Optical Fiber Communication Conference

Effects of concentration and clusters in EDFAs

Piotr Myslinski, Dan Trung Nguyen, Jacek Chrostowski

Published Jan 1, 1995• 2 citations

Abstract

Strong interest in heavily doped erbium-doped waveguides1 and in the applications of heavily doped erbium-doped fibers (EDFs) in lasers has resulted in several recent studies of collective processes in erbium ions. Rapid cross relaxation within a fraction of clustered ions, called pair-induced quenching (PIQ), has been identified as the main cause of EDF performance degradation.2-4 To date, studies on the dependence of EDF performance on ion concentration have been focused on pair/cluster-induced nonsaturable absorption of EDFs,2 which leads to the reduced quantum efficiency (QE) of EDF lasers.4 Recently, detailed theoretical analysis of the effect of PIQ on the performance of erbium-doped fiber amplifiers (EDFAs) has also been reported.4

DOI: 10.1364/ofc.1995.wp3

Related papers

Effects of concentration on the performance of erbium-doped fiber amplifiers

Piotr Myslinski, Dan Trung Nguyen, Jacek Chrostowski

The dependence of erbium-doped fiber amplifier (EDFA) performance on the erbium ion concentration is studied experimentally and theoretically. The quantum efficiency of the amplifier is found to he strongly dependent on the erbium ion concentration, the signal wavelength, and the relative propagation direction of the pump and signal beams. This dependence is fully explained by the presence of an upconversion mechanism between ions residing in pairs or larger clusters and suggests that other sources of amplifier performance degradation (back-ground loss, excited state absorption, homogenous upconversion) are negligible. The experimental data show that in the present EDFA designs with over 80% quantum/conversion efficiency, the aluminum co-doped fibers with erbium ion concentration less than 20/spl times/10/sup 24/ m/sup -3/ (900 molar ppm Er/sup 3+/) are most suitable.

Journal of Lightwave TechnologyJan 1, 1997221 citations

Clustering-induced nonsaturable absorption phenomenon in heavily erbium-doped silica fibers

Eric Maurice, Gérard Monnom, Bernard Dussardier +1 more

Nonsaturable absorption experiments in heavily erbium-doped fibers demonstrate that the behavior of the absorption with pump power cannot be interpreted with an ion-pair model but requires that the presence of larger clusters be taken into account. Numerical modeling permits the determination of the percentage of ions organized in clusters, as much as 52% of the dopants in the tested fiber, and the intracluster transfer rate, up to 2 × 106 s−1.

Optics LettersDec 15, 199546 citations

Excited-State Absorption at 1.5 µm in Er3+-Doped Fiber Amplifiers

Peter Blixt, Johan Nilsson, Jurgis Gintautas Babonas +1 more

Erbium-Doped Fiber Amplifiers (EDFAs) can very efficiently convert pump to signal energy. Quantum efficiencies higher than 80 % with 1.48 pm pump [1], and 93% when pumped at 980 nm [2] are reported. However, even higher values should be theoretically possible for an ideal EDFA. Various physical effects may lead to quantum efficiency (QE) reduction. Not all of them are quite well understood yet. At Erbium concentrations above 100 ppm by weight the pump loss is partly explained by energy transfer between two excited ions resulting in upcon- version process [3]. At low concentrations Excited-State Absorption (ESA) could be a more significant effect reducing QE. ESA of photons from 1.5 |im band have been predicted from absorption measurements [4] and also observed [5]. However, to our knowledge, no quantitative analysis has been made which would distinguish between the contributions of ESA and two-particle upconversion when measurements of short wavelength luminescence were performed.

Optical Amplifiers and Their ApplicationsJan 1, 19922 citations

The Effects of Complex Energy Transfer Dynamics and Gaussian Profiles on the Performance of High-Concentration EDFAs

Cüneyt Berkdemir, Sedat Özsoy

In this paper, we investigate the effects of complex energy transfer dynamics and Gaussian profiles on the gain and noise figure performance of erbium-doped fiber amplifiers (EDFAs) with high doping concentration. We use a two-level system to study the complex energy transfer dynamics that comes from the homogeneous up-conversion (HUC) and the pair-induced quenching (PIQ). In our model, the system is stimulated by a pump source at the wavelength of 1480 nm and operated with a signal source at the wavelength of 1560 nm. Assuming a uniform distribution of erbium ions in the fiber core, we approximate the fundamental mode distributions by Gaussian profiles which are commonly used to calculate the mode radius or spot size. Using the numerical calculations and analysis of the rate and power propagation equations for a two-level model under consideration, the most advantageous Gaussian profile is determined as the Whitley mode radius to obtain a high-gain and a low-noise figure per unit length of silica-based fiber amplifiers. The effects of the number of ions per cluster and the percentage of ions in clusters on the calculated gain and noise figure are compared for several pump powers. Results are discussed to achieve a desired gain and noise figure performance, and compared with the available experimental data to verify the feasibility of the model.

Journal of Lightwave TechnologyJul 7, 20095 citations

The effect of upconversion on erbium-doped fiber amplifiers (EDFA)

Zhou Meng

Erbium-doped fiber amplifier(EDFA)efficiency strongly depends on erbium concentration.Highly doped erbium devices show degraded performance when compared with low concentration ones.The mechanism of upconversion is studied and the effect of it on the performance of an EDFA is analyzed numerically,by means of a set of rate equations model.Approximate analytical solutions,for the rate equations,which include the effect of the upconversion,are presented,when the amplified spontaneous emission can be neglected,compared to the pump and signal powers.Results show that the pump and signal powers all bear degradation due to upconversion.,and the effect can't be neglected when the Er3+ concentration is larger than 2.95×1025 m-3.

Optical TechniqueJan 1, 20060 citations

Experimental evidence of differences in the absorption spectra of clustered and isolated ions in erbium-doped fibers

B.N. Samson, Wei H. Loh, J.P. de Sandro

The absorption spectra of clustered and isolated ions in erbium-doped germanosilicate fibers have been experimentally studied. The ground-state absorption spectra broaden as the degree of erbium-ion clustering increases, indicating that the absorption spectrum of clustered ions is significantly different from that of the homogeneous ions. This fact is confirmed by comparison of the broadened absorption spectra with the fiber's unbleachable loss spectrum, a direct measurement of the clustered ions. This is the first experimental evidence to the authors' knowledge that indicates different absorption cross sections for the two species of ions in germanosilicate glass, an assumption that is used in the theoretical description of self-pulsing in erbium-doped fiber lasers but is in direct contradiction to the pair-induced quenching model widely used to characterize erbium-doped fiber amplifiers.

Optics LettersDec 1, 199716 citations