We extend our previous work [S. Sharma and G. K.-L. Chan, J. Chem. Phys. 136, 124121 (2012)], which described a spin-adapted (SU(2) symmetry) density matrix renormalization group algorithm, to additionally utilize general non-Abelian point group symmetries. A key strength of the present formulation is that the requisite tensor operators are not hard-coded for each symmetry group, but are instead generated on the fly using the appropriate Clebsch-Gordan coefficients. This allows our single implementation to easily enable (or disable) any non-Abelian point group symmetry (including SU(2) spin symmetry). We use our implementation to compute the ground state potential energy curve of the C2 dimer in the cc-pVQZ basis set (with a frozen-core), corresponding to a Hilbert space dimension of 10(12) many-body states. While our calculated energy lies within the 0.3 mEh error bound of previous initiator full configuration interaction quantum Monte Carlo and correlation energy extrapolation by intrinsic scaling calculations, our estimated residual error is only 0.01 mEh, much more accurate than these previous estimates. Due to the additional efficiency afforded by the algorithm, the excitation energies (Te) of eight lowest lying excited states: a(3)Πu, b(3)Σg (-), A(1)Πu, c(3)Σu (+), B(1)Δg, B(') (1)Σg (+), d(3)Πg, and C(1)Πg are calculated, which agree with experimentally derived values to better than 0.06 eV. In addition, we also compute the potential energy curves of twelve states: the three lowest levels for each of the irreducible representations (1)Σg (+), (1)Σu (+), (1)Σg (-), and (1)Σu (-), to an estimated accuracy of 0.1 mEh of the exact result in this basis.
Abstract. – We describe here the extension of the density matrix renormalization group algorithm to the case where the Hamiltonian has a non-Abelian global symmetry group. The block states transform as irreducible representations of the non-Abelian group. Since the representations are multi-dimensional, a single block state in the new representation corresponds to multiple states of the original density matrix renormalization group basis. We demonstrate the usefulness of the construction via the the one-dimensional Hubbard model as the symmetry group is enlarged from U(1) × U(1), up to SU(2) × SU(2). In past years, the density matrix renormalization group (DMRG) method [1] has been extensively used to study one and two dimensional strongly correlated electron systems [2]. This method became very popular when it was realized that it enabled a level of numerical accuracy for one dimensional systems that was not possible using other methods [3]. One major drawback of DMRG is that calculations are performed in a subspace of purely Abelian symmetries, such as the U(1) symmetries of total particle number and the z component of the total spin. Thus one can only obtain a few states in different total particle
One of the long standing problems in quantum chemistry had been the inability to exploit full spatial and spin symmetry of an electronic Hamiltonian belonging to a non-Abelian point group. Here, we present a general technique which can utilize all the symmetries of an electronic (magnetic) Hamiltonian to obtain its full eigenvalue spectrum. This is a hybrid method based on Valence Bond basis and the basis of constant z-component of the total spin. This technique is applicable to systems with any point group symmetry and is easy to implement on a computer. We illustrate the power of the method by applying it to a model icosahedral half-filled electronic system. This model spans a huge Hilbert space (dimension 1,778,966) and in the largest non-Abelian point group. The C60 molecule has this symmetry and hence our calculation throw light on the higher energy excited states of the bucky ball. This method can also be utilized to study finite temperature properties of strongly correlated systems within an exact diagonalization approach. (C) 2011 Wiley Periodicals, Inc. Int J Quantum Chem, 2012
We have developed an efficient method for performing density matrix renormalization group (DMRG) simulations of the SU(
N) Fermi-Hubbard chain, fully leveraging the SU(
N) symmetry of the problem. This method extends a previously developed approach for the SU(
N) Heisenberg model and relies on the systematic use of the semistandard Young tableaux (SSYT) basis in a DMRG algorithm ``\`a la White.'' Specifically, the method aligns the site-by-site growth process of the infinite-size part of the DMRG, in its original formulation, with the site-by-site construction of the SSYT (or Gelfand-like) basis, based on the chain of unitary subgroups $U(1)\ensuremath{\subset}U(2)\ensuremath{\subset}U(3)\ensuremath{\subset}U(4)\ensuremath{\cdots}$. We give special emphasis to the calculation of the symmetry-resolved reduced matrix elements of the hopping terms between the left and the right block, which makes direct use of the basis of SSYT and of the Gelfand-Tsetlin coefficients, offering a computational advantage in scaling with
N compared to alternative methods that rely on summing over Clebsch-Gordan coefficients. Focusing on the model with homogeneous hopping between nearest neighbors, we have calculated the ground-state energy as a function of
U, i.e., the atom-atom interaction amplitude, up to
N=6 for filling
1/N (one particle per site in average), and for one atom (respectively, hole) away from filling
1/N. It allows us to compute the charge gaps and to estimate in the thermodynamical limit, the critical value
Uc (separating the Mott insulator from the metallic phase), which is proved to be finite (i.e.,
Uc>0) and to increase with
N. Central charges
c are also extracted from the entanglement entropy using the Calabrese-Cardy formula and are consistent with the theoretical predictions: $c=N\ensuremath{-}1$, expected from the
SU(N)1 Wess-Zumino-Witten conformal field theory in the spin sector for the Mott phase, and
c=N in the metallic phase, reflecting the presence of one additional (charge) gapless critical mode.
