Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review Letters

Absolute Electron-Impact Ionization Cross Section Measurements Using a Magneto-Optical Trap

R. Scott Schappe, Thad G Walker, L. W. Anderson, Chun Chia Lin

Published Jun 3, 1996• 57 citations
Publisher

Abstract

We present a new method for measuring absolute total electron-impact ionization cross sections. The technique measures fractional loss rates from a magneto-optical trap due to electron-impact ionization. The method requires only relative measurements of the number of target atoms and therefore eliminates a major source of difficulty in previous experiments. We report total ionization cross sections of Rb for electron energies from 50 to 500 eV.

DOI
10.1103/physrevlett.76.4328

Related papers

Electron Collision Cross-Sections Measured with the Use of a Magneto-Optical Trap

R. Scott Schappe, P Feng, L. W. Anderson +2 more

We present the first application of optically trapped atoms as targets for a scattering experiment. We report absolute total electron scattering cross-sections for ground-state Rb atoms in the range of 7-500 eV.

Europhysics Letters (EPL)•Feb 20, 1995•34 citations

Electron-Scattering Measurements using a Magneto-Optical Trap

Thad G Walker

Optically trapped atoms are in many ways ideal replacements for atomic beams for scattering experiments. In a typical such experiment, a particle beam ejects atoms from the trap at a rate {Gamma} = {sigma}{phi}, where {phi} is the particle flux density and {sigma} the scattering cross section. {Gamma} is easily measured from trap decay transients. Since the trapped atoms have neV kinetic energies, the method is sensitive to extremely small momentum transfers. Since the beam flux is measured, the absolute target density is not required, removing an important source of error for most atomic beam experiments. At Wisconsin the authors have integrated an electron beam with a magneto-optical trap and performed electron-scattering experiments on Rb atoms in the range of 10-1000 eV. In the first experiment they measured total cross sections for scattering from the 5s state by lowering the capture velocity of the trap below the recoil velocity of the scattered atoms. In the second experiment they isolated the total ionization cross section by operating the trap such that virtually all elastically and inelastically scattered atoms were captured by the trap. These experimental results will test new theoretical methods for calculating total and ionization cross sections. Straightforward extensions ofmore » these methods should allow similar measurements using excited-state atoms (5p, 5d) as well. The techniques should also be readily adaptable to the important case of the metastable noble gases.« less

Bulletin of the American Physical Society•May 1, 1996•0 citations

Use of trapped atoms to measure absolute photoionization cross sections

Timothy P. Dinneen, Christopher D. Wallace, Kit-Yan N. Tan +1 more

We describe a new technique for accurate measurement of absolute photoionization cross sections. By measuring the loss rateof atoms from a laser trap in the presence of ionizing light, we directly measure the photoionization rate. The only quantities requiring absolute calibration are the ionizing laser intensity and the fractional population in the relevant state. Our technique is capable of detecting extremely small ionization rates, which means that low-power cw sources can be used. We have applied this method to photoionization from the 5P(3/2) state of rubidium at wavelengths of 413 and 407 nm.The cross sections are 1.36(12) x 10(-17) and 1.25(11) x 10(-17) cm(2) , respectively.

Optics Letters•Dec 1, 1992•78 citations

Partial photoionization cross section measurement in a Rb magneto-optical trap

C. Gabbanini, F. Ceccherini, Silvia Gozzini +1 more

We report an experiment in which relative measurements of the partial photoionization cross sections are performed on trapped rubidium atoms. This experimental procedure allows us, together with recent new methods to determine the absolute total cross section, to make a complete quantitative study of the photoionization process in an atomic trap.

Journal of Physics B Atomic Molecular and Optical Physics•Sep 28, 1998•19 citations

Electron collision studies of cesium using a magneto-optical trap.

J. A. MacAskill

Experiments involving a magneto-optical trap (MOT) as the target in electron impact cross section studies were carried out. The use of a MOT allows the kinematic properties of the target atoms, and their electronic states, to be controlled via operating parameters of the MOT's lasers. A MOT is capable of saturating the excited state of a gaseous target of atoms and provides a unique opportunity to measure exotic collision processes. Measurements use a trap-loss technique to relate the loss rate of atoms from the trap due to electron interactions to a collision cross section. Total scattering cross section measurements are given for the 62S 1/2 ground state and the 62P3/2 excited state of cesium. The excited state measurement is the first measurement of its kind. Total ionization cross sections are also presented for the both the 6 2S1/2 ground state and 62P3/2 excited state. The ionization cross sections are measured by adjusting the radiation force of the MOT lasers to damp the elastic scattering component of the total cross section. The ionization cross section for the excited state is the first experimental determination of its kind. Full details of the experimental apparatus and the analysis procedure are presented. The results of this experiment are combined with other experimental data and compared to the most recent calculations.Dept. of Physics. Paper copy at Leddy Library: Theses & Major Papers - Basement, West Bldg. / Call Number: Thesis2003 .M322. Source: Dissertation Abstracts International, Volume: 64-10, Section: B, page: 4996. Adviser: J. W. McConkey. Thesis (Ph.D.)--University of Windsor (Canada), 2003.

