Ground-state two-particle reduced density matrices (2-RDMs) are used to calculate excited-state energy spectra. Solving the Schrodinger equation for excited states dominated by single excitations from the ground-state wavefunction requires the ground-state 2- and 3-RDMs. The excited states, however, can be obtained without a knowledge of the ground-state 3-RDM by two methods: (i) cumulant expansion methods which build the 3-RDM from the 2-RDM, and (ii) double commutator methods which eliminate the 3-RDM. Previous work [Mazziotti, Phys. Rev. A 68, 052501 (2003)] examined the accuracy of excited states extracted from ground-state 2-RDMs, which were calculated by full configuration interaction or the variational 2-RDM method. In this work we employ (i) advances in semidefinite programming to treat the excited states of water and hydrogen fluoride and chains of hydrogen atoms, and (ii) the addition of partial three-particle N-representability conditions to compute more accurate ground-state 2-RDMs. With the hydrogen chains we examine the metal-to-insulator transition as measured by the band gap (the difference between the ground-state and the first excited-state energies), which is difficult for excited-state methods to capture.
Ground-state two-particle reduced density matrices (2-RDMs) are used to calculate excited-state energy spectra. Solving the Schrodinger equation for excited states dominated by single excitations from the ground-state wavefunction requires the ground-state 2- and 3-RDMs. The excited states, however, can be obtained without a knowledge of the ground-state 3-RDM by two methods: (i) cumulant expansion methods which build the 3-RDM from the 2-RDM, and (ii) double commutator methods which eliminate the 3-RDM. Previous work [Mazziotti, Phys. Rev. A 68, 052501 (2003)] examined the accuracy of excited states extracted from ground-state 2-RDMs, which were calculated by full configuration interaction or the variational 2-RDM method. In this work we employ (i) advances in semidefinite programming to treat the excited states of water and hydrogen fluoride and chains of hydrogen atoms, and (ii) the addition of partial three-particle N-representability conditions to compute more accurate ground-state 2-RDMs. With the hydrogen chains we examine the metal-to-insulator transition as measured by the band gap (the difference between the ground-state and the first excited-state energies), which is difficult for excited-state methods to capture.
Electronic excited states are computed through a technique for extracting them from a knowledge of the ground-state two-particle reduced density matrix (2-RDM). Diagonalization of the Hamiltonian in the basis set of one-particle excitations, deexcitations, and projections from the ground-state wave function yields those excited states dominated by one-particle excitations; however, explicit evaluation of the Hamiltonian requires a knowledge of the ground-state 4-RDM. Two techniques are developed for evaluating the Hamiltonian elements with only a knowledge of the 2-RDM: (i) the cumulant method in which the higher RDMs are reconstructed from the 2-RDM via cumulant theory and (ii) the Hermitian or anti-Hermitian operator method in which the higher RDMs are eliminated by selecting the basis functions to be Hermitian or anti-Hermitian. These techniques are extendable to the diagonalization of the Hamiltonian in basis sets of m-excitations where m>1. Excited-state energies with an accuracy between 0.1% and 0.001% of their absolute values are determined in illustrative calculations on Be, LiH, H2O, and BH.
An improved parametrization of the two-electron reduced density matrix (2-RDM) [D. A. Mazziotti, Phys. Rev. Lett. 101, 253002 (2008)] was recently shown to yield energies and properties that are markedly better than those calculated by traditional ab initio methods of similar computational scaling. In this paper a family of such energy functionals, generalizing the ones obtained previously, is derived through the use of (i) p-particle contraction relations based on the contraction of the cumulant expansions of p-particle RDMs and (ii) Cauchy-Schwarz relations that arise from an important set of N-representability constraints known as the two-positivity conditions. The 2-RDMs are explicitly parameterized in terms of the first-order part of the cumulant 2-RDM and, for the inclusion of single excitations, a second-order part of the 1-RDM. In contrast to earlier formulations based on the coefficients from configuration interaction with single and double excitations (CISD), the cumulant-based parametric 2-RDM methods, from the properties of cumulants, are rigorously size extensive. We also show that writing the energy functionals in terms of correlated 1-RDMs and cumulant 2-RDMs reduces the computational cost of the parametric 2-RDM methods to that of CISD. Applications are made to ground-state energies of several molecules, equilibrium bond distances, and frequencies of HF, F2, and CO, the relative energy of the cis and trans isomers of HO3${}^{\ensuremath{-}}$, and the HCN-HNC isomerization reaction. For bond breaking in hydrogen fluoride the improved and more efficient parametric 2-RDM methods yield energies with similar accuracies at both equilibrium and nonequilibrium geometries in 6-31G** and polarized valence quadruple-$\ensuremath{\zeta}$ basis sets. Computed 2-RDMs very nearly satisfy well-known N-representability conditions.
