Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

NEW METHOD OF MEASURING THE AVERAGE THERMAL VELOCITY OF ATOMS

T. S. Stein, J. P. Carrico, E. Lipworth, M. C. Weisskopf

Published Jan 1, 1970• 8 citations
Publisher

Abstract

The average thermal velocity of atoms in an atomic-beam apparatus is measured using the velocity-dependent interaction μ lim →·[(v lim →/c)× E lim →].
DOI
10.1063/1.1653011

Related papers

VELOCITY DEPENDENCE OF THE DIFFERENTIAL CROSS SECTIONS, AND POTENTIAL WELL DEPTHS FROM ATOMIC BEAM SCATTERING MEASUREMENTS: K-Hg AND Cs-Hg SYSTEMS

Fred A. Morse, Richard B. Bernstein

Measurements of the velocity dependence of the angular intensity distribution of potassium and cesium atomic beams scattered by a crossed atomic beam of mercury are presented. The alkali atomic beam was velocity-selected, having a triangular velocity distribution with a halfintensity width of 0.047 of the peak velocity. The alkali velocity could be varied over the range 185 to 1100 m/s. The Hg beam had a thermal velocity distribution. The average speed of the Hg atoms in a typical experiment was 235 m/s (the calculated half-intensity width of the velocity distribution was 190 m/s). A typical angular distribution curve showed the expected very large low angle scattering, but evidenced a region in which the slope changed sharply, often resulting in a bump on the curve. This behavior is indicative of the phenomenon of rainbow scattering. The energy dependence of the rainbow angle was used to evaluate the depth of the interatomic potential wells; values (in ergs x 10/sup 14/) obtained are 7.7/sub 2/ for Cs-Hg and 7.4/sub 6/ for K-Hg. It is difficult to estimate the magnitude of the systematic errors in the absolute differential cross sections. However, reliable values for relative differential cross sections, which are velocity independent, can readilymore » be obtained by the methods described. From the low angle behavior of the differential cross sections, direct experimental evidence for the inverse sixth power dependence of the long-range attractive part of the potential was obtained. (auth)« less

•Jun 1, 1962•0 citations

Atomic beam velocity measurements using phase choppers in an atom interferometer

Ivan Hromada, William F. Holmgren, Catherine E. Klauss +1 more

Bulletin of the American Physical Society•Jun 14, 2011•0 citations

A Dynamic Method for the Determination of the Velocity Distribution of Thermal Atoms

Irving L. Kofsky, H. J. Levinstein

Physical Review•Aug 15, 1948•20 citations

PUMP-PROBE SPECTROSCOPY AND VELOCIMETRY OF A SLOW BEAM OF COLD ATOMS

Giovanni Di Domenico, G. Mileti, P. Thomann

We have observed Raman, Rayleigh and recoil induced resonances (RIR) in a continuous beam of slow and cold cesium atoms extracted from a 2D MOT with the moving molasses technique. We use the RIR to measure the velocity distribution, therefore the average speed (0.6–4 m/s) and temperature (50–500 μK) of the atomic beam. Compared to time of flight (TOF), this technique has the advantage of being local, more sensitive in the low-velocity regime (ν< 1 m/s ) and it gives access to transverse velocities and temperatures. It may be extended to measure atomic velocities in the 2D MOT source of the atomic beam. It is an additional tool to study and optimize the cooling, the extraction and the (transverse) post-cooling of slow atomic beams.

Laser Spectroscopy•Jun 1, 2002•0 citations

Velocity distribution in an atomic beam

Yu. G. Abashev, Gennady F. Voronin, R. A. Valitov

Measurement Techniques•Nov 1, 1972•0 citations

SCATTERING OF A VELOCITY SELECTED POTASSIUM BEAM BY NEON, ARGON, AND XENON GASES AT DIFFERENT TEMPERATURES

Howard Howland Brown, K. Lulla, Benjamin B. Bederson

A thermal K beam was velocity selected, and scattered by Ne, Ar, and Xe gases. The dependence of the total cross section on relative velocity is approximately v/sup -0.4/ for K--Ar and K--Xe, and v/sup 0.8/ for K--Ne. The average relative velocity ranges were 400 to 1430 m/sec for Ne, 480 to 1350 m/sec for Ar, and 380 to 1320 m/sec for Xe. The dependence of the cross section on relative velocity was obtained by removing the cross section from the collision frequency integral. For the v/sup -0.4/ dependences, this gives results correct to 3%. For the v/sup -0.8/ dependences, the error is most likely greater. Three gas temperatures were used: liquid air, room, and 200 deg C. The results for a given gas at different temperatures are consistent with kinetic theory predictions. (auth)

•Jan 1, 1962•0 citations
Measurements of the velocity dependence of the angular intensity distribution of potassium and cesium atomic beams scattered by a crossed atomic beam of mercury are presented. The alkali atomic beam was velocity-selected, having a triangular velocity distribution with a halfintensity width of 0.047 of the peak velocity. The alkali velocity could be varied over the range 185 to 1100 m/s. The Hg beam had a thermal velocity distribution. The average speed of the Hg atoms in a typical experiment was 235 m/s (the calculated half-intensity width of the velocity distribution was 190 m/s). A typical angular distribution curve showed the expected very large low angle scattering, but evidenced a region in which the slope changed sharply, often resulting in a bump on the curve. This behavior is indicative of the phenomenon of rainbow scattering. The energy dependence of the rainbow angle was used to evaluate the depth of the interatomic potential wells; values (in ergs x 10/sup 14/) obtained are 7.7/sub 2/ for Cs-Hg and 7.4/sub 6/ for K-Hg. It is difficult to estimate the magnitude of the systematic errors in the absolute differential cross sections. However, reliable values for relative differential cross sections, which are velocity independent, can readilymore » be obtained by the methods described. From the low angle behavior of the differential cross sections, direct experimental evidence for the inverse sixth power dependence of the long-range attractive part of the potential was obtained. (auth)« less
We have observed Raman, Rayleigh and recoil induced resonances (RIR) in a continuous beam of slow and cold cesium atoms extracted from a 2D MOT with the moving molasses technique. We use the RIR to measure the velocity distribution, therefore the average speed (0.6–4 m/s) and temperature (50–500 μK) of the atomic beam. Compared to time of flight (TOF), this technique has the advantage of being local, more sensitive in the low-velocity regime (ν< 1 m/s ) and it gives access to transverse velocities and temperatures. It may be extended to measure atomic velocities in the 2D MOT source of the atomic beam. It is an additional tool to study and optimize the cooling, the extraction and the (transverse) post-cooling of slow atomic beams.
A thermal K beam was velocity selected, and scattered by Ne, Ar, and Xe gases. The dependence of the total cross section on relative velocity is approximately v/sup -0.4/ for K--Ar and K--Xe, and v/sup 0.8/ for K--Ne. The average relative velocity ranges were 400 to 1430 m/sec for Ne, 480 to 1350 m/sec for Ar, and 380 to 1320 m/sec for Xe. The dependence of the cross section on relative velocity was obtained by removing the cross section from the collision frequency integral. For the v/sup -0.4/ dependences, this gives results correct to 3%. For the v/sup -0.8/ dependences, the error is most likely greater. Three gas temperatures were used: liquid air, room, and 200 deg C. The results for a given gas at different temperatures are consistent with kinetic theory predictions. (auth)