Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optical Engineering

Pump-controlled signal switching using a nonlinear dual-core fiber

Yi Bin Lu, P. L. Chu

Published Dec 1, 2002• 1 citation
Publisher

Abstract

We report a pump-controlled optical signal switch consisting simply of a length of dual-core erbium-doped fiber. It has the following attractive features: (1) wide bandwidth signal switching covering the wavelength range 1552 to 1585 nm, and (2) switching efficiency of nearly 100%.
DOI
10.1117/1.1521134

Related papers

Laser-diode-pumped nonlinear switch in erbium-doped fiber

R. H. Pantell, Robert W. Sadowski, Michel J. F. Digonnet +1 more

We describe a two-mode fiber switch made of a short length of erbium-doped fiber in which switching is accomplished by a nonlinearity that is resonantly enhanced by the dopant. In a 0.95-m fiber pumped with a 1.48-μm laser diode, a 906-nm signal is switched with only 8 mW of absorbed power at a signal absorption loss of 0.25 dB.

Optics Letters•Jul 15, 1992•35 citations

Optical switching in erbium-doped fibers

P. L. Chu, Yan Xue, Bin Wu

Theoretical and experimental investigations of the nonlinear refractive index in an erbium- doped fiber are reported. We also show that an optical switch based on twin-core erbium- doped fiber can be constructed and operated at low input optical power, in the order of 1 or 2 mW. The transient response of this fiber also is examined. The switching speed can be improved by using a signal power at a wavelength close to the resonant wavelength between the excited state and the ground state.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 11, 1993•2 citations

Resonantly enhanced nonlinear optical switching in rare-earth-doped fibers

Robert W. Sadowski, Michel J. F. Digonnet, R. H. Pantell +1 more

We report low loss, low pump power, optical-optical switches in rare-earth-doped fibers based on the third-order optical nonlinearity resonantly enhanced by the dopant. In a 0.95-m Er- doped two-mode fiber switch pumped with a 1.48-micrometers diode laser, the absorbed pump power required for switching a 906-nm signal was 8 mW, for a signal loss of only 0.25 dB. This is an enhancement by a factor of 6200 in power-length product over undoped silica. The phase shift was found to be due in part to a non-resonant contribution, thought to arise from a strong UV-VUV transition, and in part to a resonant term from the 980-nm transition. In a 0.98-m Nd-doped, elliptical-core, two-mode fiber switch, switching of a 632.8-nm signal was achieved with only 6.6 mW of absorbed power at 900 nm. The dynamic response of the switch was found to have two components, a slow component equal to the metastable level lifetime (approximately equals 380 microsecond(s) ) and a fast component (approximately equals 2 microsecond(s) ). The latter is believed to arise from rapid cross-relaxation between paired ions, a mechanism which shows promises for low- power, microsecond switching in fibers.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Mar 23, 1993•6 citations

Microsecond optical–optical switching in a neodymium-doped two-mode fiber

Robert W. Sadowski, Michel J. F. Digonnet, R. H. Pantell +1 more

We report on optically induced optical switching of a 632.8-nm signal in a Nd3+-doped, two-mode fiber based on a nonlinearity resonantly enhanced by the dopant. A fast, 0.38-μs component was observed in the switched signal, which we believe is due to cross relaxation between clustered ions. We demonstrated a 600-kHz switch in a 1.14-m elliptical-core fiber with 0.31 μJ of launched 807-nm pump energy. Information about cluster size and speed of the cross-relaxation process is inferred from the switch dynamics.

Optics Letters•Jun 1, 1993•29 citations

Strong Optical Bistability in a Simple LLL -Band Tunable Erbium-Doped Fiber Ring Laser

Jung Mi Oh, Dong-Han Lee

We demonstrate strong optical bistability in a widely tunable L-band erbium-doped fiber ring laser pumped by a 980-nm laser diode. The bistable region is as much as 150-mW wide and can be controlled by the lasing wavelength or the length of erbium-doped fiber. The mechanism for the bistability is not typical cross gain saturation in a two-mode operation, but rather saturable absorption strongly enhanced in the proposed scheme.

