Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

European Microwave Conference (EuMC)

A 125-180 GHz fixed-tuned SIS mixer for radioastronomy

Alexandre Karpov, J. Blondel, P. Pasturel, K. H. Gundlach

Published Oct 1, 1996• 0 citations
Publisher

Abstract

A fixed-tuned SIS mixer covering an instantaneous band of 45% around 150 GHz has been developed for radioastronomy. A new type of coplanar tuning circuit for the SIS junction is introduced. The minimum DSB receiver noise is 19 K, while the average noise is 25K in the 130-175 GHz range with a 1 GHz IF band. A speedup of the observations by a factor 2-3 is possible with the new receiver.

DOI
10.1109/euma.1996.337519

Related papers

A 125-180 GHz fixed-tuned SIS mixer for radioastronomy

Alexandre Karpov, J. Blondel, P. Pasturel +1 more

An ultra low noise fixed-tuned SIS mixer covering an instantaneous band of 45% around 150 GHz has been developed for radioastronomy. A new type of coplanar tuning circuit for the SIS junction is introduced. The Nb/Al oxide/Nb junctions are 2 /spl mu/m/sup 2/ with critical Josephson current density of 4.2 KA/cm/sup 2/. The minimum DSB mixer noise is 11 K. The minimum DSB receiver noise is 19 K, while the average noise is 25 K in the 130-175 GHz range with a 1 GHz IF band. A speedup of the observations by a factor 2-3 is possible with the new receiver at 30 m IRAM radiotelescope.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•6 citations

Design and characterization of 225-370 GHz DSB and 247-360 GHz SSB full height waveguide SIS mixers

B. Lazareff, Dominique Billon-Pierron, A. Navarrini +1 more

We report on the design and characterization of two full height waveguide SIS mixers for astronomical applications: a Double Side Band (DSB) fixed-tuned mixer covering the 225-370 GHz band ( 50 % of relative bandwidth), and a tunable Single Side Band (SSB) mixer covering the 247-360 GHz frequency range. The DSB receiver noise temperature we have measured is below 50 K over a bandwidth larger than 100 GHz for the DSB mixer and has a minimum of 27 K (uncorrected) at 336 GHz; to our knowledge this is the lowest noise ever reported at this frequency. A receiver noise temperature below 80 K and an image band rejection around -14 dB were measured over most of the band of the SSB mixer. Both mixers use similar chips that integrate a parallel tuning inductor with a radial microstrip stub to compensate for the junction capacitance of 75 fF (junction size 1 μm 2 ). A stability criterion for intrinsically DSB and SSB mixers under typical operating conditions has been derived. The receiver designs have been optimised in order to guarantee a low mixer noise temperature while maintaining adequate gain and stable operation over the whole frequency bands of interest.

Journal de Physique IV (Proceedings)•May 1, 2002•5 citations

Progress on tunerless SIS mixers for the 200-300 GHz band

Anthony R. Kerr, S.-K. Pan, A. W. Lichtenberger +1 more

An integrated superconductor-insulator-superconductor (SIS) mixer for the 200-300-GHz band with no adjustable tuning is described. A waveguide input is coupled to a coplanar mixer circuit with six individually tuned SIS junctions in series. Using the best mixer, the receiver noise temperature is 45-80 K DSB over 215-275 GHz. The mixer noise temperature at 230 GHz is 12 K DSB, and the conversion loss is 2.5 dB DSB.>

IEEE Microwave and Guided Wave Letters•Nov 1, 1992•36 citations

A 547 GHz SIS receiver employing a submicron Nb junction with an integrated matching circuit

Pascal Febvre, William R. McGrath, P. D. Batelaan +4 more

A heterodyne receiver using an SIS (superconductor-insulator-superconductor) waveguide mixer with two mechanical tuners has been built and characterized over the frequency range of 460 GHz to 630 GHz. This receiver is designed for radioastronomy applications. The mixer uses high-current-density, 0.25- mu m/sup 2/, Nb/AlO/sub x//Nb SIS tunnel junctions with integrated superconductive RF circuits to tune the junction capacitance. A DSB (double sideband) receiver noise temperature as low as 200+or-17 K has been obtained at 540 GHz. In addition, negative differential resistance has been observed in the DC I-V (current-voltage) curve at 487-491 GHz.>

IEEE MTT-S International Microwave Symposium digest•Dec 30, 2002•4 citations

A 100-GHz fixed-tuned waveguide SIS mixer exhibiting broad bandwidth and very low noise temperature

Sheng-Gai Shi, Takashi Noguchi, Junji Inatani

This paper presents design and performance data for a 100-GHz waveguide superconductor-insulator-superconductor (SIS) mixer, which is incorporated with a twin-junction device (i.e., two identical junctions connected in parallel through a tuning inductance) and a fixed-tuned broad-band waveguide mixer mount. The 100-GHz mixer is actually developed as a prototype of the 500-GHz one. The constructed 100-GHz SIS receiver results in an overall receiver noise temperature (DSB) of less than 40 K over the frequency range from 80-120 GHz, with a minimum value of just 20 K that is four times as large as the quantum limit (i.e., 4/spl planck//spl omega//k). Such a performance is comparable or even superior to those of the best mechanically tunable waveguide SIS receivers at the same frequency band. In addition, some interesting mixing behaviors related to this two-junction device are described in detail.

