Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Soviet Journal of Quantum Electronics

Characteristics of the mode intensity and optical bistability in multimode lasers with a saturable absorber. I. Single-mode operator

Dinh Van Hoang, Phan N Ha

Published Mar 31, 1986• 1 citation
Publisher

Abstract

The characteristics of the mode intensity and conditions for occurrence of optical bistability in a ring laser with a saturable absorber are considered. The rate equation approximation method is used to find analytic expressions for these characteristics. It is shown that changes in such physical parameters as the homogeneous and inhomogeneous broadening, coefficients of relaxation of amplifying and absorbing cells, etc. cause changes in the range of existence of optical bistability or a hysteresis cycle. The influence of inhomogeneous broadening and of spontaneous emission near the lasing threshold on the appearance of optical bistability is demonstrated for the single-mode regime.

DOI
10.1070/qe1986v016n03abeh005987

Related papers

Conditions for the appearance of an optical instability of a laser with a saturable absorber and an inhomogeneously broadened line

Dinh Van Hoang, Vo Duc Luong

An analysis is made of the operation of a laser with a saturable absorber and dominant inhomogeneous line broadening. A four-level model is used to determine the characteristics of mode intensities and conditions for the appearance of an optical bistability. By analogy with a two-level model, the results obtained demonstrate that in single-mode operation this bistability appears only if the relaxation coefficients of the upper levels of atomic or molecular systems are different in the amplifying and absorbing parts of a laser. Moreover, a change in the inhomogeneous broadening alters greatly the optical bistability interval. The calculation method used in the present study can be readily extended to analyze a multimode laser.

Soviet Journal of Quantum Electronics•Sep 30, 1987•2 citations

Operation of a ring multimode laser containing a saturable absorber with dominant inhomogeneous line broadening

Dinh Van Hoang, Vo Duc Luong

Multimode operation of a ring laser containing a saturable absorber is considered. When the pump energy is distributed uniformly between all the modes, the condition for appearance of an optical bistability is similar to the same condition for the single-mode operation. However, if the pump energy is distributed inhomogeneously over the modes in the amplifying part of the laser, an optical bistability appears only at certain modes and this is due to competition between them.

Soviet Journal of Quantum Electronics•May 31, 1990•2 citations

Optical bistability of Fabry-Perot LSA with inhomogeneous broadening

Dinh Van Hoang, Phung Quoc Bao

The optical bistability (OB) behavior of single-mode Fabry- Perot lasers containing saturable absorber (LSA) is presented on the basis of the rate equations with allowance for spontaneous emission and spatial hole-burning. Special attention is paid to the case of dominant inhomogeneous broadening in both Lorentzian and Gaussian models. The OB occurrence conditions are clearly displayed in phase diagrams. The influence of the main LSA parameters on OB characteristics as well as on OB curves' stability are investigated in detail. Some practical suggestions for optimizing the bistable operation in LSA are also given.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 8, 1999•3 citations

Influence of the "hole burning" effect on the optical bistability in lasers containing a saturable absorber

Dinh Van Hoang, Vo Thanh Lam

An analysis is made of the influence of the "hole burning" effect on the optical bistability during operation of lasers containing a saturable absorber in the resonator. The rate equation approximation is used to examine single-mode and multimode lasing. The results obtained show that under certain conditions not only the bistability, but also multistable states can appear.

Soviet Journal of Quantum Electronics•Apr 30, 1989•0 citations

Properties of a Lorentz-broadened single-mode unidirectional ring laser

Paul Mandel

We study some properties of a single-mode unidirectional ring laser characterized by a Lorentzian inhomogeneous broadening. The emphasis is on the derivation of analytic results. First we determine the various classes of stationary solutions and demonstrate the existence of low-intensity and high-intensity optical bistability. Both types of optical bistability require a finite detuning and inhomogeneous broadening. Next we study the linear stability of the steady solutions and determine the conditions for the occurrence of a Casperson instability in various limits but on resonance.

Journal of the Optical Society of America B•Jan 1, 1985•24 citations

Optical bistability in the oscillation of an inhomogeneously broadened quasi-three-level laser

Junhai Liu, Xueping Tian

A theoretical modeling analysis is presented to study the optical bistability exhibited in the oscillation of an inhomogeneously broadened quasi-three-level laser. All the major characteristics of optical bistability depend on two normalized parameters, f and xa, which are defined by f = Isat,a/Isat,m and xa = 2αa0pa/δ and are related to measurable properties of the laser medium. In comparison with the case of a homogeneously broadened laser, the essential condition for the occurrence of such bistability, f < xa/(xa + 1), turns out to be the same, whereas the intensities at the up- and down-thresholds are substantially increased and the bistability range is reduced.

Laser Physics•Mar 15, 2013•0 citations
The characteristics of the mode intensity and conditions for occurrence of optical bistability in a ring laser with a saturable absorber are considered. The rate equation approximation method is used to find analytic expressions for these characteristics. It is shown that changes in such physical parameters as the homogeneous and inhomogeneous broadening, coefficients of relaxation of amplifying and absorbing cells, etc. cause changes in the range of existence of optical bistability or a hysteresis cycle. The influence of inhomogeneous broadening and of spontaneous emission near the lasing threshold on the appearance of optical bistability is demonstrated for the single-mode regime.
An analysis is made of the operation of a laser with a saturable absorber and dominant inhomogeneous line broadening. A four-level model is used to determine the characteristics of mode intensities and conditions for the appearance of an optical bistability. By analogy with a two-level model, the results obtained demonstrate that in single-mode operation this bistability appears only if the relaxation coefficients of the upper levels of atomic or molecular systems are different in the amplifying and absorbing parts of a laser. Moreover, a change in the inhomogeneous broadening alters greatly the optical bistability interval. The calculation method used in the present study can be readily extended to analyze a multimode laser.
The optical bistability (OB) behavior of single-mode Fabry- Perot lasers containing saturable absorber (LSA) is presented on the basis of the rate equations with allowance for spontaneous emission and spatial hole-burning. Special attention is paid to the case of dominant inhomogeneous broadening in both Lorentzian and Gaussian models. The OB occurrence conditions are clearly displayed in phase diagrams. The influence of the main LSA parameters on OB characteristics as well as on OB curves' stability are investigated in detail. Some practical suggestions for optimizing the bistable operation in LSA are also given.
We study some properties of a single-mode unidirectional ring laser characterized by a Lorentzian inhomogeneous broadening. The emphasis is on the derivation of analytic results. First we determine the various classes of stationary solutions and demonstrate the existence of low-intensity and high-intensity optical bistability. Both types of optical bistability require a finite detuning and inhomogeneous broadening. Next we study the linear stability of the steady solutions and determine the conditions for the occurrence of a Casperson instability in various limits but on resonance.
A theoretical modeling analysis is presented to study the optical bistability exhibited in the oscillation of an inhomogeneously broadened quasi-three-level laser. All the major characteristics of optical bistability depend on two normalized parameters, f and xa, which are defined by f = Isat,a/Isat,m and xa = 2αa0pa/δ and are related to measurable properties of the laser medium. In comparison with the case of a homogeneously broadened laser, the essential condition for the occurrence of such bistability, f < xa/(xa + 1), turns out to be the same, whereas the intensities at the up- and down-thresholds are substantially increased and the bistability range is reduced.