which are embedded in a low-impedance strip-line. The microwave power required for exciting the coherent oscillation is very low and allows the integration of low power sources. Even operation without any external microwave source appears to be possible.
We have investigated a new type of microwave circuit for the generation of frequency-scaled Josephson voltages useful for the representation of highly accurate reference voltages. The circuit consists of a superconducting microstrip resonator and series arrays of Josephson junctions integrated within its rf current antinodes. The circuit is designed to operate at low frequencies of about 10 GHz to simplify the microwave techniques. At a resonator circuit with four Josephson junctions driven at 10.9 GHz we have obtained stable overlapping Shapiro steps up to 4.6 mV at a step width of about 70 µA. A more advanced double-resonator circuit with altogether 216 junctions allows to generate scaled reference voltages up to 0.16 V at steps of about 25 µA in width and at a microwave frequency of 11.1 GHz.
We report on the performance of a 1-V dc programmable Josephson voltage standard (PJVS) operating on a commercially available Gifford-McMahon cryocooler at 4 K. The NIST-fabricated niobium superconductor-normal metal-superconductor junction chip has been shown to operate successfully as integrated with this cryopackage, generating 1.229 V at the maximum operating frequency of 19.364 GHz with Shapiro steps at constant voltage that are flat to within less than 100 nV. Because of the large operating margin (greater than 1 mA), these steps were highly stable and immune from noise. Differences in behavior of the PJVS in liquid helium and on the cryocooler are discussed. This demonstration paves the way towards automated warming and cooling of the Josephson device and a fully automated voltage standard system.