Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Express

Field-quadrature and photon-number correlations produced by parametric processes

Colin J. McKinstrie, Magnus Karlsson, Z. Tong

Published Sep 1, 2010• 31 citations
Publisher

Abstract

In a previous paper [Opt. Express 13, 4986 (2005)], formulas were derived for the field-quadrature and photon-number variances produced by multiple-mode parametric processes. In this paper, formulas are derived for the quadrature and number correlations. The number formulas are used to analyze the properties of basic devices, such as two-mode amplifiers, attenuators and frequency convertors, and composite systems made from these devices, such as cascaded parametric amplifiers and communication links. Amplifiers generate idlers that are correlated with the amplified signals, or correlate pre-existing pairs of modes, whereas attenuators decorrelate pre-existing modes. Both types of device modify the signal-to-noise ratios (SNRs) of the modes on which they act. Amplifiers decrease or increase the mode SNRs, depending on whether they are operated in phase-insensitive (PI) or phase-sensitive (PS) manners, respectively, whereas attenuators always decrease these SNRs. Two-mode PS links are sequences of transmission fibers (attenuators) followed by two-mode PS amplifiers. Not only do these PS links have noise figures that are 6-dB lower than those of the corresponding PI links, they also produce idlers that are (almost) completely correlated with the signals. By detecting the signals and idlers, one can eliminate the effects of electronic noise in the detectors.

DOI
10.1364/oe.18.019792

Related papers

Higher-capacity communication links based on two-mode phase-sensitive amplifiers

Colin J. McKinstrie, Nikola Alić, Zhi Tong +1 more

Optical communication links are usually made with erbium-doped fiber amplifiers, which amplify the signal waves in a phase-insensitive (PI) manner. They can also be made with parametric fiber amplifiers, in which the signal waves interact with idler waves. If information is transmitted using only the signals, parametric amplifiers are PI and their noise figures are comparable to those of erbium amplifiers. However, transmitting correlated information in the signals and idlers, or copying the signals prior to transmission, allows parametric amplifiers to be phase-sensitive (PS), which lowers their noise figures. The information capacities of two-mode PS links exceed those of the corresponding PI links by 2 b/s-Hz.

Optics Express•Jun 6, 2011•20 citations

Quantum noise properties of parametric processes

Colin J. McKinstrie, M. Yu, M. G. Raymer +1 more

In this paper the quantum noise properties of phase-insensitive and phase-sensitive parametric processes are studied. Formulas for the field-quadrature and photon-number means and variances are derived, for processes that involve arbitrary numbers of modes. These quantities determine the signal-to-noise ratios associated with the direct and homo-dyne detection of optical signals. The consequences of the aforementioned formulas are described for frequency conversion, amplification, monitoring, and transmission through sequences of attenuators and amplifiers.

Optics Express•Jan 1, 2005•114 citations

Quadrature and number fluctuations produced by parametric devices driven by pulsed pumps

Colin J. McKinstrie, M.E. Marhic

Two sets of formulas are derived for the field-quadrature and photon-number fluctuations (variances and correlations) produced by parametric amplifiers and frequency convertors that are driven by pulsed pumps and act on pulsed signals. The first set is based on the Green functions for the underlying parametric processes, whereas the second is based on the associated Schmidt coefficients and modes. These formulas facilitate the modeling and performance optimization of parametric devices used in a wide variety of applications.

Optics Express•Aug 12, 2013•5 citations

Everything you always wanted to know about cascaded parametric amplifiers, but were afraid to ask

Colin J. McKinstrie

I will review briefly the properties of optical amplifiers and attenuators, and how they affect the information carried by signals. I will then describe in detail the properties of cascaded parametric amplifiers and transmission links, and explain why such links are signal-phase-insensitive, but have noise figures that are 6-dB lower than standard phase-insensitive links.

