Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Japanese Journal of Applied Physics

Predicted Performance of Superconductor-Insulator-Superconductor Mixers with Inhomogeneous Distributed Junction Arrays

Masanori Takeda, Takashi Noguchi, Sheng‐Cai Shi

Published Sep 1, 2000• 10 citations
Publisher

Abstract

The mixing properties of a new type of distributed superconductor-insulator-superconductor (SIS) junction array, which consists of different dimensions of junctions and spacings between every two junctions, have been theoretically investigated using the quantum theory of mixing. A set of dimensions of junctions and spacings between every two junctions of the distributed junction array have been determined so as to minimize the reflection coefficient of an S-parameter, S 11, at the input port in the array using microwave computer-aided design, assuming that each SIS junction is represented by a parallel combination of linear normal-state resistance and geometrical capacitance. When the array is composed of well optimized set of dimensions of junctions and spacings between every two junctions, it is demonstrated that excellent mixing properties are attained over a broad-band in spite of the low critical current density of an SIS junction. It is also found that the degradation of mixing properties, which is always observed at certain frequencies in a conventional array with the equal dimensions of junctions and spacings, can be considerably suppressed in the array with a well optimized set of dimensions and spacings of junctions.

DOI
10.1143/jjap.39.5095

Related papers

Low-noise SIS mixers with a parallel array of junctions at submillimeter wavelengths

Takashi Noguchi, Sheng‐Cai Shi, Hiroyuki Iwashita +1 more

A Superconductor-Insulator-Superconductor (SIS) mixer using parallel array of N junctions have been studied. It has been shown by theoretical analysis that the performance of this type of device is excellent and that nearly quantum-limited performance of the mixer can be obtained. It has been demonstrated that the double sideband (DSB) noise temperature of a receiver employing parallel array of twin junctions, which is the most simplest case in the parallel array of N junctions, was approximately 3 to 5 times as large as the quantum limited photon noise up to the gap frequency of Nb (approximately 700 GHz). It has been also shown that the bandwidth performance of parallel junction arrays can be improved significantly with a large number of SIS junctions even if SIS junctions with a relatively low current density or a large (omega) RNCJ product are adopted in the arrays.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jul 3, 2000•2 citations

SIS Mixer Research

A. W. Lichtenberger, M.J. Feldman

Theoretica and experimental research has been conducted to elucidate the basic physics behind the properties of superconductor-insulator-superconductor (SIS) tunnel junction receiving devices. The properties of an SIS mixer using a slightly nonideal junction, with finite LO power, were determined by analytic expansion of the equations of the quantum theory of mixing. The resulting equations have a particularly simple form. The minimum noise temperature is controlled by the leakage current of the junction. Even the most nearly ideal junctions made today require a considerable LO for best sensitivity; nevertheless, even a comparatively large leakage current allows mixer noise to be only a small factor above the quantum limit. The saturation properties of SIS mixers subjected to broad-band thermal noise obey the equations derived for monochromatic saturating signals. The Josephson junction tuning inductor was analyzed with the conclusion that such a device is not feasible with present fabrication techniques. Computer calculations using synthetic SIS junction I-V characteristics predicted the performance of an optimized receiver over its entire operating frequency range. Many aspects of the operation of SIS mixers were clarified and unexpected new phenomena were predicted. A 'photon picture' interpretation of the quantum theory of mixing is in the early stages ofmore » development. Niobium nitride edge junctions with excellent current-voltage characteristics were fabricated using novel barrier formation processes. The role of surface damage in the quality of NbN edge junction electrical characteristics was investigated and unexpected results were obtained.« less

Final Technical Report•Nov 1, 1990•0 citations

A Circuit for Tuning Superconductor–Insulator–Superconductor Mixers Using Distributed Tunnel Junctions

Yoshinori Uzawa, Masanori Takeda, Zhen Wang

A circuit that produces broadband impedance matching with low-current-density junctions at submillimeter wavelengths for tuning superconductor–insulator–superconductor (SIS) mixers is described; it consists of half-wavelength distributed SIS junctions connected alternately by half-wavelength microstrip lines. It is made of Nb and was designed for two practical source impedances using numerical calculation based on the Mattis–Bardeen theory of the anomalous skin effect at 660 GHz, assuming SIS junctions with a current density of 5 kA/cm 2 . An SIS mixer tuned using this circuit had a large fractional bandwidth of more than 18%, below -10 dB matching, even though the assumed ω C J R N product was about 16. Investigation of the mixer performance using Tucker's quantum theory of mixing showed that it has excellent broadband and low-noise characteristics compared with conventional mixers consisting of half- or full-wavelength distributed elements.

