Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Express

On the balance between delay, bandwidth and signal distortion in slow light systems based on stimulated Brillouin scattering in optical fibers

Evgeny Shumakher, N. Orbach, Amir Nevet, David Dahan, G. Eisenstein

Published Jan 1, 2006• 46 citations
Publisher

Abstract

We describe systematic measurements of the gain and delay spectra in a slow light system based on stimulated Brillouin scattering in optical fibers. The measurements yield the system complex transfer function with which delays and signal distortion can be calculated for any input signal. The theoretical predictions are confirmed experimentally for single pulses as well as 50 Mb/s data streams in a system which employs pump modulation to modify the gain and delay spectra of the SBS process.

DOI
10.1364/oe.14.005877

Related papers

Delay of Broadband Signals Using Slow Light in Stimulated Brillouin Scattering With Phase-Modulated Pump

Lilin Yi, Li Zhan, Weisheng Hu +1 more

Slow light due to stimulated Brillouin scattering in fibers is a promising technique to realize all-optical data storage and synchronization. For delaying high-speed data, we demonstrate an approach to solve the problem of narrowband Brillouin gain by phase-modulating the Brillouin pump. The bit rate of the phase-modulating signal determines the Brillouin gain bandwidth. A 1.25-Gb/s nonreturn-to-zero pseudorandom binary sequence data is delayed by 520 ps with a phase-modulated pump operating at 2.5-Gb/s bit rate. We have also observed the pattern-dependent delay and distortion of the data caused by the filtering characteristics of Brillouin amplification, and we have suppressed the distortion by detuning the carrier of the signal away from the Brillouin gain peak

IEEE Photonics Technology Letters•Jan 1, 2007•46 citations

Broadening-free stimulated Brillouin scattering-based slow and fast light in optical fibers

Thomas Schneider, Andrzej Wiatrek

The manipulation of the group velocity of optical signals (slow and fast light) has many possible applications in telecommunications, sensing, nonlinear optics, and so on. The exploitation of the effect of stimulated Brillouin scattering (SBS) is of special interest for the alteration of the group velocity in optical fibers, since it just requires standard telecom equipment and low-to-moderate optical power. However, each delay in one single, low-gain SBS-based slow-light system is accompanied by a pulse broadening. This is a result of the inherent Kramers–Kronig relations among the gain, the phase change, and the accompanied group velocity. For an ideal flat gain, the phase change is nonideal, and for an ideal phase change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is adapted to the signal by broadening, the delay will be reduced. Thus the signal broadening can be reduced by several methods for one single low-gain slow-light system, but it cannot be zero. Here, we will show how a zero-broadening SBS-based slow light can be achieved with several methods. The basic idea is a reshaping of the original pulse in a second stage by saturation of the SBS system, or by the superposition of two gains. As will be shown, all of these systems show an almost ideal overall gain and phase function over the bandwidth of the pulses. Thus, SBS-based slow light with a delay bandwidth product of 1 bit and zero distortion is possible.

Optical Engineering•Aug 25, 2014•0 citations

Optimisation of optical signal delay in slow-light systems based on stimulated brillouin scattering

Ronny Henker, Thomas Schneider, Andrzej Wiatrek +4 more

Different Slow-light systems have been discussed and developed as a powerful tool to reduce the group velocity of optical signals during the last years. It has enjoyed much recent interest because of the potential system applications in optical telecommunication and information systems. Especially the nonlinear effect of stimulated Brillouin scattering (SBS) has become important for fiber based Slow-light systems. But, the SBS also has two challenges. First, the maximum time delay is limited due to the saturation of the Brillouin amplification process and second, the delay of the pulses is accompanied by pulse distortions (pulse shape broadening). For these aspects the shape of the Brillouin spectrum is of special interest. In this article a system is presented which allows the optimisation of the Brillouin spectrum. Simulations and first measurements show how the time delay can be enhanced with a simultaneous reduction of the pulse distortions.

