Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Parametric Amplification Using Superconducting Tunnel Junctions.

H. Olsson, T. Claeson

Published Nov 18, 1988• 0 citations
Publisher

Abstract

Stable and low noise operation of a Josephson parametric amplifier has been obtained at 9GHz. Best performance was acheived in the externally pumped modes giving a double side-band noise temperature of 3±4K, a gain of 13B, and an instantaneous bandwidth of 310MHz. An operation mode that uses the internally generated Josephson oscillation as the pump source gave higher noise (-50K) due to the broad width of the pump.

DOI
10.1117/12.978330

Related papers

Low-noise self-pumped Josephson tunnel junction amplifier

Nils P. Calander, T. Claeson, S. Rudner

We have studied the parametric amplification properties of an internally pumped Josephson tunnel junction, where the shunt contained resistive and inductive components. The amplification was, in this case, limited by circuit component values to less than 8 dB at 10 GHz, but it was very stable against variations in bias conditions. The amplifier gain-bandwidth product was large and the noise level very low. We estimated the noise temperature to be less than 50 K, which should make the device attractive for mm-wave amplification.

Applied Physics Letters•Oct 15, 1981•10 citations

Arrays of Josephson tunnel junctions as parametric amplifiers

S. Wahlsten, S. Rudner, T. Claeson

Arrays of 10 or 40 series-connected small densely packed Josephson tunnel junctions were successfully operated as parametric amplifiers at 10 GHz. Between 50 and 90% of the junctions in an array were observed to work coherently in the amplification process. Signal gain exceeding 24 dB was achieved with a pump power as low as −50 to −70 dBm. A power width (i.e., the range of the pump power for a gain within 3 dB of the peak gain) of 0.25 dB and a bandwidth of 15 MHz were measured for 20-dB gain. The power width was in accordance with theory but the bandwidth was reduced, probably due to noise saturation effects. The latter effects can be reduced by lowering the input noise temperature or by including an external band limitation. The noise temperature was also increased by saturation; however, with an external bandwidth of 60 MHz, a noise temperature of 30±20 K was measured. The application of a magnetic field has proved extremely useful as a means of tuning the amplifiers to stable high-gain operating points. This tuning was also utilized in evaluating the amplifier parameters, and the theory by Feldman, Parrish, and Chiao has been verified. The upper frequency limit for a lead tunnel junction amplifier ought to be well above 300 GHz.

Journal of Applied Physics•Jul 1, 1978•60 citations

Low-noise Josephson parametric amplification and oscillations at 9 GHz

H. Olsson, T. Claeson

We have investigated the performance of a resistive rf SQUID as a 9 GHz parametric amplifier and oscillator. It was coupled to a low impedance microstrip transformer. Stable Josephson oscillations were obtained for βLQ =2eI0ZL/hf <1.1–1.8. Oscillation linewidth (830 kHz) and output power (−74 dBm) were measured. The four-photon internally pumped amplifier produced large single sideband (ssb) noise temperatures, typically around 50 K, due to the broad flanks of the pump. The best performance was achieved in the three- and four-photon externally pumped modes. Both modes gave signal gains of about 10 dB and negligible noise power contributions. A hot/cold measurement on the four-photon amplifier yielded Gdsb =13 dB (dsb=double sideband) and Tdsb =3±4 K over a bandwidth of 310 MHz. For larger values of βLQ , subharmonics 1/2 and 1/3, as well as noninteger ‘‘excitations’’ of the Josephson oscillation, were observed. The subharmonic oscillations were not tunable in frequency with unchanged linewidth. Amplification close to an excitation also produced gain but with ssb noise temperatures of ∼20 K.

