Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Journal of Modern Physics B

ESCAPE FROM THE ZERO-VOLTAGE STATE IN HYSTERETIC DC-SQUIDS WITH DIFFERENT DIMENSIONLESS INDUCTANCE

Maria Gabriella Castellano, A. INTELISANO, Roberto Leoni, N. Milanese, G. Torrioli, C. Cosmelli, P. Carelli, F. Chiarello

Published Oct 30, 2000• 3 citations
Publisher

Abstract

We studied the escape process from the zero-voltage state to the running state in hysteretic dc-SQUIDs made with trilayer Nb-AlOx-Nb junctions. We analyze the experimental results, according to the thermal activation model, for devices having similar parameters except for the dimensionless inductance β L , which however is always very small. The interest in hysteretic dc-SQUIDs is in the possibility of using them to perform non-invasive measurements of the flux states in rf-SQUIDs: this achievement would be very important both in tests of macroscopic quantum properties of SQUIDs and in measurements on a class of quantum bits that has been recently proposed, based on magnetic flux states in SQUIDs.

DOI
10.1142/s0217979200003307

Related papers

A hysteretic dc SQUID reading the flux states of an rf SQUID

C. Cosmelli, P. Carelli, Maria Gabriella Castellano +3 more

We have realized a hysteretic dc SQUID to measure the flux states of a rf SQUID inductively coupled to the hysteretic dc SQUID. This type of measurement is required whenever is necessary to make a non invasive measure of the state of the rf SQUID. This is the case of measurements of macroscopic quantum coherence or measurements on q-bits systems. With the proposed set up the hysteretic dc SQUID can switch from the superconducting to the normal state depending on the total applied magnetic flux. On this system we measured at 4.2 K the change on the switching probability of the dc SQUID by varying the flux state of the rf SQUID. The experimental results agree very well with the theoretical predictions showing that this device can be used to perform non invasive measurements of the rf SQUID flux state.

IEEE Transactions on Applied Superconductivity•Mar 1, 2001•12 citations

Thermal activation of a hysteretic dc superconducting quantum interference device from its different zero-voltage states

Valérie Lefèvre-Seguin, Emmanuel Turlot, C. Urbina +2 more

We have measured the thermally-activated escape rate out of the zero-voltage state of hysteretic dc superconducting quantum interference devices (SQUID's) at 4.2 K. We found evidence that the zero-voltage state of these SQUID's is in general not unique, but can correspond instead to several metastable states. Each of these substates is associated with a given number of flux quanta trapped in the super-conducting loop of the SQUID's. The existence of this multiplicity is a direct consequence of the two-dimensional character of the dc-SQUID dynamics. For a fixed external magnetic flux, each zero-voltage substate is characterized by a particular value of the critical current, the expression of which can be derived from the double-cosine tilted two-dimensional SQUID potential. Experimentally, we observed multiple peaks in the switching-current distribution. Each peak was assigned to a given zero-voltage substate and we measured the dependence of the associated critical currents on the external magnetic flux. A procedure was developed in order to select a given substate among the multiplicity of the zero-voltage state. This allowed a precise measurement of the lifetime of one preselected zero-voltage substate as a function of the barrier height. Good agreement with two-dimensional transition-state theory was obtained.

Physical review. B, Condensed matter•Sep 1, 1992•60 citations

An integrated system of SQUIDs for the study of macroscopic quantum coherence

C. Cosmelli, Maria Gabriella Castellano, Roberto Leoni +3 more

The observation and study of macroscopic quantum coherence (MQC), i.e. the coherent superposition and evolution of macroscopically distinct quantum states, is of great importance for both our understanding of nature and for quantum engineering, for example in quantum computing. Recently a first indication of MQC in a system of SQUIDs has been indirectly observed by means of spectroscopic techniques. Applications like quantum computing, however, require the manipulation and the observation of the time evolution of the MQC states. We have realized a system of SQUIDs for the study of MQC. Our system, based on trilayer Nb/AlOx/Nb technology, consists of a double rf-SQUID, source of the MQC state, inductively coupled to a non-hysteretic dc-SQUID magnetometer and to a hysteretic dc-SQUID threshold detector, used for the read-out of the magnetic flux state. The magnetometer is used to test and monitor the rf-SQUID behaviour, while the hysteretic dc-SQUID is used to perform fast measurements with a reduced back action on the rf-SQUID. We present measurements performed at 4.2 K and at 20 mK to characterize the single devices and their overall behaviour, and a scheme for the use of a set of SQUIDs as a qubit system.

