We theoretically study single and two-qubit dynamics in the circuit QED architecture. We focus on the current experimental design [Wallraff et al., Nature (London) 431, 162 (2004); Schuster et al., Nature (London) 445, 515 (2007)] in which superconducting charge qubits are capacitively coupled to a single high-
Q superconducting coplanar resonator. In this system, logical gates are realized by driving the resonator with microwave fields. Advantages of this architecture are that it allows for multiqubit gates between non-nearest qubits and for the realization of gates in parallel, opening the possibility of fault-tolerant quantum computation with superconduting circuits. In this paper, we focus on one- and two-qubit gates that do not require moving away from the charge-degeneracy ``sweet spot.'' This is advantageous as it helps to increase the qubit dephasing time and does not require modification of the original circuit QED. However, these gates can, in some cases, be slower than those that do not use this constraint. Five types of two-qubit gates are discussed, these include gates based on virtual photons, real excitation of the resonator, and a gate based on the geometric phase. We also point out the importance of selection rules when working at the charge degeneracy point.
Abstract We propose a scheme for controlling the gradiometric flux qubit (GFQ) by applying an ac bias current in a circuit-QED architecture. The GFQ is insensitive to the magnetic flux fluctuations, which at the same time makes it challenging to manipulate the qubit states by an external magnetic field. In this study, we demonstrate that an ac bias current applied to the α-junction of the GFQ can control the qubit states. Further, the present scheme is robust against the charge fluctuations as well as the magnetic flux fluctuations, promising a long coherence time for quantum gate operations. We introduce a circuit-QED architecture to perform the single and two-qubit operations with a sufficiently strong coupling strength.
Superconducting circuit QED is a promising approach for building a quantum computer. In order to realise superconducting circuits at a sufficient scale for useful near-term applications, an architecture with an extensible design is required which implements good connectivity between qubits, and allows for selective readout and control of the qubits without introducing detrimental crosstalk or decoherence. This thesis describes the development of a new coaxial circuit QED architecture that fulfils this requirement of extensibility by incorporating out-of-plane wiring into the sample holder. Single-qubit unit cells consisting of a transmon qubit and readout resonator with coaxial geometries are fabricated on opposing sides of a substrate, and selective control and readout of the qubits is achieved via a capacitance to coaxial wiring built into the device enclosure. Unit cells of qubit and resonator can be arranged in a 2D array without modification of the wiring scheme. A single-qubit unit cell of this architecture is used to implement dispersive circuit QED, and a full characterisation of the Hamiltonian is performed. The device is shown to have parameters comparable to those found in other approaches, such as a coupling between qubit-resonator of ~100 MHz and a coherence time of order ~10 µs. The extension of this scheme to 2D arrays of qubits is then presented, and realizations of two-qubits gates are demonstrated with fidelities all above 87% on a four qubit device. Further evaluations are performed on multi-qubit devices, including a characterisation of the drive isolation of the mode-matched drive ports, finding values in the range of 50 dB and 30 dB for measurement and control respectively. Similarly, the cross coupling between circuits is shown to have values ~2% of the coupling within a unit cell. The effective circuit temperatures are measured, finding typical values of ~100 mK, and the techniques of spin-locking and T2 spectroscopy are employed to probe the noise environment. Finally the architecture is extended to incorporate frequency tuning of qubits with gradiometric SQUID loops by way of off-chip flux bias lines (FBLs). These lines are used to tune qubits with a signal isolation of >99%. Furthermore, the ability of these FBLs to dynamically control the qubit frequency is shown by demonstrating switching of the frequency on a nanosecond time-scale, and parametric driving over a frequency range of gigahertz.