Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review A

Bose-Einstein condensation on a permanent-magnet atom chip

Christopher D. J. Sinclair, E. A. Curtis, Isabel Llorente‐Garcia, J. A. Retter, B. V. Hall, S. Eriksson, B. E. Sauer, Edward A. Hinds

Published Sep 21, 2005• 75 citations
Publisher

Abstract

We have produced a Bose-Einstein condensate on a permanent-magnet atom chip based on periodically magnetized videotape. We observe the expansion and dynamics of the condensate in one of the microscopic waveguides close to the surface. The lifetime for atoms to remain trapped near this dielectric material is significantly longer than above a metal surface of the same thickness. These results illustrate the suitability of microscopic permanent-magnet structures for quantum-coherent preparation and manipulation of cold atoms.

DOI
10.1103/physreva.72.031603

Related papers

Preparation of a Bose-Einstein condensate on a permanent-magnet atom chip

Sinclair, CDJ, Curtis, EA, Retter, JA +5 more

We describe an atom chip based on periodically magnetised videotape. Cold atoms are loaded into one of the microscopic magnetic traps formed by the videotape atom chip. Using forced evaporation we have produced a 87 Rb Bose-Einstein condensate in a permanent-magnet microtrap.

•Jan 1, 2005•4 citations

Preparation of a Bose–Einstein condensate on a permanent-magnet atom chip

Christopher D. J. Sinclair, E A Curtis, J. A. Retter +5 more

We describe an atom chip based on periodically magnetised videotape. Cold atoms are loaded into one of the microscopic magnetic traps formed by the videotape atom chip. Using forced evaporation we have produced a 87 Rb Bose–Einstein condensate in a permanent-magnet microtrap.

arXiv:cond-mat/0503619•Journal of Physics Conference Series•Jan 1, 2005•4 citations

Bose-Einstein condensates on a magnetic film atom chip

S. Whitlock

Atom chips are devices used to magnetically trap and manipulate ultracold atoms and Bose-Einstein condensates near a surface. In particular, permanent magnetic film atom chips can allow very tight confinement and intricate magnetic field designs while circumventing technical current noise. Research described in this thesis is focused on the development of a magnetic film atom chip, the production of Bose-Einstein condensates near the film surface, the characterisation of the associated magnetic potentials using rf spectroscopy of ultracold atoms and the realisation of a precision sensor based on splitting Bose-Einstein condensates in a double-well potential. The atom chip itself combines the edge of a perpendicularly magnetised GdTbFeCo film with a machined silver wire structure. A mirror magneto-optical trap collects up to 5 x 108 87Rb atoms beneath the chip surface. The current-carrying wires are then used to transfer the cloud of atoms to the magnetic film microtrap and radio frequency evaporative cooling is applied to produce Bose-Einstein condensates consisting of 1 x 105 atoms. We have identified small spatial magnetic field variations near the film surface that fragment the ultracold atom cloud. These variations originate from inhomogeneity in the film magnetisation and are characterised using a novel technique based on spatially resolved radio frequency spectroscopy of the atoms to map the magnetic field landscape over a large area. The observations agree with an analytic model for the spatial decay of random magnetic fields from the film surface. Bose-Einstein condensates in our unique potential landscape have been used as a precision sensor for potential gradients. We transfer the atoms to the central region of the chip which produces a double-well potential. A single BEC is formed far from the surface and is then dynamically split in two by moving the trap closer to the surface. After splitting, the population of atoms in each well is extremely sensitive to the asymmetry of the potential and can be used to sense tiny magnetic field gradients or changes in gravity on a small spatial scale.

•Jan 1, 2007•5 citations

Permanent magnet atom chips for BEC and microtrap arrays

S. Whitlock, R. Gerritsma, T. Fernholz +1 more

An atom chip is designed to manipulate magnetically trapped ultracold atoms and Bose-Einstein condensates (BECs) near a surface using micro fabricated patterns of current-carrying wires or permanent magnetic materials. We report on experiments using our permanent magnet atom chip.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 1, 2007•0 citations

A permanent magnetic film atom chip for Bose–Einstein condensation

B V Hall, S. Whitlock, F Scharnberg +2 more

We present a hybrid atom chip which combines a permanent magnetic film with a micromachined current-carrying structure used to realize a Bose–Einstein condensate (BEC). A novel TbGdFeCo material with large perpendicular magnetization has been tailored to allow small scale, stable magnetic potentials for ultracold atoms. We are able to produce 87 Rb BEC in a magnetic trap based on either the permanent magnetic film or the current-carrying structure. Using the condensate as a magnetic field probe we perform cold atom magnetometry to profile both the field magnitude and gradient as a function of distance from the magnetic film surface. Finally, we discuss future directions for our permanent magnetic film atom chip.

arXiv:cond-mat/0507435•Journal of Physics B Atomic Molecular and Optical Physics•Dec 5, 2005•33 citations