Japanese Journal of Applied Physics•Jan 15, 2003•2 citations

A 200-285-GHz waveguide SIS mixer with an inhomogeneous distributed junction array

Mahoto Takeda, Takashi Noguchi

In this paper, we present the experimental results of a waveguide superconductor-insulator-superconductor (SIS) mixer with an inhomogeneous distributed junction array. The mixer consists of five Nb-AlO/sub x/-Nb SIS junctions with different dimensions distributed on a superconducting microstrip. The critical current density of the fabricated junctions was 3100 A/cm/sup 2/. Detailed measurements of the receiver noise temperature have been made in the frequency range from 190 to 284 GHz at 4.2 K. A double-sideband (DSB) receiver noise temperature of 5 hw/k was obtained in the frequency range from 202 to 284 GHz and the lowest DSB receiver noise temperature of 46 K was obtained at 210 GHz.

IEEE Transactions on Microwave Theory and Techniques•Nov 1, 2002•2 citations

Theoretical SIS mixer research

M. J. Feldman

Theoretical research has been conducted to elucidate the basic physics behind the properties of superconductor-insulator-superconductor (SIS) tunnel junction receiving devices. The properties of SIS mixers using nonideal junctions and finite LO power, were determined by analytic expansion of the equations of the quantum theory of mixing, and also by computer simulations of SIS receivers over the entire range of experimental parameters. The result is a new coherent and intuitive picture of SIS mixer behavior. Many of the outstanding mysteries and questions about SIS receivers are resolved, and this contributes greatly to the design and interpretation of SIS mixer experiments. Other calculations show how to achieve sub-quantum noise temperatures in the phase sensitive SIS mixer, an important step towards realization of ultra-low- noise detectors. A simplified model casts doubt on the superlative experimental results reported for the rf-series dc-parallel biased array SIS mixer. Superconductivity; SIS mixer; Submillimeter-wave detection.

Final Technical Report•Jun 1, 1993•0 citations

Experimental results of SIS mixers with distributed junction arrays

Sheng‐Cai Shi, Takashi Noguchi, Junji Inatani +2 more

The heterodyne mixing performance of three respective distributed junction arrays, i.e., a number of superconductor-insulator-superconductor (SIS) junctions distributed along a thin-film transmission line involving two, five, and ten junctions are measured and compared to their Fourier transform spectroscopy (FTS) detection responses. It has been found that distributed junction arrays have a rather large bandwidth in comparison to conventional SIS junction devices, while still keeping a quantum-limited noise performance. Detailed experimental results are presented.

