Several parameters are proposed for describing the statistical thermodynamic component of the exchange of photons between a pump and a laser beam. They are based on the occupation probability of absorbing and emitting, pump and laser levels, and are complementary to the optical cross sections. The ldquooccupation factor,rdquof0, is appropriate for describing an optical amplifier in the small signal regime.f1is appropriate for describing an amplifier in the large signal regime, e.g., a laser. They serve to facilitate a quantitative comparison of laser gain media, operating temperatures, and choice of pump and laser wavelengths. After a simple scaling, both occupation factors have a numerical value that coincides well, in most cases, with conventional usage of the terms two-, three-, and four-level laser. They can thus serve as an unambiguous, quantitative alternative to the quasi-two-, quasi-three-, and quasi-four-level terminology. The proposed definitions are general enough to apply to many types of gain media, but are particularly useful for comparing systems with discrete levels, pumped with a narrowband source, in near-resonance with the laser wavelength. Several low-quantum-defect combinations of pump and laser wavelengths are analyzed for Er3+, Nd3+, Yb3+, and Ho3+in YAG, as a function of temperature.
Several parameters are proposed for describing the statistical thermodynamic component of the exchange of photons between a pump and a laser beam. They are based on the occupation probability of absorbing and emitting, pump and laser levels, and are complementary to the optical cross sections. The ldquooccupation factor,rdquof0, is appropriate for describing an optical amplifier in the small signal regime.f1is appropriate for describing an amplifier in the large signal regime, e.g., a laser. They serve to facilitate a quantitative comparison of laser gain media, operating temperatures, and choice of pump and laser wavelengths. After a simple scaling, both occupation factors have a numerical value that coincides well, in most cases, with conventional usage of the terms two-, three-, and four-level laser. They can thus serve as an unambiguous, quantitative alternative to the quasi-two-, quasi-three-, and quasi-four-level terminology. The proposed definitions are general enough to apply to many types of gain media, but are particularly useful for comparing systems with discrete levels, pumped with a narrowband source, in near-resonance with the laser wavelength. Several low-quantum-defect combinations of pump and laser wavelengths are analyzed for Er3+, Nd3+, Yb3+, and Ho3+in YAG, as a function of temperature.
In this paper it is presented a theoretical evaluation of the following important amplifier parameters: the output mean photon number, the standard deviation, the Fano factor, the statistical fluctuation and the spontaneous emission factor for single and double pass configuration, and for forward and backward pumping schemes in quasi two level optical waveguide amplifiers. The theoretical model used to evaluate the noise characterization of an Er3+-doped Ti:LiNbO3 waveguide amplifiers is based on the photon statistics master equation of the linear amplifier, closely related with EDFA model and has been modified to account for the effects of the host material. One considered a quasi two level system model and one neglected ESA due to the considered pumping wavelength. The interaction of the pump and signal photons with Er3+ ions in LiNbO3 can be described using the rate equations. The simulations were performed using the small gain approximation in Er3+:Ti:LiNbO3 optical waveguides. The pump was supposed in the 1480 nm range and the signal having (lambda) equals 1530 nm. The evaluation of the above mentioned parameters vs. wavelength, pump powers, etc. were also performed and commented.
Exact and approximate theoretical models of the small-signal single-pass gain in single-mode three-level laser fibers are presented. These models are relevant to the behavior of rare-earth-doped (in particular Er/sup 3+/) silica-based fibers. They account for the effects of both the pump and signal-mode structures and pump excited-state absorption (ESA), the latter being present for some pump wavelengths in Er-doped silica fibers. By relying on the modal overlap integral formalism for four-level lasers, relatively simple closed-form expressions for the pump absorption and the gain are derived. These expressions are also applicable to four level laser fibers by a simple adjustment of some of the model parameters.>
POPULATION RATE EQUATIONS From the discussion in the preceding chapter, it is clear that population inversion is the basic condition for an optical gain. For any system in its normal state in thermal equilibrium, a low-energy level is always more populated than a high-energy level, hence there is no population inversion. Population inversion in a system can only be accomplished through a process called pumping by actively exciting the atoms in a low-energy level to a high-energy level. If left alone, the atoms in a system relax to thermal equilibrium. Therefore, population inversion is a nonequilibrium state that cannot be sustained without active pumping. To keep a constant optical gain, continuous pumping is required to maintain population inversion. This condition is clearly consistent with the law of conservation of energy: amplification of an optical wave leads to an increase in optical energy, which is possible only if the required energy is supplied by a source. Pumping is the process that supplies energy to the gain medium for the amplification of an optical wave. There are many different pumping techniques, including optical excitation, electric current injection, electric discharge, chemical reaction, and excitation with particle beams. The use of a specific pumping technique depends on the properties of the gain medium being pumped. The lasers and optical amplifiers of particular interest in photonic systems are made of either dielectric solid-state media doped with active ions, such as Nd:YAG and Er:glass fiber, or direct-gap semiconductors, such as GaAs and InP. For a dielectric gain medium, the most commonly used pumping technique is optical pumping using either an incoherent light source, such as a flashlamp or a light-emitting diode, or a coherent light source from another laser. A semiconductor gain medium can also be optically pumped, but it is usually pumped by electric current injection. In this section, we consider the general conditions for pumping to achieve population inversion. Detailed pumping mechanisms and physical setups are not addressed here because they depend on the specific gain medium used in a particular application. The net rate of increase of the population density in a given energy level is described by a rate equation. As we shall see below, pumping for population inversion in any practical gain medium always requires the participation of more than two energy levels.