Investigating the dynamics of a Bose Einstein condensate on an atom chip

I J M Barr

In this thesis I discuss work that has been carried out on the dynamics of a Bose Einstein condensate of Rb 87 produced near an atom chip. A Bose Einstein Condensate (BEC) is a quantum state of matter where a single quantum state becomes occupied by a macroscopic number of identical Bosons. In our case this is achieved by cooling a system of trapped identical rubidium 87 atoms to its ground state. To reach temperatures of condensation we initially laser cool atoms from room temperature, before loading them into a magnetic trap. The magnetic trap is produced through a combination of uniform magnetic fields from coils outside our vacuum chamber and currents running through wires on an atom chip. The atom chip is a microfabricated device, produced by a coating a silicon chip with a thin layer of gold and etching wires into it. Together, these fields create a magnetic field minimum 120μm from the surface of the chip which can be used to confine low field seeking hyperfine states of the atom in an elongated harmonic trap. Once the atoms are confined in the magnetic trap we used force evaporative cooling out to reach the phase space densities required for Bose Einstein condensation. The BEC is used to investigate the relative dynamics between the fraction of the atoms in the condensate to those not in the condensate. Our atom chip provided a suitable environment to investigate this due to fragmentation of the magnetic potential close to the chip. Small imperfections in the wires on our atom chip mean that the trapping potential isn’t smooth. Small regions of higher trapping frequency - or fragments - are formed. Due to the small size of these fragments it is possible to find a position where a condensate can form in the fragment, and see a potential of high frequency, whereas a non-condensed atom will see a lower frequency potential. We exploit this to set the condensed fraction moving relative to the non condensed part and investigate the subsequent damping of their motion relative to each other.

•May 1, 2015•2 citations
We have produced a Bose-Einstein condensate on a permanent-magnet atom chip based on periodically magnetized videotape. We observe the expansion and dynamics of the condensate in one of the microscopic waveguides close to the surface. The lifetime for atoms to remain trapped near this dielectric material is significantly longer than above a metal surface of the same thickness. These results illustrate the suitability of microscopic permanent-magnet structures for quantum-coherent preparation and manipulation of cold atoms.
Atom chips are devices used to magnetically trap and manipulate ultracold atoms and Bose-Einstein condensates near a surface. In particular, permanent magnetic film atom chips can allow very tight confinement and intricate magnetic field designs while circumventing technical current noise. Research described in this thesis is focused on the development of a magnetic film atom chip, the production of Bose-Einstein condensates near the film surface, the characterisation of the associated magnetic potentials using rf spectroscopy of ultracold atoms and the realisation of a precision sensor based on splitting Bose-Einstein condensates in a double-well potential. The atom chip itself combines the edge of a perpendicularly magnetised GdTbFeCo film with a machined silver wire structure. A mirror magneto-optical trap collects up to 5 x 108 87Rb atoms beneath the chip surface. The current-carrying wires are then used to transfer the cloud of atoms to the magnetic film microtrap and radio frequency evaporative cooling is applied to produce Bose-Einstein condensates consisting of 1 x 105 atoms. We have identified small spatial magnetic field variations near the film surface that fragment the ultracold atom cloud. These variations originate from inhomogeneity in the film magnetisation and are characterised using a novel technique based on spatially resolved radio frequency spectroscopy of the atoms to map the magnetic field landscape over a large area. The observations agree with an analytic model for the spatial decay of random magnetic fields from the film surface. Bose-Einstein condensates in our unique potential landscape have been used as a precision sensor for potential gradients. We transfer the atoms to the central region of the chip which produces a double-well potential. A single BEC is formed far from the surface and is then dynamically split in two by moving the trap closer to the surface. After splitting, the population of atoms in each well is extremely sensitive to the asymmetry of the potential and can be used to sense tiny magnetic field gradients or changes in gravity on a small spatial scale.
We present a hybrid atom chip which combines a permanent magnetic film with a micromachined current-carrying structure used to realize a Bose–Einstein condensate (BEC). A novel TbGdFeCo material with large perpendicular magnetization has been tailored to allow small scale, stable magnetic potentials for ultracold atoms. We are able to produce 87 Rb BEC in a magnetic trap based on either the permanent magnetic film or the current-carrying structure. Using the condensate as a magnetic field probe we perform cold atom magnetometry to profile both the field magnitude and gradient as a function of distance from the magnetic film surface. Finally, we discuss future directions for our permanent magnetic film atom chip.
In this thesis I discuss work that has been carried out on the dynamics of a Bose Einstein condensate of Rb 87 produced near an atom chip. A Bose Einstein Condensate (BEC) is a quantum state of matter where a single quantum state becomes occupied by a macroscopic number of identical Bosons. In our case this is achieved by cooling a system of trapped identical rubidium 87 atoms to its ground state. To reach temperatures of condensation we initially laser cool atoms from room temperature, before loading them into a magnetic trap. The magnetic trap is produced through a combination of uniform magnetic fields from coils outside our vacuum chamber and currents running through wires on an atom chip. The atom chip is a microfabricated device, produced by a coating a silicon chip with a thin layer of gold and etching wires into it. Together, these fields create a magnetic field minimum 120μm from the surface of the chip which can be used to confine low field seeking hyperfine states of the atom in an elongated harmonic trap. Once the atoms are confined in the magnetic trap we used force evaporative cooling out to reach the phase space densities required for Bose Einstein condensation. The BEC is used to investigate the relative dynamics between the fraction of the atoms in the condensate to those not in the condensate. Our atom chip provided a suitable environment to investigate this due to fragmentation of the magnetic potential close to the chip. Small imperfections in the wires on our atom chip mean that the trapping potential isn’t smooth. Small regions of higher trapping frequency - or fragments - are formed. Due to the small size of these fragments it is possible to find a position where a condensate can form in the fragment, and see a potential of high frequency, whereas a non-condensed atom will see a lower frequency potential. We exploit this to set the condensed fraction moving relative to the non condensed part and investigate the subsequent damping of their motion relative to each other.