Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Temporal and spectral control of single-photon frequency upconversion for pulsed radiation

Xiaorong Gu, Kun Huang, Yao Li, Haifeng Pan, E Wu, Heping Zeng

Published Mar 29, 2010• 39 citations
Publisher

Abstract

We demonstrate efficient single-photon detection at 1.04 μm with quite low background counts by using the frequency upconversion detection technique with pulsed single-photon source and strong pump field prepared from two synchronized fiber lasers. Temporal and spectral control of the pump and signal lasers enabled an upconversion efficiency of 81.1%. As the system was pumped at a wavelength longer than that of the signal, the corresponding background counts were reduced down to 1.5×103 s−1 due to efficient suppression of parametric fluorescence in the periodic poled lithium niobate crystal.

DOI
10.1063/1.3374330

Related papers

High-Speed Single-Photon Frequency Upconversion With Synchronous Pump Pulses

Xiaorong Gu, Yao Li, Haifeng Pan +2 more

Single-photon signals at 1.56 ¿m were converted into the visible region by sum-frequency generation, with synchronous pump pulses at 1.03 ¿m in a periodically poled lithium niobate crystal. The signal and pump sources were provided by two synchronized mode-locked fiber lasers at the operation rate of 7.88 MHz. Such a high-speed single-photon upconversion system has shown an overall detection efficiency of 10.4%. The corresponding background noise was measured to be 3.3 × 103s-1. The noise-equivalent power in this scheme was 9.93 × 10-17W/Hz1/2, which was the lowest compared to the other upconversion systems with similar pump and signal wavelengths.

IEEE Journal of Selected Topics in Quantum Electronics•Jan 1, 2009•8 citations

Efficient single-photon counting at 1.55μm by intracavity frequency upconversion in a unidirectional ring laser

Haifeng Pan, Huafang Dong, Heping Zeng +1 more

A single-photon signal at 1.55μm was converted to its visible replica by sum-frequency mixing with a strong intracavity pump of a unidirectional ring laser at 1.06μm in a periodically poled lithium niobate (PPLN) crystal. In the ring laser configuration, standing-wave photorefractive effects in the PPLN crystal could be suppressed and consequently, the spectral bandwidth of the intracavity pump could be controlled for excellent quasi-phase-matching. A conversion efficiency of 96% was demonstrated, and the corresponding background counts were less than 6.0×105s−1. The single-photon upconversion was used for efficient single-photon counting at 1.55μm with long-term stability.

Applied Physics Letters•Nov 6, 2006•34 citations

Efficient single-photon counting at 155 µm by means of frequency upconversion

Marius A. Albotǎ, Franco N. C. Wong

We demonstrate efficient single-photon detection at 1.55 microm by means of sum-frequency mixing with a strong pump at 1.064 microm in periodically poled lithium niobate followed by photon counting in the visible region. This scheme offers significant advantages over existing InGaAs photon counters: continuous-wave operation, higher detection efficiency, higher counting rates, and no afterpulsing. We achieved single-photon upconversion efficiency of 90% at 21.6 W of circulating power in a resonant pump cavity with a 400-mW Nd:YAG laser. We observed high background counts at strong circulating pump powers due to efficient upconversion of pump-induced fluorescence photons.

Optics Letters•Jul 1, 2004•316 citations

Efficient single-photon frequency upconversion at 1.06 μm with ultralow background counts

Huafang Dong, Haifeng Pan, Yao Li +2 more

We demonstrated an efficient single-photon frequency upconversion system for the infrared photons at 1.06 μm with ultralow background counts. By pumping the system at a longer wavelength than that of the single-photon signal, the background counts caused by the pump-induced parametric fluorescence in the nonlinear crystal were reduced markedly. We achieved so far the lowest noise of ∼150/s for a near unity conversion efficiency.

Applied Physics Letters•Aug 18, 2008•43 citations

Efficient and stable single-photon counting at 155 μm by intracavity frequency upconversion

Haifeng Pan, Heping Zeng

A single-photon signal at 1.55 microm was converted to the visible region by sum-frequency mixing with a strong pumping beam at 1064 nm in a periodically poled lithium niobate crystal placed in a diode-pumped Nd:YVO4 laser cavity. As the intracavity pump laser could be automatically stabilized without cavity lock, robust long-term stability was demonstrated for single-photon frequency upconversion, with a conversion efficiency of 74.3%. Such a stable single-photon upconversion was demonstrated to be efficient and robust for single-photon counting at 1550 nm, and the corresponding background noise was measured at less than 420 x 10(3) s(-1).

