IEEE Transactions on Circuits and Systems I Regular Papers

Reduced-Complexity Min-Sum Algorithm for Decoding LDPC Codes With Low Error-Floor

F. Angarita, Javier Valls, Vicenç Almenar, V. Torres

Published Feb 18, 2014• 72 citations

Abstract

This paper proposes a low-complexity min-sum algorithm for decoding low-density parity-check codes. It is an improved version of the single-minimum algorithm where the two-minimum calculation is replaced by one minimum calculation and a second minimum emulation. In the proposed one, variable correction factors that depend on the iteration number are introduced and the second minimum emulation is simplified, reducing by this way the decoder complexity. This proposal improves the performance of the single-minimum algorithm, approaching to the normalized min-sum performance in the water-fall region. Also, the error-floor region is analyzed for the code of the IEEE 802.3an standard showing that the trapping sets are decoded due to a slow down of the convergence of the algorithm. An error-floor free operation below BER=10-15is shown for this code by means of a field-programmable gate array (FPGA)-based hardware emulator. A layered decoder is implemented in a 90-nm CMOS technology achieving 12.8 Gbps with an area of 3.84 mm2.

DOI: 10.1109/tcsi.2014.2304660

Related papers

Hardware Implementation Analysis of Min-Sum Decoders

Rajagopal Anantharaman, Karibasappa Kwadiki, Vasundara Patel Kerehalli Shankar Rao

The objective of this work is to propose a modified Min-Sum decoding Low Density Parity Check (LDPC) algorithm and perform the hardware implementation analysis of Min-Sum, optimized Min-Sum and modified Min-Sum decoders. The Min-Sum algorithm mainly uses the process of finding the minimum and addition. Hence the number of multiplications is drastically reduced which helps in reducing the complexity of implementation. Adding an optimisation factor to the decoder increases the accuracy and reduces the number of iterations required to compute the decoded message. Hence the process of optimisation reduces the overall decoding time required. Modified Min-Sum algorithm is proposed to further improve the performance by decreasing the number of stages in the decoding process which reduces the complexity in Field Programmable Gate Array (FPGA) implementation.

Advances in Electrical and Electronic EngineeringJun 22, 20195 citations

A Second Minimum Approximation Method for Layered Min-Sum Decoding of QC-LDPC Codes

Zijian Qin, Yangcan Zhou, Zhongfeng Wang

Low-density parity-check (LDPC) codes have attracted tremendous attention for their excellent error-correction performance and inherent fitness for high-parallelism implementation. With great complexity reduction and friendly for hardware implementation, the min-sum (MS) decoding algorithm for LDPC codes gains widespread applications in practical. In the MS decoding algorithm, finding the first two minima among input variable-to-check messages is the most complex part. To further reduce the complexity of the MS decoding algorithm, an efficient single-minimum (single-min) based layered MS decoding for quasi-cyclic LDPC (QC-LDPC) codes is proposed in this paper. It is found that statistically the difference between the first minimum and second minimum increases as the decoding becomes more convergent. Accordingly, in the proposed single-min scheme, the second minimum is approximately derived based on the first minimum and an index indicating the convergence degree. Besides, some other metrics that are easily obtained are used to refine the second minimum. Simulation results show that the proposed method can significantly improve the error-correction performance and lower the average number of iterations, compared with the state-of-the-art single-min based MS decoding algorithms.

Information Communication Technologies Conference (ICTC)May 17, 20231 citation

Design and implementation of decoders for error correction in high-speed communication systems.