Irish Signals and Systems Conference•Jan 1, 2008•3 citations

Theoretical analysis and experiment performance of slow-light based on stimulated Brillouin scattering (SBS)

Hongyan Zhou, Kun Hua Zhong, Ru Zhang +1 more

Slow light technology will play a key role in future all-optical communication. The slow-light technology based on stimulated Brillouin scattering has become a research highlight because of its additional advantages, such as compatibility of the devices with existing telecommunication systems, room-temperature operation, and tunable at arbitrary wavelengths. According to the propagation of a cw pulse through a Brillouin fiber amplifier, whose frequency is near the Stokes resonance, via three-wave coupling equations, both pump depletion and fiber losses taken into consideration, the principle of how slow-light effect based on stimulated Brillouin scattering produced and the mathematical expression of time delay are strictly deduced. A delay of 8 ns is obtained when the input Stokes pulse is 200ns and the SBS (stimulated Brillouin scattering) gain G is ~18 in our designed experiment of SBS slow-light system. Then the extent of transformation from pump waves to Stokes waves is measured using MATLAB numerical simulation according to the experiment dates, based on the relation between output pump light power and input pump light power and also the relation between output Stokes light power and input pump light power. And the relation between the input light power and propagation distance is discussed as well. Finally the relation between slow light pulse delay and SBS gain is also obtained.

Journal of Physics Conference Series•Feb 1, 2011•0 citations

The Brillouin gain and experiment performance based on stimulated Brillouin scattering slow light

Hongyan Zhou, Ru Zhang, Kun Hua Zhong

Slow light is generated via the gain mechanisms of nonlinear optical phenomena-- stimulated stimulated Brillouin scattering in optical fiber. Slow light is characterized in terms of Brillouin threshold, gain spectrum, Brillouin frequency shift by using optical heterodyne detection. According to the measured Brillouin frequency shift, we set our signal frequency in the gain region by manual matching method to get the maximum gain, and the gain bandwidth is broadened to 450MHz using a phrase-modulated pump. A delay of 32ns is achieved for the 500ns input signal when the gain is 15dB.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 2, 2011•0 citations

The Brillouin gain and experiment performance based on stimulated Brillouin scattering slow light

Hongyan Zhou, Ru Zhang, Kun Hua Zhong

Slow light is generated via the gain mechanisms of nonlinear optical phenomena-- stimulated stimulated Brillouin scattering in optical fiber. Slow light is characterized in terms of Brillouin threshold, gain spectrum, Brillouin frequency shift by using optical heterodyne detection. According to the measured Brillouin frequency shift, we set our signal frequency in the gain region by manual matching method to get the maximum gain, and the gain bandwidth is broadened to 450MHz using a phrase-modulated pump. A delay of 32ns is achieved for the 500ns input signal when the gain is 15dB.

