Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

European Conference on Optical Communication

Experimental Characterization of a Phase-Sensitive Four-Mode Fiber-Optic Parametric Amplifier

Thomas Richter, Bill Corcoran, Samuel L. I. Olsson, Carl Lundström, Magnus Karlsson, Colja Schubert, Peter A. Andrekson

Published Jan 1, 2012• 16 citations
Publisher

Abstract

Four-mode phase-sensitive amplification is experimentally introduced for the first time. In a proof-of-principle realization using a dual-pump fiber-optic parametric amplifier we achieve nearly 20-dB gain. The influence of the individual phases of the six interacting waves on the signal gain is investigated.
DOI
10.1364/eceoc.2012.th.1.f.1

Related papers

Detailed characterization of a fiber-optic parametric amplifier in phase-sensitive and phase-insensitive operation

Joseph Kakande, Carl Lundström, Peter A. Andrekson +5 more

We experimentally demonstrate a single-pumped, non-degenerate phase-sensitive parametric amplifier with a precise control of phase and amplitude of the in-going waves and investigate in detail its gain, attenuation and saturation properties in comparison with operation in phase insensitive amplifier (PIA) mode. We experimentally observe the variation of the gain and attenuation as a function of the relative phase, pump power and the signal-idler power ratio. The phase sensitive gain spectrum is studied over a 24 nm symmetrical bandwidth and we achieve a maximum phase sensitive amplification (PSA) gain of 33 dB. A departure from the theoretical maximum attenuation as the gain increases is observed and explained.

Optics Express•Feb 17, 2010•70 citations

Pump Frequency Allocation and Dispersion Effect on Dual-Pump Phase Sensitive Amplifier Gain Spectrum

Ruwan U. Weerasuriya, Junda Chen, Rasmus Larsson +1 more

Dual-pump fiber optical parametric amplifiers offer wide, flat gain spectra across arbitrary wavelengths, often outperforming the use of single-pump designs. However, gain flatness depends on the pump frequencies’ center of gravity relative to the nonlinear fiber’s zero-dispersion wavelength. This study experimentally investigated the gain, gain flatness, and noise figure of degenerate dual-pump fiber-optic phase-sensitive amplification at various separations between these points. We demonstrated 38 dB gain with 1.5 dB gain flatness variation over a 30 nm bandwidth as well as a noise figure below the conventional 3 dB quantum limit for a degenerate signal.

IEEE Photonics Technology Letters•Jul 30, 2025•3 citations

Gain characteristics of a frequency nondegenerate phase-sensitive fiber-optic parametric amplifier with phase self-stabilized input

Renyong Tang, Jacob Lasri, Preetpaul S. Devgan +3 more

We experimentally demonstrate, for the first time to our knowledge, a phase-sensitive amplifier based on frequency nondegenerate parametric amplification in optical fiber, where the input signal-idler pair is prepared all-optically. Using two fiber-optic parametric amplifier sections separated by a fiber-based wavelength-dependent phase shifter, we observe and investigate phase-sensitive gain profile in the 1550 nm region both experimentally and theoretically. The realized scheme automatically generates gain-defining phase that is environmentally stable, making it advantageous for building phase-sensitive transmission links.

Optics Express•Jan 1, 2005•127 citations

Fiber-based phase-sensitive optical amplifiers and their applications

Peter A. Andrekson, Magnus Karlsson

Optical parametric amplifiers rely on second-order susceptibility (three-wave mixing) or third-order susceptibility (four-wave mixing) in a nonlinear process where the energy of incoming photons is not changed (elastic scattering). In the latter case, two pump photons are converted to a signal and to an idler photon. Under certain conditions, related to the phase evolution of the waves involved, this conversion can be very efficient, resulting in large amplification of an input signal. As the nonlinear process can be very fast, all-optical applications aside from pure amplification are also possible. If the amplifier is implemented in an optical input-phase-sensitive manner, it is possible to amplify a signal wave without excess noise, i.e., with a noise figure of 0 dB. In this paper, we will provide the fundamental concepts and theory of such amplifiers, with a focus on their implementation in highly nonlinear optical fibers relying on four-wave mixing. We will discuss the distinctions between phase-insensitive and phase-sensitive operation and include several experimental results to illustrate their capability. Different applications of parametric amplifiers are also discussed, including their use in optical communication links.

Advances in Optics and Photonics•Feb 20, 2020•102 citations

Noise in phase-(in)sensitive dual-core fiber parametric amplification

Vítor Ribeiro, Abel Lorences-Riesgo, Peter A. Andrekson +1 more

Flat and wide-bandwidth gain spectrum, along with phase-sensitive gain with no need to generate amplifier input idlers, can be achieved with a coupled dual-core fiber optical parametric amplifier. In this paper, we analyze the noise properties of such an amplifier. We achieve a 3 dB noise figure in the phase-insensitive case and a minimum of -6 dB noise figure in the phase-sensitive configuration. An alternative phase-sensitive configuration is also studied, that avoids the use of idlers at the input of the amplifier, leading to a 3 dB flat spectrum combined noise figure for the output signals. Pump transfer noise in phase-insensitive and phase-sensitive configurations is also studied along with the noise figure variation against the length of the amplifier.

