This paper presents the concept and implementation of a Braided Single-stage Protocol for quantum secure communication. The braided single-stage protocol is a multi-photon tolerant secure protocol. This multi-photon tolerant protocol has been implemented in the laboratory using free-space optics technology. The proposed protocol capitalizes on strengths of the three-stage protocol and extends it with a new concept of braiding. This protocol overcomes the limitations associated with the three-stage protocol in the following ways: It uses the transmission channel only once as opposed to three times in the three-stage protocol, and it is invulnerable to man-in-the-middle attack. This paper also presents the error analysis resulting from the misalignment of the devices in the implementation. The experimental results validate the efficient use of transmission resources and improvement in the data transfer rate.
This paper presents the concept and implementation of a Braided Single-stage Protocol for quantum secure communication. The braided single-stage protocol is a multi-photon tolerant secure protocol. This multi-photon tolerant protocol has been implemented in the laboratory using free-space optics technology. The proposed protocol capitalizes on strengths of the three-stage protocol and extends it with a new concept of braiding. This protocol overcomes the limitations associated with the three-stage protocol in the following ways: It uses the transmission channel only once as opposed to three times in the three-stage protocol, and it is invulnerable to man-in-the-middle attack. This paper also presents the error analysis resulting from the misalignment of the devices in the implementation. The experimental results validate the efficient use of transmission resources and improvement in the data transfer rate.
This paper presents an investigation of practical quantum secure communication using multi-photon tolerant protocols. Multi-photon tolerant protocols loosen the limit on the number of photons imposed by currently used quantum key distribution protocols. The multi-photon tolerant protocols investigated in this paper are multi-stage protocols that do not require any prior agreement between a sender Alice and a receiver Bob. The security of such protocols stems from the fact that the optimal detection strategies between the legitimate users and the eavesdropper are asymmetrical, allowing Bob to obtain measurement results deterministically while imposing unavoidable quantum noise to the eavesdropper Eve's measurement. Multi-photon tolerant protocols are based on the use of transformations known only to the communicating party applying them i.e. either Alice or Bob. In this paper multi-photon tolerant protocols are used in order to share a key or a message between a sender Alice and a receiver Bob. Thus such protocols can be either used as quantum key distribution (QKD) protocols or quantum communication protocols. In addition, multi-stage protocols can be used to share a key between Alice and Bob, followed by the shared key used as a seed key to a single-stage protocol, called the braiding concept. This paper presents a practical study of multi-photon tolerant multi-stage protocols. Security aspects as well as challenges to the practical implementation are discussed. In addition, secret raw key generation rates are calculated with respect to both losses and distances over a fiber optical channel. It is well-known that raw key generation rates decreases with the increase in channel losses and distances. In this paper, coherent non-decoying quantum states are used to transfer the encoded bits from Alice to Bob. Raw key generation rates are calculated for different average photon numbers µ and compared with the case of µ=0.1, which is the average number of photons used in most single-photon based QKD protocols. Furthermore, an optimal average number of photons to be used within the secure region of the multi-photon tolerant protocols is calculated. It is worth noting that, with the increased key generation rates and distances of communication offered by the multi-photon tolerant protocols, quantum secure communication need not be restricted to quantum key distribution; it can be elevated to attain direct quantum secure communication.
This paper proposes a quantum secure communication protocol using multiple photons to represent each bit of a message to be shared. The multi-photon tolerant approach to quantum cryptography provides a quantum level security while using more than a single photon per transmission. The protocol proposed is a multi-stage protocol; an explanation of its operation and implementation are provided. The multi-stage protocol is based on the use of unitary transformations known only to Alice and Bob. This paper studies the security aspects of the multi-stage protocol by assessing its vulnerability to different attacks. It is well known that as the number of photons increases, the level of vulnerability of the multi-stage protocol increases. This paper sets a limit on the number of photons that can be used while keeping the multi-stage protocol a multi-photon tolerant quantum secure method for communication. The analysis of the number of photons to be used is based on the probability of success of a Helstrom discrimination done by an eavesdropper on the channel. Limiting the number of photons up to certain threshold per stage makes it impossible for an eavesdropper to decipher the message sent over the channel. The proposed protocol obviates the disadvantages associated with single photon implementations, such as limited data rates and distances along with the need to have no more than a single photon per time slot. The multi-stage protocol is a step toward direct quantum communication rather than quantum key distribution associated with single photon approaches.