Joan Marc Català Pérez

This thesis is focused on the design and implementation of binary low-density parity-check (LDPC) code decoders for high-speed modern communication systems. The basic of LDPC codes and the performance and bottlenecks, in terms of complexity and hardware efficiency, of the main soft-decision and hard-decision decoding algorithms (such as Min-Sum, Optimized 2-bit Min-Sum and Reliability-based iterative Majority-Logic) are analyzed. The complexity and performance of those algorithms are improved to allow efficient hardware architectures.\n\nA new decoding algorithm called One-Minimum Min-Sum is proposed. It reduces considerably the complexity of the check node update equations of the Min-Sum algorithm. The second minimum is estimated from the first minimum value by a means of a linear approximation that allows a dynamic adjustment. The Optimized 2-bit Min-Sum algorithm is modified to initialize it with the complete LLR values and to introduce the extrinsic information in the messages sent from the variable nodes. Its variable node equation is reformulated to reduce its complexity. Both algorithms were tested for the (2048,1723) RS-based LDPC code and (16129,15372) LDPC code using an FPGA-based hardware emulator. They exhibit BER performance very close to Min-Sum algorithm and do not introduce early error-floor. \n\nIn order to show the hardware advantages of the proposed algorithms, hardware decoders were implemented in a 90 nm CMOS process and FPGA devices based on two types of architectures: full-parallel and partial-parallel one with horizontal layered schedule. The results show that the decoders are more area-time efficient than other published decoders and that the low-complexity of the Modified Optimized 2-bit Min-Sum allows the implementation of 10 Gbps decoders in current FPGA devices. \n\nFinally, a new hard-decision decoding algorithm, the Historical-Extrinsic Reliability-Based Iterative Decoder, is presented. This algorithm introduces the new idea of considering hard-decision votes as soft-decision to compute the extrinsic information of previous iterations. It is suitable for high-rate codes and improves the BER performance of the previous RBI-MLGD algorithms, with similar complexity.

Jul 7, 20170 citations

Modified min-sum decoding algorithm for LDPC codes based on classified correction

Zhong Zhou, Yunzhou Li, Xiang Chen +2 more

In this paper, a modified min-sum decoding algorithm based on classified correction is proposed for low density parity check (LDPC) codes. Different from the single correction in the normalized belief propagation (BP)-based and offset BP-based algorithms [4], the proposed algorithm utilizes two corrections for both minimum and sub-minimum magnitudes of input messages in check nodes. These two correction factors can be obtained by analyzing the offset of updated messages in check nodes between the BP and the min-sum algorithms associated with check node degree. Simulation results show that the proposed algorithm can achieve performance very close to that of the BP algorithm. Furthermore, the FPGA implementation of this algorithm can reach a throughput of 200 Mbps at BER=10-6with lower complexity and fewer resources than the BP algorithm.

International Conference on Communications and Networking in China (ChinaCom)Aug 1, 20089 citations

Improved Min-sum Algorithm with Low Complexity for Decoding LDPC Codes

Wu Ju

In order to reduce the performance loss of SMMS( Single-Minimum,Min-Sum) algorithm for decoding LDPC( LowDensity Parity-Check) codes,the ACMS( adaptive configurable Min-Sum) algorithm is proposed in this paper. Only the absolute minimum is used in this algorithm to update the check-node message and the second minimum is determined by a configurable estimation weight factor based on the iteration and a correction factor based on the number of error bits in each hard decision. Compared to the original SMMS and VWMS algorithm,the simulation result shows the proposed ACMS algorithm reduce the performance loss in general by introducing only a little additional complexity.

Video EngineeringJan 1, 20150 citations

Fast convergence algorithm for decoding of low density parity check codes

Jin Xie, Liuguo Yin, Ning Ge +1 more

Abstract: In this paper, a fast-convergence algorithm is proposed for the decoding of low-density parity-check (LDPC) codes. By putting more weight on the message update from check node to variable node in current iteration, the proposed method speeds up the decoding significantly. Simulation results show that compared with the standard layered min-sum decoding algorithm, the proposed scheme may reduce about 1/6 iteration numbers for LDPC codes used in DVB-S2, with hardware complexity overhead less than 2%. Key–Words: LDPC code, fast convergence decoding algorithm, layered decoding, min-sum algorithm, hardware implementation 1

WSEAS TRANSACTIONS on COMMUNICATIONS archiveJul 1, 20091 citation