Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal de Physique IV (Proceedings)

Adiabatic transportation of a Bose–Einstein condensate to a dielectric surface

Yves Colombe, Hélène Perrin, B. Mercier, V. Lorent

Published Nov 1, 2004• 3 citations
Publisher

Abstract

We present the adiabatic transportation of a Bose-Einstein condensate from a standard magnetic trap to a dielectric surface located 3.6 mm below. The vertical shifting of the trapping potential is obtained by ramping up an additional homogeneous magnetic field in 100 ms. It is the first stage of the adiabatic transfer of the condensate from the initial 3D magnetic trap into a 2D evanescent light trap sitting at the dielectric surface.

DOI
10.1051/jp4:2004119036

Related papers

Schemes for loading a Bose Einstein condensate into a two-dimensional dipole trap

Yves Colombe, Demascoth Kadio, Maxim Olshanii +3 more

We propose two loading mechanisms of a degenerate Bose gas into a surface trap. This trap relies on the dipole potential produced by two evanescent optical waves far detuned from the atomic resonance, yielding a strongly anisotropic trap with typical frequencies 40 Hz × 65 Hz × 30 kHz. We present numerical simulations based on the time-dependent Gross–Pitaevskii equation of the transfer process from a conventional magnetic trap into the surface trap. We show that, despite a large discrepancy between the oscillation frequencies along one direction in the initial and final traps, a loading time of a few tens of milliseconds would lead to an adiabatic transfer. Preliminary experimental results are presented.

arXiv:cond-mat/0304650•Journal of Optics B Quantum and Semiclassical Optics•Apr 1, 2003•21 citations

Two-Dimensional Bose-Einstein Condensate in an Optical Surface Trap

D. Rychtarik, B. Engeser, Hanns‐Christoph Nägerl +1 more

We report on the creation of a two-dimensional Bose-Einstein condensate of cesium atoms in a gravito-optical surface trap. The condensate is produced a few microm above a dielectric surface on an evanescent-wave atom mirror. After evaporative cooling by all-optical means, expansion measurements for the tightly confined vertical motion show energies well below the vibrational energy quantum. The presence of a condensate is observed in two independent ways by a magnetically induced collapse at negative scattering length and by measurements of the horizontal expansion.

arXiv:cond-mat/0309536•Physical Review Letters•Apr 27, 2004•203 citations

Bose-Einstein Condensation in a Ioffe-Pritchard trap

U. Ernst, Andreas Marte, Florian Schreck +2 more

Since its first observation in 1995, Bose-Einstein condensation (BEC) experiments in dilute gases have been performed with only a few different kinds of magnetic traps. We have performed a BEC experiment with /sup 87/Rb atoms in a Ioffe-Pritchard magnetic potential, which opens up the possibility to study, e.g., Bose-Einstein condensates released in only one dimension. Our trap consists of a clip-like coil, which generates a pure two-dimensional (2D) quadrupole field for radial confinement. The axial confinement is provided by two plane pinch coils inside the clip-coil. These two coils create a bottle field. Two additional Helmholtz coils on the same symmetry axis are used to compensate the homogeneous part of the bottle field. By continuously varying the currents through the coils, the trapping potential can be changed from a 3D spherical harmonic to a 2D linear potential. The change can be done adiabatically or nonadiabatically by switching off the axial confinement slowly, or instantaneously respectively. This opens up the possibility to study 1D nonlinear atom optics. In combination with, e.g., far detuned light sheets, a Fabry-Perot type interferometer for a condensate might be realizable. Our experiments are performed in a vacuum system with two magneto-optical traps, which serves as the source of cold atoms for the magnetic trap. 10/sup 9/ atoms are captured in less than one minute. RF-induced evaporative cooling is used to increase the phase space density of the trapped atomic cloud. The BEC phase transition occurs at a temperature of 550 nK with 10/sup 6/ particles in the trap. Pure condensates with more than 10/sup 5/ atoms were produced.

