The theory in which the laser is interpreted as a nonlinear amplifier and filter is applied to the calculation of its spectral density in the case of a homogeneous medium. The method is extended to an injected laser in which the source term includes both the spontaneous emission and the injected signal. Linewidth narrowing or widening, spectral amplification or attenuation are described, using simple semiclassical formulas.
The theory in which the laser is interpreted as a nonlinear amplifier and filter is applied to the calculation of its spectral density in the case of a homogeneous medium. The method is extended to an injected laser in which the source term includes both the spontaneous emission and the injected signal. Linewidth narrowing or widening, spectral amplification or attenuation are described, using simple semiclassical formulas.
The process of amplification of light by a laser set above its oscillation threshold is studied. This laser has a wide bandwidth (typically 100 MHz) and is injected by a signal whose bandwidth is much narrower, which allows to separate the amplified signal from the ordinary laser spectral density. Theoretical calculations are based on simple semiclassical formulas and agree with the experimental results which are performed at 1.55 μm using single-mode semiconductor lasers. The amplification arises from a progressive channeling of energy from the wider laser line onto the narrow injected signal.
The theory of the laser amplifier is developed for conditions in which the strength of the input signal is increased from small values, where the amplification is linear, to larger values, where the amplification becomes nonlinear. The below-threshold laser amplifier oscillates at a single frequency equal to that of the input signal, and its properties are found by solution of the nonlinear equation of motion for the single excitation amplitude. For the above-threshold laser amplifier, the effects of the nonlinear behavior are to shift the laser frequency from its free-running value and to transfer intensity from the laser line to the signal frequency and to a range of satellite lines, whose frequency detunings are integer multiples of the signal detuning. The intensities of the various emission lines of the laser are calculated by power-series expansions of the field amplitudes up to terms of fourth order in the input signal strength. The onset of injection locking is determined by the conditions for which the intensity at the shifted free-running laser frequency falls to zero. The injection-locked state is characterized by a single excitation frequency equal to that of the input signal, and its properties are found by solution of the same nonlinear equation of motion as for the below-threshold amplifier. The ranges of input signal strength and detuning are determined for which the injection-locked state is stable. The energy conservation properties of the laser amplifier are considered for each of its operating states. \textcopyright{} 1996 The American Physical Society.
The amplification of noise in a laser amplifier is treated theoretically. The model for the active medium and its description using density-matrix techniques, are taken from the theory of laser operation. The fundamental concern of this investigation is the spectral behavior of the radiation in the nonlinear regime; hence, the formalism is written from the onset in the frequency domain. The statistics of the light are gradually modified by the nonlinear amplification process, and expressions are derived for the rate of change of fluctuations in intensity as a measure of statistical changes. These expressions should be easily susceptible to detailed experimental observations. In addition, the range of validity of Litvak's Gaussian-statistics approximation is discussed with some detail. In the homogeneous-broadening case, the evolution of initially broadband Gaussian radiation toward quasimonochromatic oscillations with laserlike statistics is extensively explored in several numerical examples. The connections of this study with the time-domain work of Risken and Nummedal, on self-pulsing in a ring-laser configuration, are clearly established. Finally, spectral-narrowing and -rebroadening effects in Doppler-broadened media are discussed both analytically and with numerical examples. These examples show the distinct contribution of pulsations in the population ("Raman-type terms"), and saturation phenomena. The predicted narrowing-rebroadening rate is compared with expressions found in previous literature.
A theory is described which accounts for the dependence of the spectral distribution of amplified spontaneous emission on the length and inversion density of the active medium. For an inhomogeneously broadened line an unanticipated dip occurs in the plot of linewidth against length at lengths slightly greater than the critical length, but is explained by a simple physical analysis. Agreement occurs between the theory and that of Yariv and Leite (1963) in the regime over which their theory is expected to work. Observations by other workers on the spectral distribution of amplified spontaneous emission systems are discussed.
Using semiclassical radiation theory, a formalism similar to that used by Lamb in his Theory of an Optical Maser is developed for studying the amplification of vector traveling waves in a laser-type medium. The effect of the medium on the waves is given in terms of space (or time) dependent field amplitudes and phases and a nonlinear index of refraction. With particular emphasis on typical gaseous media, the effects of Doppler broadening are treated in detail for arbitrary ratios of natural to Doppler linewidths. Polarization and propagation vectors in various directions are considered, and the nonlinear effects are found to make an isotropic medium effectively anisotropic.
Lowest order nonlinear effects (due to a polarization cubic in the field amplitudes) are studied extensively, and the frequency dependence of several of these processes is presented in graphical form. In particular, the introduction of fields at new frequencies and polarization effects are considered. The characteristics of these nonlinear processes peculiar to Doppler broadened lines are discussed, and the processes are interpreted in terms of saturation and coherent modulation of the population inversion density.
Strong nonlinear effects are considered in a more approximate way and are found to consist of saturation of the various linear and nonlinear processes previously considered. These strong nonlinear effects should occur at low enough intensities to be easily observed in practice on a CW basis. With the present formalism, the analytical results of Gordon, White and Rigden regarding gain saturation in laser amplifiers are obtained, and the extension is made to include frequencies away from line center and the effects of multiple spectral components. Again, the introduction of fields at new frequencies is considered in detail. These results are also discussed in terms of saturation and coherent modulation of the populations and hole burning.
Introduction In this chapter we will present the theory of spectral gain in optical amplifiers and the related optical power distribution. The concepts are general, as they apply to every optical amplifier configuration, independent of the specific architecture and implementation technology. We will configure the optical amplifying medium as a traveling-wave device, where the optical field undergoes optical amplification as it propagates from the input to the output sections. Generally speaking, optical amplification is achieved by a net stimulated emission process. Referring to a generic section z of infinitesimal thickness dz , optical gain is determined by the imbalance between net stimulated emission and cavity losses, including extrinsic absorption, reflection and radiated fields. As we know from the theory of light amplification in the three-level atomic system presented in Chapter 5, stimulated absorption of photons is governed by the same transition rate as stimulated emission, and is included in the net stimulated emission process. With this in mind, we note the identity between stimulated emission and the stimulated absorption rates, Γ 12 = Γ 21 , and the net stimulated photon term Γ[ j 2 ( t ) – j 1 ( t )] p ( t ) in the rate equation. In order to develop the traveling-wave model, the photon density becomes a function of the longitudinal position 0 ≤ z ≤ L along the amplifier medium. Accordingly, we will set p ( t , z ) as the relative density of stimulated photons per unit volume (0 ≤ p ( t , z ) ≤ 1) at time t and section z . When photons with appropriate energy proceed along the amplifying medium, they are amplified by means of net stimulated emission. At some section z = z 0 , the steady-state photon density P ( z ) can approach the saturation density P sat ( z ).