IEEE Transactions on Applied Superconductivity•Jan 1, 1997•22 citations

Wide-Band, Ultra Low Noise MM-Wave Mixers with a Single Tuning Element

Antti V. Räisänen, Denis Crété, P. L. Richards +1 more

Several SIS quasiparticle mixers have been designed and tested for the frequency range from 80 to 115 GHz. The sliding back short is the only adjustable RF-tuning element. The RF-filter reactance is used a s a fixed RF-matching element. A mixer which uses a single 2 × 2 μm2Pb-alloy junction in a 1/4-height waveguide mount has a coupled conversion gain of GM(DSB) = 2.6 ± 0.5 dB with an associated noise temperature of TM(DSB) = 16.4 ± 1.8 K at the best DSB operation point. The receiver noise temperature TR(DSB) is 27.5 ± 0.8 K for the test apparatus. This mixer provides a SSB receiver noise temperature below 50 K over the frequency range from 91 to 96 GHz, the minimum being TR(SSB) = 44 ± 4 K. Another mixer with an array of five 5 × 5 μm2junctions in series has much lower noise TM(DSB) = 6.6 ± 1.6 K, but less gain GM(DSB) = -5.1 ± 0.5 dB.

European Microwave Conference (EuMC)•Sep 1, 1986•2 citations
A fixed-tuned SIS mixer covering an instantaneous band of 45% around 150 GHz has been developed for radioastronomy. A new type of coplanar tuning circuit for the SIS junction is introduced. The minimum DSB receiver noise is 19 K, while the average noise is 25K in the 130-175 GHz range with a 1 GHz IF band. A speedup of the observations by a factor 2-3 is possible with the new receiver.
An ultra low noise fixed-tuned SIS mixer covering an instantaneous band of 45% around 150 GHz has been developed for radioastronomy. A new type of coplanar tuning circuit for the SIS junction is introduced. The Nb/Al oxide/Nb junctions are 2 /spl mu/m/sup 2/ with critical Josephson current density of 4.2 KA/cm/sup 2/. The minimum DSB mixer noise is 11 K. The minimum DSB receiver noise is 19 K, while the average noise is 25 K in the 130-175 GHz range with a 1 GHz IF band. A speedup of the observations by a factor 2-3 is possible with the new receiver at 30 m IRAM radiotelescope.
We report on the design and characterization of two full height waveguide SIS mixers for astronomical applications: a Double Side Band (DSB) fixed-tuned mixer covering the 225-370 GHz band ( 50 % of relative bandwidth), and a tunable Single Side Band (SSB) mixer covering the 247-360 GHz frequency range. The DSB receiver noise temperature we have measured is below 50 K over a bandwidth larger than 100 GHz for the DSB mixer and has a minimum of 27 K (uncorrected) at 336 GHz; to our knowledge this is the lowest noise ever reported at this frequency. A receiver noise temperature below 80 K and an image band rejection around -14 dB were measured over most of the band of the SSB mixer. Both mixers use similar chips that integrate a parallel tuning inductor with a radial microstrip stub to compensate for the junction capacitance of 75 fF (junction size 1 μm 2 ). A stability criterion for intrinsically DSB and SSB mixers under typical operating conditions has been derived. The receiver designs have been optimised in order to guarantee a low mixer noise temperature while maintaining adequate gain and stable operation over the whole frequency bands of interest.
A heterodyne receiver using an SIS (superconductor-insulator-superconductor) waveguide mixer with two mechanical tuners has been built and characterized over the frequency range of 460 GHz to 630 GHz. This receiver is designed for radioastronomy applications. The mixer uses high-current-density, 0.25- mu m/sup 2/, Nb/AlO/sub x//Nb SIS tunnel junctions with integrated superconductive RF circuits to tune the junction capacitance. A DSB (double sideband) receiver noise temperature as low as 200+or-17 K has been obtained at 540 GHz. In addition, negative differential resistance has been observed in the DC I-V (current-voltage) curve at 487-491 GHz.>
This paper presents design and performance data for a 100-GHz waveguide superconductor-insulator-superconductor (SIS) mixer, which is incorporated with a twin-junction device (i.e., two identical junctions connected in parallel through a tuning inductance) and a fixed-tuned broad-band waveguide mixer mount. The 100-GHz mixer is actually developed as a prototype of the 500-GHz one. The constructed 100-GHz SIS receiver results in an overall receiver noise temperature (DSB) of less than 40 K over the frequency range from 80-120 GHz, with a minimum value of just 20 K that is four times as large as the quantum limit (i.e., 4/spl planck//spl omega//k). Such a performance is comparable or even superior to those of the best mechanically tunable waveguide SIS receivers at the same frequency band. In addition, some interesting mixing behaviors related to this two-junction device are described in detail.
Several SIS quasiparticle mixers have been designed and tested for the frequency range from 80 to 115 GHz. The sliding back short is the only adjustable RF-tuning element. The RF-filter reactance is used a s a fixed RF-matching element. A mixer which uses a single 2 × 2 μm2Pb-alloy junction in a 1/4-height waveguide mount has a coupled conversion gain of GM(DSB) = 2.6 ± 0.5 dB with an associated noise temperature of TM(DSB) = 16.4 ± 1.8 K at the best DSB operation point. The receiver noise temperature TR(DSB) is 27.5 ± 0.8 K for the test apparatus. This mixer provides a SSB receiver noise temperature below 50 K over the frequency range from 91 to 96 GHz, the minimum being TR(SSB) = 44 ± 4 K. Another mixer with an array of five 5 × 5 μm2junctions in series has much lower noise TM(DSB) = 6.6 ± 1.6 K, but less gain GM(DSB) = -5.1 ± 0.5 dB.