Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

Slow-light delay enhancement in small-core pure silica photonic crystal fiber based on Brillouin scattering

Sigang Yang, Hongwei Chen, Ciyuan Qiu, Ming Chen, Minghua Chen, Shizhong Xie, Jinyan Li, Wei Chen

Published Jan 3, 2008• 29 citations
Publisher

Abstract

We demonstrate that we realize large-delay slow light based on stimulated Brillouin scattering in a short length of our fabricated small-core photonic crystal fiber (PCF). The cavity effect from the partially reflective splices in the end of the PCF enhances slow-light delay significantly. Our experiments show that large slow-light delay can be easily realized in a very short length of the PCF with a moderate pump power. Up to a one-half pulse-width delay is achieved in only 50 m of PCF in a single pump segment.

DOI
10.1364/ol.33.000095

Related papers

Slow light generation using SBS in a liquid-core photonic crystal fiber

Wenbin An, Haiming Jiang, Yinjia Fang +3 more

Based on stimulated Brillouin scattering (SBS), the slow light effect in photonic crystal fibre (PCF), which is filled with highly nonlinear liquid-carbon disuphide in the core region, is investigated. Maximum allowable pump power for undistorted output pulse, minimum value of pump power required to initiate the SBS effect, Brillouin gain and time-tonic delay experienced by the pulse in the designed liquid-core photonic crystal fibre, are all calculated numerically. We have found that the maximum time-delay up to ∼134.4 ns at 1.064 μm can be obtained using 1 m long liquid-core PCF pumped with only 65.8 mW, which is lower than the value reported in the literature for achieving such a high delay time. The results indicate that liquid-core PCF is capable of generating tunable time-delay that is adjusted by the pump power and structural parameters of the proposed liquid-core PCF.

Journal of Modern Optics•Nov 11, 2016•4 citations

Improving the Delay Efficiency of SBS Slow Light by Using Highly Nonlinear Photonic Crystal Fiber

Xiufeng Yang, Zhengrong Tong, Junfa Zhao +2 more

An efficient stimulated Brillouin scattering slow light system based on a highly nonlinear photonic crystal fiber is presented. Up to 30 ns time delay could be achieved by using 70-m long fiber under the pump power 101 mW. The figure of merit (FOM) of this kind fiber is 0.0035 dB/mW/m, which is about 4.8 times larger than the single mode fiber (SMF).

•Apr 1, 2010•0 citations

An efficient method of all-optical buffering with ultra-small core photonic crystal fibers

Yingchun Cao, Peixiang Lu, Zhenyu Yang +1 more

We propose a new method of all-optical buffering with ultra-small core photonic crystal fibers (PCFs) based on stimulated Brillouin scattering. The large refractive index contrast between the near-hollow cladding and the pure-silica core contributes to high nonlinearity of the PCF. Considering the unusual gain spectrum of the ultra-small core PCF, we numerically investigate the influence of these factors to the buffering efficiency. A PCF with a length of 1 meter and a core diameter of 1.06 micrometer is simulated as the storage medium in this paper. It is shown that we can obtain a good buffering efficiency under a very low control power of 2 watt, which promises a significant improvement for the all-optical communication system.

Optics Express•Aug 26, 2008•14 citations

Slow light with a swept-frequency source

Rui Zhang, Yunhui Zhu, Jing Wang +1 more

ct: We introduce a new concept for stimulated-Brillouin-scattering-based slow light in optical fibers that is applicable for broadly-tunable frequency-swept sources. It allows slow light to be achieved, in principle, over the entire transparency window of the optical fiber. We demonstrate a slow light delay of 10 ns at 1.55 μm using a 10-m-long photonic crystal fiber with a source sweep rate of 400 MHz/μs and a pump power of 200 mW. We also show that there exists a maximal delay obtainable by this method, which is set by the SBS threshold, independent of sweep rate. For our fiber with optimum length, this maximum delay is ~38 ns, obtained for a pump power of 760 mW.

arXiv:1010.3179•Optics Express•Dec 10, 2010•6 citations

Slow light with a swept-frequency source.

Zhang, R, Yunhui Zhu, Wang, J +1 more

ct: We introduce a new concept for stimulated-Brillouin-scattering-based slow light in optical fibers that is applicable for broadly-tunable frequency-swept sources. It allows slow light to be achieved, in principle, over the entire transparency window of the optical fiber. We demonstrate a slow light delay of 10 ns at 1.55 μm using a 10-m-long photonic crystal fiber with a source sweep rate of 400 MHz/μs and a pump power of 200 mW. We also show that there exists a maximal delay obtainable by this method, which is set by the SBS threshold, independent of sweep rate. For our fiber with optimum length, this maximum delay is ~38 ns, obtained for a pump power of 760 mW.

