Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review A

Atomic alkali-metal gas cells at liquid-helium temperatures: Loading by light-induced atom desorption

A. Hatakeyama, Katsunari Enomoto, N. Sugimoto, T. Yabuzaki

Published Jan 16, 2002• 26 citations
Publisher

Abstract

We have studied the loading of gaseous alkali-metal atoms into glass cells held at about 2 K by light-induced atom desorption (LIAD). In LIAD loading, the cell containing dense helium gas and a small amount of alkali metal is irradiated with cw laser light. This technique has two unique features to be investigated: alkali-metal atoms are desorbed, even by weak laser irradiation, from the cell walls not covered visibly with alkali metal, and loading efficiency is much higher below the superfluid transition temperature for the helium inside the cell than above this temperature. On the basis of extensive experimental studies for Rb presented in this paper, we give a consistent picture of the loading mechanism: alkali-metal atoms are optically desorbed from alkali-metal particles on the walls, then transported effectively into the cell volume by helium-gas flow produced by the continuous evaporation of the helium film, which is supplied by the superfluid-film flow on the walls from the bulk liquid helium at the bottom of the cell.

DOI
10.1103/physreva.65.022904

Related papers

Properties of Alkali Atoms Confined in a Cold Helium Gas

A. Hatakeyama, Katsunari Enomoto, T. Yabuzaki

Properties of alkali atoms (mainly rubidium and cesium) in a cold helium gas have been extensively studied. Experiments are performed at temperatures down to 1.2 K using alkali-metal vapor cells containing a helium buffer gas, with alkali atoms driven from the cell walls by one of three loading methods: laser ablation, light-induced atom desorption, and spark discharge. For alkali atoms loaded into the cold helium gas, we have found that the relaxation time of the electronic spin of optically polarized rubidium atoms in the ground state is about a minute, much longer than that achieved in conventional vapor cells at room temperature and above. We have also spectroscopically investigated the interactions of excited alkali atoms with helium atoms, especially the formation of alkali–He exciplexes.

Physica Scripta•Jan 1, 2004•7 citations

Light-induced Desorption of Alkali-metal Atoms as a Source of Laser-cooled Atoms

A. Hatakeyama

Light-induced atom desorption (LIAD) of alkali-metal atoms in alkali-metal vapor cells can be used to quickly increase the vapor density. It is particularly useful as a source for laser-cooled atoms. We review the studies of LIAD for alkali-metal atoms, with particular attention to its application to laser cooling experiments. We show clear differences in LIAD properties for quartz and Pyrex substrates, which are widely used materials in laser-cooling cells.

Vacuum and Surface Science•Oct 9, 2020•0 citations

Atomic sources controlled by light: main features and applications

Andrea Bogi, A. Burchianti, C. de Mauro +6 more

We present in this paper recent results on Light - Induced Atom Desorption (LIAD) in sealed and open coated cells. LIAD is defined via the description of an experiment on rubidium atoms stored in a dry - film coated cell, where a few milliwatts of even non coherent and non resonant light are able to increase the alkali atomic density for more than one order of magnitude. Modeling of the effect is given. New features become relevant in the case of LIAD in porous glasses: in fact, although the photodesorption efficiency per unit area in bare glass is much lower, photoatomic sources can be prepared, due to the huge inner surface of porous samples. We applied LIAD from organic coatings to the stabilization of alkali densities out of equilibrium: sodium case is here discussed. Finally, we report on fully original, preliminary measurements of rubidium Magneto - Optical Trap loading via LIAD from a dry - film coated cell.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 8, 2010•1 citation

Light-induced atomic desorption and related phenomena

A. Burchianti, Andrea Bogi, C. Marinelli +2 more

We review some recent studies on light-induced atomic desorption (LIAD) from dielectric surfaces. Alkali-metal atoms adsorbed either on organic films or on porous glass are released into the vapor phase under illumination. The measurements were performed in Pyrex resonance cells either coated with siloxane films or containing a porous glass sample. In both cases, the experimental results show that LIAD can be used to produce atomic densities suitable for most atomic physics experiments. Moreover, we find that photoinduced effects, correlated with LIAD, produce reversible formation and evaporation of alkali-metal clusters in porous glass. These processes depend on the light frequency, making the porous glass transmittance controllable by light.

Physica Scripta•Jul 1, 2009•14 citations

Light-induced atomic desorption in cells with different PDMS coatings

S. Tsvetkov, S. Gateva, Marian A. Taslakov +2 more

Light-induced atomic desorption (LIAD) is a non-thermal process in which atoms adsorbed at a surface are released under illumination. It is applied mostly to implementing optical dispensers in the cases when high atomic density at low temperature is needed – for example, for loading atomic devices as atomic magnetometers, atomic clocks, magneto-optical traps and their miniaturization. However, as the desorption depends on the atom-surface interaction, it can also be used for optical characterization and manipulation of alkali metal nanoparticles. The paper describes an experimental investigation of the shape of the transmission spectra and their dependence on the illuminating blue-light power in PDMS coated cells prepared with two different concentrations of PDMS in ether. A comparison is conducted with the LIAD effect in SC-77 coated and in uncoated cells. All measurements are performed on the Rb D2 line in vacuum. The potential is discussed for application of these dependences to analyzing the quality of the coating surface and its optimization.