Molecular ground-state energies and two-electron reduced density matrices (2-RDMs) have recently been computed without the many-electron wave function by constraining the 2-RDM to satisfy a complete set of three-positivity conditions for N representability [D. A. Mazziotti, Phys. Rev. A 74, 032501 (2006)]. Energies at both equilibrium and nonequilibrium geometries are obtained within 0.3% of the correlation energy. In this paper the authors extend this work to examine the accuracy of molecular properties, including multipole moments and components of the ground-state energy, relative to full configuration interaction (FCI). Comparisons are also made with 2-RDM methods with two-positivity conditions and two-positivity plus the generalized T1T2 conditions as well as several approximate wave function methods. Using the 2-RDM method with three-positivity conditions, the authors obtain dipole, quadrupole, and octupole moments for BeH2, BH, H2O, CO, and NH3 at equilibrium geometries that are within 0.04% of their FCI values. In addition, for the potential energy surface of N2, the 2-RDM method with three-positivity yields not only accurate total ground-state energies but also accurate expectation values of the kinetic energy operator, the electron-nuclei potential, and electron-electron repulsion.
Variationally calculating the ground state of a many-electron quantum system using only the two-electron reduced-density-matrix (2-RDM) requires N-representability conditions that constrain the 2-RDM to correspond to an N-electron wave function. A systematic hierarchy of N-representability conditions, known as p-positivity conditions, has been developed [D. A. Mazziotti and R. M. Erdahl, Phys. Rev. A 63, 042113 (2001)], and many-electron atoms and molecules in nonminimal basis sets have been solved with useful accuracy by a variational 2-RDM method with 2-positivity conditions [D. A. Mazziotti, Phys. Rev. Lett. 93, 213001 (2004)]. This paper considers two forms of partial 3-positivity conditions, the lifting conditions and the T1∕T2 conditions, to further enhance the accuracy of the 2-RDM methods without the computational cost of full 3-positivity conditions. Variational 2-RDM methods with different N-representability constraints including 2-positivity conditions, the two types of partial 3-positivity conditions, as well as the complete 3-positivity conditions are applied to compute the ground state of the Lipkin spin model. The energies and 2-RDMs are compared to the results from full and truncated configuration interaction, many-body perturbation theory, and couple cluster theory with single and double excitations. Implications of using partial 3-positivity for variational 2-RDM calculations of many-electron atoms and molecules will be discussed.
For 50 years, progress toward the direct calculation of the ground-state two-electron reduced density matrix (2-RDM) was stymied from an inability to constrain the 2-RDM to represent an N-electron wave function. Recent advances in theory and optimization have realized the direct calculation of the 2-RDM. A variational 2-RDM procedure, using first-order semidefinite programming, has been shown to capture multireference correlation effects important at nonequilibrium geometries [Mazziotti, Phys. Rev. Lett. 2004, 93, No. 213001]. This method emerged from research on a nonvariational calculation of the 2-RDM by the contracted Schrödinger equation. Both approaches will be discussed and illustrated.
Correlation energies and reduced density matrices (RDMs) of atoms and molecules are directly computed by solving the 1,3-contracted Schr\"odinger equation (1,3-CSE). The solution of the 1,3-CSE synthesizes two optimization strategies recently employed for the direct determination of the 2-RDM: (i) variational minimization of the energy with respect to a 2-RDM constrained by positivity conditions [D. A. Mazziotti, Phys. Rev. A 65, 062511 (2002)] and (ii) the contracted power method for solving the 2,4-CSE [D. A. Mazziotti, J. Chem. Phys. 116, 1239 (2002)]. While both the 3- and the 4-RDMs in the 2,4-CSE are reconstructed from the 2-RDM by cumulant expansions, similar techniques cannot be directly applied to the 1,3-CSE because constructing the 2-RDM from the 1-RDM with cumulant theory does not improve upon the mean-field approximation. We, however, establish a unique mapping from the 1-RDM to the 2-RDM by searching for the 2-RDM, constrained by contraction and N-representability conditions, which minimizes the energy. The 2-RDM constrained search is practically implemented through recent advances in positive semidefinite programming. With the variational reconstruction of the 2-RDM and a cumulant reconstruction of the 3-RDM, the 1,3-CSE may be solved via a contracted power method for the ground-state energy and RDMs. The initial RDMs, it is shown, need not be N representable for the contracted power method to converge; this allows us to choose the original RDMs from a variational calculation with approximate N-representability conditions on the 2-RDM. Application of the 1,3-CSE algorithm to atoms and molecules yields highly accurate correlation energies both near and far from equilibrium geometries.