Optics Express•Feb 7, 2018•13 citations

Experimental analysis of degenerate vector phase-sensitive amplification

Abel Lorences-Riesgo, Fabrizio Chiarello, Carl Lundström +2 more

We comprehensively investigate a degenerate vector phase-sensitive amplifier (PSA). We determine the gain dependence on the relative phase and polarization angle between the pumps and the degenerate signal wave. The vector PSA is experimentally shown to be sensitive to the pump states of polarization (SOP) due to polarization mode dispersion in the fiber. However, the scheme performance agrees well with theory under specific pump SOPs and we achieve an on-off gain over 10 dB with a small deviation from the theoretically expected results. In comparison to the scalar scheme, the proposed vector scheme has larger tolerance for pump depletion due to four-wave mixing between pumps and generation of higher-order idlers.

Optics Express•Sep 2, 2014•19 citations
We experimentally demonstrate a single-pumped, non-degenerate phase-sensitive parametric amplifier with a precise control of phase and amplitude of the in-going waves and investigate in detail its gain, attenuation and saturation properties in comparison with operation in phase insensitive amplifier (PIA) mode. We experimentally observe the variation of the gain and attenuation as a function of the relative phase, pump power and the signal-idler power ratio. The phase sensitive gain spectrum is studied over a 24 nm symmetrical bandwidth and we achieve a maximum phase sensitive amplification (PSA) gain of 33 dB. A departure from the theoretical maximum attenuation as the gain increases is observed and explained.
Dual-pump fiber optical parametric amplifiers offer wide, flat gain spectra across arbitrary wavelengths, often outperforming the use of single-pump designs. However, gain flatness depends on the pump frequencies’ center of gravity relative to the nonlinear fiber’s zero-dispersion wavelength. This study experimentally investigated the gain, gain flatness, and noise figure of degenerate dual-pump fiber-optic phase-sensitive amplification at various separations between these points. We demonstrated 38 dB gain with 1.5 dB gain flatness variation over a 30 nm bandwidth as well as a noise figure below the conventional 3 dB quantum limit for a degenerate signal.
We experimentally demonstrate, for the first time to our knowledge, a phase-sensitive amplifier based on frequency nondegenerate parametric amplification in optical fiber, where the input signal-idler pair is prepared all-optically. Using two fiber-optic parametric amplifier sections separated by a fiber-based wavelength-dependent phase shifter, we observe and investigate phase-sensitive gain profile in the 1550 nm region both experimentally and theoretically. The realized scheme automatically generates gain-defining phase that is environmentally stable, making it advantageous for building phase-sensitive transmission links.
Optical parametric amplifiers rely on second-order susceptibility (three-wave mixing) or third-order susceptibility (four-wave mixing) in a nonlinear process where the energy of incoming photons is not changed (elastic scattering). In the latter case, two pump photons are converted to a signal and to an idler photon. Under certain conditions, related to the phase evolution of the waves involved, this conversion can be very efficient, resulting in large amplification of an input signal. As the nonlinear process can be very fast, all-optical applications aside from pure amplification are also possible. If the amplifier is implemented in an optical input-phase-sensitive manner, it is possible to amplify a signal wave without excess noise, i.e., with a noise figure of 0 dB. In this paper, we will provide the fundamental concepts and theory of such amplifiers, with a focus on their implementation in highly nonlinear optical fibers relying on four-wave mixing. We will discuss the distinctions between phase-insensitive and phase-sensitive operation and include several experimental results to illustrate their capability. Different applications of parametric amplifiers are also discussed, including their use in optical communication links.
Flat and wide-bandwidth gain spectrum, along with phase-sensitive gain with no need to generate amplifier input idlers, can be achieved with a coupled dual-core fiber optical parametric amplifier. In this paper, we analyze the noise properties of such an amplifier. We achieve a 3 dB noise figure in the phase-insensitive case and a minimum of -6 dB noise figure in the phase-sensitive configuration. An alternative phase-sensitive configuration is also studied, that avoids the use of idlers at the input of the amplifier, leading to a 3 dB flat spectrum combined noise figure for the output signals. Pump transfer noise in phase-insensitive and phase-sensitive configurations is also studied along with the noise figure variation against the length of the amplifier.
We comprehensively investigate a degenerate vector phase-sensitive amplifier (PSA). We determine the gain dependence on the relative phase and polarization angle between the pumps and the degenerate signal wave. The vector PSA is experimentally shown to be sensitive to the pump states of polarization (SOP) due to polarization mode dispersion in the fiber. However, the scheme performance agrees well with theory under specific pump SOPs and we achieve an on-off gain over 10 dB with a small deviation from the theoretically expected results. In comparison to the scalar scheme, the proposed vector scheme has larger tolerance for pump depletion due to four-wave mixing between pumps and generation of higher-order idlers.