Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Low-noise SIS mixer for far-infrared radio astronomy

Alexandre Karpov, David Miller, F. Rice, Jeffrey A. Stern, B. Bumble, Henry George LeDuc, Jonas Stasys Zmuidzinas

Published Oct 8, 2004• 25 citations

Abstract

We present a low noise SIS mixer developed for the 1.2 THz band of the heterodyne spectrometer of the Herschel Space Observatory. With the launch of the Herschel SO in 2007, this device will be among the first SIS mixers flown in space. This SIS mixer has a quasi-optical design, with a double slot planar antenna and an extended spherical lens made of pure Si. The SIS junctions are Nb/AlN/NbTiN with a critical current density of about 30 KA/cm2 and with the junction area of a quarter of a micron square. Our mixer circuit uses two SIS junctions biased in parallel. To improve the simultaneous suppression of the Josephson current in each of them, we use diamond-shaped junctions. A low loss Nb/Au micro-strip transmission line is used for the first time in the mixer circuit well above the gap frequency of Nb. The minimum uncorrected Double Sideband receiver noise is 550 K (Y=1.34). The minimum receiver noise corrected for the local oscillator beam splitter and for the cryostat window is 340 K, about 6 hv/k, the lowest value achieved thus far in the THz frequencies range.

DOI: 10.1117/12.553190

Related papers

Low noise 1.2 THz SIS mixer for Herschel radio observatory

Alexandre Karpov, David A. B. Miller, F. Rice +4 more

We present a low noise SIS mixer developed for the 1.2 THz band of the heterodyne spectrometer of the Herschel Space Observatory. With the launch of the Herschel SO in 2007, this device will be among the first SIS mixers flown in space. This SIS mixer has a quasi optical design, with a double slot planar antenna and an extended spherical lens made of pure Si. The SIS junctions are Nb/A1N/NbTiN with a critical current density of about 30 KA/cm2 and with the junction area of a quarter of a micron square. Our mixer circuit uses two SIS junctions biased in parallel. To improve the simultaneous suppression of the Josephson current in each of them, we use diamond-shaped junctions. A low loss Nb/Au micro-strip transmission line is used for the first time in the mixer circuit well above the gap frequency of Nb. The minimum uncorrected Double Sideband receiver noise is 550 K (Y=1.34). The minimum receiver noise corrected for the local oscillator beam splitter and for the cryostat window is 340 K, about 6 hv/k, the lowest value achieved thus far in the THz frequencies range.

Jan 1, 20091 citation

Development of 1.25 THz SIS mixer for Herschel Space Observatory

Alexandre Karpov, D. Miller, F. Rice +4 more

We summarize the development and the delivery of two SIS mixers for the 1.1-1.25 THz band of the heterodyne spectrometer of Herschel Observatory (HSO). The quasi-optical SIS mixer has two Nb/AlN/NbTiN junctions with the area of 0.25 um2. The Josephson critical current density in the junction is 30-50 kA/cm2. The tuning circuit integrated with SIS junction has the base electrode of Nb and a gold wire layer. With the new SIS mixers the test receiver maximum Y factor is 1.41. The minimum receiver uncorrected DSB noise temperature is 450 K. The SIS receiver noise corrected for the loss in the optics is 350-450 K across the 1100-1250 GHz band. The receiver has a uniform sensitivity in the full IF range of 4-8 GHz. The sub-micron sized SIS junction shape is optimized to ease the suppression of the Josephson current, and the receiver operation is stable. The measured mixer beam pattern is symmetrical and, in a good agreement with the requirements, has the f/d =4.25 at the central frequency of the operation band. The minimum DSB SIS receiver noise is close to 6 hv/k, the lowest value achieved thus far in the THz frequencies range.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIEJun 14, 20068 citations

