Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Physics

Transverse Shapiro steps in a radio frequency driven superconducting Wheatstone bridge

G. Qian, Marc M. Cahay, R. Kothari

Published Mar 15, 1994• 3 citations
Publisher

Abstract

We study the current-voltage characteristics of a superconducting Wheatstone bridge in the presence of radio frequency current sources. Besides the regular integer Shapiro steps in the current-voltage characteristics observed when the voltage is measured between the input and output leads of the dc biasing current, we also found additional integer steps in the transverse voltage for large value of the dc biasing current. An explanation for these steps is given in terms of competing circulating currents in the bridge.

DOI
10.1063/1.356127

Related papers

Current-voltage characteristics of unbalanced superconducting Wheatstone bridges

Marc M. Cahay, G. Qian, Rohit C. Kothari

We compute the current-voltage characteristics of unbalanced superconducting Wheatstone bridges biased with constant and radio frequency current sources. An analytical expression for the critical supercurrent at which a nonzero voltage appears across the transverse junction of the bridge is derived. Analytical expressions of the first three Shapiro steps are also given and found to be in good agreement with numerical simulations.

Journal of Applied Physics•Aug 15, 1995•1 citation

Numerical investigation for the frequency dependence of Shapiro steps in an RF-field-driven SQUID

Yoshinao Mizugaki

Shapiro steps in an RF-field-driven dc-SQUID (RFDS), where an RF signal is coupled to the SQUID loop magnetically, are numerically investigated. We calculate the current–voltage characteristics of RFDSs under no dc offset flux, which show the enhancement of the even-order Shapiro steps. First, the maximum second (the lowest even-order) step height is evaluated as a function of the normalized frequency Ω. In the case of the inductance parameter βL ≥ 1.0, the maximum second step height is maintained at a certain value in the low frequency region. In the case of βL < 1.0, on the other hand, the maximum step height decreases in the low frequency region of Ω < 0.10. The dependence of the current positions of the step upon the RF signal amplitude shows that the voltage transition at the non-superconductive area between the superconducting interference lobes limits the upper current position of the step.

Superconductor Science and Technology•Nov 5, 2003•2 citations

Shapiro Steps Observed in a Superconducting Single Electron Transistor

Saxon Liou, Watson Kuo, Y. W. Suen +3 more

The dc current-voltage (Ⅳ) characteristics of a superconducting single electron transistor irradiated with microwaves up to 18 GHz are experimentally studied. The switching current as a function of gate voltage demonstrates clear phase-charge duality in a Josephson junction. At higher microwave power levels, Shapiro steps in Ⅳ characteristics are observed. The step height in Ⅳ can be analyzed using the model an ac-voltage source applied to a single Josephson junction.

Chinese Journal of Physics•Apr 1, 2007•3 citations

Shapiro steps in superconducting films with a periodic pinning potential

Lieve Van Look, Erik Rosseel, Margriet J. Van Bael +2 more

Shapiro voltage steps at voltages V n = nV 0 occur in the voltage-current characteristics of a superconducting film with a periodic pinning potential in the presence of rf radiation. We report on their experimental observation in a superconducting film with a square lattice of perforated microholes (antidots) and on numerical simulations showing the Shapiro steps in the voltage-current characteristics of the dc flux transformer. For the square antidot lattice, the ratio VQ/V of the step height to the applied rf frequency depends on the antidot lattice period d, while in the flux transformer geometry this ratio can be tuned by the magnetic field. This tuneability of the resolution makes the flux transformer a good candidate for applications (e.g. broad-band radiation detection).

Philosophical Magazine B•May 1, 2000•0 citations

Microwave induced steps in RF-field-driven DC SQUID and its potential applications

Takaharu Kondo, Yoshinao Mizugaki, J. Chen +2 more

We have been studying an RF-Field-driven DC SQUID (RFDS) that exhibits RF-induced-current-steps larger than those of single junctions at lower normalized frequency and a strong selection rule for the step orders which depends on the external DC magnetic field. In RFDS, even order steps are dominant in the absence of DC magnetic field. Contrarily, a DC magnetic field of a half flux quantum dominantly enhances odd order steps. Therefore the output of an RFDS can be switched between two voltage levels corresponding to the RF-induced-step by an external DC field input for a certain bias condition. We carried out numerical simulations to characterize the switching properties of the RFDS for various bias conditions, including RF circulating currents and DC bias current.