A quantitative analysis is made of quantum fluctuations in the number of photons in the resonator of a single-mode laser considered in a quasi-linear approximation. An expression is obtained for a general four-level system, which is exact above the lasing threshold, but can also be used to calculate the fluctuations in the case of three- and two-level lasers. Above the threshold when certain relationships between the spontaneous decay constants are satisfied, the photon statistics are of the sub-Poisson type in four- and three-level systems. However, for other relationships between the decay constants, pumping rate, and average number of photons, fluctuations in the resonator obey both the Poisson and super-Poisson statistics with variances much greater than the average number of photons. Both Poisson and super-Poisson statistics with large values of the variance are found for a two-level system. The results of calculations indicate that, in general, there is no coherent Glauber state of the field in a laser resonator when the threshold is significantly exceeded.
In this paper, coupled power-gain equations were derived and solved to investigate the role of different power-degradation mechanisms on the continuous-wave power performance of a laser in the absence of thermal effects. Nine different power-degradation cases were considered, including a low-gain ideal four-level operation, ground-state reabsorption, pump excited-state absorption with and without storage, laser excited-state absorption with and without storage, intermediate storage, and Auger-type energy transfer upconversion with and without storage. There were three distinct types of laser performance identified, in terms of how the output power varies as a function of the pump power. Explicit analytical expressions were derived for the threshold pump power Pth, slope efficiency η, and the product Pthη/T as a function of output coupler transmission T and other physical parameters that describe the power degradation mechanism. The analytical approach developed here provides valuable insight about the role of major power degradation mechanisms in lasers, and it should be applicable to the analysis of a wide range of low-power, optically pumped laser media, including solid-state, fiber, and ceramic lasers.
During six decades of quantum electronics, a vast majority of new types of quantum generators have been developed. Although the principle of population inversion has united different ranges of electromagnetic spectra (and respective quantum generators), the existence of the title laser without the population inversion, makes that the exception had confirmed the rule, i. e. that this title deserves to be discussed further. Developing of formalisms describing the operation of quantum generators, by now have produced several approaches, which must have a quantum mechanics base. For the practical reasons, negative coefficient of absorption is acquired using classic electromagnetics as well, however for the population purposes, quantum representation must be entered. A few levels of formalisms will be set in this paper, linked to quantum generators accenting the optical portion of the spectra. The lowest level descriptions are based on lumped circuits. This could be expanded to equivalents of other physical problems, using program packages developed for the electrical engineering application purposes (Spice, etc.). Schematics are defined at the macro as well as micro equivalent levels (atomic – electronic levels). The kinetic equations with simpler approach will be considered as well as simplified laser equations based on quantum/ semi-quantum approach. The use of Fourier analysis or other appropriate transformations leads to formulating the main five laser equations which serve as the base for various working regimes of quantum generators and amplifiers (free generation regime, Q switch, synchronization, operation with filters, two modes regime, regime with losses, etc.). The Lyapunov stability theorem has to be included here, etc. For some of the chosen types of quantum generator, analytical modeling will be analyzed as well as the results of program packages developed for the lasers dynamics, regimes and parameters. The systems pumped with electronic beams (relativistic) will be considered and the nuclear physics statements discussed which must be included at the beginning, in order to consider further necessary parts of the condensed – solid state theory and laser techniques, after slowing down towards thermal energies. Existing program packages provide fast modeling and visualization of laser energy distribution, temperature, modes, etc. in active material with or without the resonator. A modeling will be performed for the specified geometries and a temperature distribution in active material will be captured during operation of a chosen laser system. Different pump geometries will be compared. Contemporary lasers with the shortest existing pulse durations demand new formalisms. Areas of nonlinear optics and quantum electrody-namics, Glauber states and similar, are areas that have to be included. Two main formalisms thermodynamical and quantum mechanical with transition probabilities using perturbation methods and secondary quantization naturally had to be complemented if the Brillouin, Raman, Compton, soliton, fiber and other lasers are included more generally.