Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Chemical Physics Letters

Photophysical hole burning in the excited state absorption bands of dissolved organic molecules at room temperature

Ralf Menzel, Peter Witte

Published Dec 1, 1987• 12 citations
Publisher
DOI
10.1016/0009-2614(87)85124-2

Related papers

Characteristic lifetimes derived from steady state photophysical hole burning measurements on crystal violet in water at room temperature

Ralf Menzel, Peter Witte

Optics Communications•Dec 1, 1989•1 citation

High-resolution spectroscopy of organic molecules in solids: from fluorescence line narrowing and hole burning to single molecule spectroscopy

Michel Orrit, J. Bernard, Roman I. Personov

The Journal of Physical Chemistry•Oct 1, 1993•191 citations

Spectral Hole-Burning in Crystalline and Amorphous Organic Solids. Optical Relaxation Processes at Low Temperature

Silvia Volker

Physics and chemistry of materials with low-dimensional structures. Series C, Molecular structures•Jan 1, 1989•40 citations

Microparticle-based persistent spectral hole-burning memory at room temperature

Lingbing Chen, Yan Wang, Yong‐Le Pan +5 more

Persistent spectral hole burning with multiplicity was realized at room temperature for Nile blue molecules-doped polymeric dielectric spherical microparticles based on morphology-dependent resonances. Hole parameters depending on burning conditions were studied. Dynamical characteristic behavior of hole formation was measured and analyzed with a model based on rate equations. The effective hole formation rate was obtained by simulation. Photophysical and photochemical mechanisms of the room temperature hole burning for this system was discussed.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 3, 1996•0 citations

Investigation of low-temperature line broadening mechanisms in organic amorphous solids with photon echo, hole-burning and single-molecule spectroscopy

Stephan J. Zilker, J. Friebel, D. Haarer +2 more

Chemical Physics Letters•Jun 1, 1998•10 citations

Modelling excited state absorption (ESA) measurements including the photophysical hole burning effect with rate equations

Ralf Menzel

Excited state absorption measurements have usually to be modelled for the determination of the population densities in the different occupied excited states. Rate equations can be used for this purpose if the described experimental conditions are fulfilled. The photophysical hole burning (PPHB) effect may then be considered in an elementary way. Finally the decay rates of the different states and the holes can be determined. Fast routines for solving the system of differential equations are given allowing for an easy interactive analysis of the measurements on personal computers. The behaviour of the solutions for the two simplest models is discussed. The experimental results of PPHB measurements on crystal violet in 2-propanol were modelled using this formalism.

Molecular Physics•Sep 1, 1989•5 citations
Persistent spectral hole burning with multiplicity was realized at room temperature for Nile blue molecules-doped polymeric dielectric spherical microparticles based on morphology-dependent resonances. Hole parameters depending on burning conditions were studied. Dynamical characteristic behavior of hole formation was measured and analyzed with a model based on rate equations. The effective hole formation rate was obtained by simulation. Photophysical and photochemical mechanisms of the room temperature hole burning for this system was discussed.
Excited state absorption measurements have usually to be modelled for the determination of the population densities in the different occupied excited states. Rate equations can be used for this purpose if the described experimental conditions are fulfilled. The photophysical hole burning (PPHB) effect may then be considered in an elementary way. Finally the decay rates of the different states and the holes can be determined. Fast routines for solving the system of differential equations are given allowing for an easy interactive analysis of the measurements on personal computers. The behaviour of the solutions for the two simplest models is discussed. The experimental results of PPHB measurements on crystal violet in 2-propanol were modelled using this formalism.