IEEE Journal of Quantum Electronics•Mar 30, 2004•40 citations

Digital all-optical switching in a ytterbium-doped two-mode fiber interferometer

Zourab Brodzeli, Graham R. Atkins, John W. Arkwright

A resonance-enhanced nonlinearity is used to demonstrate a digital switching response in a two-mode fiber interferometer constructed from ytterbium(III)-doped optical fiber. The fiber used was single-mode at the pump wavelength (980 nm) and two-moded at the signal wavelength (514 nm). Interferometer-based optical switches are generally sensitive to fluctuations in pump power, because of the sinusoidal dependence of the output state on pump power. However by allowing the doped fiber to lase, thus clamping the phase shift, this sensitivity can be eliminated to yield a bi-stable, digital switching response. In our interferometer configuration, a laser cavity was defined in the ytterbium-doped fiber by a matched pair of Bragg gratings, and the magnitude of the clamped phase shift was controlled by stretching one of the gratings to adjust the laser threshold. Digital switching of a 514 nm signal with 11 dB isolation and a power-length product of 1.3 mW.m was demonstrated. The relaxation time of the switch was determined by the ytterbium(III) excited state lifetime, while the rise time could be reduced by increasing the pump power without compromising the isolation. The clamping technique demonstrated in this paper should be applicable to any optical switch incorporating a gain medium.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Dec 21, 1998•0 citations
We report low loss, low pump power, optical-optical switches in rare-earth-doped fibers based on the third-order optical nonlinearity resonantly enhanced by the dopant. In a 0.95-m Er- doped two-mode fiber switch pumped with a 1.48-micrometers diode laser, the absorbed pump power required for switching a 906-nm signal was 8 mW, for a signal loss of only 0.25 dB. This is an enhancement by a factor of 6200 in power-length product over undoped silica. The phase shift was found to be due in part to a non-resonant contribution, thought to arise from a strong UV-VUV transition, and in part to a resonant term from the 980-nm transition. In a 0.98-m Nd-doped, elliptical-core, two-mode fiber switch, switching of a 632.8-nm signal was achieved with only 6.6 mW of absorbed power at 900 nm. The dynamic response of the switch was found to have two components, a slow component equal to the metastable level lifetime (approximately equals 380 microsecond(s) ) and a fast component (approximately equals 2 microsecond(s) ). The latter is believed to arise from rapid cross-relaxation between paired ions, a mechanism which shows promises for low- power, microsecond switching in fibers.
We report on optically induced optical switching of a 632.8-nm signal in a Nd3+-doped, two-mode fiber based on a nonlinearity resonantly enhanced by the dopant. A fast, 0.38-μs component was observed in the switched signal, which we believe is due to cross relaxation between clustered ions. We demonstrated a 600-kHz switch in a 1.14-m elliptical-core fiber with 0.31 μJ of launched 807-nm pump energy. Information about cluster size and speed of the cross-relaxation process is inferred from the switch dynamics.
A resonance-enhanced nonlinearity is used to demonstrate a digital switching response in a two-mode fiber interferometer constructed from ytterbium(III)-doped optical fiber. The fiber used was single-mode at the pump wavelength (980 nm) and two-moded at the signal wavelength (514 nm). Interferometer-based optical switches are generally sensitive to fluctuations in pump power, because of the sinusoidal dependence of the output state on pump power. However by allowing the doped fiber to lase, thus clamping the phase shift, this sensitivity can be eliminated to yield a bi-stable, digital switching response. In our interferometer configuration, a laser cavity was defined in the ytterbium-doped fiber by a matched pair of Bragg gratings, and the magnitude of the clamped phase shift was controlled by stretching one of the gratings to adjust the laser threshold. Digital switching of a 514 nm signal with 11 dB isolation and a power-length product of 1.3 mW.m was demonstrated. The relaxation time of the switch was determined by the ytterbium(III) excited state lifetime, while the rise time could be reduced by increasing the pump power without compromising the isolation. The clamping technique demonstrated in this paper should be applicable to any optical switch incorporating a gain medium.