•Oct 1, 2003•1 citation

Electron-atom collisions: From Franck-Hertz experiment to atom traps

Chang-Chun Lin

The key features of the cross sections for electron-impact excitation out of the ground levels of the rare-gas atoms are summarized and application of these cross section data is shown. This is followed by discussions of recent experiments on determination of electron-impact cross sections for excitation out of the metastable levels of He and Ar. The metastiable atom targets are produced by two different methods, i.e., hollow-cathode discharges and charge-exchange collisions of rare-gas ions with Cs atoms. The former method is simple but is limited to low electron energies because of the very small metastable concentration, whereas the latter method yields a fast target beam with predominantly metastable atoms allowing measurements up to the keV range. The measured cross sections show features very different from those of excitation out of the ground levels. Another new development in electron-atom collision is the use of atom traps for measuring ionization cross sections. The experiment is conducted by passing an electron beam pulse through magneto-optically trapped Rb atoms while the trap is momentarily turned off. Turning the trap back on immediately after the electron beam pulse recaptures the unionized atoms allowing only the ions to escape. The ionization cross section is determined bymore » measuring the electron beam current density at the trapped atom region and the fractional loss of trapped atoms due to the electron beam. This method avoids measurements of the absolute number of the target atoms and the overlap between the atomic and electron beams and therefore eliminates the major sources of uncertainty associated with the crossed-beam method for measuring ionization cross section.« less

Bulletin of the American Physical Society•May 1, 1996•0 citations
We present a new method for measuring absolute total electron-impact ionization cross sections. The technique measures fractional loss rates from a magneto-optical trap due to electron-impact ionization. The method requires only relative measurements of the number of target atoms and therefore eliminates a major source of difficulty in previous experiments. We report total ionization cross sections of Rb for electron energies from 50 to 500 eV.
Optically trapped atoms are in many ways ideal replacements for atomic beams for scattering experiments. In a typical such experiment, a particle beam ejects atoms from the trap at a rate {Gamma} = {sigma}{phi}, where {phi} is the particle flux density and {sigma} the scattering cross section. {Gamma} is easily measured from trap decay transients. Since the trapped atoms have neV kinetic energies, the method is sensitive to extremely small momentum transfers. Since the beam flux is measured, the absolute target density is not required, removing an important source of error for most atomic beam experiments. At Wisconsin the authors have integrated an electron beam with a magneto-optical trap and performed electron-scattering experiments on Rb atoms in the range of 10-1000 eV. In the first experiment they measured total cross sections for scattering from the 5s state by lowering the capture velocity of the trap below the recoil velocity of the scattered atoms. In the second experiment they isolated the total ionization cross section by operating the trap such that virtually all elastically and inelastically scattered atoms were captured by the trap. These experimental results will test new theoretical methods for calculating total and ionization cross sections. Straightforward extensions ofmore » these methods should allow similar measurements using excited-state atoms (5p, 5d) as well. The techniques should also be readily adaptable to the important case of the metastable noble gases.« less
We describe a new technique for accurate measurement of absolute photoionization cross sections. By measuring the loss rateof atoms from a laser trap in the presence of ionizing light, we directly measure the photoionization rate. The only quantities requiring absolute calibration are the ionizing laser intensity and the fractional population in the relevant state. Our technique is capable of detecting extremely small ionization rates, which means that low-power cw sources can be used. We have applied this method to photoionization from the 5P(3/2) state of rubidium at wavelengths of 413 and 407 nm.The cross sections are 1.36(12) x 10(-17) and 1.25(11) x 10(-17) cm(2) , respectively.
Experiments involving a magneto-optical trap (MOT) as the target in electron impact cross section studies were carried out. The use of a MOT allows the kinematic properties of the target atoms, and their electronic states, to be controlled via operating parameters of the MOT's lasers. A MOT is capable of saturating the excited state of a gaseous target of atoms and provides a unique opportunity to measure exotic collision processes. Measurements use a trap-loss technique to relate the loss rate of atoms from the trap due to electron interactions to a collision cross section. Total scattering cross section measurements are given for the 62S 1/2 ground state and the 62P3/2 excited state of cesium. The excited state measurement is the first measurement of its kind. Total ionization cross sections are also presented for the both the 6 2S1/2 ground state and 62P3/2 excited state. The ionization cross sections are measured by adjusting the radiation force of the MOT lasers to damp the elastic scattering component of the total cross section. The ionization cross section for the excited state is the first experimental determination of its kind. Full details of the experimental apparatus and the analysis procedure are presented. The results of this experiment are combined with other experimental data and compared to the most recent calculations.Dept. of Physics. Paper copy at Leddy Library: Theses & Major Papers - Basement, West Bldg. / Call Number: Thesis2003 .M322. Source: Dissertation Abstracts International, Volume: 64-10, Section: B, page: 4996. Adviser: J. W. McConkey. Thesis (Ph.D.)--University of Windsor (Canada), 2003.
The key features of the cross sections for electron-impact excitation out of the ground levels of the rare-gas atoms are summarized and application of these cross section data is shown. This is followed by discussions of recent experiments on determination of electron-impact cross sections for excitation out of the metastable levels of He and Ar. The metastiable atom targets are produced by two different methods, i.e., hollow-cathode discharges and charge-exchange collisions of rare-gas ions with Cs atoms. The former method is simple but is limited to low electron energies because of the very small metastable concentration, whereas the latter method yields a fast target beam with predominantly metastable atoms allowing measurements up to the keV range. The measured cross sections show features very different from those of excitation out of the ground levels. Another new development in electron-atom collision is the use of atom traps for measuring ionization cross sections. The experiment is conducted by passing an electron beam pulse through magneto-optically trapped Rb atoms while the trap is momentarily turned off. Turning the trap back on immediately after the electron beam pulse recaptures the unionized atoms allowing only the ions to escape. The ionization cross section is determined bymore » measuring the electron beam current density at the trapped atom region and the fractional loss of trapped atoms due to the electron beam. This method avoids measurements of the absolute number of the target atoms and the overlap between the atomic and electron beams and therefore eliminates the major sources of uncertainty associated with the crossed-beam method for measuring ionization cross section.« less