The Josephson junction provides two strong nonlinearities, the Josephson inductance utilized in parametric amplification and the sharp resistive knee used in SIS mixing. Both of these nonlinearities can be strong compared to a characteristic quantum current or voltage scale. This opens the possibility of using Josephson junctions to carry out fundamental experiments in quantum electronics that would be difficult or impossible to carry out at optical frequencies due to the lack of a correspondingly large nonlinearity in optical media. Here we propose a number of such experiments ranging from the generation of squeezed states with Josephson-parametric amplifiers to the generation of quantum-mechanical superpositions of macroscopically distinguishable states via Josephson-transmission lines. How the properties of such states can be investigated using SIS mixers will also be described. Squeezed states may be technologically useful in sensitive and precision measurement. How such states can be used to enhance interferometer sensitivity or reduce noise in phase sensitive measurement will also be described.
The Josephson junction provides two strong nonlinearities, the Josephson inductance utilized in parametric amplification and the sharp resistive knee used in SIS mixing. Both of these nonlinearities can be strong compared to a characteristic quantum current or voltage scale. This opens the possibility of using Josephson junctions to carry out fundamental experiments in quantum electronics that would be difficult or impossible to carry out at optical frequencies due to the lack of a correspondingly large nonlinearity in optical media. Here we propose a number of such experiments ranging from the generation of squeezed states with Josephson-parametric amplifiers to the generation of quantum-mechanical superpositions of macroscopically distinguishable states via Josephson-transmission lines. How the properties of such states can be investigated using SIS mixers will also be described. Squeezed states may be technologically useful in sensitive and precision measurement. How such states can be used to enhance interferometer sensitivity or reduce noise in phase sensitive measurement will also be described.
Three-wave mixing devices, i.e. non-linear circuits converting power among three microwave signals, are key elements of analog information processing in the microwave domain. However, they are based on dissipative components such as semiconductor diodes, or SIS tunnel junctions biased near the superconducting gap. The loss of signal limits their operation and also introduces noise above the minimum required by quantum mechanics. By using Josephson junctions and superconducting resonators, we've been able to build such a quantum device. In its amplification mode, this device can be used as a preamplifier in many experiments where a few photon wide microwave signals must be measured by commercial instruments, which are sensitive to powers several orders of magnitude larger. The price to pay for this amplification is the necessary degradation of information. Indeed, an extension of the no-cloning theorem imposes that a linear phase preserving amplifier adds at least half a quantum of noise to the signal. By amplifying the finite frequency noise emitted by an NIN tunnel junction, we demonstrated that the total measurement chain adds less than 2.3 quanta to this limit thanks to our device. The operating principle of this device is based on Josephson parametric amplification. I will explain this mechanism and show preliminary results which illustrate that it can generate quantum correlated pairs of spatially separated photons with different wavelengths known as two-mode squeezed states. This experiment exploits the tunability of our device and the ease-of-use inherent to micro-wave circuits to perform a quantum optics experiment demonstrating this entanglement.
Three-wave mixing devices, i.e. non-linear circuits converting power among three microwave signals, are key elements of analog information processing in the microwave domain. However, they are based on dissipative components such as semiconductor diodes, or SIS tunnel junctions biased near the superconducting gap. The loss of signal limits their operation and also introduces noise above the minimum required by quantum mechanics. By using Josephson junctions and superconducting resonators, we've been able to build such a quantum device. In its amplification mode, this device can be used as a preamplifier in many experiments where a few photon wide microwave signals must be measured by commercial instruments, which are sensitive to powers several orders of magnitude larger. The price to pay for this amplification is the necessary degradation of information. Indeed, an extension of the no-cloning theorem imposes that a linear phase preserving amplifier adds at least half a quantum of noise to the signal. By amplifying the finite frequency noise emitted by an NIN tunnel junction, we demonstrated that the total measurement chain adds less than 2.3 quanta to this limit thanks to our device. The operating principle of this device is based on Josephson parametric amplification. I will explain this mechanism and present results which illustrate that it can generate quantum correlated pairs of spatially separated photons with different wavelengths known as two-mode squeezed states. This experiment exploits the tunability of our device and the ease-of-use inherent to micro-wave circuits to perform a quantum optics experiment demonstrating this entanglement.
Near-quantum-limited amplifiers are essential building blocks for high-fidelity readout of superconducting qubits. Josephson parametric amplifiers (JPAs) have been developed to achieve this ultra-low-noise performance [1] in the last two decades by exploiting the quartic term in the nonlinear energy-phase relation of Al-AlO X superconductor-insulator-superconductor Josephson Junctions (SIS JJs). An ongoing research focus is to enhance JPAs’ compression power for processing readout signals in large-scale quantum processors. One approach is to optimize circuit designs to minimize parasitic higher-order nonlinear terms while preserving the quartic nonlinearity for the amplification process. An alternative approach is to make use of new types of JJ devices with small quartic nonlinearity such that parasitic nonlinearities are inherently even lower. Here, we demonstrate that superconductor-semiconductor-superconductor (SSmS) JJs, realized with Al-InAs heterostructures are a promising device to realize quantum-limited amplifiers for superconducting quantum computing. Al-InAs JJs have been used to realize qubits [2] , voltage-tunable resonators [3] , and parametric amplifiers [4] by exploiting critical current tunability via gate voltage ( Fig. 1(a–b) ). In this work, for the first time, we experimentally studied the nonlinear energy-phase relation of Al-InAs JJs and revealed their inherently low quartic nonlinearity. Next, we demonstrate a four-wave-mixing (4WM) parametric amplifier made with an Al-InAs junction that achieves greater than 20 dB of gain, 6 MHz of bandwidth and −119 dBm of compression power.