Superconductor Science and Technology•Nov 21, 2001•7 citations

Quantum dynamics of a microwave-driven SQUID

C. Cosmelli, P. Carelli, Maria Gabriella Castellano +6 more

In recent years, the quantum behaviour of Josephson devices has been the object of thorough experimental investigation, mainly with the objective of studying quantum mechanics in macroscopic objects. At present, the same quantum properties are being exploited with the aim of the physical implementation of quantum bits and quantum registers. Here we present measurements on a system containing potential qubits, namely a rf SQUID and a hysteretic dc SQUID, magnetically coupled, under microwave excitation; the devices are realized on a single chip with trilayer Nb/AlO x /Nb technology. On this system we have performed a set of measurements to test the dc SQUID response to short pulses of microwaves ranging from 2 to 32 GHz. A first analysis of our results indicates the presence of population oscillations in the hysteretic dc SQUID. This result is very promising in view of using SQUIDs for more complex qubits systems.

Superconductor Science and Technology•Oct 31, 2003•7 citations

Tracing the characteristics of a flux qubit with a hysteretic dc-superconducting quantum interference device comparator

Maria Gabriella Castellano, F. Chiarello, Roberto Leoni +6 more

A hysteretic dc-superconducting quantum interference device (SQUID) is used to trace the flux characteristic of a tunable rf-SQUID, the basic element for the realization of superconducting flux qubits. This allows important simplifications of circuitry and electronics in developing devices for quantum computing, by eliminating the necessity of more complex magnetometers. A hysteretic dc-SQUID is usually operated as a comparator, distinguishing only which one of two adjacent flux states is occupied by the rf-SQUID. The necessary sensitivity, moreover, is usually reached only at temperatures in the mK range. However, by exploiting the statistical properties of the current–voltage curve in the region where the switching from the zero-voltage state occurs, it is possible to obtain an accurate tracing of the input flux, even at a relatively high temperature (a few Kelvin). In our case, the input signal is given by the internal flux of a tunable rf-SQUID, the building block of a flux qubit.

Journal of Applied Physics•Dec 4, 2003•4 citations

Evidence of Two-Dimensional Macroscopic Quantum Tunneling of a Current-Biased dc SQUID

Franck Balestro, Julien Claudon, Jukka P Pekola +1 more

The escape probability out of the superconducting state of a hysteretic dc SQUID has been measured at different values of the applied magnetic flux. At low temperatures, the escape current and the width of the probability distribution are temperature independent but they depend on flux. Experimental results do not fit the usual one-dimensional macroscopic quantum tunneling (MQT) law but are perfectly accounted for by the two-dimensional MQT behavior as we propose here. Near zero flux, our data confirms the recent MQT observation in a dc SQUID [Phys. Rev. Lett. 89, 98301 (2002)]].