Optoelectronic Materials and Devices•Jan 1, 2011•0 citations
We describe systematic measurements of the gain and delay spectra in a slow light system based on stimulated Brillouin scattering in optical fibers. The measurements yield the system complex transfer function with which delays and signal distortion can be calculated for any input signal. The theoretical predictions are confirmed experimentally for single pulses as well as 50 Mb/s data streams in a system which employs pump modulation to modify the gain and delay spectra of the SBS process.
Slow light due to stimulated Brillouin scattering in fibers is a promising technique to realize all-optical data storage and synchronization. For delaying high-speed data, we demonstrate an approach to solve the problem of narrowband Brillouin gain by phase-modulating the Brillouin pump. The bit rate of the phase-modulating signal determines the Brillouin gain bandwidth. A 1.25-Gb/s nonreturn-to-zero pseudorandom binary sequence data is delayed by 520 ps with a phase-modulated pump operating at 2.5-Gb/s bit rate. We have also observed the pattern-dependent delay and distortion of the data caused by the filtering characteristics of Brillouin amplification, and we have suppressed the distortion by detuning the carrier of the signal away from the Brillouin gain peak
The manipulation of the group velocity of optical signals (slow and fast light) has many possible applications in telecommunications, sensing, nonlinear optics, and so on. The exploitation of the effect of stimulated Brillouin scattering (SBS) is of special interest for the alteration of the group velocity in optical fibers, since it just requires standard telecom equipment and low-to-moderate optical power. However, each delay in one single, low-gain SBS-based slow-light system is accompanied by a pulse broadening. This is a result of the inherent Kramers–Kronig relations among the gain, the phase change, and the accompanied group velocity. For an ideal flat gain, the phase change is nonideal, and for an ideal phase change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is adapted to the signal by broadening, the delay will be reduced. Thus the signal broadening can be reduced by several methods for one single low-gain slow-light system, but it cannot be zero. Here, we will show how a zero-broadening SBS-based slow light can be achieved with several methods. The basic idea is a reshaping of the original pulse in a second stage by saturation of the SBS system, or by the superposition of two gains. As will be shown, all of these systems show an almost ideal overall gain and phase function over the bandwidth of the pulses. Thus, SBS-based slow light with a delay bandwidth product of 1 bit and zero distortion is possible.
Different Slow-light systems have been discussed and developed as a powerful tool to reduce the group velocity of optical signals during the last years. It has enjoyed much recent interest because of the potential system applications in optical telecommunication and information systems. Especially the nonlinear effect of stimulated Brillouin scattering (SBS) has become important for fiber based Slow-light systems. But, the SBS also has two challenges. First, the maximum time delay is limited due to the saturation of the Brillouin amplification process and second, the delay of the pulses is accompanied by pulse distortions (pulse shape broadening). For these aspects the shape of the Brillouin spectrum is of special interest. In this article a system is presented which allows the optimisation of the Brillouin spectrum. Simulations and first measurements show how the time delay can be enhanced with a simultaneous reduction of the pulse distortions.
Slow light technology will play a key role in future all-optical communication. The slow-light technology based on stimulated Brillouin scattering has become a research highlight because of its additional advantages, such as compatibility of the devices with existing telecommunication systems, room-temperature operation, and tunable at arbitrary wavelengths. According to the propagation of a cw pulse through a Brillouin fiber amplifier, whose frequency is near the Stokes resonance, via three-wave coupling equations, both pump depletion and fiber losses taken into consideration, the principle of how slow-light effect based on stimulated Brillouin scattering produced and the mathematical expression of time delay are strictly deduced. A delay of 8 ns is obtained when the input Stokes pulse is 200ns and the SBS (stimulated Brillouin scattering) gain G is ~18 in our designed experiment of SBS slow-light system. Then the extent of transformation from pump waves to Stokes waves is measured using MATLAB numerical simulation according to the experiment dates, based on the relation between output pump light power and input pump light power and also the relation between output Stokes light power and input pump light power. And the relation between the input light power and propagation distance is discussed as well. Finally the relation between slow light pulse delay and SBS gain is also obtained.
Slow light is generated via the gain mechanisms of nonlinear optical phenomena-- stimulated stimulated Brillouin scattering in optical fiber. Slow light is characterized in terms of Brillouin threshold, gain spectrum, Brillouin frequency shift by using optical heterodyne detection. According to the measured Brillouin frequency shift, we set our signal frequency in the gain region by manual matching method to get the maximum gain, and the gain bandwidth is broadened to 450MHz using a phrase-modulated pump. A delay of 32ns is achieved for the 500ns input signal when the gain is 15dB.
Slow light is generated via the gain mechanisms of nonlinear optical phenomena-- stimulated stimulated Brillouin scattering in optical fiber. Slow light is characterized in terms of Brillouin threshold, gain spectrum, Brillouin frequency shift by using optical heterodyne detection. According to the measured Brillouin frequency shift, we set our signal frequency in the gain region by manual matching method to get the maximum gain, and the gain bandwidth is broadened to 450MHz using a phrase-modulated pump. A delay of 32ns is achieved for the 500ns input signal when the gain is 15dB.