Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Physics B Atomic and Molecular Physics

Collisions in a parallel atomic beam

K Zankel

Published Jan 1, 1972• 1 citation
Publisher

Abstract

A calculation is given for the collision frequency and the angular distribution of particles scattered from a well collimated atomic beam. It is assumed that their total number is small. Results are plotted for the flow from a supersonic nozzle with the Mach-number varying from 0 to 8.
DOI
10.1088/0022-3700/5/1/017

Related papers

Structure in the angular dependence of optical suppression of photoassociative ionization collisions within an optically cooled and collimated sodium atom beam

W. DeGraffenreid, Jaime Ramirez-Serrano, Y.-M. Liu +3 more

Applied Physics B•Dec 1, 2000•3 citations

Gasdynamic method for reducing the phase volume of an atomic beam

Victor L. Varentsov, Valeriy V. Yashchuk

It is suggested that atomic and molecular beams can be thermalizd by collisions with a supersonic gas jet. (AIP)

•Feb 1, 1983•2 citations

Supersonic Molecular Beams of Alkali Dimers

Robert J. Gordon, Y. T. Lee, Dudley R. Herschbach

Intense alkali beams containing up to 30% mole fraction of K2, Rb2, or Cs2 have been generated from a supersonic nozzle expansion, with oven temperatures up to ∼ 900°K (corresponding to alkali vapor pressures up to ∼ 350 torr) and nozzle temperatures ∼ 50–300°K higher. The total beam intensity obtained reached ∼ 5 × 1017 particles sec−1·sr−1. An inhomogeneous deflecting magnet was used to separate the dimer and atom components of the beam, and the variation of dimer concentration with oven pressure and nozzle temperature were studied for a variety of nozzle sizes (throat diameters 0.04–0.15 mm). The velocity distributions of the atom and dimer components were also measured and found to be quite similar; the peaks occur at velocities up to 70% higher than the most probable atom velocity in the oven, and the widths are very narrow, corresponding to random translational temperatures as low as ∼ 30°K, and Mach numbers up to ∼ 15. A simple one-dimensional theory of dimerization which takes into account vibrational relaxation and heat of condensation is found to be consistent with the data. It is shown that the observed velocity distributions and the variation of the dimer yield with pressure and nozzle diameter imply that most of the heat of condensation does not contribute to the beam acceleration but goes into vibrational excitation of the dimer molecules. A nominal value of ∼ 3 × 10−30 cm6 sec−1 at ∼ 600°K is obtained for the recombination rate constant for Cs+Cs+Cs→Cs2+Cs. A reduced variable plot is provided which enables the theory to be applied to nozzle expansions of any substance for which the chemical recombination is governed by three-body collisions.

The Journal of Chemical Physics•Mar 15, 1971•138 citations

Average cluster size determination in supersonic beams from angular distribution measurements after scattering by a buffer gas

Antonello De Martino, M. Benslimane, M. Châtelet +3 more

Zeitschrift für Physik D Atoms Molecules and Clusters•Jun 1, 1993•38 citations

Direct Images of the Virtual Source in a Supersonic Expansion

Thomas J.G. Reisinger, G. Bracco, Stefan Rehbein +3 more

Direct images of the virtual source in a supersonic expansion of helium are presented. The images were obtained using a Fresnel zone plate with free-standing zones, 540 microm in diameter and with an outermost zone width of 50 nm. The general method can be extended to other beams, including seeded beams. Measurements were carried out at absolute source pressures ranging from 11 to 171 bar using a 10 microm nozzle with a source temperature of 320 K. The size of the virtual source was found to be strongly dependent on pressure, changing from a diameter of 67+/-6 microm at an absolute nozzle pressure of 11 bar to 180+/-9 microm at 171 bar. The virtual-source brightness displays a maximum at an absolute nozzle pressure of around 30 bar. This phenomenon occurs because of two competing effects: As the pressure increases, the total flux also increases, but at the same time the virtual source broadens. We modeled the expansion process by calculating the velocity distribution with solutions from the Boltzmann equation to estimate the location of the quitting surface where the frequency of interatomic collisions is assumed negligible. Realistic potentials have been used to calculate the cross section for atomic collisions and, for the velocity distribution perpendicular to the center streamline, a proper scaling with distance derived from the continuum expansion model has been introduced. A good agreement between experiments and model has been found and we discuss its approximation limits. For instance, backscattering effects are not included in the calculations and at present we cannot exclude that they also contribute to a broadening of the virtual-source size for the highest pressure regime. The results presented here are important for improving the understanding of the supersonic expansion process. The experimental method might eventually be used as a new way to test molecular and atomic interaction potentials.

