Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review A

Pulse-Area-Pulse-Energy Description of a Traveling-Wave Laser Amplifier

S. L. McCall, Erwin Louis Hahn

Published Sep 1, 1970• 75 citations
Publisher

Abstract

The effects of a transverse mode, degeneracy, overlapping transitions, background losses, and transverse population variations are included in an analysis of light-pulse amplification in a system with an inhomogeneously broadened gain profile. Over a wide range of resonant gain and background loss, the steady-state pulse energy is proportional to the inverse cube of the pulse width, in accord with the observations of Frova et al.

DOI
10.1103/physreva.2.861

Related papers

Pulse Propagation in a Laser Amplifier

James P. Wittke, Peter J. Warter

Pulse propagation in maser-type traveling-wave amplifiers with a homogeneously broadened transition is treated by a formalism analogous to the Bloch equations. Phenomenological dephasing (T2) and recovery (T1) times are defined, and a linear (nonsaturable) loss mechanism is included. In the numerical calculations, only the case of negligible excitation during the time it takes a pulse to pass is considered. When pulses are allowed to grow until the amplifier is ``saturated,'' steady-state pulses having a unique shape and intensity independent of the initial pulse are found. The parameters of these steady-state pulses depend only on the ratio of the linear loss and gain coefficients. Steady-state pulses have a peak intensity that decreases monotonically from infinity to zero as the linear loss coefficient varies from zero to the gain coefficient, while the pulse width correspondingly varies from zero to infinity, and the pulse energy varies from a finite value to zero. Steady-state pulses propogate at a velocity less than that of the small signal velocity in the medium.

Journal of Applied Physics•Jun 1, 1964•75 citations

Spectral gain modeling of optical amplifiers

Stefano Bottacchi

Introduction In this chapter we will present the theory of spectral gain in optical amplifiers and the related optical power distribution. The concepts are general, as they apply to every optical amplifier configuration, independent of the specific architecture and implementation technology. We will configure the optical amplifying medium as a traveling-wave device, where the optical field undergoes optical amplification as it propagates from the input to the output sections. Generally speaking, optical amplification is achieved by a net stimulated emission process. Referring to a generic section z of infinitesimal thickness dz , optical gain is determined by the imbalance between net stimulated emission and cavity losses, including extrinsic absorption, reflection and radiated fields. As we know from the theory of light amplification in the three-level atomic system presented in Chapter 5, stimulated absorption of photons is governed by the same transition rate as stimulated emission, and is included in the net stimulated emission process. With this in mind, we note the identity between stimulated emission and the stimulated absorption rates, Γ 12 = Γ 21 , and the net stimulated photon term Γ[ j 2 ( t ) – j 1 ( t )] p ( t ) in the rate equation. In order to develop the traveling-wave model, the photon density becomes a function of the longitudinal position 0 ≤ z ≤ L along the amplifier medium. Accordingly, we will set p ( t , z ) as the relative density of stimulated photons per unit volume (0 ≤ p ( t , z ) ≤ 1) at time t and section z . When photons with appropriate energy proceed along the amplifying medium, they are amplified by means of net stimulated emission. At some section z = z 0 , the steady-state photon density P ( z ) can approach the saturation density P sat ( z ).

Cambridge University Press eBooks•Sep 6, 2014•0 citations

Lasers without inversion: Single-atom transient response

Stephen E. Harris, John J Macklin

We discuss the effect of the transient response on the dynamics of lifetime broadened lasers that operate without the need for population inversion. A relationship between the steady-state absorptive transition probability rate and the transient gain and loss is given.

Physical Review A•Oct 1, 1989•127 citations

Optical frequency amplifiers

Christophér C. Davis

Introduction When an electromagnetic wave propagates through amedium stimulated emissions increase the intensity of the wave, while absorptions diminish it. The overall intensity will increase if the number of stimulated emissions can be made larger than the number of absorptions. If we can create such a situation then we have built an amplifier that operates through the mechanism of stimulated emission. This laser amplifier , in common with electronic amplifiers, has useful gain only over a particular frequency bandwidth. Its operating frequency range will be determined by the lineshape of the transition, and we expect the frequency width of its useful operating range to be of the same order as the width of the lineshape. It is very important to consider how this frequencywidth is related to the various mechanisms by which transitions between different energy states of a particle are smeared out over a range of frequencies. This line broadening affects in a fundamental way not only the frequency bandwidth of the amplifier, but also its gain. A laser amplifier can be turned into an oscillator by supplying an appropriate amount of positive feedback. The level of oscillation will stabilize because the amplifier saturates. Laser amplifiers fall into two categories, which saturate in different ways. A homogeneously broadened amplifier consists of a number of amplifying particles that are essentially equivalent, whereas an inhomogeneously broadened amplifier contains amplifying particles with a distribution of amplification characteristics. Homogeneous line broadening All energy states, except the lowest energy state of a particle (the ground state) cover a range of possible energies.