With a large portfolio of elemental quantum components, superconducting quantum circuits have contributed to dramatic advances in microwave quantum optics. Of these elements, quantum-limited parametric amplifiers have proven to be essential for low noise readout of quantum systems whose energy range is intrinsically low (tens of µeV). They are also used to generate non classical states of light that can be a resource for quantum enhanced detection. Superconducting parametric amplifiers, like quantum bits, typically utilize a Josephson junction as a source of magnetically tunable and dissipation-free nonlinearity. The magnetic control is not an industry standard for devices and starts already to be an issue in large scale circuits. In recent years, efforts have been made to introduce semiconductor weak links as electrically tunable nonlinear elements, with demonstrations of microwave resonators and quantum bits using semiconductor nanowires, a two dimensional electron gas, carbon nanotubes and graphene. However, given the challenge of balancing nonlinearity, dissipation, participation, and energy scale, parametric amplifiers have not yet been implemented with a semiconductor weak link. The work presented in this PhD thesis demonstrates the design, fabrication and performances of a parametric amplifier leveraging a graphene Josephson junction.The graphene is encapsulated in between hBN flakes in order to improve its quality. Using such high quality junctions, we demonstrate amplification with 20 dB gain which is the milestone for overcoming noise of the classical amplifiers in the rest of the amplification chain. The Josephson parametric amplifier being based on a resonant structure (around 6 GHz) suffers from the gain bandwidth product limiting the amplification to a few MegaHertz frequency range. The use of a side gate to electrically tune the graphene gives control of the Josephson junction inductance and thus the resonant frequency of the amplifier. We demonstrate a near 1 GHz tunability of the amplification frequency with the use of a side gate which is as good as the tunability offered by using a magnetic flux on a SQUID for similar amplifier designs. Moreover, graphene has shown to exhibit nonlinear loss under a strong microwave irradiation arising because of dynamics in the Andreev states. Dissipation is known to add intrinsic noise on quantum amplifiers and could be a problem for quantum limited parametric amplification. We demonstrate that despite the presence of nonlinear loss, graphene based Josephson parametric amplifiers can reach near quantum limited amplification. A two photon loss model was used to describe the behaviour of the device but we show that a more complex model is required in order to take into account the nonlinear dissipation and the non-sinusoidal current phase relation. We also studied the dynamic range and showed that the graphene based Josephson parametric amplifier can reach a 1 dB compression point of -123 dBm which is as good as single tunnel junctions based parametric amplifiers. Our results expand the toolset for electrically tunable superconducting quantum circuits and offer new opportunities for the development of quantum technologies such as quantum computing, quantum sensing and fundamental science.
Nearly quantum limited Josephson parametric amplifiers (JPAs) are essential components in superconducting quantum circuits. However, higher order nonlinearities of the Josephson cosine potential are known to cause gain compression, therefore limiting scalability. In an effort to reduce the fourth order, or Kerr nonlinearity, we realize a parametric amplifier with an Al-InAs superconductor–semiconductor hybrid Josephson junction (JJ). We extract the Kerr nonlinearity of the Al-InAs JJ from two different devices and show that it is three orders of magnitude lower compared to an Al-AlOX junction with identical Josephson inductance. We then demonstrate a four-wave-mixing (4WM) parametric amplifier made with an Al-InAs junction that achieves more than 20 dB of gain and −119 dBm of compression power, which outperforms single resonant JPAs based on Al junctions.
A quantum-limited amplifier enables the amplification of weak signals while introducing minimal noise dictated by the principles of quantum mechanics. Such amplifiers serve a broad spectrum of applications in quantum computing, including fast and accurate readout of superconducting qubits and spins, as well as various uses in quantum sensing and metrology. Parametric amplification, primarily developed with use of Josephson junctions, has evolved into the leading technology for highly effective microwave measurements within quantum circuits. Despite their significant contributions, these amplifiers face fundamental limitations, such as their inability to handle high powers, their sensitivity to parasitic magnetic fields, and particularly their limitation to operate only at millikelvin temperatures. To tackle these challenges, here we experimentally develop a novel quantum-limited amplifier based on superconducting kinetic inductance and present an extensive theoretical model to describe this nonlinear coupled-mode system. Our device surpasses the conventional constraints associated with Josephson-junction amplifiers by operating at much higher temperatures up to 4.5 K. With two distinct spectral modes and tunability through bias current, this amplifier can operate selectively in both the single-mode-amplification regime and the double-mode-amplification regime near the quantum noise limit. Using a nonlinear thin film exhibiting kinetic inductance, our device attains gain exceeding 50 dB in a single-mode configuration and 32 dB in a double-mode configuration, while adding 0.82 input-referred noise quanta. Importantly, this amplifier eliminates the need for Josephson junctions, resulting in the capability to handle significantly higher powers than Josephson junction--based amplifiers. It also demonstrates resilience in the presence of magnetic fields, offers a straightforward design, and increases reliability. This positions the amplifier as a versatile solution for quantum applications and facilitates its integration into future superconducting quantum computers.