Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Peculiarities of radio frequency YBa2Cu3O7−x superconducting quantum interference device response with a finite amplitude of the second harmonic in the current-phase relationship

Evgeni V. Il’ichev

Published Nov 20, 2000• 0 citations
Publisher

Abstract

The signal properties of radio frequency (rf) (SQUIDs) based on YBa2Cu3O7−x symmetrical 30° and asymmetrical 45° grain-boundary Josephson junctions have been experimentally investigated. Both amplitude as well as phase detection have been used to read out the SQUID output signal. Comparison of the SQUID output signals to each other is given. It is shown that peculiarities of the rf SQUID response of SQUIDs with a 45° grain-boundary Josephson junction are consistent with an unconventional current-phase relation (CPR) of the Josephson junction, namely, the CPR contains a finite amplitude of the second harmonic.

DOI
10.1063/1.1326845

Related papers

Signal properties of radio frequency SQUID with a finite amplitude of the second harmonic in the current-phase relationship

Evgeni V. Il’ichev, Ya. S. Greenberg, R.P.J. IJsselsteijn +3 more

The signal properties of radio frequency (rf) SQUIDs with a finite amplitude of the second harmonic in the current-phase relationship have been theoretically and experimentally investigated. Both amplitude as well as phase detection has been considered in order to readout the SQUID's output signal. We observed peculiarities of the rf SQUID response of a SQUID with YBCO 45 degree grain boundary Josephson junction. We found that the current-phase relationship contains a finite amplitude of the second harmonic. Comparison of the theoretical and experimental results is given. It is shown that the sign of the amplitude of the second harmonic can be determined from the shape of experimental curves, and the value of this amplitude is defined by the positions of extrema of these curves.

IEEE Transactions on Applied Superconductivity•Mar 1, 2001•0 citations

Inductance mode characteristics of a ceramic YBa2Cu3O7−x radio-frequency superconducting quantum interference device at 77 K

Evgeni V. Il’ichev, A. V. Andreev, Christian S. Jacobsen

Experimental results on some radio-frequency superconducting quantum interference device (rf-SQUID) signal properties are presented. The quantum interferometer was made of ceramic YBa2Cu3O7−x and was due to a low critical current operated in the inductance or nonhysteretic mode. With bias current as reference, amplitude variation, and phase shift of the voltage over the tank circuit coupled to the SQUID were measured simultaneously. It is shown that there is qualitative agreement between calculations based on the resistivity shunted junction model and the data. Moreover, using phase detection, signal instabilities predicted for the rf-SQUID inductance mode were observed. These signal instabilities may be exploited to enhance the transfer coefficient for measured flux-to-output signal.

Journal of Applied Physics•Sep 1, 1993•1 citation

Basic properties of an rf SQUID involving two Josephson junctions connected in series

Bo Mao, Tan Zhong-Kui, Meng Shu-Chao +2 more

We have studied the basic characteristics of a radio frequency superconducting quantum interference device (rf SQUID) involving two Josephson junctions connected in series, the case for the widely used grain boundary junction (GBJ) rf SQUID. It is found that the SQUID properties are determined mainly by the weaker junction when the critical current of the weaker junction is much lower than that of the other junction. Otherwise, the effect of the other junction is not negligible. We also find that only when the hysteresis parameter β is less than 1−α, where α is the critical current ratio of the two junctions, will the SQUID operate in the nonhysteretic mode.

Chinese Physics•Jul 29, 2004•7 citations

Experimental study of amplitude–frequency characteristics of high-transition-temperature radio frequency superconducting quantum interference devices

Xian-Lin Zeng, Y. Zhang, Boris Chesca +3 more

We measured the amplitude–frequency characteristics of radio frequency superconducting quantum interference devices (rf SQUIDs) over a temperature range between 65 and 79 K. Using the expressions derived from the recently developed rf SQUID theory, valid also at large thermal fluctuations, we determined from these data the basic parameters of high-transition-temperature superconductor (HTS) rf SQUIDs. These parameters were: (a) the high-frequency coupling coefficient between the rf SQUID and the tank circuit resonator, k, (b) the SQUIDs hysteretic parameter, β, (c) the critical current of the Josephson junction, Ic, (d) its normal resistance, Rn, and (e) its noise parameter, Γ. We found a good agreement with the values of β(Ic) and Rn determined directly after destructively opening the SQUID loop. In accordance with the theoretical predictions, our experimental results show that at large thermal fluctuation levels (T≅77 K), rf SQUIDs with large loop inductance operate in nonhysteretic mode up to β values exceeding 3. Furthermore, we have shown that the optimal energy sensitivity is attained in the nonhysteretic mode at a value of β distinctly higher than 1. A quantitative comparison of white noise predicted by the theory with that obtained from the experiment showed a reasonable agreement. We also discussed the contribution of the phase information to the SQUID’s signal and noise at optimum operation conditions, when a mixer was used as a signal detector.