European Quantum Electronics Conference (EQEC)•Aug 24, 2005•0 citations

Bose-Einstein Condensation in a Surface Microtrap

Herwig Ott, József Fortágh, G. Schlotterbeck +2 more

Bose-Einstein condensation has been achieved in a magnetic surface microtrap with 4 x 10(5) (87)Rb atoms. The strongly anisotropic trapping potential is generated by a microstructure which consists of microfabricated linear copper conductor of widths ranging from 3 to 30 microm. After loading a high number of atoms from a pulsed thermal source directly into a magneto-optical trap the magnetically stored atoms are transferred into the microtrap by adiabatic transformation of the trapping potential. In the microtrap the atoms are cooled to condensation using forced rf-evaporation. The complete in vacuo trap design is compatible with ultrahigh vacuum below 2 x 10(-11) mbar.

arXiv:cond-mat/0109322•Physical Review Letters•Nov 13, 2001•371 citations

Bose-Einstein condensation in a Ioffe-Pritchard trap

U. Ernst, Andreas Marte, Florian Schreck +2 more

Summary form only given.Since its first observation in 1995, Bose-Einstein condensation (BEC) experiments in dilute gases have been performed with only a few different kinds of magnetic traps. We have performed a BEC experiment with /sup 87/Rb atoms in a Ioffe-Pritchard magnetic potential, which opens up the possibility to study, e.g., Bose-Einstein condensates released in only one dimension. Our trap consists of a clip-like coil, which generates a pure two-dimensional (2D) quadrupole field for radial confinement. The axial confinement is provided by two plane pinch coils inside the clip-coil. These two coils create a bottle field. Two additional Helmholtz coils on the same symmetry axis are used to compensate the homogeneous part of the bottle field. By continuously varying the currents through the coils, the trapping potential can be changed from a 3D spherical harmonic to a 2D linear potential. The change can be done adiabatically or nonadiabatically by switching off the axial confinement slowly, or instantaneously respectively. This opens up the possibility to study 1D nonlinear atom optics. In combination with, e.g., far detuned light sheets, a Fabry-Perot type interferometer for a condensate might be realizable. Our experiments are performed in a vacuum system with two magneto-optical traps, which serves as the source of cold atoms for the magnetic trap. 10/sup 9/ atoms are captured in less than one minute. RF-induced evaporative cooling is used to increase the phase space density of the trapped atomic cloud. The BEC phase transition occurs at a temperature of 550 nK with 10/sup 6/ particles in the trap. Pure condensates with more than 10/sup 5/ atoms were produced.

Conference on Lasers and Electro-Optics•Nov 27, 2002•0 citations

BOSE-EINSTEIN CONDENSATE IN A SURFACE MICRO TRAP

József Fortágh, Herwig Ott, Götz Schlotterbeck +2 more

We report on Bose-Einstein condensation in a surface micro trap. The strongly anisotropic trapping potential is generated by a microstructure which consists of micro-fabricated linear copper conductors at a width ranging from 3 to 30 μm. The ratio of the trap frequencies for the motion in longitudinal and transverse direction can be varied continuously in a wide range up to values of 100.000. After capturing of 5×10 8 87 Rb atoms from a pulsed thermal dispenser source directly into a magneto-optical trap (MOT) the magnetically stored atoms are transfered into the micro trap by adiabatic transformation of the trapping potential. In the micro trap with high collision rate the atoms are cooled by forced evaporation into the degenerate regime. The pure condensate contains of up to 4×10 5 atoms. The complete in vacuo trap design is compatible with ultrahigh vacuum conditions below 2×10 −11 mbar.

