Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Superconductor Science and Technology

Microstrip-coupled SNS Josephson junctions on p-type InAs

K Biedermann, T. Matsuyama, U. Merkt

Published Nov 1, 1999• 0 citations
Publisher

Abstract

We investigate the high-frequency (rf) coupling of two Nb/InAs(2DES)/Nb Josephson junctions coupled by a superconducting microstrip. One junction acts as a transmitter and the other one as a receiver. We report on the influence of the transmitter junction on the critical current and on the Fiske resonances of the receiver junction for different geometrical designs.

DOI
10.1088/0953-2048/12/11/337

Related papers

Josephson array oscillators with microstrip resonators

Akira Kawakami, Yoshinori Uzawa, Z. Wang

Interaction between two Josephson junctions and a microstrip resonator is investigated using a resonator shunted junction (RLCSJ) model. A sharp current step resulting from coupling with the resonator is observed in simulated I-V characteristics. There is strong phase-locking and decreasing of dynamic resistance at the current step. We design and fabricate two types of Josephson array oscillators using these effects to obtain stable phase locking and narrow linewidth for the oscillation. The fabricated oscillators are formed with nine shunted Nb/AlOx/Nb tunnel junctions and Nb microstrip resonators. The power of the oscillator delivered to the load resistor was estimated to be about 3.6 /spl mu/W at 330 GHz. A composite linewidth of the oscillators is also measured at about 19 MHz at 4.2 K using two oscillators with a log-periodic antenna and a SIS detector.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•14 citations

Superconducting transport in single and parallel double InAs quantum dot Josephson junctions with Nb-based superconducting electrodes

Shoji Baba, Juergen Sailer, Russell Deacon +4 more

We report conductance and supercurrent measurements for InAs single and parallel double quantum dot Josephson junctions contacted with Nb or NbTiN superconducting electrodes. Large superconducting gap energy, high critical field, and large switching current are observed, all reflecting the features of Nb-based electrodes. For the parallel double dots, we observe an enhanced supercurrent when both dots are on resonance, which may reflect split Cooper pair tunneling.

arXiv:1512.02344•Applied Physics Letters•Nov 30, 2015•14 citations

Resonator coupled Josephson junctions; parametric excitations and mutual locking

Hans Dalsgaard Jensen, A. Larsen, J. Mygind

Self-pumped parametric excitations and mutual locking in systems of Josephson tunnel junctions coupled to multimode resonators are reported. For the very large values of the coupling parameter, obtained with small Nb-Al/sub 2/O/sub 3/-Nb junctions integrated in superconducting microstrip resonators, the DC I-V characteristic shows an equidistant series of current steps generated by subharmonic pumping of the fundamental resonator mode. This is confirmed by measurement of frequency and linewidth of the emitted Josephson radiation.

IEEE Transactions on Magnetics•Mar 1, 1991•5 citations

Josephson soliton oscillators in a superconducting thin film resonator

J. Holm, J. Mygind, N. F. Pedersen +3 more

Josephson soliton oscillators integrated in a resonator consisting of two closely spaced coplanar superconducting microstrips have been investigated experimentally. Pairs of long 1-D Josephson junctions with a current density of about 1000 A/cm/sup 2/ were made using the Nb-AlO/sub x/-Nb trilayer technique. Different modes of half-wave resonances in the thin-film structure impose different magnetic field configurations at the boundaries of the junctions. The DC I-V characteristic shows zero-field steps with a number of resonator-induced steps. These structures are compared to RF-induced steps generated by phase-locking of the soliton motion to an external microwave source. The two different resonant configurations identified may be interpreted as a coupling to the microwave field at the end boundary and as a more homogeneous coupling distributed over the junction length.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•1 citation

SNS junction on Nb-Ti base for microwave circuits

M. Schubert, Ludwig Fritzsch, G. Wende +1 more

Superconductor-normal metal-superconductor (SNS) junctions are well-suited for large-scale integrated superconducting circuits. Potential applications are programmable voltage standards, digital-to-analog converters and large-scale RSFQ circuits. The application of SNS junctions provides some advantages, e.g. a simplified fabrication technology and reduced parasitic inductances. But it requires a technological process with dimensions down to the submicrometer region to achieve sufficiently high characteristic voltages I/sub C/R/sub N/. In our process the normal metal interlayer is titanium. Therefore the sidewall insulation of the junctions can be made by anodization, as it is known from the Nb-Al technology. Nb-Ti-Nb Josephson junctions and junction arrays were fabricated down to the submicrometer range with I/sub C/R/sub N/ values up to 87 microvolt depending on the titanium thickness. Their measured critical currents have a small spread of about 10 percent. Shapiro steps are observed under the influence of microwave irradiation. For the application of such junctions in a programmable Josephson voltage standard a new type of microwave circuit using coplanar strips is proposed and successfully tested in 10 V SIS circuits.

