Gain and noise properties of a non-degenerate one-frequency parametric amplifier using a self-pumped Josephson junction are investigated both theoretically and experimentally. The amplifier uses the phenomenon of microwave negative resistance of the junction. Theoretical analysis made in usual resistively shunted junction (RSJ) model shows that the minimum noise temperature is equal to approximately 42T. It takes place at a signal frequency f close to the junction characteristic frequency f0. Maximum effectivity (the product of the square root of power gain and relative bandwidth) can reach 0.4 at f≃f0. Gain up to 20 dB was obtained at X-band using amplifier with Nb-Ta point-contact junction. Minimum noise temperature at T = 4.2K was about 200K.
Gain and noise properties of a non-degenerate one-frequency parametric amplifier using a self-pumped Josephson junction are investigated both theoretically and experimentally. The amplifier uses the phenomenon of microwave negative resistance of the junction. Theoretical analysis made in usual resistively shunted junction (RSJ) model shows that the minimum noise temperature is equal to approximately 42T. It takes place at a signal frequency f close to the junction characteristic frequency f0. Maximum effectivity (the product of the square root of power gain and relative bandwidth) can reach 0.4 at f≃f0. Gain up to 20 dB was obtained at X-band using amplifier with Nb-Ta point-contact junction. Minimum noise temperature at T = 4.2K was about 200K.
The high-frequency amplification properties of transformer coupled, resistively shunted Josephson tunnel junctions have been investigated. The importance of the shunt loop inductance is stressed. It allows a high cutoff frequency, of significance for good high-frequency performance. The self-pumped parametric amplifier showed none of the excessive noise rise, which has hitherto plagued the development of externally pumped Josephson junction amplifiers. Around 10 GHz, we estimated a noise temperature less than 30 K for an amplifier pumped by a Josephson oscillation with a frequency well above twice the signal frequency. The corresponding gain of 5 dB may be increased in a better impedance matched circuit. The gain was very stable against variations in the bias conditions. A gain-bandwidth product as high as 0.3 was registered. The experimental results agreed well with the established theory for self-pumped parametric Josephson amplifiers. It should be possible to extend the low noise amplification by this device to mm wave frequencies. A relaxation oscillation occurred at a subharmonic of the Josephson frequency when the shunt loop inductance became large. The amplification in this mode followed closely the predictions of a simple model, where the signal modulated the switching of the sawtooth-like (relatively low frequency) relaxation current. Gains of about 15 dB were measured around 10 GHz, but the amplification was sensitive to bias conditions and noisy in this case where the relaxation frequency fell well below the signal frequency. Much improved properties were registered when the inductance was decreased so that the relaxation frequency approached the Josephson frequency and exceeded twice the signal frequency. The behavior then resembled that of a Josephson mode parametric amplifier, but the high content of harmonics of a relaxation oscillation meant that the amplifier became noisier due to converted noise from the many idler frequencies.
The signal and noise properties of two basic types of externally pumped parametric amplifiers, using Josephson junctions with low capacitance, are calculated. The first type is a single- frequency nondegenerate amplifier and second one is a two-frequency degenerate amplifier, referred to sometimes as SUPARAMP. Calculations are based on the conventional RSJ model of the Josephson junction. In contrast to the works published earlier, the most realistic open circuit approximation is used for idler combinational frequencies, as well as for the pumping frequency harmonics. A single-frequency amplifier is shown to have relatively low noise temperatures (T_{N} \approx 25T) at signal frequencies of the order of the Josephson junction characteristic frequency ωc. On the other hand, SUPARAMP can have much lower noise but at lower frequencies, and it behaves approximately as a usual parametric amplifier with a critical frequency\omega_{cr} \approx 0.2 \omega_{c}.
Crossover between thermal and quantum noise in the externally-pumped Josephson-junction parametric amplifiers is theoretically followed. Two different approaches are used for the analysis : i. Josephson junction is replaced with its RSJ model with the equilibrium source of fluctuations; ii. microscopic theory of the tunnel junctions is used, which takes into account not only thermal and quantum but also shot noise. Because of inconvenience of the noise temperature TNfor the amplifier sensitivity characterization in the quantum limit, we express our results in terms of the figure ΘNwhich is essentially the amplifier output noise energy, reduced to its input (in the classical limit,\Theta_{N}=k_{B}T_{N}). For the nondegenerate amplifier, the minimum value of ΘN. equals hω/2 and is due to quantum noise (zero-point oscillations) in the idle-frequency resonator of the amplifier. For the degenerate amplifier, sensitive to only one quadrature component of the input signal, ΘNcan be made much less than the above "quantum limit" even at operation temperatures much higher thanh\omega/k_{B}, if the Josephson junction characteristic frequency ωcis high enough,h\omega_{c}\gsimk_{B}T. Our analysis of the experimental situatlon shows that the values\Theta_{N}<h\omega/2can be achieved using two-dimensional arrays of a large number (N\simeq100) single-tunnel-junction interferometers with low inductances, inductively coupled to a microwave cavity.
We report the lowest noise temperature of any microwave amplifier except the maser. This amplifier is a nearly degenerate superconducting parametric amplifier at X-band consisting of a low β, thin film, single junction SQUID, a monolithic 50 Ω to 1 Ω impedance matching network, and a cooled circulator. Nb/Nb2O5/Pb alloy junctions were incorporated into Nb and Pb-in circuitry on 1×2 cm silicon chips. The SQUID was phase-biased near 90° and driven by an external pump at approximately twice the operating frequency. The self-resonance frequency of the SQUID inductance and junction capacitance was set at the operating frequency of 8.2GHz. The operating charac teristics depended on the pump amplitude, the junction phase bias, and the SQUID parameters. For small values of\beta < 1, the maximum gain in both the signal and idler channels was ≈10dB, the bandwidth = 170MHz, and the single-sidehand noise temperature was 6K with an uncertainty of (+15 to -7)K. For higher β, the gain increased to nearly 30dB with increased noise and parametric oscillations occurring near the pump subharmonic frequency.
We have studied the parametric amplification properties of an internally pumped Josephson tunnel junction, where the shunt contained resistive and inductive components. The amplification was, in this case, limited by circuit component values to less than 8 dB at 10 GHz, but it was very stable against variations in bias conditions. The amplifier gain-bandwidth product was large and the noise level very low. We estimated the noise temperature to be less than 50 K, which should make the device attractive for mm-wave amplification.
The parametric nature of supercurrent in Josephson junctions may be exploited for amplification of high frequency signals in several modes of operation, where in each case the reactance variation is provided by the internal oscillations due to the average contact potential, a)One mode is negative resistance amplification with a single idler. This mode is entirely equivalent to that generally employed in conventional parametric amplifiers with varactor diodes. b)Negative resistance amplification with several idlers at further combination frequencies. This mode of operation is typical for the resistively shunted junction model, c)Amplification by upconversion, which is conceptually employed in the rf SQUID used in magnetometry. Experimental verifications of these various modes are described and their suitability for low noise amplification discussed. The upconverter experiment permitted the measurement of device noise by variation of the temperature of the input termination. An upper noise limit of 15°K is established. This experiment demonstrates that in high frequency application of active self-oscillating Josephson junctions the fundamental noise achievable is not greatly in excess of the thermal limit.