Low Noise 1 THz–1.4 THz Mixers Using Nb/Al-AlN/NbTiN SIS Junctions

Alexandre Karpov, D. Miller, F. Rice +4 more

We present the development of a low noise 1.2 THz and 1.4 THz SIS mixers for heterodyne spectrometry on the Stratospheric Observatory For Infrared Astronomy (SOFIA) and Herschel Space Observatory. This frequency range is above the limit for the commonly used Nb quasi particle SIS junctions, and a special type of hybrid Nb/AlN/NbTiN junctions has been developed for this project. We are using a quasi-optical mixer design with two Nb/AlN/NbTiN junctions with an area of 0.25. The SIS junction tuning circuit is made of Nb and gold wire layers. At 1.13 THz the minimum SIS receiver uncorrected noise temperature is 450 K. The SIS receiver noise corrected for the loss in the LO coupler and in the cryostat optics is 350-450 K across 1.1-1.25 THz band. The receiver has a uniform sensitivity in a full 4-8 GHz IF band. The 1.4 THz SIS receiver test at 1.33-1.35 THz gives promising results, although limited by the level of available LO power. Extrapolation of the data obtained with low LO power level shows a possibility to reach 500 K DSB receiver noise using already existing SIS mixer.

IEEE Transactions on Applied SuperconductivityJun 1, 200759 citations

Low Noise 1 THz SIS Mixer for Stratospheric Observatory: Design and Characterization

Alexandre Karpov, D A Miller, J. A. Stern +5 more

We report the development of a low noise SIS mixer aimed for 1 THz channel of the Caltech Airborne Submillimeter Interstellar Medium Investigations Receiver (CASIMIR), designed for the Stratospheric Observatory for Far Infrared Astronomy (SOFIA). The mixer uses Nb/Al-AlN/NbTiN SIS junctions with critical current density of about 45 kA/cm2. The junctions are shaped in order to optimize the suppression of the Josephson DC currents. We used a double slot planar antenna to couple the mixer chip with the telescope beam. The RF matching microcircuit is made using Nb and gold films. The mixer IF circuit is designed to cover 4-8 GHz band. The test receiver with the new mixer has the low noise operation in a 0.9-1.05 THz band. The minimum DSB receiver noise measured at 1 THz is 260 K (Y=1.64) , apparently the lowest reported up to date.

IEEE Transactions on Applied SuperconductivityMar 22, 20116 citations

Low Noise 1.2 THz SIS Receiver

Alexandre Karpov, David A. B. Miller, F. Rice +4 more

We present the development of a low noise superconductor insulator superconductor (SIS) mixer for the 1.1 - 1.25 THz heterodyne receiver of FIRST space radiotelescope. The quasi-optical SIS mixer has two NbTiN/AlN/Nb junctions with critical current density 30 kA/sq cm. The individual junction area is close to 0.65 square micrometers. The SIS junctions are coupled to the optical input beam through a planar double slot antenna and a Si hyperhemispherical lens. The minimum DSB receiver noise temperature is 650 K, about 12 hv/k.

Softwaretechnik-TrendsDec 1, 20017 citations

Low Noise SIS Mixer with Nb Tuning Circuit for the Frequency above 1 THz

Alexandre Karpov, Jonas Stasys Zmuidzinas, F. Rice +4 more

We developed a SIS mixer for the 1.1-1.25 THz band of the heterodyne receiver of Herschel space observatory. The quasi-optical SIS mixer has two NbN/A1N/Nb junctions with the critical current 30-50 IcA/cm 2 and the gap voltage of 3.4 mV. The tuning circuit integrated with SIS junction has the base electrode of Nb and a gold wire layer. This approach simplifies the SIS junction technology, compared to a design using NbTiN base electrode. The junction base electrode and the ground of the tuning micro strip circuit are formed in one step. The frequency of operation of the mixer is well above the gap frequency of Nb, and it behaves here as a normal metal. The epitaxial Nb film is gown at the sapphire substrate. The resistivity of Nb at the critical temperature of 0.211,011m cm is below the resitivity of the best normal metal films. This allows us to expect the loss of only 2 dB in the junction tuning circuit at 1.2 THz. The measured receiver noise temperature is below 600 K.

Mar 1, 20021 citation