Optical Fiber Communication Conference•Jan 1, 2012•2 citations

Information Efficiencies of Parametric Devices

Colin J. McKinstrie, Nikola Alić

In this paper, studies are made of the information efficiencies of optical amplifiers, attenuators, and frequency convertors. Attenuators always reduce the amount of information carried by a signal. In contrast, parametric amplifiers and frequency convertors redistribute information between the signal and idler sidebands, but preserve the total information. Homodyne detection of the sideband quadratures degrades their signal-to-noise ratios. Detection always reduces the back-to-back and converted information capacities by moderate amounts, which do not depend on how the input information is encoded. The effects of detection on the amplified information capacity can be small or large, depending on how the input information is encoded. For (standard) two-sideband amplifiers, it is best to encode correlated information in both sidebands.

IEEE Journal of Selected Topics in Quantum Electronics•May 20, 2011•8 citations

Signal Processing using Nonlinear Optical Eects in Single- and Few-Mode Fibers

Søren Friis

The stagnating increase in data transmission capacity in optical communication systems combined with the ever growing demand of transmission bandwidth is leading to an impending capacity crunch, referring to the point in time after which the available bandwidth of the individual user starts to decrease. To postpone this point in time, existing technologies in terms of data transmission through optical fibers must be optimized and new degrees of freedom must be introduced to continue the exponential increase in available bandwidth; space-division multiplexing is believed to be the strongest candidate for another degree of freedom in transmission fibers. This thesis is two-fold: firstly, starting at Maxwell’s equations and basic principles of quantum mechanics, a semi-classical model of the noise properties of fiber optical parametric amplifiers and frequency converters is presented. The model accounts for multiple effects present in nonlinear fibers such as four-wave mixing, Raman scattering, distributed loss, and dispersion, and it is valid in the depleted pump regime. After validating the model against well-known results of quantum models, the model is used to predict the impacts of Raman noise, loss, and pump depletion on the noise properties of parametric frequency conversion and phase-insensitive and phase-sensitive parametric amplification. An important part of realizing space-division multiplexing is the ability of optical signal processing so the second part of this thesis addresses few-mode Raman fiber amplifiers and parametric amplifiers and frequency converters. A model of weak random linear mode coupling in the pump of a two-mode distributed Raman fiber amplifier is presented and it is shown that an amplification noise figure induced by mode coupling increases with the degree of mode coupling and that this tendency increases as the pump depletes. Also, a very low mode-dependent gain of 0.25 dB per 10 dB gain is experimentally demonstrated in a two-mode distributed Raman fiber amplifier by exciting the pump in a combination of two modes. A comprehensive model of four-wave mixing in two-mode fibers acvi counting for six simultaneous processes is derived, and the conversion efficiency from signal to idler in the four-wave mixing processes of phase conjugation and Bragg scattering in two two-mode fibers with different phase matching properties are experimentally investigated. A conversion efficiency of > −2.70 dB is demonstrated for Bragg scattering in the conversion of a signal in the LP01-mode to the idler in the LP11-mode; the signal-to-idler separation is ∼ 25 nm. Good qualitative agreement between experiments and theory is found for both processes in both fibers.

