Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review A

Quantum limit on noise in a Raman amplifier

Philip R. Battle, R. C. Swanson, John L. Carlsten

Published Aug 1, 1991• 13 citations
Publisher

Abstract

Using Caves's theory on the quantum-noise limit in an amplifier, we consider the quantum limit on noise in a Raman amplifier. We show explicitly that the full quantum equations for the Raman interaction can be transformed into the general form for a quantum amplifier. In addition, we show that in the steady-state limit the Raman amplifier becomes a phase-insensitive amplifier. At this limit we find that the output signal-to-noise ratio is unity when one photon per mode is input. Thus we conclude that the Raman amplifier, in the phase-insensitive limit, will operate at the quantum-noise limit.

DOI
10.1103/physreva.44.1922

Related papers

Quantum-noise measurements of Raman amplifiers using an interferometer

R. C. Swanson, Philip R. Battle, John L. Carlsten

We have measured the quantum noise added to a signal by a Raman amplifier. This was done using a modified Mach-Zender interferometer with an amplifier placed in each leg. Quantum noise added by the amplifiers manifests itself by degrading the visibility of the ensemble-average output fringe patterns. The amount of noise added by the amplifiers is deduced from the degradation of the visibility. The experimental results are compared with both ideal, single-mode amplifier theory and Raman theory. We find that the Raman amplifier operates near the quantum limit with only a few input photons per mode required to dominate the noise added by the amplifiers.

Physical Review A•Feb 1, 1992•9 citations

Quantum limits on noise in linear amplifiers

Carlton M. Caves

How much noise does quantum mechanics require a linear amplifier to add to a signal it processes? An analysis of narrow-band amplifiers (single-mode input and output) yields a fundamental theorem for phase-insensitive linear amplifiers; it requires such an amplifier, in the limit of high gain, to add noise which, referred to the input, is at least as large as the half-quantum of zero-point fluctuations. For phase-sensitive linear amplifiers, which can respond differently to the two quadrature phases ("$cos\ensuremath{\omega}t$" and "$sin\ensuremath{\omega}t$"), the single-mode analysis yields an amplifier uncertainty principle---a lower limit on the product of the noises added to the two phases. A multimode treatment of linear amplifiers generalizes the single-mode analysis to amplifiers with nonzero bandwidth. The results for phase-insensitive amplifiers remain the same, but for phase-sensitive amplifiers there emerge bandwidth-dependent corrections to the single-mode results. Specifically, there is a bandwidth-dependent lower limit on the noise carried by one quadrature phase of a signal and a corresponding lower limit on the noise a high-gain linear amplifier must add to one quadrature phase. Particular attention is focused on developing a multimode description of signals with unequal noise in the two quadrature phases.

Physical review. D. Particles, fields, gravitation, and cosmology/Physical review. D. Particles and fields•Oct 15, 1982•1,723 citations

Raman amplifiers in a two-leg interferometer: quantum noise versus fringe visibility

R. C. Swanson, Philip R. Battle, John L. Carlsten

Quantum mechanics fundamentally requires any linear amplifier to introduce quantum noise onto the amplified signal.1 In the case of the linear Raman amplifier, the fully quantum-mechanical Raman equations give a precise prediction of how much noise is introduced.2 Understanding and testing this prediction is important not only from a practical point of view, where one might be interested in the conditions for which a signal can be amplified without distortion, but also from the fundamental point of view of understanding the quantum-mechanical Raman process. To test these predictions, we consider the specific case of a Mach-Zehnder interferometer with a Raman amplifier in each leg of the interferometer. The input signal is provided by a separate Raman generator. As the input signal is varied from a small input to a large input, the fringe visibility varies from essentially zero, indicating that the noise dominates the output pulse, to nearly unity, as the amplified input signal dominates the noise. Using the Raman equations, we find that surprisingly few photons are predicted to be necessary for the signal to dominate the noise. The present work is devoted to measuring these fringes experimentally.

Annual Meeting Optical Society of America•Jan 1, 1990•0 citations

Quantum limits on phase-preserving linear amplifiers

Carlton M. Caves, Joshua Combes, Jiang Zhang +1 more

The purpose of a phase-preserving linear amplifier is to make a small signal larger, regardless of its phase, so that it can be perceived by instruments incapable of resolving the original signal, while sacrificing as little as possible in signal-to-noise ratio. Quantum mechanics limits how well this can be done: A high-gain linear amplifier must degrade the signal-to-noise ratio; the noise added by the amplifier, when referred to the input, must be at least half a quantum at the operating frequency. This well-known quantum limit only constrains the second moments of the added noise. Here we derive the quantum constraints on the entire distribution of added noise: We show that any phase-preserving linear amplifier is equivalent to a parametric amplifier with a physical state for the ancillary mode; the noise added to the amplified field mode is distributed according to the Wigner function of the ancilla state.

arXiv:1208.5174•Physical Review A•Dec 3, 2012•109 citations

Output moments and photon statistics in fiber raman amplification

R. W. Davies, Paul Melman, Walter Nelson +2 more

The problem of output moments, photon statistics, and signal-to-noise ratio in fiber Raman amplification is considered using a master equation approach, including absorption in the signal and pump modes. In the parametric approximation for the pump, results are obtained for the output moments which can be cast in a general form derived by Loudon and Shepherd [23] for phase-insensitive quantum amplifiers and attenuators. Beyond the parametric approximation, it is shown that the output moments of the signal may be obtained through iteration from lower order moments in an approximation where signal-pump correlation is ignored. Comparison with other work is discussed.