IEEE Microwave and Guided Wave Letters•Jan 1, 1998•22 citations
The mixing properties of a new type of distributed superconductor-insulator-superconductor (SIS) junction array, which consists of different dimensions of junctions and spacings between every two junctions, have been theoretically investigated using the quantum theory of mixing. A set of dimensions of junctions and spacings between every two junctions of the distributed junction array have been determined so as to minimize the reflection coefficient of an S-parameter, S 11, at the input port in the array using microwave computer-aided design, assuming that each SIS junction is represented by a parallel combination of linear normal-state resistance and geometrical capacitance. When the array is composed of well optimized set of dimensions of junctions and spacings between every two junctions, it is demonstrated that excellent mixing properties are attained over a broad-band in spite of the low critical current density of an SIS junction. It is also found that the degradation of mixing properties, which is always observed at certain frequencies in a conventional array with the equal dimensions of junctions and spacings, can be considerably suppressed in the array with a well optimized set of dimensions and spacings of junctions.
A Superconductor-Insulator-Superconductor (SIS) mixer using parallel array of N junctions have been studied. It has been shown by theoretical analysis that the performance of this type of device is excellent and that nearly quantum-limited performance of the mixer can be obtained. It has been demonstrated that the double sideband (DSB) noise temperature of a receiver employing parallel array of twin junctions, which is the most simplest case in the parallel array of N junctions, was approximately 3 to 5 times as large as the quantum limited photon noise up to the gap frequency of Nb (approximately 700 GHz). It has been also shown that the bandwidth performance of parallel junction arrays can be improved significantly with a large number of SIS junctions even if SIS junctions with a relatively low current density or a large (omega) RNCJ product are adopted in the arrays.
Theoretica and experimental research has been conducted to elucidate the basic physics behind the properties of superconductor-insulator-superconductor (SIS) tunnel junction receiving devices. The properties of an SIS mixer using a slightly nonideal junction, with finite LO power, were determined by analytic expansion of the equations of the quantum theory of mixing. The resulting equations have a particularly simple form. The minimum noise temperature is controlled by the leakage current of the junction. Even the most nearly ideal junctions made today require a considerable LO for best sensitivity; nevertheless, even a comparatively large leakage current allows mixer noise to be only a small factor above the quantum limit. The saturation properties of SIS mixers subjected to broad-band thermal noise obey the equations derived for monochromatic saturating signals. The Josephson junction tuning inductor was analyzed with the conclusion that such a device is not feasible with present fabrication techniques. Computer calculations using synthetic SIS junction I-V characteristics predicted the performance of an optimized receiver over its entire operating frequency range. Many aspects of the operation of SIS mixers were clarified and unexpected new phenomena were predicted. A 'photon picture' interpretation of the quantum theory of mixing is in the early stages ofmore » development. Niobium nitride edge junctions with excellent current-voltage characteristics were fabricated using novel barrier formation processes. The role of surface damage in the quality of NbN edge junction electrical characteristics was investigated and unexpected results were obtained.« less
A circuit that produces broadband impedance matching with low-current-density junctions at submillimeter wavelengths for tuning superconductor–insulator–superconductor (SIS) mixers is described; it consists of half-wavelength distributed SIS junctions connected alternately by half-wavelength microstrip lines. It is made of Nb and was designed for two practical source impedances using numerical calculation based on the Mattis–Bardeen theory of the anomalous skin effect at 660 GHz, assuming SIS junctions with a current density of 5 kA/cm 2 . An SIS mixer tuned using this circuit had a large fractional bandwidth of more than 18%, below -10 dB matching, even though the assumed ω C J R N product was about 16. Investigation of the mixer performance using Tucker's quantum theory of mixing showed that it has excellent broadband and low-noise characteristics compared with conventional mixers consisting of half- or full-wavelength distributed elements.
In this paper, we present the experimental results of a waveguide superconductor-insulator-superconductor (SIS) mixer with an inhomogeneous distributed junction array. The mixer consists of five Nb-AlO/sub x/-Nb SIS junctions with different dimensions distributed on a superconducting microstrip. The critical current density of the fabricated junctions was 3100 A/cm/sup 2/. Detailed measurements of the receiver noise temperature have been made in the frequency range from 190 to 284 GHz at 4.2 K. A double-sideband (DSB) receiver noise temperature of 5 hw/k was obtained in the frequency range from 202 to 284 GHz and the lowest DSB receiver noise temperature of 46 K was obtained at 210 GHz.
Theoretical research has been conducted to elucidate the basic physics behind the properties of superconductor-insulator-superconductor (SIS) tunnel junction receiving devices. The properties of SIS mixers using nonideal junctions and finite LO power, were determined by analytic expansion of the equations of the quantum theory of mixing, and also by computer simulations of SIS receivers over the entire range of experimental parameters. The result is a new coherent and intuitive picture of SIS mixer behavior. Many of the outstanding mysteries and questions about SIS receivers are resolved, and this contributes greatly to the design and interpretation of SIS mixer experiments. Other calculations show how to achieve sub-quantum noise temperatures in the phase sensitive SIS mixer, an important step towards realization of ultra-low- noise detectors. A simplified model casts doubt on the superlative experimental results reported for the rf-series dc-parallel biased array SIS mixer. Superconductivity; SIS mixer; Submillimeter-wave detection.
The heterodyne mixing performance of three respective distributed junction arrays, i.e., a number of superconductor-insulator-superconductor (SIS) junctions distributed along a thin-film transmission line involving two, five, and ten junctions are measured and compared to their Fourier transform spectroscopy (FTS) detection responses. It has been found that distributed junction arrays have a rather large bandwidth in comparison to conventional SIS junction devices, while still keeping a quantum-limited noise performance. Detailed experimental results are presented.