Laser Spectroscopy•Jun 1, 2002•0 citations
We present the adiabatic transportation of a Bose-Einstein condensate from a standard magnetic trap to a dielectric surface located 3.6 mm below. The vertical shifting of the trapping potential is obtained by ramping up an additional homogeneous magnetic field in 100 ms. It is the first stage of the adiabatic transfer of the condensate from the initial 3D magnetic trap into a 2D evanescent light trap sitting at the dielectric surface.
We propose two loading mechanisms of a degenerate Bose gas into a surface trap. This trap relies on the dipole potential produced by two evanescent optical waves far detuned from the atomic resonance, yielding a strongly anisotropic trap with typical frequencies 40 Hz × 65 Hz × 30 kHz. We present numerical simulations based on the time-dependent Gross–Pitaevskii equation of the transfer process from a conventional magnetic trap into the surface trap. We show that, despite a large discrepancy between the oscillation frequencies along one direction in the initial and final traps, a loading time of a few tens of milliseconds would lead to an adiabatic transfer. Preliminary experimental results are presented.
We report on the creation of a two-dimensional Bose-Einstein condensate of cesium atoms in a gravito-optical surface trap. The condensate is produced a few microm above a dielectric surface on an evanescent-wave atom mirror. After evaporative cooling by all-optical means, expansion measurements for the tightly confined vertical motion show energies well below the vibrational energy quantum. The presence of a condensate is observed in two independent ways by a magnetically induced collapse at negative scattering length and by measurements of the horizontal expansion.
Since its first observation in 1995, Bose-Einstein condensation (BEC) experiments in dilute gases have been performed with only a few different kinds of magnetic traps. We have performed a BEC experiment with /sup 87/Rb atoms in a Ioffe-Pritchard magnetic potential, which opens up the possibility to study, e.g., Bose-Einstein condensates released in only one dimension. Our trap consists of a clip-like coil, which generates a pure two-dimensional (2D) quadrupole field for radial confinement. The axial confinement is provided by two plane pinch coils inside the clip-coil. These two coils create a bottle field. Two additional Helmholtz coils on the same symmetry axis are used to compensate the homogeneous part of the bottle field. By continuously varying the currents through the coils, the trapping potential can be changed from a 3D spherical harmonic to a 2D linear potential. The change can be done adiabatically or nonadiabatically by switching off the axial confinement slowly, or instantaneously respectively. This opens up the possibility to study 1D nonlinear atom optics. In combination with, e.g., far detuned light sheets, a Fabry-Perot type interferometer for a condensate might be realizable. Our experiments are performed in a vacuum system with two magneto-optical traps, which serves as the source of cold atoms for the magnetic trap. 10/sup 9/ atoms are captured in less than one minute. RF-induced evaporative cooling is used to increase the phase space density of the trapped atomic cloud. The BEC phase transition occurs at a temperature of 550 nK with 10/sup 6/ particles in the trap. Pure condensates with more than 10/sup 5/ atoms were produced.
Bose-Einstein condensation has been achieved in a magnetic surface microtrap with 4 x 10(5) (87)Rb atoms. The strongly anisotropic trapping potential is generated by a microstructure which consists of microfabricated linear copper conductor of widths ranging from 3 to 30 microm. After loading a high number of atoms from a pulsed thermal source directly into a magneto-optical trap the magnetically stored atoms are transferred into the microtrap by adiabatic transformation of the trapping potential. In the microtrap the atoms are cooled to condensation using forced rf-evaporation. The complete in vacuo trap design is compatible with ultrahigh vacuum below 2 x 10(-11) mbar.
Summary form only given.Since its first observation in 1995, Bose-Einstein condensation (BEC) experiments in dilute gases have been performed with only a few different kinds of magnetic traps. We have performed a BEC experiment with /sup 87/Rb atoms in a Ioffe-Pritchard magnetic potential, which opens up the possibility to study, e.g., Bose-Einstein condensates released in only one dimension. Our trap consists of a clip-like coil, which generates a pure two-dimensional (2D) quadrupole field for radial confinement. The axial confinement is provided by two plane pinch coils inside the clip-coil. These two coils create a bottle field. Two additional Helmholtz coils on the same symmetry axis are used to compensate the homogeneous part of the bottle field. By continuously varying the currents through the coils, the trapping potential can be changed from a 3D spherical harmonic to a 2D linear potential. The change can be done adiabatically or nonadiabatically by switching off the axial confinement slowly, or instantaneously respectively. This opens up the possibility to study 1D nonlinear atom optics. In combination with, e.g., far detuned light sheets, a Fabry-Perot type interferometer for a condensate might be realizable. Our experiments are performed in a vacuum system with two magneto-optical traps, which serves as the source of cold atoms for the magnetic trap. 10/sup 9/ atoms are captured in less than one minute. RF-induced evaporative cooling is used to increase the phase space density of the trapped atomic cloud. The BEC phase transition occurs at a temperature of 550 nK with 10/sup 6/ particles in the trap. Pure condensates with more than 10/sup 5/ atoms were produced.
We report on Bose-Einstein condensation in a surface micro trap. The strongly anisotropic trapping potential is generated by a microstructure which consists of micro-fabricated linear copper conductors at a width ranging from 3 to 30 μm. The ratio of the trap frequencies for the motion in longitudinal and transverse direction can be varied continuously in a wide range up to values of 100.000. After capturing of 5×10 8 87 Rb atoms from a pulsed thermal dispenser source directly into a magneto-optical trap (MOT) the magnetically stored atoms are transfered into the micro trap by adiabatic transformation of the trapping potential. In the micro trap with high collision rate the atoms are cooled by forced evaporation into the degenerate regime. The pure condensate contains of up to 4×10 5 atoms. The complete in vacuo trap design is compatible with ultrahigh vacuum conditions below 2×10 −11 mbar.