Applied Optics

Highly cascadable optically bistable device for large fan-out optical computing uses

Nicholas C. Craft

Published May 1, 1988• 5 citations

Abstract

Limited cascadability and fan-out are among the problems associated with the use of optically bistable Fabry-Perot -talons as optical logic elements. A novel etalon-based device is described which is shown to have a much increased cascadability, and therefore fan-out capability, over conventional optical logic elements.

DOI: 10.1364/ao.27.001764

Related papers

A Highly Cascadable Optically Bistable Device for Large Fan-out Optical Computing Applications

Nicholas C. Craft, Stanley Desmond Smith

Smith et al have shown (1) that in order to ensure that the change in output from one bistable device is sufficient to switch the succeeding one, the technique know as ’hold and switch’ is desirable. This involves holding a device as close as possible to its switch point with one laser beam, and using the change in output from a previous similar device to induce switching, thus providing fully restoring logic. Due to the fact that the holding power cannot be made arbitrarily close to the switching power, and that a substantial "over switch" is required to avoid the effects of critical slowing down, there exists a fundamental limit upon the cascadability and fan out potential of conventional bistable devices. This is because their change in output power can only be less than or equal to their switching power. A better device would be one in which the change in output power could be significantly larger than the switching power. The twin cavity device (TCD) described here will be shown to possess this quality.

Jan 1, 19872 citations

Use of a single nonlinear Fabry–Perot étalon as optical logic gates

Jack L. Jewell, Michael C. Rushford, H. M. Gibbs

The all-optical operation of many logic elements (nor, etc.) on a single passive nonlinear Fabry–Perot etalon is discussed. An experiment using dye-filled etalons verifies the prediction and agrees with a computer simulation. This kind of Fabry–Perot gate should be capable of very high speed operation with minimum energy per cycle.

Applied Physics LettersJan 15, 198479 citations

Optical Bistability, Logic Gating, and Waveguide Operation in Semiconductor Etalons

Warren S. Warren, Koch, Gibbs

This article describes the application of one type of optical bistable device based on gallium arsenide as the nonlinear medium. The authors discuss several possible operations with GaAs nonlinear Fabry-Perot etalons. This article utilizes a recently developed computer model to illustrate the basic operating principles and applications. The authors mainly concentrate on the device operation itself. In keeping with common practice they use the term optical bistable device when referring to a device that can exhibit optical bistability even when not being used in such a manner. Instead of the expression nonlinear Fabry-Perot etalon, they often use nonlinear etalons or etalon devices.

ComputerDec 1, 198714 citations

OPTICAL FLIP-FLOP AND LOGIC GATE OPERATIONS WITH ZnSe NONLINEAR ETALONS USING TWO LIGHT BEAMS

Takashi Kurokawa, Hiroyuki Tsuda, S. Fukushima

There has recently been increasing interest in bistable optical devices because of their potential for all-optical signal processing in optical computing systems and optical transmission networks(1), (2). Nonlinear Fabry-Perot etalons whose steady-state properties have been studied extensively are one candidate for such applications. Relatively little work, however, has been done on their operating characteristics and transient behavior(3).

Jul 18, 19880 citations

Guided-wave controlled etalons

Dror Sarid

Abstract Optical bistability in a nonlinear Fabry-Perot etalon can be controlled by several optical beams injected through the edges of the etalon. The control beams, which propagate transversely in the etalon, modify the refractive index, which in turn switches the etalon between its two stable states. The theory of operation of the device is presented, possible logical operations are discussed and experimental results from using an InSb etalon and a CO laser are reported.

Philosophical Transactions of the Royal Society of London Series A Mathematical and Physical SciencesDec 18, 19840 citations

A bistable Fabry-Perot resonator

P. W. E. Smith, E. H. Turner

We propose and demonstrate the operation of a novel bistable optical device that exhibits differential gain and can function as an optical switch, limiter, or optical memory element.

Applied Physics LettersMar 15, 1977151 citations