The Journal of Physical Chemistry A•Nov 7, 2007•36 citations

Coherence-Length Effects in Fast Atom Diffraction at Grazing Incidence

M. S. Gravielle, J. E. Miraglia, L. Frisco

Coherence properties of projectiles, found relevant in ion-atom collisions, are investigated by analyzing the influence of the degree of coherence of the atomic beam on interference patterns produced by grazing-incidence fast-atom diffraction (GIFAD or FAD). The transverse coherence length of the projectiles, which depends on the incidence conditions and the collimating setup, determines the overall characteristics of GIFAD distributions. We show that for atoms scattered from a LiF(001) surface after a given collimation, we can modify the interference signatures of the angular spectra by varying the total impact energy, while keeping the normal energy as a constant. Also, the role played by the geometry of the collimating aperture is analyzed, comparing results for square and circular openings. Furthermore, we study the spot-beam effect, which is due to different focus points of the impinging particles. We show that when a region narrower than a single crystallographic channel is coherently illuminated by the atomic beam, the spot-beam contribution strongly affects the visibility of the interference structures, contributing to the gradual quantum-classical transition of the projectile distributions.

Atoms•Nov 27, 2018•7 citations
Intense alkali beams containing up to 30% mole fraction of K2, Rb2, or Cs2 have been generated from a supersonic nozzle expansion, with oven temperatures up to ∼ 900°K (corresponding to alkali vapor pressures up to ∼ 350 torr) and nozzle temperatures ∼ 50–300°K higher. The total beam intensity obtained reached ∼ 5 × 1017 particles sec−1·sr−1. An inhomogeneous deflecting magnet was used to separate the dimer and atom components of the beam, and the variation of dimer concentration with oven pressure and nozzle temperature were studied for a variety of nozzle sizes (throat diameters 0.04–0.15 mm). The velocity distributions of the atom and dimer components were also measured and found to be quite similar; the peaks occur at velocities up to 70% higher than the most probable atom velocity in the oven, and the widths are very narrow, corresponding to random translational temperatures as low as ∼ 30°K, and Mach numbers up to ∼ 15. A simple one-dimensional theory of dimerization which takes into account vibrational relaxation and heat of condensation is found to be consistent with the data. It is shown that the observed velocity distributions and the variation of the dimer yield with pressure and nozzle diameter imply that most of the heat of condensation does not contribute to the beam acceleration but goes into vibrational excitation of the dimer molecules. A nominal value of ∼ 3 × 10−30 cm6 sec−1 at ∼ 600°K is obtained for the recombination rate constant for Cs+Cs+Cs→Cs2+Cs. A reduced variable plot is provided which enables the theory to be applied to nozzle expansions of any substance for which the chemical recombination is governed by three-body collisions.
Direct images of the virtual source in a supersonic expansion of helium are presented. The images were obtained using a Fresnel zone plate with free-standing zones, 540 microm in diameter and with an outermost zone width of 50 nm. The general method can be extended to other beams, including seeded beams. Measurements were carried out at absolute source pressures ranging from 11 to 171 bar using a 10 microm nozzle with a source temperature of 320 K. The size of the virtual source was found to be strongly dependent on pressure, changing from a diameter of 67+/-6 microm at an absolute nozzle pressure of 11 bar to 180+/-9 microm at 171 bar. The virtual-source brightness displays a maximum at an absolute nozzle pressure of around 30 bar. This phenomenon occurs because of two competing effects: As the pressure increases, the total flux also increases, but at the same time the virtual source broadens. We modeled the expansion process by calculating the velocity distribution with solutions from the Boltzmann equation to estimate the location of the quitting surface where the frequency of interatomic collisions is assumed negligible. Realistic potentials have been used to calculate the cross section for atomic collisions and, for the velocity distribution perpendicular to the center streamline, a proper scaling with distance derived from the continuum expansion model has been introduced. A good agreement between experiments and model has been found and we discuss its approximation limits. For instance, backscattering effects are not included in the calculations and at present we cannot exclude that they also contribute to a broadening of the virtual-source size for the highest pressure regime. The results presented here are important for improving the understanding of the supersonic expansion process. The experimental method might eventually be used as a new way to test molecular and atomic interaction potentials.
Coherence properties of projectiles, found relevant in ion-atom collisions, are investigated by analyzing the influence of the degree of coherence of the atomic beam on interference patterns produced by grazing-incidence fast-atom diffraction (GIFAD or FAD). The transverse coherence length of the projectiles, which depends on the incidence conditions and the collimating setup, determines the overall characteristics of GIFAD distributions. We show that for atoms scattered from a LiF(001) surface after a given collimation, we can modify the interference signatures of the angular spectra by varying the total impact energy, while keeping the normal energy as a constant. Also, the role played by the geometry of the collimating aperture is analyzed, comparing results for square and circular openings. Furthermore, we study the spot-beam effect, which is due to different focus points of the impinging particles. We show that when a region narrower than a single crystallographic channel is coherently illuminated by the atomic beam, the spot-beam contribution strongly affects the visibility of the interference structures, contributing to the gradual quantum-classical transition of the projectile distributions.