Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physica B Condensed Matter

Excess low-frequency flux noise in dc SQUIDS incorporating Nb/AIOXIDE/Nb Josephson junctions

M. E. Huber, Michael W. Cromar

Published Aug 1, 1990• 2 citations
Publisher
DOI
10.1016/s0921-4526(90)80888-p

Related papers

A Low Noise DC-SQUID Based on Nb/Al-AlOx/Nb Josephson Junctions

Leif Grönberg, Heikki Seppä, R. Cantor +4 more

Springer proceedings in physics•Jan 1, 1992•6 citations

Noise Measurements in dc-SQUIDs Based on Nb — NbOx — PbAuIn Josephson Junctions

M. Pullano, P. Carelli, Vittorio Foglietti +2 more

NATO ASI series. Series B : Physics•Jan 1, 1990•0 citations

Excess low-frequency flux noise in dc SQUIDs

M. E. Huber, Michael W. Cromar, Ronald H. Ono

We have fabricated dc superconducting quantum interference devices (SQUIDs) incorporating Nb/Al-oxide/Nb Josephson junctions in both stripline and washer geometries. Low-frequency noise in excess of that predicted by the resistively-shunted junction model is present in both geometries and is demonstrated to be flux noise. This flux noise is not environmental. Improvements in fabrication processing over the past four years have reduced the level of this flux noise. SQUIDs are now fabricated with PdAu resistors, Nb wiring layers, and SiO/sub 2/ interlayer dielectric. In our best well-coupled SQUIDs, the white-noise energy sensitivity is 5/spl times/10/sup -31/ J/spl middot/s, with a 1/f knee below 0.1 Hz. We believe further reduction in the flux noise might be obtained with the use of on-chip flux shielding and/or trapping structures.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•5 citations

Low-frequency excess noise in SQUIDS with YBa2Cu3O7step-edge junctions

V. N. Glyantsev, M. Siegel, Jürgen Schubert +2 more

We have fabricated RF and DC SQUIDS with step-edge Josephson junctions (SEJ) and YBa 2 Cu 3 O 7 thin films. The low-frequency noise of these SQUIDS has been investigated as a function of temperature, bias current and magnetic field. Typically, the energy resolution in the white noise region of the DC SQUIDS with an inductance of 45 pH was 3*10 -30 J Hz -1 at 77.5 K. Depending on the bias current, the low-frequency spectrum could be of either 1/f type or Lorentzian type. The Lorentzian spectrum was generated by random telegraph signals (RTSS). An Arrhenius plot was obtained from the temperature dependence of the switching time of these RTSS. We have determined two barrier lengths of 0.23 eV and 1 eV of the two-level fluctuator (TLF) generating this RTS noise. From the magnetic-field dependence of the low-frequency noise we have found that the noise is periodic with the flux corresponding to the area of the SEJ. The results were discussed in terms of a model treating the SEJ as a multi-junction interferometer which forms a two-level fluctuator when the junction is placed inside a SQUID loop. The noise is generated by thermally activated switching of the SQUID between the two different states of the SQUID.

Superconductor Science and Technology•May 1, 1994•11 citations

Investigation of low-frequency excess noise in low-Tc dc-SQUIDs

Sebastian Kempf, Anna Ferring, A. Fleischmann +1 more

•Jan 1, 2015•0 citations

Investigation of 1/f noise in tunnel junction DC SQUIDS

R. H. Koch, John L. Clarke, John M. Martinis +3 more

We describe two methods of measuring the 1/f noise in a dc SQUID. One is sensitive only to 1/f noise in the critical currents of the junctions, and the other is sensitive only to 1/f flux noise that is not associated with critical current fluctuations. From measurements on a planar thin-film dc SQUID incorporating Josephson tunnel junctions we conclude that the predominant source of 1/f noise is not noise in the crititcal currents, but rather an apparent flux noise of unknown origin.

IEEE Transactions on Magnetics•May 1, 1983•11 citations
We have fabricated dc superconducting quantum interference devices (SQUIDs) incorporating Nb/Al-oxide/Nb Josephson junctions in both stripline and washer geometries. Low-frequency noise in excess of that predicted by the resistively-shunted junction model is present in both geometries and is demonstrated to be flux noise. This flux noise is not environmental. Improvements in fabrication processing over the past four years have reduced the level of this flux noise. SQUIDs are now fabricated with PdAu resistors, Nb wiring layers, and SiO/sub 2/ interlayer dielectric. In our best well-coupled SQUIDs, the white-noise energy sensitivity is 5/spl times/10/sup -31/ J/spl middot/s, with a 1/f knee below 0.1 Hz. We believe further reduction in the flux noise might be obtained with the use of on-chip flux shielding and/or trapping structures.
We have fabricated RF and DC SQUIDS with step-edge Josephson junctions (SEJ) and YBa 2 Cu 3 O 7 thin films. The low-frequency noise of these SQUIDS has been investigated as a function of temperature, bias current and magnetic field. Typically, the energy resolution in the white noise region of the DC SQUIDS with an inductance of 45 pH was 3*10 -30 J Hz -1 at 77.5 K. Depending on the bias current, the low-frequency spectrum could be of either 1/f type or Lorentzian type. The Lorentzian spectrum was generated by random telegraph signals (RTSS). An Arrhenius plot was obtained from the temperature dependence of the switching time of these RTSS. We have determined two barrier lengths of 0.23 eV and 1 eV of the two-level fluctuator (TLF) generating this RTS noise. From the magnetic-field dependence of the low-frequency noise we have found that the noise is periodic with the flux corresponding to the area of the SEJ. The results were discussed in terms of a model treating the SEJ as a multi-junction interferometer which forms a two-level fluctuator when the junction is placed inside a SQUID loop. The noise is generated by thermally activated switching of the SQUID between the two different states of the SQUID.