arXiv:cond-mat/0308559•Physical Review Letters•Oct 6, 2003•40 citations
We studied the escape process from the zero-voltage state to the running state in hysteretic dc-SQUIDs made with trilayer Nb-AlOx-Nb junctions. We analyze the experimental results, according to the thermal activation model, for devices having similar parameters except for the dimensionless inductance β L , which however is always very small. The interest in hysteretic dc-SQUIDs is in the possibility of using them to perform non-invasive measurements of the flux states in rf-SQUIDs: this achievement would be very important both in tests of macroscopic quantum properties of SQUIDs and in measurements on a class of quantum bits that has been recently proposed, based on magnetic flux states in SQUIDs.
We have realized a hysteretic dc SQUID to measure the flux states of a rf SQUID inductively coupled to the hysteretic dc SQUID. This type of measurement is required whenever is necessary to make a non invasive measure of the state of the rf SQUID. This is the case of measurements of macroscopic quantum coherence or measurements on q-bits systems. With the proposed set up the hysteretic dc SQUID can switch from the superconducting to the normal state depending on the total applied magnetic flux. On this system we measured at 4.2 K the change on the switching probability of the dc SQUID by varying the flux state of the rf SQUID. The experimental results agree very well with the theoretical predictions showing that this device can be used to perform non invasive measurements of the rf SQUID flux state.
We have measured the thermally-activated escape rate out of the zero-voltage state of hysteretic dc superconducting quantum interference devices (SQUID's) at 4.2 K. We found evidence that the zero-voltage state of these SQUID's is in general not unique, but can correspond instead to several metastable states. Each of these substates is associated with a given number of flux quanta trapped in the super-conducting loop of the SQUID's. The existence of this multiplicity is a direct consequence of the two-dimensional character of the dc-SQUID dynamics. For a fixed external magnetic flux, each zero-voltage substate is characterized by a particular value of the critical current, the expression of which can be derived from the double-cosine tilted two-dimensional SQUID potential. Experimentally, we observed multiple peaks in the switching-current distribution. Each peak was assigned to a given zero-voltage substate and we measured the dependence of the associated critical currents on the external magnetic flux. A procedure was developed in order to select a given substate among the multiplicity of the zero-voltage state. This allowed a precise measurement of the lifetime of one preselected zero-voltage substate as a function of the barrier height. Good agreement with two-dimensional transition-state theory was obtained.
The observation and study of macroscopic quantum coherence (MQC), i.e. the coherent superposition and evolution of macroscopically distinct quantum states, is of great importance for both our understanding of nature and for quantum engineering, for example in quantum computing. Recently a first indication of MQC in a system of SQUIDs has been indirectly observed by means of spectroscopic techniques. Applications like quantum computing, however, require the manipulation and the observation of the time evolution of the MQC states. We have realized a system of SQUIDs for the study of MQC. Our system, based on trilayer Nb/AlOx/Nb technology, consists of a double rf-SQUID, source of the MQC state, inductively coupled to a non-hysteretic dc-SQUID magnetometer and to a hysteretic dc-SQUID threshold detector, used for the read-out of the magnetic flux state. The magnetometer is used to test and monitor the rf-SQUID behaviour, while the hysteretic dc-SQUID is used to perform fast measurements with a reduced back action on the rf-SQUID. We present measurements performed at 4.2 K and at 20 mK to characterize the single devices and their overall behaviour, and a scheme for the use of a set of SQUIDs as a qubit system.
In recent years, the quantum behaviour of Josephson devices has been the object of thorough experimental investigation, mainly with the objective of studying quantum mechanics in macroscopic objects. At present, the same quantum properties are being exploited with the aim of the physical implementation of quantum bits and quantum registers. Here we present measurements on a system containing potential qubits, namely a rf SQUID and a hysteretic dc SQUID, magnetically coupled, under microwave excitation; the devices are realized on a single chip with trilayer Nb/AlO x /Nb technology. On this system we have performed a set of measurements to test the dc SQUID response to short pulses of microwaves ranging from 2 to 32 GHz. A first analysis of our results indicates the presence of population oscillations in the hysteretic dc SQUID. This result is very promising in view of using SQUIDs for more complex qubits systems.
A hysteretic dc-superconducting quantum interference device (SQUID) is used to trace the flux characteristic of a tunable rf-SQUID, the basic element for the realization of superconducting flux qubits. This allows important simplifications of circuitry and electronics in developing devices for quantum computing, by eliminating the necessity of more complex magnetometers. A hysteretic dc-SQUID is usually operated as a comparator, distinguishing only which one of two adjacent flux states is occupied by the rf-SQUID. The necessary sensitivity, moreover, is usually reached only at temperatures in the mK range. However, by exploiting the statistical properties of the current–voltage curve in the region where the switching from the zero-voltage state occurs, it is possible to obtain an accurate tracing of the input flux, even at a relatively high temperature (a few Kelvin). In our case, the input signal is given by the internal flux of a tunable rf-SQUID, the building block of a flux qubit.
The escape probability out of the superconducting state of a hysteretic dc SQUID has been measured at different values of the applied magnetic flux. At low temperatures, the escape current and the width of the probability distribution are temperature independent but they depend on flux. Experimental results do not fit the usual one-dimensional macroscopic quantum tunneling (MQT) law but are perfectly accounted for by the two-dimensional MQT behavior as we propose here. Near zero flux, our data confirms the recent MQT observation in a dc SQUID [Phys. Rev. Lett. 89, 98301 (2002)]].