Cambridge University Press eBooks•Mar 20, 2014•0 citations

Self-Induced Transparency

S. L. McCall, Erwin Louis Hahn

Above a critical power threshold for a given pulse width, a short pulse of coherent traveling-wave optical radiation is observed to propagate with anomalously low energy loss while at resonance with a two-quantum-level system of absorbers. The line shape of the resonant system is determined by inhomogeneous broadening, and the pulse width is short compared to dissipative relaxation times. A new mechanism of self-induced transparency, which accounts for the low energy loss, is analyzed in the ideal limit of a plane wave which excites a resonant medium with no damping present. The stable condition of transparency results after the traversal of the pulse through a few classical absorption lengths into the medium. This condition exists when the initial pulse has evolved into a symmetric hyperbolic-secant pulse function of time and distance, and has the area characteristic of a "$2\ensuremath{\pi}$ pulse." Ideal transparency then persists when coherent induced absorption of pulse energy during the first half of the pulse is followed by coherent induced emission of the same amount of energy back into the beam direction during the second half of the pulse. The effects of dissipative relaxation times upon pulse energy, pulse area, and pulse delay time are analyzed to first order in the ratio of short pulse width to long damping time. The analysis shows that the $2\ensuremath{\pi}$ pulse condition can be maintained if losses caused by damping are compensated by beam focusing. In an amplifying inhomogeneously broadened medium an analytic "$\ensuremath{\pi}$ pulse area" solution is presented in the limit of a sharp leading edge of the pulse. The dynamics of self-induced transparency are studied for the particular effects of Doppler velocities upon a resonant gas. The analysis of transparency for random orientations of dipole moments associated with degenerate rotational states yields modified forms of self-induced transparency behavior, which indicates a finite pulse energy loss as a function of distance in some cases. The effect of self-induced transparency on the photon echo is considered. Experimental observations of self-induced transparency have been made in a ruby sample at resonance with a pulsed ruby-laser beam. Single and multiple $2\ensuremath{\pi}$ pulse outputs have been observed, and pulse areas measured in the range of $2\ensuremath{\pi}$. The experimental results are compared with the predictions of the ideal-plane-wave theory. Deviations from the ideal-plane-wave theory are discussed. An analysis is made of the effect of a transverse mode of the propagating beam upon the transparency properties of the pulse.

Physical Review•Jul 10, 1969•1,394 citations

Weak versus strong harmonic-expansion analyses of self-pulsing lasers: II—the inhomogeneously broadened system