•Jan 1, 2016•0 citations
In a previous paper [Opt. Express 13, 4986 (2005)], formulas were derived for the field-quadrature and photon-number variances produced by multiple-mode parametric processes. In this paper, formulas are derived for the quadrature and number correlations. The number formulas are used to analyze the properties of basic devices, such as two-mode amplifiers, attenuators and frequency convertors, and composite systems made from these devices, such as cascaded parametric amplifiers and communication links. Amplifiers generate idlers that are correlated with the amplified signals, or correlate pre-existing pairs of modes, whereas attenuators decorrelate pre-existing modes. Both types of device modify the signal-to-noise ratios (SNRs) of the modes on which they act. Amplifiers decrease or increase the mode SNRs, depending on whether they are operated in phase-insensitive (PI) or phase-sensitive (PS) manners, respectively, whereas attenuators always decrease these SNRs. Two-mode PS links are sequences of transmission fibers (attenuators) followed by two-mode PS amplifiers. Not only do these PS links have noise figures that are 6-dB lower than those of the corresponding PI links, they also produce idlers that are (almost) completely correlated with the signals. By detecting the signals and idlers, one can eliminate the effects of electronic noise in the detectors.
Optical communication links are usually made with erbium-doped fiber amplifiers, which amplify the signal waves in a phase-insensitive (PI) manner. They can also be made with parametric fiber amplifiers, in which the signal waves interact with idler waves. If information is transmitted using only the signals, parametric amplifiers are PI and their noise figures are comparable to those of erbium amplifiers. However, transmitting correlated information in the signals and idlers, or copying the signals prior to transmission, allows parametric amplifiers to be phase-sensitive (PS), which lowers their noise figures. The information capacities of two-mode PS links exceed those of the corresponding PI links by 2 b/s-Hz.
In this paper the quantum noise properties of phase-insensitive and phase-sensitive parametric processes are studied. Formulas for the field-quadrature and photon-number means and variances are derived, for processes that involve arbitrary numbers of modes. These quantities determine the signal-to-noise ratios associated with the direct and homo-dyne detection of optical signals. The consequences of the aforementioned formulas are described for frequency conversion, amplification, monitoring, and transmission through sequences of attenuators and amplifiers.
Two sets of formulas are derived for the field-quadrature and photon-number fluctuations (variances and correlations) produced by parametric amplifiers and frequency convertors that are driven by pulsed pumps and act on pulsed signals. The first set is based on the Green functions for the underlying parametric processes, whereas the second is based on the associated Schmidt coefficients and modes. These formulas facilitate the modeling and performance optimization of parametric devices used in a wide variety of applications.
In this paper, studies are made of the information efficiencies of optical amplifiers, attenuators, and frequency convertors. Attenuators always reduce the amount of information carried by a signal. In contrast, parametric amplifiers and frequency convertors redistribute information between the signal and idler sidebands, but preserve the total information. Homodyne detection of the sideband quadratures degrades their signal-to-noise ratios. Detection always reduces the back-to-back and converted information capacities by moderate amounts, which do not depend on how the input information is encoded. The effects of detection on the amplified information capacity can be small or large, depending on how the input information is encoded. For (standard) two-sideband amplifiers, it is best to encode correlated information in both sidebands.
The stagnating increase in data transmission capacity in optical communication systems combined with the ever growing demand of transmission bandwidth is leading to an impending capacity crunch, referring to the point in time after which the available bandwidth of the individual user starts to decrease. To postpone this point in time, existing technologies in terms of data transmission through optical fibers must be optimized and new degrees of freedom must be introduced to continue the exponential increase in available bandwidth; space-division multiplexing is believed to be the strongest candidate for another degree of freedom in transmission fibers. This thesis is two-fold: firstly, starting at Maxwell’s equations and basic principles of quantum mechanics, a semi-classical model of the noise properties of fiber optical parametric amplifiers and frequency converters is presented. The model accounts for multiple effects present in nonlinear fibers such as four-wave mixing, Raman scattering, distributed loss, and dispersion, and it is valid in the depleted pump regime. After validating the model against well-known results of quantum models, the model is used to predict the impacts of Raman noise, loss, and pump depletion on the noise properties of parametric frequency conversion and phase-insensitive and phase-sensitive parametric amplification. An important part of realizing space-division multiplexing is the ability of optical signal processing so the second part of this thesis addresses few-mode Raman fiber amplifiers and parametric amplifiers and frequency converters. A model of weak random linear mode coupling in the pump of a two-mode distributed Raman fiber amplifier is presented and it is shown that an amplification noise figure induced by mode coupling increases with the degree of mode coupling and that this tendency increases as the pump depletes. Also, a very low mode-dependent gain of 0.25 dB per 10 dB gain is experimentally demonstrated in a two-mode distributed Raman fiber amplifier by exciting the pump in a combination of two modes. A comprehensive model of four-wave mixing in two-mode fibers acvi counting for six simultaneous processes is derived, and the conversion efficiency from signal to idler in the four-wave mixing processes of phase conjugation and Bragg scattering in two two-mode fibers with different phase matching properties are experimentally investigated. A conversion efficiency of > −2.70 dB is demonstrated for Bragg scattering in the conversion of a signal in the LP01-mode to the idler in the LP11-mode; the signal-to-idler separation is ∼ 25 nm. Good qualitative agreement between experiments and theory is found for both processes in both fibers.