IEEE Transactions on Applied Superconductivity•Mar 1, 2001•12 citations

Microstrip resonances in superconducting circuits

Andrew D. Smith, Bruce J. Dalrymple, Arnold H. Silver +2 more

Josephson junctions connected to high Q microstriplines display current-steps which we attribute to standing wave resonances. The step voltages of the resonances depend on sample geometry and correspond to frequencies at which the loaded microstrip is resonant. The voltages of the resonances are insensitive to applied magnetic field and junction current density. Current step amplitudes scale with the zero-voltage critical current, and are largest for zero applied magnetic field. The strength of these resonant steps has important implications for biasing weakly damped Josephson junction circuits. In addition, the resonances are a useful tool for measuring microstrip properties.

IEEE Transactions on Magnetics•Mar 1, 1987•10 citations
We investigate the high-frequency (rf) coupling of two Nb/InAs(2DES)/Nb Josephson junctions coupled by a superconducting microstrip. One junction acts as a transmitter and the other one as a receiver. We report on the influence of the transmitter junction on the critical current and on the Fiske resonances of the receiver junction for different geometrical designs.
Interaction between two Josephson junctions and a microstrip resonator is investigated using a resonator shunted junction (RLCSJ) model. A sharp current step resulting from coupling with the resonator is observed in simulated I-V characteristics. There is strong phase-locking and decreasing of dynamic resistance at the current step. We design and fabricate two types of Josephson array oscillators using these effects to obtain stable phase locking and narrow linewidth for the oscillation. The fabricated oscillators are formed with nine shunted Nb/AlOx/Nb tunnel junctions and Nb microstrip resonators. The power of the oscillator delivered to the load resistor was estimated to be about 3.6 /spl mu/W at 330 GHz. A composite linewidth of the oscillators is also measured at about 19 MHz at 4.2 K using two oscillators with a log-periodic antenna and a SIS detector.
Self-pumped parametric excitations and mutual locking in systems of Josephson tunnel junctions coupled to multimode resonators are reported. For the very large values of the coupling parameter, obtained with small Nb-Al/sub 2/O/sub 3/-Nb junctions integrated in superconducting microstrip resonators, the DC I-V characteristic shows an equidistant series of current steps generated by subharmonic pumping of the fundamental resonator mode. This is confirmed by measurement of frequency and linewidth of the emitted Josephson radiation.
Josephson soliton oscillators integrated in a resonator consisting of two closely spaced coplanar superconducting microstrips have been investigated experimentally. Pairs of long 1-D Josephson junctions with a current density of about 1000 A/cm/sup 2/ were made using the Nb-AlO/sub x/-Nb trilayer technique. Different modes of half-wave resonances in the thin-film structure impose different magnetic field configurations at the boundaries of the junctions. The DC I-V characteristic shows zero-field steps with a number of resonator-induced steps. These structures are compared to RF-induced steps generated by phase-locking of the soliton motion to an external microwave source. The two different resonant configurations identified may be interpreted as a coupling to the microwave field at the end boundary and as a more homogeneous coupling distributed over the junction length.>
Superconductor-normal metal-superconductor (SNS) junctions are well-suited for large-scale integrated superconducting circuits. Potential applications are programmable voltage standards, digital-to-analog converters and large-scale RSFQ circuits. The application of SNS junctions provides some advantages, e.g. a simplified fabrication technology and reduced parasitic inductances. But it requires a technological process with dimensions down to the submicrometer region to achieve sufficiently high characteristic voltages I/sub C/R/sub N/. In our process the normal metal interlayer is titanium. Therefore the sidewall insulation of the junctions can be made by anodization, as it is known from the Nb-Al technology. Nb-Ti-Nb Josephson junctions and junction arrays were fabricated down to the submicrometer range with I/sub C/R/sub N/ values up to 87 microvolt depending on the titanium thickness. Their measured critical currents have a small spread of about 10 percent. Shapiro steps are observed under the influence of microwave irradiation. For the application of such junctions in a programmable Josephson voltage standard a new type of microwave circuit using coplanar strips is proposed and successfully tested in 10 V SIS circuits.
Josephson junctions connected to high Q microstriplines display current-steps which we attribute to standing wave resonances. The step voltages of the resonances depend on sample geometry and correspond to frequencies at which the loaded microstrip is resonant. The voltages of the resonances are insensitive to applied magnetic field and junction current density. Current step amplitudes scale with the zero-voltage critical current, and are largest for zero applied magnetic field. The strength of these resonant steps has important implications for biasing weakly damped Josephson junction circuits. In addition, the resonances are a useful tool for measuring microstrip properties.