Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Frontiers in Optics

High Resolution Optical Time-Domain Reflectometry using Superconducting Single-Photon Detectors

Olga V. Minaeva, Andrew M. Fraine, Alexander A. Korneev, Alexander V. Divochiy, Gregory N Gol'tsman, Alexander V. Sergienko

Published Jan 1, 2012• 3 citations
Publisher

Abstract

We discuss the advantages and limitations of single-photon optical time-domain reflectometry with superconducting single-photon detectors. The higher two-point resolution can be achieved due to superior timing performance of SSPDs in comparison with InGaAs APDs.
DOI
10.1364/fio.2012.fw3a.39

Related papers

Optical time domain reflectometry with low noise waveguide-coupled superconducting nanowire single-photon detectors

Carsten Schuck, Wolfram H. P. Pernice, Xiao‐Song Ma +1 more

We demonstrate optical time domain reflectometry over 200 km of optical fiber using low-noise NbTiN superconducting single-photon detectors integrated with Si3N4 waveguides. Our small detector footprint enables high timing resolution of 50 ps and a dark count rate of 3 Hz with unshielded fibers, allowing for identification of defects along the fiber over a dynamic range of 37.4 dB. Photons scattered and reflected back from the fiber under test can be detected in free-running mode without showing dead zones or other impairments often encountered in semiconductor photon-counting optical time domain reflectometers.

arXiv:1305.7000•Applied Physics Letters•May 13, 2013•41 citations

Spectroscopy With Nanostructured Superconducting Single Photon Detectors

Elisabeth Reiger, Dong Pan, Wojtek Slysz +10 more

Superconducting single-photon detectors (SSPDs) are nanostructured devices made from ultrathin superconducting films. They are typically operated at liquid helium temperature and exhibit high detection efficiency, in combination with very low dark counts, fast response time, and extremely low timing jitter, within a broad wavelength range from ultraviolet to mid-infrared (up to 6mum). SSPDs are very attractive for applications such as fiber-based telecommunication, where single-photon sensitivity and high photon-counting rates are required. We review the current state-of-the-art in the SSPD research and development, and compare the SSPD performance to the best semiconducting avalanche photodiodes and other superconducting photon detectors. Furthermore, we demonstrate that SSPDs can also be successfully implemented in photon-energy-resolving experiments. Our approach is based on the fact that the size of the hotspot, a nonsuperconducting region generated upon photon absorption, is linearly dependent on the photon energy. We introduce a statistical method, where, by measuring the SSPD system detection efficiency at different bias currents, we are able to resolve the wavelength of the incident photons with a resolution of 50 nm.

IEEE Journal of Selected Topics in Quantum Electronics•Jul 1, 2007•29 citations

Single-photonics at telecom wavelengths using nanowire superconducting single photon detectors

C. Zinoni, Blandine Alloing, Lianhe H. Li +7 more

Novel single-photon detectors based on NbN superconducting nanostructures promise orders-of-magnitude improvement over InGaAs APDs. We demonstrate this improved performance for the first time by measuring the g(2)(τ) on single photon states produced by a quantum dot at telecom wavelength.

Quantum Electronics and Laser Science Conference•May 1, 2007•1 citation

Superconducting single-photon detectors based on ultrathin NbTiN films

Stephan Steinhauer, Samuel Gyger, Bruno Lopez-Rodriguez +5 more

Superconducting single-photon detectors (SSPDs) have developed into a mature device technology and excel due outstanding performance metrics, in particular high detection efficiency combined with high time resolution and low dark count rate for a wide wavelength range from the visible to the mid-infrared. In addition to commercially available systems with devices coupled to optical fibers, SSPDs can be integrated with photonic circuits using scalable nanofabrication technologies. Here, we will present recent progress on SSPDs based on NbTiN thin films and their integration on different photonic material platforms. Our process for NbTiN growth at room temperature will be described, using magnetron reactive co-sputtering to achieve high-quality superconducting layers down to thicknesses of few nanometres. Optimized SSPD devices are realized by tuning the superconducting properties of NbTiN thin films, adjusting the material composition and nanocrystalline structure. The realization of different types of detectors and geometries will be shown, including nanofabrication techniques for achieving fully suspended nanowire structures. Furthermore, we will discuss challenges and prospects for scaling-up SSPD device technology as well as detector systems. Multiplexing schemes such as dispersion engineering of superconducting transmission lines will be highlighted as powerful approach to address multiple detectors and reduce the number of required feedthroughs and electrical lines in the cryostat. Eventually, exemplary applications of SSPDs for photon counting in quantum optics and light detection and ranging (LIDAR) will be outlined.