Belkacem Meziane, Samia Ayadi

Optical and Quantum Electronics•Jan 1, 2007•4 citations
The effects of a transverse mode, degeneracy, overlapping transitions, background losses, and transverse population variations are included in an analysis of light-pulse amplification in a system with an inhomogeneously broadened gain profile. Over a wide range of resonant gain and background loss, the steady-state pulse energy is proportional to the inverse cube of the pulse width, in accord with the observations of Frova et al.
Pulse propagation in maser-type traveling-wave amplifiers with a homogeneously broadened transition is treated by a formalism analogous to the Bloch equations. Phenomenological dephasing (T2) and recovery (T1) times are defined, and a linear (nonsaturable) loss mechanism is included. In the numerical calculations, only the case of negligible excitation during the time it takes a pulse to pass is considered. When pulses are allowed to grow until the amplifier is ``saturated,'' steady-state pulses having a unique shape and intensity independent of the initial pulse are found. The parameters of these steady-state pulses depend only on the ratio of the linear loss and gain coefficients. Steady-state pulses have a peak intensity that decreases monotonically from infinity to zero as the linear loss coefficient varies from zero to the gain coefficient, while the pulse width correspondingly varies from zero to infinity, and the pulse energy varies from a finite value to zero. Steady-state pulses propogate at a velocity less than that of the small signal velocity in the medium.
Introduction In this chapter we will present the theory of spectral gain in optical amplifiers and the related optical power distribution. The concepts are general, as they apply to every optical amplifier configuration, independent of the specific architecture and implementation technology. We will configure the optical amplifying medium as a traveling-wave device, where the optical field undergoes optical amplification as it propagates from the input to the output sections. Generally speaking, optical amplification is achieved by a net stimulated emission process. Referring to a generic section z of infinitesimal thickness dz , optical gain is determined by the imbalance between net stimulated emission and cavity losses, including extrinsic absorption, reflection and radiated fields. As we know from the theory of light amplification in the three-level atomic system presented in Chapter 5, stimulated absorption of photons is governed by the same transition rate as stimulated emission, and is included in the net stimulated emission process. With this in mind, we note the identity between stimulated emission and the stimulated absorption rates, Γ 12 = Γ 21 , and the net stimulated photon term Γ[ j 2 ( t ) – j 1 ( t )] p ( t ) in the rate equation. In order to develop the traveling-wave model, the photon density becomes a function of the longitudinal position 0 ≤ z ≤ L along the amplifier medium. Accordingly, we will set p ( t , z ) as the relative density of stimulated photons per unit volume (0 ≤ p ( t , z ) ≤ 1) at time t and section z . When photons with appropriate energy proceed along the amplifying medium, they are amplified by means of net stimulated emission. At some section z = z 0 , the steady-state photon density P ( z ) can approach the saturation density P sat ( z ).
Introduction When an electromagnetic wave propagates through amedium stimulated emissions increase the intensity of the wave, while absorptions diminish it. The overall intensity will increase if the number of stimulated emissions can be made larger than the number of absorptions. If we can create such a situation then we have built an amplifier that operates through the mechanism of stimulated emission. This laser amplifier , in common with electronic amplifiers, has useful gain only over a particular frequency bandwidth. Its operating frequency range will be determined by the lineshape of the transition, and we expect the frequency width of its useful operating range to be of the same order as the width of the lineshape. It is very important to consider how this frequencywidth is related to the various mechanisms by which transitions between different energy states of a particle are smeared out over a range of frequencies. This line broadening affects in a fundamental way not only the frequency bandwidth of the amplifier, but also its gain. A laser amplifier can be turned into an oscillator by supplying an appropriate amount of positive feedback. The level of oscillation will stabilize because the amplifier saturates. Laser amplifiers fall into two categories, which saturate in different ways. A homogeneously broadened amplifier consists of a number of amplifying particles that are essentially equivalent, whereas an inhomogeneously broadened amplifier contains amplifying particles with a distribution of amplification characteristics. Homogeneous line broadening All energy states, except the lowest energy state of a particle (the ground state) cover a range of possible energies.
Above a critical power threshold for a given pulse width, a short pulse of coherent traveling-wave optical radiation is observed to propagate with anomalously low energy loss while at resonance with a two-quantum-level system of absorbers. The line shape of the resonant system is determined by inhomogeneous broadening, and the pulse width is short compared to dissipative relaxation times. A new mechanism of self-induced transparency, which accounts for the low energy loss, is analyzed in the ideal limit of a plane wave which excites a resonant medium with no damping present. The stable condition of transparency results after the traversal of the pulse through a few classical absorption lengths into the medium. This condition exists when the initial pulse has evolved into a symmetric hyperbolic-secant pulse function of time and distance, and has the area characteristic of a "$2\ensuremath{\pi}$ pulse." Ideal transparency then persists when coherent induced absorption of pulse energy during the first half of the pulse is followed by coherent induced emission of the same amount of energy back into the beam direction during the second half of the pulse. The effects of dissipative relaxation times upon pulse energy, pulse area, and pulse delay time are analyzed to first order in the ratio of short pulse width to long damping time. The analysis shows that the $2\ensuremath{\pi}$ pulse condition can be maintained if losses caused by damping are compensated by beam focusing. In an amplifying inhomogeneously broadened medium an analytic "$\ensuremath{\pi}$ pulse area" solution is presented in the limit of a sharp leading edge of the pulse. The dynamics of self-induced transparency are studied for the particular effects of Doppler velocities upon a resonant gas. The analysis of transparency for random orientations of dipole moments associated with degenerate rotational states yields modified forms of self-induced transparency behavior, which indicates a finite pulse energy loss as a function of distance in some cases. The effect of self-induced transparency on the photon echo is considered. Experimental observations of self-induced transparency have been made in a ruby sample at resonance with a pulsed ruby-laser beam. Single and multiple $2\ensuremath{\pi}$ pulse outputs have been observed, and pulse areas measured in the range of $2\ensuremath{\pi}$. The experimental results are compared with the predictions of the ideal-plane-wave theory. Deviations from the ideal-plane-wave theory are discussed. An analysis is made of the effect of a transverse mode of the propagating beam upon the transparency properties of the pulse.