Journal of Physics Conference Series•May 15, 2014•5 citations

Light induced atomic desorption influence on the spectra of alkali atoms

Стоян Цветков, S. Tsvetkov

This work is devoted to a systematic study of the effect of Light-Induced Atomic Desorption (LIAD). LIAD is a non-heating process in which atoms adsorbed on a surface are desorbed by illumination with non-resonant light. The aim of the dissertation is an experimental study of the LIAD process, its influence on the spectra of alkali atoms in optical cells without and with Anti-Relaxation Coating (ARC) and the possibilities of LIAD for optical characterization of ARC, as well as in high resolution spectroscopy. For the first time, the LIAD process under homogeneous illumination was investigated experimentally, whereby the efficiency of the LIAD was significantly increased even for a cell without ARC, the dynamic characteristics are obtained with a better signal to noise ratio and repeatability, and the desorption and adsorption processes are faster. LIAD effect in cells with different ARC coatings has shown that each coating has different desorption and adsorption rates and the results obtained show the possibility of applying the method for optical characterization of ARC. An experimental study of the number of collisions without atomic spin depolarization in cells with different ARCs and the impact of LIAD was performed, as well as various parameters such as laser intensity and cell temperature were investigated.

•Mar 27, 2019•0 citations
We have studied the loading of gaseous alkali-metal atoms into glass cells held at about 2 K by light-induced atom desorption (LIAD). In LIAD loading, the cell containing dense helium gas and a small amount of alkali metal is irradiated with cw laser light. This technique has two unique features to be investigated: alkali-metal atoms are desorbed, even by weak laser irradiation, from the cell walls not covered visibly with alkali metal, and loading efficiency is much higher below the superfluid transition temperature for the helium inside the cell than above this temperature. On the basis of extensive experimental studies for Rb presented in this paper, we give a consistent picture of the loading mechanism: alkali-metal atoms are optically desorbed from alkali-metal particles on the walls, then transported effectively into the cell volume by helium-gas flow produced by the continuous evaporation of the helium film, which is supplied by the superfluid-film flow on the walls from the bulk liquid helium at the bottom of the cell.
Properties of alkali atoms (mainly rubidium and cesium) in a cold helium gas have been extensively studied. Experiments are performed at temperatures down to 1.2 K using alkali-metal vapor cells containing a helium buffer gas, with alkali atoms driven from the cell walls by one of three loading methods: laser ablation, light-induced atom desorption, and spark discharge. For alkali atoms loaded into the cold helium gas, we have found that the relaxation time of the electronic spin of optically polarized rubidium atoms in the ground state is about a minute, much longer than that achieved in conventional vapor cells at room temperature and above. We have also spectroscopically investigated the interactions of excited alkali atoms with helium atoms, especially the formation of alkali–He exciplexes.
We present in this paper recent results on Light - Induced Atom Desorption (LIAD) in sealed and open coated cells. LIAD is defined via the description of an experiment on rubidium atoms stored in a dry - film coated cell, where a few milliwatts of even non coherent and non resonant light are able to increase the alkali atomic density for more than one order of magnitude. Modeling of the effect is given. New features become relevant in the case of LIAD in porous glasses: in fact, although the photodesorption efficiency per unit area in bare glass is much lower, photoatomic sources can be prepared, due to the huge inner surface of porous samples. We applied LIAD from organic coatings to the stabilization of alkali densities out of equilibrium: sodium case is here discussed. Finally, we report on fully original, preliminary measurements of rubidium Magneto - Optical Trap loading via LIAD from a dry - film coated cell.
We review some recent studies on light-induced atomic desorption (LIAD) from dielectric surfaces. Alkali-metal atoms adsorbed either on organic films or on porous glass are released into the vapor phase under illumination. The measurements were performed in Pyrex resonance cells either coated with siloxane films or containing a porous glass sample. In both cases, the experimental results show that LIAD can be used to produce atomic densities suitable for most atomic physics experiments. Moreover, we find that photoinduced effects, correlated with LIAD, produce reversible formation and evaporation of alkali-metal clusters in porous glass. These processes depend on the light frequency, making the porous glass transmittance controllable by light.
Light-induced atomic desorption (LIAD) is a non-thermal process in which atoms adsorbed at a surface are released under illumination. It is applied mostly to implementing optical dispensers in the cases when high atomic density at low temperature is needed – for example, for loading atomic devices as atomic magnetometers, atomic clocks, magneto-optical traps and their miniaturization. However, as the desorption depends on the atom-surface interaction, it can also be used for optical characterization and manipulation of alkali metal nanoparticles. The paper describes an experimental investigation of the shape of the transmission spectra and their dependence on the illuminating blue-light power in PDMS coated cells prepared with two different concentrations of PDMS in ether. A comparison is conducted with the LIAD effect in SC-77 coated and in uncoated cells. All measurements are performed on the Rb D2 line in vacuum. The potential is discussed for application of these dependences to analyzing the quality of the coating surface and its optimization.
This work is devoted to a systematic study of the effect of Light-Induced Atomic Desorption (LIAD). LIAD is a non-heating process in which atoms adsorbed on a surface are desorbed by illumination with non-resonant light. The aim of the dissertation is an experimental study of the LIAD process, its influence on the spectra of alkali atoms in optical cells without and with Anti-Relaxation Coating (ARC) and the possibilities of LIAD for optical characterization of ARC, as well as in high resolution spectroscopy. For the first time, the LIAD process under homogeneous illumination was investigated experimentally, whereby the efficiency of the LIAD was significantly increased even for a cell without ARC, the dynamic characteristics are obtained with a better signal to noise ratio and repeatability, and the desorption and adsorption processes are faster. LIAD effect in cells with different ARC coatings has shown that each coating has different desorption and adsorption rates and the results obtained show the possibility of applying the method for optical characterization of ARC. An experimental study of the number of collisions without atomic spin depolarization in cells with different ARCs and the impact of LIAD was performed, as well as various parameters such as laser intensity and cell temperature were investigated.