The symmetry adapted density matrix renormalization group (SDMRG) technique has been an efficient method for studying low-lying eigenstates in one- and quasi-one-dimensional electronic systems. However, the SDMRG method had bottlenecks involving the construction of linearly independent symmetry adapted basis states as the symmetry matrices in the DMRG basis were not sparse. We have developed a modified algorithm to overcome this bottleneck. The new method incorporates end-to-end interchange symmetry
(C2), electron-hole symmetry
(J), and parity or spin-flip symmetry
(P) in these calculations. The one-to-one correspondence between direct-product basis states in the DMRG Hilbert space for these symmetry operations renders the symmetry matrices in the new basis with maximum sparseness, just one nonzero matrix element per row. Using methods similar to those employed in the exact diagonalization technique for Pariser-Parr-Pople (PPP) models, developed in the 1980s, it is possible to construct orthogonal SDMRG basis states while bypassing the slow step of the Gram-Schmidt orthonormalization procedure. The method together with the PPP model which incorporates long-range electronic correlations is employed to study the correlated excited-state spectra of 1,12-benzoperylene and a narrow mixed graphene nanoribbon with a chrysene molecule as the building unit, comprising both zigzag and cove-edge structures.
The benefits of exploiting the presence of symmetries in tensor network algorithms have been extensively demonstrated in the context of matrix product states (MPSs). These include the ability to select a specific symmetry sector (e.g., with a given particle number or spin), to ensure the exact preservation of total charge, and to significantly reduce computational costs. Compared to the case of a generic tensor network, the practical implementation of symmetries in the MPS is simplified by the fact that tensors only have three indices (they are trivalent, just as the Clebsch-Gordan coefficients of the symmetry group) and are organized as a one-dimensional array of tensors, without closed loops. Instead, a more complex tensor network, one where tensors have a larger number of indices and/or a more elaborate network structure, requires a more general treatment. In two recent papers, namely, (i) [Singh, Pfeifer, and Vidal, Phys. Rev. A 82, 050301 (2010)] and (ii) [Singh, Pfeifer, and Vidal, Phys. Rev. B 83, 115125 (2011)], we described how to incorporate a global internal symmetry into a generic tensor network algorithm based on decomposing and manipulating tensors that are invariant under the symmetry. In (i) we considered a generic symmetry group
G that is compact, completely reducible, and multiplicity free, acting as a global internal symmetry. Then, in (ii) we described the implementation of Abelian group symmetries in much more detail, considering a U(1) symmetry (e.g., conservation of global particle number) as a concrete example. In this paper, we describe the implementation of non-Abelian group symmetries in great detail. For concreteness, we consider an SU(2) symmetry (e.g., conservation of global quantum spin). Our formalism can be readily extended to more exotic symmetries associated with conservation of total fermionic or anyonic charge. As a practical demonstration, we describe the SU(2)-invariant version of the multiscale entanglement renormalization ansatz and apply it to study the low-energy spectrum of a quantum spin chain with a global SU(2) symmetry.
This article presents an efficient and parallelized implementation of the density matrix renormalization group (DMRG) algorithm for quantum chemistry calculations. The DMRG method as a large-scale multireference electronic structure model is by nature particularly efficient for one-dimensionally correlated systems, while the present development is oriented toward applications for polynuclear transition metal compounds, in which the macroscopic one-dimensional structure of electron correlation is absent. A straightforward extension of the DMRG algorithm is proposed with further improvements and aggressive optimizations to allow its application with large multireference active space, which is often demanded for metal compound calculations. Special efficiency is achieved by making better use of sparsity and symmetry in the operator and wave function representations. By accomplishing computationally intensive DMRG calculations, the authors have found that a large number of renormalized basis states are required to represent high entanglement of the electron correlation for metal compound applications, and it is crucial to adopt auxiliary perturbative correction to the projected density matrix during the DMRG sweep optimization in order to attain proper convergence to the solution. Potential energy curve calculations for the Cr(2) molecule near the known equilibrium precisely predicted the full configuration interaction energies with a correlation space of 24 electrons in 30 orbitals [denoted by (24e,30o)]. The energies are demonstrated to be accurate to 0.6mE(h) (the error from the extrapolated best value) when as many as 10,000 renormalized basis states are employed for the left and right DMRG block representations. The relative energy curves for [Cu(2)O(2)](2+) along the isomerization coordinate were obtained from DMRG and other correlated calculations, for which a fairly large orbital space (32e,62o) is modeled as a full correlation space. The DMRG prediction nearly overlaps with the energy curve from the coupled cluster with singles, doubles, and perturbative triple [CCSD(T)] calculations, while the multireference complete active space self-consistent field (CASSCF) calculations with the small reference configuration (8e,8o) are found to overestimate the biradical character of the electronic state of [Cu(2)O(2)](2+) according to the one-electron density matrix analysis.