Journal of Applied Physics•Nov 15, 1988•15 citations

Shunted Josephson tunnel junctions: High-frequency, self-pumped low noise amplifiers

Nils P. Calander, T. Claeson, S. Rudner

The high-frequency amplification properties of transformer coupled, resistively shunted Josephson tunnel junctions have been investigated. The importance of the shunt loop inductance is stressed. It allows a high cutoff frequency, of significance for good high-frequency performance. The self-pumped parametric amplifier showed none of the excessive noise rise, which has hitherto plagued the development of externally pumped Josephson junction amplifiers. Around 10 GHz, we estimated a noise temperature less than 30 K for an amplifier pumped by a Josephson oscillation with a frequency well above twice the signal frequency. The corresponding gain of 5 dB may be increased in a better impedance matched circuit. The gain was very stable against variations in the bias conditions. A gain-bandwidth product as high as 0.3 was registered. The experimental results agreed well with the established theory for self-pumped parametric Josephson amplifiers. It should be possible to extend the low noise amplification by this device to mm wave frequencies. A relaxation oscillation occurred at a subharmonic of the Josephson frequency when the shunt loop inductance became large. The amplification in this mode followed closely the predictions of a simple model, where the signal modulated the switching of the sawtooth-like (relatively low frequency) relaxation current. Gains of about 15 dB were measured around 10 GHz, but the amplification was sensitive to bias conditions and noisy in this case where the relaxation frequency fell well below the signal frequency. Much improved properties were registered when the inductance was decreased so that the relaxation frequency approached the Josephson frequency and exceeded twice the signal frequency. The behavior then resembled that of a Josephson mode parametric amplifier, but the high content of harmonics of a relaxation oscillation meant that the amplifier became noisier due to converted noise from the many idler frequencies.

Journal of Applied Physics•Jul 1, 1982•26 citations

Low-noise parametric amplification at 35 GHz in a single Josephson tunnel junction

J. Mygind, N. F. Pedersen, O. H. Soerensen +2 more

Parametric amplification at 35 GHz has been obtained using a single Josephson tunnel junction as the active element. The amplifier was operated in the singly quasidegenerate mode with a pump frequency at 70 GHz. The noise temperature was measured and found correlated with the gain. At the highest gain achieved, 11.6 dB, the noise temperature was 400 K. The noise temperature was reduced considerably by decreasing the gain. At 8 and 4 dB we found 165±25 K and 50±30 K, respectively.

Applied Physics Letters•Jul 1, 1979•25 citations

A low-noise series-array Josephson junction parametric amplifier

Bernard Yurke, Michael Lee Roukes, Roman Movshovich +1 more

We have obtained parametric gain at 19 GHz from a distributed Josephson junction parametric amplifier whose active gain medium consists of a series array of 1000 Josephson junctions embedded in a coplanar waveguide. When cooled to 1.7 K the amplifier provides 16 dB gain in a mode where the internally generated double sideband noise referred to input is 0.5±0.1 K. This noise is consistent with Nyquist noise generated from the losses. An instantaneous bandwidth of 125 MHz has been observed with a peak gain of 12 dB. The 3 dB compression point with a peak gain of 14.6 dB is -90.5 dB and the dynamic range is 38 dB.