Journal of Applied Physics•Dec 1, 2000•13 citations

Determination of the Current–Phase Relation in Josephson Junctions by Means of an Asymmetric Two-Junction SQUID

Lev V. Ginzburg, Igor E. Batov, V. V. Bol’ginov +7 more

An analytical approach that makes it possible to reconstruct the current–phase relation (CPR) in Josephson structures included in one of the arms of a two-junction superconducting quantum interference device (SQUID), where the second junction has a significantly higher critical current and a known (sinusoidal) CPR, has been developed. The developed methods of analytical and numerical studies of current–flow transformations in two-junction SQUIDs make it possible to reconstruct the CPR of a junction with a low critical current taking into account both the existence of the self-inductance of the interferometer contour and a possible asymmetry in the supply current system. The efficiency of this approach has been confirmed by the experimental study of niobium–aluminum/aluminum oxide–niobium test structures with the known CPR.

Journal of Experimental and Theoretical Physics Letters•Jan 1, 2018•17 citations

Influence of the current-phase relation of nanobridge junction on the SQUID performance

Xinxin Fan, Yue Wang, Xu Liu +8 more

Superconducting quantum interference devices (SQUIDs) based on nanobridge junctions (NBJs) are promising platforms for highly sensitive magnetic detection. The SQUID performance is influenced by the non-sinusoidal current-phase relation (CPR) of NBJs. In this work, we measured the flux modulation of 10 asymmetric Nb SQUIDs based on three-dimensional NBJs, along with the CPR response in each device, which is mainly determined by the junction with the smaller critical current. By studying the CPR parameters (skewness Δ θ , critical current I c1 , and effective junction inductance L j ), together with the SQUID modulation characteristics (voltage modulation amplitude Δ I c R n and current modulation ratio Δ I c /2 I c1 ), we found that as I c1 increases from 0.6 μA to 6.6 μA and L j correspondingly decreases from 106 pH to 70 pH, the CPR skewness Δ θ increases from 0.2 rad to 1.5 rad. Over this range, Δ I c /2 I c1 decreases from 1.2 to 0.5, while Δ I c R n increases from about 0.06 mV to 0.22 mV. More specifically, Δ I c R n increases while Δ I c /2 I c1 decreases with increasing I c1 , whereas both quantities decrease with increasing L j . These results reveal a trade-off between intrinsic SQUID response and tolerance to readout noise, suggesting that improved performance can be achieved by engineering NBJs with increased I c1 and smaller L j .

