Silicon photonics has drawn a lot of attention over the last decades, mainly in telecom-related application fields where the nonlinear optical properties of silicon are ignored or minimized. However, silicon’s high χ(3) Kerr optical nonlinearity in sub-micron-scale high-confinement waveguides can enable significant improvements in traditional nonlinear devices, such as for wavelength conversion, and also enable some device applications in quantum optics or for quantum key distribution. In order to establish the viability of silicon photonics in practical applications, some big challenges are to improve the optical performance (e.g., optimize nonlinearity or minimize loss) and integration of optics with microelectronics. In this context, we discuss how electronic PIN diodes improve the performance of wavelength conversion in a microring resonator based four-wave mixing device, which achieves a continuous-wave four-wave mixing conversion efficiency of −21.3 dB at 100 mW pump power, with enough bandwidth for the wavelength conversion of a 10 Gbps signal. In the regime of quantum optics, we describe a coupled microring device that can serve as a tunable source of entangled photon pairs at telecommunications wavelengths, operating at room temperature with a low pump power requirement. By controlling either the optical pump wavelength, or the chip temperature, we show that the output bi-photon spectrum can be varied, with implications on the degree of frequency correlation of the generated quantum state.
Silicon photonics has drawn a lot of attention over the last decades, mainly in telecom-related application fields where the nonlinear optical properties of silicon are ignored or minimized. However, silicon’s high χ(3) Kerr optical nonlinearity in sub-micron-scale high-confinement waveguides can enable significant improvements in traditional nonlinear devices, such as for wavelength conversion, and also enable some device applications in quantum optics or for quantum key distribution. In order to establish the viability of silicon photonics in practical applications, some big challenges are to improve the optical performance (e.g., optimize nonlinearity or minimize loss) and integration of optics with microelectronics. In this context, we discuss how electronic PIN diodes improve the performance of wavelength conversion in a microring resonator based four-wave mixing device, which achieves a continuous-wave four-wave mixing conversion efficiency of −21.3 dB at 100 mW pump power, with enough bandwidth for the wavelength conversion of a 10 Gbps signal. In the regime of quantum optics, we describe a coupled microring device that can serve as a tunable source of entangled photon pairs at telecommunications wavelengths, operating at room temperature with a low pump power requirement. By controlling either the optical pump wavelength, or the chip temperature, we show that the output bi-photon spectrum can be varied, with implications on the degree of frequency correlation of the generated quantum state.
Four-wave mixing (FWM) in silicon photonics offers promising applications in optical signal processing, wavelength conversion, and quantum photonics, necessitating a comprehensive understanding of its underlying physics and limitations. Stimulated four-wave mixing in silicon photonic wire waveguides has been investigated theoretically by considering two-photon absorption, free carrier absorption, and free carrier dispersion, etc., operating near λ∼1550 nm. It has been shown that these effects severely degrade the performance when operating at higher pump power levels. We present exact numerical calculations of idler wavelength conversion efficiency and bandwidth taking into account the abovementioned nonlinearities, to show the effects of various parameters within the waveguide structure. We extended to investigate silicon photonic microring resonators in terms of the four-wave mixing performance of high-Q-value microring resonators, which are very promising as photon sources (spontaneous four-wave mixing) for large-scale quantum photonic circuits. Our analysis illustrates the limitations of analytical models in describing FWM in ring resonator behavior at a moderate input power level, necessitating a rigorous numerical approach. Experimentally, we demonstrate stimulated FWM (1525 nm≤λp≤1575 nm) in a silicon photonic wire with a cross-section of 500 nm×220 nm and with a small waveguide length of 2 mm. The idler-to-signal conversion efficiency of about −35 dB has been measured for an approximate launched pump power of 30 mW. The conversion efficiency is improved further in the microring resonator as predicted by the simulation results.
We demonstrate efficient nonlinear functions using silicon nanophotonic structures. In the ultrasmall core of the
waveguides and cavities, nonlinear phenomena are significantly enhanced. Applying the two-photon absorption effect,
we have confirmed all optical modulation, in which the modulation speed is improved to around 50 ps by eliminating
free carriers. Applying the four-wave-mixing effect, we have achieved high-efficiency wavelength conversion. The
conversion efficiency is -11 dB, and the efficiency will be further improved by eliminating free carriers. Using the four-wave-
mixing effect, we have also realized a low-noise entangled photon pair source. The source does not need a
refrigeration system for noise reduction, which is a great advantage for practical application.
Silicon photonic microchips may be useful for compact, inexpensive, room-temperature optically pumped photon-pair sources, which unlike conventional photon-pair generators based on crystals or optical fibers, can be manufactured using CMOS-compatible processes on silicon wafers. It has been shown that photon pairs can be created in simple structures such as microring resonators at a rate of a few hundred kilohertz using less than a milliwatt of optical pump power, based on the process of spontaneous four-wave mixing. To create a practical photon-pair source, however, also requires some way of monitoring the device and aligning the pump wavelength when the temperature varies, since silicon resonators are highly sensitive to temperature. In fact, monitoring photodiodes are standard components in classical laser diodes, but the incorporation of germanium or InGaAs photodiodes would raise the cost and fabrication complexity. Here, we present a simple and effective all-electronic technique for finding the optimum operating point for the microring used to generate photon pairs, based on measuring the reverse-biased current in a silicon p-i-n junction diode fabricated across the waveguide that constitutes the silicon microring. We show that by monitoring the current, and using it to tune the pump laser wavelength, the photon-pair generation properties of the microring can be preserved over a temperature range of more than 30 °C.