In order to mitigate the problem of low transmission rate and limited communication distance in Quantum Communication (QCs), multiphoton over multi-stages approach has been proven to be a possible alternative to the conventional single photon approach. Multiphoton has the ability to improve the range of distances and key generation rate over multi-stages photon transmission. However, the determination of optimal mean photon numbers and number of stages in multiphoton approach remains a key challenge to make the protocols well utilized during their operations. Following this concern, three problems and their corresponding proposed solutions in this thesis are presented below: Firstly, the existing multiphoton approaches involve multiple photons to travel throughout a number of stage. Furthermore, extra time is required to update the polarization angle of optical device for encoding purposes. These conditions would result in an increase in the total transmission time of the photons to be transmitted over the quantum channel. Accordingly, a Hybrid M-Ary in Braided Single-Stage (HMBSS) approach by utilizing data compression concept is proposed to address these issues. In HMBSS, the sender is able to compress the secret message using Huffman encoding over the braided single-stage operation. This compression mechanism has reduced the number of bits required to represent a string of symbols, thereby reducing the time to encode the photons. The simulation experiments shows that HMBSS achieved promising result by 75.9% and 91.7% total average transmission time decrease as compared to the well-known Multiphoton-BSS, Multiphoton-M-ary and Multiphoton-TSIV. Secondly, providing strong authentication is the main focus in this research which aims to make multiphoton QC secure against variety types of attacks. Current authentication procedure in multiphoton QC requires public agreement to pre-share the authentication key and secret angles before onset of the transmission, therefore increasing the communication cost. As a solution, a Secure Secret Authentication Key (SSAK) is proposed. In SSAK, the quantum handshake scheme is used to share initial secret polarization angle and authentication key which is utilized before quantum communication session. The results of simulation experiments reveal that SSAK significantly outperformed the Three-stage protocol in terms of average covered angle by Eve. The simulation experiments and security analysis of initial authentication and transmission of messages verified that an eavesdropper is unable to disclose any information about the transmitted message or the authentication key. Lastly, most of the proposed QKD protocol employs a single-beam set up to transmit the photons over the free space optic which results in low bit rate and limited distance coverage due to high impact of geometrical loss. To deal with this, a transmission technique of Multiphoton Quantum Communication using multiple beam concept (MQC-MB) is proposed. Comparison is conducted in terms of total loss and received power on different number of beam shows that 4-beam is acceptable to be adapted in MQC-MB. The statistical analysis shows that such approach has reduced the total attenuation by 6dB compared to single-beam setup.
This dissertation presents a study of the security and performance of a quantum communication system using multi-stage multi-photon tolerant protocols. Multi-stage protocols are a generalization of the three-stage protocol proposed in 2006 by Subhash Kak. Multi-stage protocols use “Polarization Hopping,” which is the process of changing the polarization state at each stage of transmission. During the execution of a multi-stage protocol, the message transfer always starts by encoding a bit of information in a polarization state; for example, bit 0 is encoded using state |0⟩ and bit 1 is encoded using state|1⟩ whereas, on the channel, the state of polarization is given by α|├ 0⟩┤+β|├ 1⟩┤. In the following α and β are restricted to the real numbers i.e., the polarization stays on the equator of the Poincare sphere. A transformation applied by one communicating party at a given stage will result in new values of α and β. \nThis dissertation analyzes the security of multi-stage, multi-photon tolerant protocols and proposes an upper bound on the average number of photons per pulse in the cases where Fock states and the cases where coherent states are used in the implementation of the three-stage protocol. The derived average number of photons is the maximum limit at which the three-stage protocol can operate at a quantum secure level while operating in a multi-photon domain. In addition, this dissertation studies the vulnerability of the multi-stage protocol to the Trojan horse attack, Photon Number splitting attack (PNS), Amplification attack, as well as the man-in-the middle attack. Moreover, this dissertation proposes a modified version of the multi-stage protocol. This modified version uses an initialization vector and implements a chaining mode between consecutive implementations of the protocol. The modified version is proposed in the case of the three-stage protocol and named a key/message expansion four variables three-stage protocol. The proposed nomenclature is based on the fact that an additional variable is added to secure the three-stage protocol. The introduction of this additional variable has the potential to secure the multi-stage protocol in the multi-photon regime. It results in the eavesdropper having a set of simultaneous equations where the number of variables exceeds the number of equations. \nThe dissertation also addresses the performance of the multi-stage, multi-photon tolerant protocol. An average photon number of 1.5 photon/stage is used to calculate the maximum achievable distance and key transfer rates while using the single-stage protocol over fiber optic cables. We compute the increase in distance as well as data transfer rate while using the single-stage protocol. Channel losses as well as the detector losses are accounted for. \nFinally, an application of the multi-stage protocol in IEEE 802.11 is proposed. This application provides wireless networks with a quantum-level of security. It proposes the integration of multi-stage protocols into the four-way handshake of IEEE 802.11.
The reported research in literature for message transformation by a third party does not provide the necessary efficiency and security against different attacks. The data transmitted through the computer network must be confidential and authenticated in advance. In this paper, we develop and improve security of the braided single stage quantum cryptography. This improvement is based on a novel authentication algorithm by using signature verification without using the three stages protocol to share the secret key between the sender and receiver. This approach will work against attacks such as replay and man-in-the-middle by increasing the security as well as the over efficiency, reducing the overhead through using three stages and increasing the speed of the communication between two parties.
Quantum secure direct communication (QSDC) is a branch of quantum cryptography which exploits laws of physics and was recently proposed for securing information transferred from sender to receiver without relying on computational complexity. Instead of an entangled photon, the quantum cryptography employs two other approaches, single photon and multiphoton for encoding the messages. The multiphoton was proposed to outperform the weaknesses of a single photon by introducing the multiplicity of a photon to perform data encryption tasks. Despite the advantages of multiphoton, the transmission time to transfer the encoded data is still regarded as a critical issue. Most of the multiphoton approaches require multiple photons to travel along a number of stages. Moreover, extra time is needed to change the polarization angle of the optical device for encoding purposes. These situations have resulted in an increase in source redundancy, which subsequently leads to an increase in the transmission time. In this paper, a compression message approach is proposed to mitigate the substantial increase in time used for the data transmission processes. The proposed compression approach, namely, hybrid M-ary in a braided single stage (HMBSS) is based on the lossless data encoding such that the number of photons is reduced in the data transmission stage. Extensive simulation experiments have been conducted to test the performance of the proposed approach against some selected multiphoton approaches. The results show that the proposed approach outperforms braided single-stage, M-ary three-stage and initialization vector in terms of reducing total average transmission time to encode the photon by about 75.9% and 91.7%, respectively. Furthermore, the HMBSS reduces the overhead on the transmission channel by minimizing the number of message's bits by about 45% in average even when the length of the message increases during the transmission as compared to others.