Applied Physics Letters•Nov 11, 1996•66 citations
Stable and low noise operation of a Josephson parametric amplifier has been obtained at 9GHz. Best performance was acheived in the externally pumped modes giving a double side-band noise temperature of 3±4K, a gain of 13B, and an instantaneous bandwidth of 310MHz. An operation mode that uses the internally generated Josephson oscillation as the pump source gave higher noise (-50K) due to the broad width of the pump.
We have studied the parametric amplification properties of an internally pumped Josephson tunnel junction, where the shunt contained resistive and inductive components. The amplification was, in this case, limited by circuit component values to less than 8 dB at 10 GHz, but it was very stable against variations in bias conditions. The amplifier gain-bandwidth product was large and the noise level very low. We estimated the noise temperature to be less than 50 K, which should make the device attractive for mm-wave amplification.
Arrays of 10 or 40 series-connected small densely packed Josephson tunnel junctions were successfully operated as parametric amplifiers at 10 GHz. Between 50 and 90% of the junctions in an array were observed to work coherently in the amplification process. Signal gain exceeding 24 dB was achieved with a pump power as low as −50 to −70 dBm. A power width (i.e., the range of the pump power for a gain within 3 dB of the peak gain) of 0.25 dB and a bandwidth of 15 MHz were measured for 20-dB gain. The power width was in accordance with theory but the bandwidth was reduced, probably due to noise saturation effects. The latter effects can be reduced by lowering the input noise temperature or by including an external band limitation. The noise temperature was also increased by saturation; however, with an external bandwidth of 60 MHz, a noise temperature of 30±20 K was measured. The application of a magnetic field has proved extremely useful as a means of tuning the amplifiers to stable high-gain operating points. This tuning was also utilized in evaluating the amplifier parameters, and the theory by Feldman, Parrish, and Chiao has been verified. The upper frequency limit for a lead tunnel junction amplifier ought to be well above 300 GHz.
We have investigated the performance of a resistive rf SQUID as a 9 GHz parametric amplifier and oscillator. It was coupled to a low impedance microstrip transformer. Stable Josephson oscillations were obtained for βLQ =2eI0ZL/hf <1.1–1.8. Oscillation linewidth (830 kHz) and output power (−74 dBm) were measured. The four-photon internally pumped amplifier produced large single sideband (ssb) noise temperatures, typically around 50 K, due to the broad flanks of the pump. The best performance was achieved in the three- and four-photon externally pumped modes. Both modes gave signal gains of about 10 dB and negligible noise power contributions. A hot/cold measurement on the four-photon amplifier yielded Gdsb =13 dB (dsb=double sideband) and Tdsb =3±4 K over a bandwidth of 310 MHz. For larger values of βLQ , subharmonics 1/2 and 1/3, as well as noninteger ‘‘excitations’’ of the Josephson oscillation, were observed. The subharmonic oscillations were not tunable in frequency with unchanged linewidth. Amplification close to an excitation also produced gain but with ssb noise temperatures of ∼20 K.
The high-frequency amplification properties of transformer coupled, resistively shunted Josephson tunnel junctions have been investigated. The importance of the shunt loop inductance is stressed. It allows a high cutoff frequency, of significance for good high-frequency performance. The self-pumped parametric amplifier showed none of the excessive noise rise, which has hitherto plagued the development of externally pumped Josephson junction amplifiers. Around 10 GHz, we estimated a noise temperature less than 30 K for an amplifier pumped by a Josephson oscillation with a frequency well above twice the signal frequency. The corresponding gain of 5 dB may be increased in a better impedance matched circuit. The gain was very stable against variations in the bias conditions. A gain-bandwidth product as high as 0.3 was registered. The experimental results agreed well with the established theory for self-pumped parametric Josephson amplifiers. It should be possible to extend the low noise amplification by this device to mm wave frequencies. A relaxation oscillation occurred at a subharmonic of the Josephson frequency when the shunt loop inductance became large. The amplification in this mode followed closely the predictions of a simple model, where the signal modulated the switching of the sawtooth-like (relatively low frequency) relaxation current. Gains of about 15 dB were measured around 10 GHz, but the amplification was sensitive to bias conditions and noisy in this case where the relaxation frequency fell well below the signal frequency. Much improved properties were registered when the inductance was decreased so that the relaxation frequency approached the Josephson frequency and exceeded twice the signal frequency. The behavior then resembled that of a Josephson mode parametric amplifier, but the high content of harmonics of a relaxation oscillation meant that the amplifier became noisier due to converted noise from the many idler frequencies.
We have obtained parametric gain at 19 GHz from a distributed Josephson junction parametric amplifier whose active gain medium consists of a series array of 1000 Josephson junctions embedded in a coplanar waveguide. When cooled to 1.7 K the amplifier provides 16 dB gain in a mode where the internally generated double sideband noise referred to input is 0.5±0.1 K. This noise is consistent with Nyquist noise generated from the losses. An instantaneous bandwidth of 125 MHz has been observed with a peak gain of 12 dB. The 3 dB compression point with a peak gain of 14.6 dB is -90.5 dB and the dynamic range is 38 dB.