Optics Letters•Mar 15, 2006•23 citations

Efficient mid-infrared single-photon frequency upconversion detection with ultra-low background counts

Xiaorong Gu, Kun Huang, Haifeng Pan +2 more

We demonstrate an efficient mid-infrared single-photon detection system with ultra-low background counts based on the frequency upconversion detection technique. The signal photons of 3.39 μm came from a He–Ne laser and the pump beam was provided by a mode-locked ytterbium-doped fiber laser. Taking into account the pulsed pumping and continuous-wave signaling scheme, the peak conversion efficiency of 64% was achieved at an average pump power of 28.3 mW. The corresponding detection efficiency was inferred to be 6.1% with ultra-low background counts of 400 s −1 .

Laser Physics Letters•Mar 7, 2013•17 citations
We demonstrate efficient single-photon detection at 1.04 μm with quite low background counts by using the frequency upconversion detection technique with pulsed single-photon source and strong pump field prepared from two synchronized fiber lasers. Temporal and spectral control of the pump and signal lasers enabled an upconversion efficiency of 81.1%. As the system was pumped at a wavelength longer than that of the signal, the corresponding background counts were reduced down to 1.5×103 s−1 due to efficient suppression of parametric fluorescence in the periodic poled lithium niobate crystal.
Single-photon signals at 1.56 ¿m were converted into the visible region by sum-frequency generation, with synchronous pump pulses at 1.03 ¿m in a periodically poled lithium niobate crystal. The signal and pump sources were provided by two synchronized mode-locked fiber lasers at the operation rate of 7.88 MHz. Such a high-speed single-photon upconversion system has shown an overall detection efficiency of 10.4%. The corresponding background noise was measured to be 3.3 × 103s-1. The noise-equivalent power in this scheme was 9.93 × 10-17W/Hz1/2, which was the lowest compared to the other upconversion systems with similar pump and signal wavelengths.
A single-photon signal at 1.55μm was converted to its visible replica by sum-frequency mixing with a strong intracavity pump of a unidirectional ring laser at 1.06μm in a periodically poled lithium niobate (PPLN) crystal. In the ring laser configuration, standing-wave photorefractive effects in the PPLN crystal could be suppressed and consequently, the spectral bandwidth of the intracavity pump could be controlled for excellent quasi-phase-matching. A conversion efficiency of 96% was demonstrated, and the corresponding background counts were less than 6.0×105s−1. The single-photon upconversion was used for efficient single-photon counting at 1.55μm with long-term stability.
We demonstrate efficient single-photon detection at 1.55 microm by means of sum-frequency mixing with a strong pump at 1.064 microm in periodically poled lithium niobate followed by photon counting in the visible region. This scheme offers significant advantages over existing InGaAs photon counters: continuous-wave operation, higher detection efficiency, higher counting rates, and no afterpulsing. We achieved single-photon upconversion efficiency of 90% at 21.6 W of circulating power in a resonant pump cavity with a 400-mW Nd:YAG laser. We observed high background counts at strong circulating pump powers due to efficient upconversion of pump-induced fluorescence photons.
A single-photon signal at 1.55 microm was converted to the visible region by sum-frequency mixing with a strong pumping beam at 1064 nm in a periodically poled lithium niobate crystal placed in a diode-pumped Nd:YVO4 laser cavity. As the intracavity pump laser could be automatically stabilized without cavity lock, robust long-term stability was demonstrated for single-photon frequency upconversion, with a conversion efficiency of 74.3%. Such a stable single-photon upconversion was demonstrated to be efficient and robust for single-photon counting at 1550 nm, and the corresponding background noise was measured at less than 420 x 10(3) s(-1).
We demonstrate an efficient mid-infrared single-photon detection system with ultra-low background counts based on the frequency upconversion detection technique. The signal photons of 3.39 μm came from a He–Ne laser and the pump beam was provided by a mode-locked ytterbium-doped fiber laser. Taking into account the pulsed pumping and continuous-wave signaling scheme, the peak conversion efficiency of 64% was achieved at an average pump power of 28.3 mW. The corresponding detection efficiency was inferred to be 6.1% with ultra-low background counts of 400 s −1 .