The possibility to perform broad wavelength generation and conversion is of great interest in classical and quantum optics. With the introduction of integrated nonlinear silicon photonics, these tasks have been made even more viable thanks to the combination of the high nonlinear refractive index of silicon with the high confinement provided by the photonic waveguides. Exploiting this platform, several solutions for wavelength conversion have been investigated, for both optical processing [1] and applications in the Mid Infrared (MIR) [2]. The possibility to perform broad and controllable wavelength generation can be exploited also for creating integrated sources of quantum states of light based on single photons [3] or correlated photon pairs [4]. Both the generation and conversion can be accomplished by means of Four Wave Mixing (FWM). FWM is a nonlinear optical process in which two pump photons at frequency are converted into signal and idler photons at frequencies and ω/ respectively (with ωI/ωS). In the particular case of wavelength conversion, FWM is stimulated by a seed wave at the same wavelength of the signal (idler) that will be converted to the wavelength of the idler (signal). FWM has to satisfy the energy conservation, according to which the relation ωP+ ωP= ωS+ ωIholds, and its efficiency is ruled by the phase matching condition. This latter condition is related to the phase mismatch among the waves involved in the FWM process, that is evaluated as Δk = kp+ kp−kS−kI, where kP, kS, kIare the wavevectors for the pump, the signal and the idler, respectively. When Δk = 0, the phase matching condition is fulfilled and the efficiency of FWM is maximized. What is important for wavelength generation and conversion is the spectral position of the phase matching condition, which determines the wavelength at which the maximum efficiency of the conversion or generation process is achieved. Because of this, techniques for the control of the phase matching condition have been developed, focusing on the possibility to tailor the Group Velocity Dispersion (GVD) through a proper engineering of the waveguide geometry [5]. While these techniques consider only the first order waveguide mode, here we propose to exploit the higher order modes propagating inside a multimode waveguide. The dispersion of the higher order modes can be used to tune the spectral position of the phase matching condition for the FWM process, achieving controllable and large spectral translation in both Stimulated Four Wave Mixing (sFWM) and Spontaneous Four Wave Mixing (SFWM).
One of the key building blocks of quantum photonic systems is a source of indistinguishable photons. Silicon ring resonators can be used as photon pair sources by taking advantage of silicon's large third order nonlinearity with a process known as spontaneous four wave mixing. These sources are capable of producing pairs of indistinguishable photons but typically suffer from an effective 50% loss. By slightly decoupling the input waveguide from the ring, the desired photons generated in the ring can be directed to the drop port. Thus, the ratio between the coincidences from the drop port and the total number of coincidences from all ports (coincidence efficiency) can be significantly increased, with the trade-off being that the pump is less efficiently coupled into the ring. This asymmetric coupling scheme was used to demonstrate a dual-bus microring source with a coincidence efficiency of ~96%. Unfortunately, the penalty to pump power was quite large, with a required ~10x increase in the pump power to maintain the same pair generation rate.\nTo further improve upon this result, a microring source was designed with multipoint evanescent couplers to induce a strong spectral dependence in the coupling coefficients. This coupler design can be used on both sides of the ring resonator so that resonances supported by one of the couplers are suppressed by the other. This is the ideal configuration for a ring-based photon-pair source as it can only support the pump photons at the input side while only allowing the generated photons to leave through the output side. Asymmetric coupling was also used in this configuration but in a different way than in the previous source. In this case, the input side of the ring was configured to be critically coupled for maximal resonance enhancement while the output side was configured to be over coupled to minimize photon-pair loss within the ring. This device design was used to demonstrate a photon-pair source with coincidence efficiencies of 0.9981+-6.425x10^-4 and 0.9979+-1.665x10^-3 for degenerate and non-degenerate pump configuration respectively.\nIn addition to the source development, work was done to move some of the pump rejection filtering onto the photonic chip. While the fabricated device only exhibited an extinction of 50 dB, the root cause of the limited extinction was explored and a new filter design was proposed to overcome these limitations. With the combination of the microring source with its greatly improved efficiency and the movement toward reducing the required off-chip filtering, this work represents a significant advancement in the scalability of integrated quantum photonic systems which can enable high performance quantum computing and communication systems.
Microring resonators made from silicon are becoming a popular microscale device format for generating photon pairs at telecommunications wavelengths at room temperature. In compact devices with a footprint less than 5 × 10(-4) mm2, we demonstrate pair generation using only a few microwatts of average pump power. We discuss the role played by important parameters such as the loss, group-velocity dispersion and the ring-waveguide coupling coefficient in finding the optimum operating point for silicon microring pair generation. Silicon photonics can be fabricated using deep ultraviolet lithography wafer-scale fabrication processes, which is scalable and cost-effective. Such small devices and low pump power requirements, and the side-coupled waveguide geometry which uses an integrated waveguide, could be beneficial for future scaled-up architectures where many pair-generation devices are required on the same chip.