•Dec 20, 2010•7 citations

Numerical study of all-optical slow-light delays via stimulated Brillouin scattering in an optical fiber

Zhaoming Zhu, Daniel J. Gauthier, Yoshitomo Okawachi +4 more

We study numerically all-optical slow-light delays in room-temperature single-mode optical fibers induced by stimulated Brillouin scattering. We consider the propagation of a pulse through a cw-pumped Brillouin fiber amplifier, where the carrier frequency of the pulse is tuned near the Stokes resonance. Pulse delay and broadening of the Stokes pulse are studied in the small-signal and gain-saturation regimes. Pulse delay is shown to be limited by saturation of the Brillouin amplifier. In the small-signal regime, both time delay and pulse broadening increase with increasing gain. In the gain-saturation regime, both time delay and broadening decrease with increasing gain, and the pulse even achieves advancement. Time delay of more than one pulse-width is observed with modest pulse distortion, and over one pulse-width advancement can be obtained with larger pulse distortion in the gain-saturation regime.

Journal of the Optical Society of America B•Nov 1, 2005•150 citations
We demonstrate that we realize large-delay slow light based on stimulated Brillouin scattering in a short length of our fabricated small-core photonic crystal fiber (PCF). The cavity effect from the partially reflective splices in the end of the PCF enhances slow-light delay significantly. Our experiments show that large slow-light delay can be easily realized in a very short length of the PCF with a moderate pump power. Up to a one-half pulse-width delay is achieved in only 50 m of PCF in a single pump segment.
Based on stimulated Brillouin scattering (SBS), the slow light effect in photonic crystal fibre (PCF), which is filled with highly nonlinear liquid-carbon disuphide in the core region, is investigated. Maximum allowable pump power for undistorted output pulse, minimum value of pump power required to initiate the SBS effect, Brillouin gain and time-tonic delay experienced by the pulse in the designed liquid-core photonic crystal fibre, are all calculated numerically. We have found that the maximum time-delay up to ∼134.4 ns at 1.064 μm can be obtained using 1 m long liquid-core PCF pumped with only 65.8 mW, which is lower than the value reported in the literature for achieving such a high delay time. The results indicate that liquid-core PCF is capable of generating tunable time-delay that is adjusted by the pump power and structural parameters of the proposed liquid-core PCF.
We propose a new method of all-optical buffering with ultra-small core photonic crystal fibers (PCFs) based on stimulated Brillouin scattering. The large refractive index contrast between the near-hollow cladding and the pure-silica core contributes to high nonlinearity of the PCF. Considering the unusual gain spectrum of the ultra-small core PCF, we numerically investigate the influence of these factors to the buffering efficiency. A PCF with a length of 1 meter and a core diameter of 1.06 micrometer is simulated as the storage medium in this paper. It is shown that we can obtain a good buffering efficiency under a very low control power of 2 watt, which promises a significant improvement for the all-optical communication system.
ct: We introduce a new concept for stimulated-Brillouin-scattering-based slow light in optical fibers that is applicable for broadly-tunable frequency-swept sources. It allows slow light to be achieved, in principle, over the entire transparency window of the optical fiber. We demonstrate a slow light delay of 10 ns at 1.55 μm using a 10-m-long photonic crystal fiber with a source sweep rate of 400 MHz/μs and a pump power of 200 mW. We also show that there exists a maximal delay obtainable by this method, which is set by the SBS threshold, independent of sweep rate. For our fiber with optimum length, this maximum delay is ~38 ns, obtained for a pump power of 760 mW.
ct: We introduce a new concept for stimulated-Brillouin-scattering-based slow light in optical fibers that is applicable for broadly-tunable frequency-swept sources. It allows slow light to be achieved, in principle, over the entire transparency window of the optical fiber. We demonstrate a slow light delay of 10 ns at 1.55 μm using a 10-m-long photonic crystal fiber with a source sweep rate of 400 MHz/μs and a pump power of 200 mW. We also show that there exists a maximal delay obtainable by this method, which is set by the SBS threshold, independent of sweep rate. For our fiber with optimum length, this maximum delay is ~38 ns, obtained for a pump power of 760 mW.
We study numerically all-optical slow-light delays in room-temperature single-mode optical fibers induced by stimulated Brillouin scattering. We consider the propagation of a pulse through a cw-pumped Brillouin fiber amplifier, where the carrier frequency of the pulse is tuned near the Stokes resonance. Pulse delay and broadening of the Stokes pulse are studied in the small-signal and gain-saturation regimes. Pulse delay is shown to be limited by saturation of the Brillouin amplifier. In the small-signal regime, both time delay and pulse broadening increase with increasing gain. In the gain-saturation regime, both time delay and broadening decrease with increasing gain, and the pulse even achieves advancement. Time delay of more than one pulse-width is observed with modest pulse distortion, and over one pulse-width advancement can be obtained with larger pulse distortion in the gain-saturation regime.