Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics

Enhancement of maximum time delay in one fiber segment slow light systems based on stimulated Brillouin scattering

Ronny Henker, Thomas Schneider, Markus Junker, Kai-Uwe Lauterbach, Max James Ammann, Andreas Thomas Schwarzbacher

Published May 1, 2007• 2 citations
Publisher

Abstract

An effective method to enhance the time delay in SBS-based slow-light systems by decoupling the delay from the Brillouin gain is shown. A drastic improvement of the time delay in one fiber segment was achieved.
DOI
10.1109/cleo.2007.4452358

Related papers

Investigation of fast light in long optical fibers based on stimulated Brillouin scattering

Kai-Uwe Lauterbach, Thomas Schneider, Ronny Henker +3 more

A simple method to generate a negative time delay in SBS-based fast-light systems using Brillouin gain and loss is shown. We achieved a maximum negative time delay of 32.4 ns in one long fiber segment.

Conference on Lasers and Electro-Optics•May 1, 2007•1 citation

Investigation of fast light in long optical fibers based on stimulated Brillouin scattering

Kai-Uwe Lauterbach, Thomas Schneider, Ronny Henker +3 more

A simple method to generate a negative time delay in SBS-based fast-light systems using Brillouin gain and loss is shown. We achieved a maximum negative time delay of 32.4 ns in one long fiber segment.

Quantum Electronics and Laser Science Conference•May 1, 2007•0 citations

Time delay enhancement in stimulated-Brillouin-scattering-based slow-light systems

Thomas Schneider, Markus Junker, Kai-Uwe Lauterbach

We show a simple method of time delay enhancement in slow-light systems based on the effect of stimulated Brillouin scattering. The method is based on the reduction of the absolute Brillouin gain by a loss produced by an additional pump laser. With this method we achieved pulse delays of nearly 100 ns in a standard single-mode fiber. In the presented approach the delay or acceleration of optical signals is decoupled from their amplification or attenuation, which allows the adaptation of the pulse amplitudes to the given application.

Optics Letters•Jan 10, 2007•44 citations

Optimisation of optical signal delay in slow-light systems based on stimulated brillouin scattering

Ronny Henker, Thomas Schneider, Andrzej Wiatrek +4 more

Different Slow-light systems have been discussed and developed as a powerful tool to reduce the group velocity of optical signals during the last years. It has enjoyed much recent interest because of the potential system applications in optical telecommunication and information systems. Especially the nonlinear effect of stimulated Brillouin scattering (SBS) has become important for fiber based Slow-light systems. But, the SBS also has two challenges. First, the maximum time delay is limited due to the saturation of the Brillouin amplification process and second, the delay of the pulses is accompanied by pulse distortions (pulse shape broadening). For these aspects the shape of the Brillouin spectrum is of special interest. In this article a system is presented which allows the optimisation of the Brillouin spectrum. Simulations and first measurements show how the time delay can be enhanced with a simultaneous reduction of the pulse distortions.

Irish Signals and Systems Conference•Jan 1, 2008•3 citations

Gain Enhancement in Slow-Light Systems Based on Stimulated Brillouin-Scattering with Several Short Fibers

Ronny Henker, Kai-Uwe Lauterbach, Andrzej Wiatrek +3 more

Presented is a novel system configuration of slow-light systems based on stimulated Brillouin-scattering consisting of several short fibers and a blocking of spurious backscattered spectral components for an enhancement of the gain and time delay.

Optical Fiber Communication Conference•Jan 1, 2009•1 citation

Broadening-free stimulated Brillouin scattering-based slow and fast light in optical fibers

Thomas Schneider, Andrzej Wiatrek

The manipulation of the group velocity of optical signals (slow and fast light) has many possible applications in telecommunications, sensing, nonlinear optics, and so on. The exploitation of the effect of stimulated Brillouin scattering (SBS) is of special interest for the alteration of the group velocity in optical fibers, since it just requires standard telecom equipment and low-to-moderate optical power. However, each delay in one single, low-gain SBS-based slow-light system is accompanied by a pulse broadening. This is a result of the inherent Kramers–Kronig relations among the gain, the phase change, and the accompanied group velocity. For an ideal flat gain, the phase change is nonideal, and for an ideal phase change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is adapted to the signal by broadening, the delay will be reduced. Thus the signal broadening can be reduced by several methods for one single low-gain slow-light system, but it cannot be zero. Here, we will show how a zero-broadening SBS-based slow light can be achieved with several methods. The basic idea is a reshaping of the original pulse in a second stage by saturation of the SBS system, or by the superposition of two gains. As will be shown, all of these systems show an almost ideal overall gain and phase function over the bandwidth of the pulses. Thus, SBS-based slow light with a delay bandwidth product of 1 bit and zero distortion is possible.

Optical Engineering•Aug 25, 2014•0 citations
We show a simple method of time delay enhancement in slow-light systems based on the effect of stimulated Brillouin scattering. The method is based on the reduction of the absolute Brillouin gain by a loss produced by an additional pump laser. With this method we achieved pulse delays of nearly 100 ns in a standard single-mode fiber. In the presented approach the delay or acceleration of optical signals is decoupled from their amplification or attenuation, which allows the adaptation of the pulse amplitudes to the given application.
Different Slow-light systems have been discussed and developed as a powerful tool to reduce the group velocity of optical signals during the last years. It has enjoyed much recent interest because of the potential system applications in optical telecommunication and information systems. Especially the nonlinear effect of stimulated Brillouin scattering (SBS) has become important for fiber based Slow-light systems. But, the SBS also has two challenges. First, the maximum time delay is limited due to the saturation of the Brillouin amplification process and second, the delay of the pulses is accompanied by pulse distortions (pulse shape broadening). For these aspects the shape of the Brillouin spectrum is of special interest. In this article a system is presented which allows the optimisation of the Brillouin spectrum. Simulations and first measurements show how the time delay can be enhanced with a simultaneous reduction of the pulse distortions.
The manipulation of the group velocity of optical signals (slow and fast light) has many possible applications in telecommunications, sensing, nonlinear optics, and so on. The exploitation of the effect of stimulated Brillouin scattering (SBS) is of special interest for the alteration of the group velocity in optical fibers, since it just requires standard telecom equipment and low-to-moderate optical power. However, each delay in one single, low-gain SBS-based slow-light system is accompanied by a pulse broadening. This is a result of the inherent Kramers–Kronig relations among the gain, the phase change, and the accompanied group velocity. For an ideal flat gain, the phase change is nonideal, and for an ideal phase change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is adapted to the signal by broadening, the delay will be reduced. Thus the signal broadening can be reduced by several methods for one single low-gain slow-light system, but it cannot be zero. Here, we will show how a zero-broadening SBS-based slow light can be achieved with several methods. The basic idea is a reshaping of the original pulse in a second stage by saturation of the SBS system, or by the superposition of two gains. As will be shown, all of these systems show an almost ideal overall gain and phase function over the bandwidth of the pulses. Thus, SBS-based slow light with a delay bandwidth product of 1 bit and zero distortion is possible.