Physica C Superconductivity•Jul 17, 2026•0 citations
The signal properties of radio frequency (rf) (SQUIDs) based on YBa2Cu3O7−x symmetrical 30° and asymmetrical 45° grain-boundary Josephson junctions have been experimentally investigated. Both amplitude as well as phase detection have been used to read out the SQUID output signal. Comparison of the SQUID output signals to each other is given. It is shown that peculiarities of the rf SQUID response of SQUIDs with a 45° grain-boundary Josephson junction are consistent with an unconventional current-phase relation (CPR) of the Josephson junction, namely, the CPR contains a finite amplitude of the second harmonic.
The signal properties of radio frequency (rf) SQUIDs with a finite amplitude of the second harmonic in the current-phase relationship have been theoretically and experimentally investigated. Both amplitude as well as phase detection has been considered in order to readout the SQUID's output signal. We observed peculiarities of the rf SQUID response of a SQUID with YBCO 45 degree grain boundary Josephson junction. We found that the current-phase relationship contains a finite amplitude of the second harmonic. Comparison of the theoretical and experimental results is given. It is shown that the sign of the amplitude of the second harmonic can be determined from the shape of experimental curves, and the value of this amplitude is defined by the positions of extrema of these curves.
Experimental results on some radio-frequency superconducting quantum interference device (rf-SQUID) signal properties are presented. The quantum interferometer was made of ceramic YBa2Cu3O7−x and was due to a low critical current operated in the inductance or nonhysteretic mode. With bias current as reference, amplitude variation, and phase shift of the voltage over the tank circuit coupled to the SQUID were measured simultaneously. It is shown that there is qualitative agreement between calculations based on the resistivity shunted junction model and the data. Moreover, using phase detection, signal instabilities predicted for the rf-SQUID inductance mode were observed. These signal instabilities may be exploited to enhance the transfer coefficient for measured flux-to-output signal.
We have studied the basic characteristics of a radio frequency superconducting quantum interference device (rf SQUID) involving two Josephson junctions connected in series, the case for the widely used grain boundary junction (GBJ) rf SQUID. It is found that the SQUID properties are determined mainly by the weaker junction when the critical current of the weaker junction is much lower than that of the other junction. Otherwise, the effect of the other junction is not negligible. We also find that only when the hysteresis parameter β is less than 1−α, where α is the critical current ratio of the two junctions, will the SQUID operate in the nonhysteretic mode.
We measured the amplitude–frequency characteristics of radio frequency superconducting quantum interference devices (rf SQUIDs) over a temperature range between 65 and 79 K. Using the expressions derived from the recently developed rf SQUID theory, valid also at large thermal fluctuations, we determined from these data the basic parameters of high-transition-temperature superconductor (HTS) rf SQUIDs. These parameters were: (a) the high-frequency coupling coefficient between the rf SQUID and the tank circuit resonator, k, (b) the SQUIDs hysteretic parameter, β, (c) the critical current of the Josephson junction, Ic, (d) its normal resistance, Rn, and (e) its noise parameter, Γ. We found a good agreement with the values of β(Ic) and Rn determined directly after destructively opening the SQUID loop. In accordance with the theoretical predictions, our experimental results show that at large thermal fluctuation levels (T≅77 K), rf SQUIDs with large loop inductance operate in nonhysteretic mode up to β values exceeding 3. Furthermore, we have shown that the optimal energy sensitivity is attained in the nonhysteretic mode at a value of β distinctly higher than 1. A quantitative comparison of white noise predicted by the theory with that obtained from the experiment showed a reasonable agreement. We also discussed the contribution of the phase information to the SQUID’s signal and noise at optimum operation conditions, when a mixer was used as a signal detector.
An analytical approach that makes it possible to reconstruct the current–phase relation (CPR) in Josephson structures included in one of the arms of a two-junction superconducting quantum interference device (SQUID), where the second junction has a significantly higher critical current and a known (sinusoidal) CPR, has been developed. The developed methods of analytical and numerical studies of current–flow transformations in two-junction SQUIDs make it possible to reconstruct the CPR of a junction with a low critical current taking into account both the existence of the self-inductance of the interferometer contour and a possible asymmetry in the supply current system. The efficiency of this approach has been confirmed by the experimental study of niobium–aluminum/aluminum oxide–niobium test structures with the known CPR.
Superconducting quantum interference devices (SQUIDs) based on nanobridge junctions (NBJs) are promising platforms for highly sensitive magnetic detection. The SQUID performance is influenced by the non-sinusoidal current-phase relation (CPR) of NBJs. In this work, we measured the flux modulation of 10 asymmetric Nb SQUIDs based on three-dimensional NBJs, along with the CPR response in each device, which is mainly determined by the junction with the smaller critical current. By studying the CPR parameters (skewness Δ θ , critical current I c1 , and effective junction inductance L j ), together with the SQUID modulation characteristics (voltage modulation amplitude Δ I c R n and current modulation ratio Δ I c /2 I c1 ), we found that as I c1 increases from 0.6 μA to 6.6 μA and L j correspondingly decreases from 106 pH to 70 pH, the CPR skewness Δ θ increases from 0.2 rad to 1.5 rad. Over this range, Δ I c /2 I c1 decreases from 1.2 to 0.5, while Δ I c R n increases from about 0.06 mV to 0.22 mV. More specifically, Δ I c R n increases while Δ I c /2 I c1 decreases with increasing I c1 , whereas both quantities decrease with increasing L j . These results reveal a trade-off between intrinsic SQUID response and tolerance to readout noise, suggesting that improved performance can be achieved by engineering NBJs with increased I c1 and smaller L j .