Journal of Lightwave Technology•Jan 1, 1987•5 citations

Interferometric measurement of quantum noise in a Raman amplifier

R. C. Swanson, Philip R. Battle, John L. Carlsten

How large must the input signal to an amplifier be to dominate the quantum noise introduced during amplification? We attempt to answer this question for a Raman amplifier with an experiment that utilizes a modified Mach-Zender interferometer with an amplifier placed in each leg. The quantum noise added by the amplifiers manifests itself by degrading the visibility of the output fringes from the interferometer. Only an average of a few photons per mode were necessary to achieve good visibility.

Physical Review Letters•Jul 1, 1991•15 citations
Using Caves's theory on the quantum-noise limit in an amplifier, we consider the quantum limit on noise in a Raman amplifier. We show explicitly that the full quantum equations for the Raman interaction can be transformed into the general form for a quantum amplifier. In addition, we show that in the steady-state limit the Raman amplifier becomes a phase-insensitive amplifier. At this limit we find that the output signal-to-noise ratio is unity when one photon per mode is input. Thus we conclude that the Raman amplifier, in the phase-insensitive limit, will operate at the quantum-noise limit.
We have measured the quantum noise added to a signal by a Raman amplifier. This was done using a modified Mach-Zender interferometer with an amplifier placed in each leg. Quantum noise added by the amplifiers manifests itself by degrading the visibility of the ensemble-average output fringe patterns. The amount of noise added by the amplifiers is deduced from the degradation of the visibility. The experimental results are compared with both ideal, single-mode amplifier theory and Raman theory. We find that the Raman amplifier operates near the quantum limit with only a few input photons per mode required to dominate the noise added by the amplifiers.
How much noise does quantum mechanics require a linear amplifier to add to a signal it processes? An analysis of narrow-band amplifiers (single-mode input and output) yields a fundamental theorem for phase-insensitive linear amplifiers; it requires such an amplifier, in the limit of high gain, to add noise which, referred to the input, is at least as large as the half-quantum of zero-point fluctuations. For phase-sensitive linear amplifiers, which can respond differently to the two quadrature phases ("$cos\ensuremath{\omega}t$" and "$sin\ensuremath{\omega}t$"), the single-mode analysis yields an amplifier uncertainty principle---a lower limit on the product of the noises added to the two phases. A multimode treatment of linear amplifiers generalizes the single-mode analysis to amplifiers with nonzero bandwidth. The results for phase-insensitive amplifiers remain the same, but for phase-sensitive amplifiers there emerge bandwidth-dependent corrections to the single-mode results. Specifically, there is a bandwidth-dependent lower limit on the noise carried by one quadrature phase of a signal and a corresponding lower limit on the noise a high-gain linear amplifier must add to one quadrature phase. Particular attention is focused on developing a multimode description of signals with unequal noise in the two quadrature phases.
Quantum mechanics fundamentally requires any linear amplifier to introduce quantum noise onto the amplified signal.1 In the case of the linear Raman amplifier, the fully quantum-mechanical Raman equations give a precise prediction of how much noise is introduced.2 Understanding and testing this prediction is important not only from a practical point of view, where one might be interested in the conditions for which a signal can be amplified without distortion, but also from the fundamental point of view of understanding the quantum-mechanical Raman process. To test these predictions, we consider the specific case of a Mach-Zehnder interferometer with a Raman amplifier in each leg of the interferometer. The input signal is provided by a separate Raman generator. As the input signal is varied from a small input to a large input, the fringe visibility varies from essentially zero, indicating that the noise dominates the output pulse, to nearly unity, as the amplified input signal dominates the noise. Using the Raman equations, we find that surprisingly few photons are predicted to be necessary for the signal to dominate the noise. The present work is devoted to measuring these fringes experimentally.
The purpose of a phase-preserving linear amplifier is to make a small signal larger, regardless of its phase, so that it can be perceived by instruments incapable of resolving the original signal, while sacrificing as little as possible in signal-to-noise ratio. Quantum mechanics limits how well this can be done: A high-gain linear amplifier must degrade the signal-to-noise ratio; the noise added by the amplifier, when referred to the input, must be at least half a quantum at the operating frequency. This well-known quantum limit only constrains the second moments of the added noise. Here we derive the quantum constraints on the entire distribution of added noise: We show that any phase-preserving linear amplifier is equivalent to a parametric amplifier with a physical state for the ancillary mode; the noise added to the amplified field mode is distributed according to the Wigner function of the ancilla state.
The problem of output moments, photon statistics, and signal-to-noise ratio in fiber Raman amplification is considered using a master equation approach, including absorption in the signal and pump modes. In the parametric approximation for the pump, results are obtained for the output moments which can be cast in a general form derived by Loudon and Shepherd [23] for phase-insensitive quantum amplifiers and attenuators. Beyond the parametric approximation, it is shown that the output moments of the signal may be obtained through iteration from lower order moments in an approximation where signal-pump correlation is ignored. Comparison with other work is discussed.