IEEE Transactions on Applied Superconductivity•Mar 1, 2001•0 citations

Missing Shapiro steps in nonhysteretic Josephson junction with 2 π periodic supercurrent

S. S. Ustavschikov, Denis Yu. Vodolazov

We theoretically demonstrate that in a nonhysteretic Josephson junction (JJ) with a $2\ensuremath{\pi}$ periodic supercurrent in the presence of radio-frequency (RF) radiation one or several low-lying Shapiro steps could be absent in the voltage-current $(VI)$ characteristic. The effect exists at low RF power and at frequencies $f$ approximately ten times smaller than ${f}_{0}={I}_{c}{R}_{N}/{\mathrm{\ensuremath{\Phi}}}_{0}$ (where ${I}_{c}$ is the critical current, ${R}_{N}$ is the normal-state resistance of the Josephson junction, and ${\mathrm{\ensuremath{\Phi}}}_{0}$ is the magnetic flux quantum). The origin of the effect is related to the large differential resistance ${R}_{\mathrm{diff}}=dV/dI$ near $I\ensuremath{\simeq}{I}_{c}$, which is significantly greater than the value predicted by the resistively capacitance shunted junction (RCSJ) model in the overdamped limit. Our theoretical results are supported by experiments on Nb/NbSi/Nb Josephson junctions with nonhysteretic $VI$ curves, where we observe the absence of one or more low-lying Shapiro steps, depending on the frequency and power of the RF radiation.

Physical review. B./Physical review. B•Nov 14, 2024•2 citations
We study the current-voltage characteristics of a superconducting Wheatstone bridge in the presence of radio frequency current sources. Besides the regular integer Shapiro steps in the current-voltage characteristics observed when the voltage is measured between the input and output leads of the dc biasing current, we also found additional integer steps in the transverse voltage for large value of the dc biasing current. An explanation for these steps is given in terms of competing circulating currents in the bridge.
Shapiro steps in an RF-field-driven dc-SQUID (RFDS), where an RF signal is coupled to the SQUID loop magnetically, are numerically investigated. We calculate the current–voltage characteristics of RFDSs under no dc offset flux, which show the enhancement of the even-order Shapiro steps. First, the maximum second (the lowest even-order) step height is evaluated as a function of the normalized frequency Ω. In the case of the inductance parameter βL ≥ 1.0, the maximum second step height is maintained at a certain value in the low frequency region. In the case of βL < 1.0, on the other hand, the maximum step height decreases in the low frequency region of Ω < 0.10. The dependence of the current positions of the step upon the RF signal amplitude shows that the voltage transition at the non-superconductive area between the superconducting interference lobes limits the upper current position of the step.
Shapiro voltage steps at voltages V n = nV 0 occur in the voltage-current characteristics of a superconducting film with a periodic pinning potential in the presence of rf radiation. We report on their experimental observation in a superconducting film with a square lattice of perforated microholes (antidots) and on numerical simulations showing the Shapiro steps in the voltage-current characteristics of the dc flux transformer. For the square antidot lattice, the ratio VQ/V of the step height to the applied rf frequency depends on the antidot lattice period d, while in the flux transformer geometry this ratio can be tuned by the magnetic field. This tuneability of the resolution makes the flux transformer a good candidate for applications (e.g. broad-band radiation detection).
We have been studying an RF-Field-driven DC SQUID (RFDS) that exhibits RF-induced-current-steps larger than those of single junctions at lower normalized frequency and a strong selection rule for the step orders which depends on the external DC magnetic field. In RFDS, even order steps are dominant in the absence of DC magnetic field. Contrarily, a DC magnetic field of a half flux quantum dominantly enhances odd order steps. Therefore the output of an RFDS can be switched between two voltage levels corresponding to the RF-induced-step by an external DC field input for a certain bias condition. We carried out numerical simulations to characterize the switching properties of the RFDS for various bias conditions, including RF circulating currents and DC bias current.
We theoretically demonstrate that in a nonhysteretic Josephson junction (JJ) with a $2\ensuremath{\pi}$ periodic supercurrent in the presence of radio-frequency (RF) radiation one or several low-lying Shapiro steps could be absent in the voltage-current (VI)(VI)(VI) characteristic. The effect exists at low RF power and at frequencies fff approximately ten times smaller than ${f}_{0}={I}_{c}{R}_{N}/{\mathrm{\ensuremath{\Phi}}}_{0}$ (where Ic{I}_{c}Ic​ is the critical current, RN{R}_{N}RN​ is the normal-state resistance of the Josephson junction, and ${\mathrm{\ensuremath{\Phi}}}_{0}$ is the magnetic flux quantum). The origin of the effect is related to the large differential resistance Rdiff=dV/dI{R}_{\mathrm{diff}}=dV/dIRdiff​=dV/dI near $I\ensuremath{\simeq}{I}_{c}$, which is significantly greater than the value predicted by the resistively capacitance shunted junction (RCSJ) model in the overdamped limit. Our theoretical results are supported by experiments on Nb/NbSi/Nb Josephson junctions with nonhysteretic VIVIVI curves, where we observe the absence of one or more low-lying Shapiro steps, depending on the frequency and power of the RF radiation.