Quantum Optics and Photon Counting•Apr 14, 2021•0 citations

Superconducting single photon detectors for ultrasensitive visible and IR detection

R. Espiau de Lamaëstre, L. Maingault, Laurent Frey +5 more

Superconducting single photons detectors (SSPDs) have emerged in recent years as a promising alternative for fast and sensitive infrared detectors working in the photon counting mode. In particular, those detectors combine very low dark count rates (below 1 Hz), high speed (above 1 GHz), photon number resolution and reasonable quantum efficiency (10% at telecom wavelengths). They already found applications in quantum cryptography systems and integrated circuit failure analysis, but could also be used as ultimate sensors in matrix configurations. We show here the optimization of SSPD fabrication and their optical metrology at CEA. SSPD are fabricated by patterning a 80 nm wide nanowire in a very thin (4 nm) NbN film on sapphire, forming a pixel of several microns size. A cryogenic all-fibered optoelectronic system has been developed and allows precise metrology of the optical performances of SSPD. When biasing near the critical current of the nanowire, we demonstrate a detection quantum efficiency of 8% at 1.55 µm, which is also found to be strongly polarization dependent. This quantum efficiency being limited by optical absorption, we propose a prism coupling based absorption enhancing structure that allows reaching 100% quantum efficiency.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jan 22, 2009•3 citations

Single photon detectors using superconductors for quantum information and communications

Sae Woo Nam

Because of the possibility of high efficiency and high rate detection of single photons with low dark counts, there is increasing interest in using superconducting optical photon detectors in a variety of applications in quantum information science and technology. I will describe our work on two types of superconducting detectors, the Superconducting Single Photon Detector (SSPD) and superconducting Transition-Edge Sensor (TES).

Frontiers in Optics•Jan 1, 2008•0 citations
We demonstrate optical time domain reflectometry over 200 km of optical fiber using low-noise NbTiN superconducting single-photon detectors integrated with Si3N4 waveguides. Our small detector footprint enables high timing resolution of 50 ps and a dark count rate of 3 Hz with unshielded fibers, allowing for identification of defects along the fiber over a dynamic range of 37.4 dB. Photons scattered and reflected back from the fiber under test can be detected in free-running mode without showing dead zones or other impairments often encountered in semiconductor photon-counting optical time domain reflectometers.
Superconducting single-photon detectors (SSPDs) are nanostructured devices made from ultrathin superconducting films. They are typically operated at liquid helium temperature and exhibit high detection efficiency, in combination with very low dark counts, fast response time, and extremely low timing jitter, within a broad wavelength range from ultraviolet to mid-infrared (up to 6mum). SSPDs are very attractive for applications such as fiber-based telecommunication, where single-photon sensitivity and high photon-counting rates are required. We review the current state-of-the-art in the SSPD research and development, and compare the SSPD performance to the best semiconducting avalanche photodiodes and other superconducting photon detectors. Furthermore, we demonstrate that SSPDs can also be successfully implemented in photon-energy-resolving experiments. Our approach is based on the fact that the size of the hotspot, a nonsuperconducting region generated upon photon absorption, is linearly dependent on the photon energy. We introduce a statistical method, where, by measuring the SSPD system detection efficiency at different bias currents, we are able to resolve the wavelength of the incident photons with a resolution of 50 nm.
Superconducting single-photon detectors (SSPDs) have developed into a mature device technology and excel due outstanding performance metrics, in particular high detection efficiency combined with high time resolution and low dark count rate for a wide wavelength range from the visible to the mid-infrared. In addition to commercially available systems with devices coupled to optical fibers, SSPDs can be integrated with photonic circuits using scalable nanofabrication technologies. Here, we will present recent progress on SSPDs based on NbTiN thin films and their integration on different photonic material platforms. Our process for NbTiN growth at room temperature will be described, using magnetron reactive co-sputtering to achieve high-quality superconducting layers down to thicknesses of few nanometres. Optimized SSPD devices are realized by tuning the superconducting properties of NbTiN thin films, adjusting the material composition and nanocrystalline structure. The realization of different types of detectors and geometries will be shown, including nanofabrication techniques for achieving fully suspended nanowire structures. Furthermore, we will discuss challenges and prospects for scaling-up SSPD device technology as well as detector systems. Multiplexing schemes such as dispersion engineering of superconducting transmission lines will be highlighted as powerful approach to address multiple detectors and reduce the number of required feedthroughs and electrical lines in the cryostat. Eventually, exemplary applications of SSPDs for photon counting in quantum optics and light detection and ranging (LIDAR) will be outlined.
Superconducting single photons detectors (SSPDs) have emerged in recent years as a promising alternative for fast and sensitive infrared detectors working in the photon counting mode. In particular, those detectors combine very low dark count rates (below 1 Hz), high speed (above 1 GHz), photon number resolution and reasonable quantum efficiency (10% at telecom wavelengths). They already found applications in quantum cryptography systems and integrated circuit failure analysis, but could also be used as ultimate sensors in matrix configurations. We show here the optimization of SSPD fabrication and their optical metrology at CEA. SSPD are fabricated by patterning a 80 nm wide nanowire in a very thin (4 nm) NbN film on sapphire, forming a pixel of several microns size. A cryogenic all-fibered optoelectronic system has been developed and allows precise metrology of the optical performances of SSPD. When biasing near the critical current of the nanowire, we demonstrate a detection quantum efficiency of 8% at 1.55 µm, which is also found to be strongly polarization dependent. This quantum efficiency being limited by optical absorption, we propose a prism coupling based absorption enhancing structure that allows reaching 100% quantum efficiency.