Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)

Lasing of cesium active optical clock with 459 nm laser pumping

Duo Pan, Zhichao Xu, Xiaobo Xue, Wei Zhuang, Jingbiao Chen

Published May 1, 2014• 18 citations
Publisher

Abstract

We realize the lasing of cesium active optical clock with 459 nm laser pumping, which operates deep in the optical bad-cavity regime. The ratio between cavity bandwidth and gain bandwidth is 55.08 theoretically. With 459 nm laser pumping, the population inversion occurs between the cesium 7S1/2state and 6P3/2state, and the stimulated radiation between the two states is realized. The 1469.9 nm output signal of cesium active optical clock can reach a power of 8 μW. The output power also shows a threshold character with pumping laser power and can be influenced by the Cs cell temperature. This active optical clock has an advantage in stability over the conventional optical clocks, due to its suppression of cavity pulling effect, which is also demonstrated experimentally.

DOI
10.1109/fcs.2014.6859908

Related papers

Cesium active optical clock in four-level laser configuration

Yanfei Wang, Xiaobo Xue, Dongying Wang +5 more

We propose an active optical clock scheme in four-level configuration with cesium atoms. The population inversion has been established experimentally between 7S1/2state and 6P3/2state in a thermal cesium cell with a 455.5 nm pumping laser. It can be used to generate active optical clock laser output in a bad cavity laser regime at the wavelength of 1469 nm.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 1, 2012•8 citations

Lasing and suppressed cavity-pulling effect of Cesium active optical clock

Zhichao Xu, Wei Zhuang, Jingbiao Chen

We experimentally demonstrate the collective emission behavior and suppressed cavity-pulling effect of four-level active optical clock with Cesium atoms. Thermal Cesium atoms in a glass cell velocity selective pumped with a 455.5 nm laser operating at 6S$_{1/2}$ to 7P$_{3/2}$ transition are used as lasing medium. Population inverted Cesium atoms between 7S$_{1/2}$ and 6P$_{3/2}$ levels are optical weakly coupled by a pair cavity mirrors working at deep bad-cavity regime with a finesse of 4.3, and the ratio between cavity bandwidth and gain bandwidth is approximately 45. With increased 455.5 nm pumping laser intensity, the output power of cesium active optical clock at 1469.9 nm from 7S$_{1/2}$ level to 6P$_{3/2}$ level shows a threshold and reach a power of 13 $μ$W. Active optical clock would dramatically improve the optical clock stability since the lasing frequency does not follow the cavity length variation exactly, but in a form of suppressed cavity pulling effect. In this letter the cavity pulling effect is measured using a Fabry-Perot interferometer (FPI) to be reduced by a factor of 38.2 and 41.4 as the detuning between the 1469.9 nm cavity length of the Cs active optical clock and the Cs 1469.9 nm transition is set to be 140.8 MHz and 281.6 MHz respectively. The mechanism demonstrated here is of great significance for new generation optical clocks and can be applied to improve the stability of best optical clocks by at least two orders of magnitude.

arXiv:1404.6021•Apr 24, 2014•5 citations

Lasing of Cesium four-level active optical clock

Zhichao Xu, Wei Zhuang, Yanfei Wang +5 more

We are setting up an experiment to investigate an active optical clock scheme in four-level configuration with Cesium atoms. The 1469 nm Cesium active optical clock output in a bad cavity laser regime is generated and the wavelength is measured to be 1469.500 nm by using spectrometer. The 1469 nm lasing threshold and output power is measured when changing 455 nm pumping laser power and frequency. The 1469 nm Cesium active optical clock output multi-threshold is observed when changing bad-cavity length. We also sweep the bad-cavity length and measure the 1469 nm Cesium active optical clock output frequency using a wavelength meter, proving the cavity-pulling reduction due to the bad-cavity effect.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Jul 1, 2013•13 citations

Research on Cs active Faraday optical frequency standard with 459 nm laser pumping

Xiaogang Zhang, Zhaojie Jiang, Zhiming Tao +3 more

Known as a unique optical clock, active optical clock has prior advantages to surpass the limitation of the conventional optical clock in potential stability. In this paper, we proposed an improved Cesium active Faraday optical frequency standard with 459 nm laser pumping. This scheme reduces the residual Doppler broadening in previous results with 852 nm laser pumping. The transmission is 2.4% and the bandwidth of the transmission peak is 12.3 MHz. It greatly narrows the bandwidth of Faraday anomalous dispersion optical filter and decreases the length of the bad cavity used in Cesium active Faraday optical frequency standard. This will be very helpful for further suppression of cavity pulling effect.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 1, 2016•1 citation

Dual-Wavelength Bad Cavity Laser as Potential Active Optical Frequency Standard

Zhi-Chao Xu, Duo Pan, Wei Zhuang +1 more

We experimentally realize the dual-wavelength bad cavity laser for the first time. As the Cs cell temperature is kept between 118°C and 144°C, both the 1359 nm and 1470 nm lasing outputs of dual-wavelength bad cavity laser are detected. The laser output power of dual-wavelength bad cavity laser is measured when changing the 455 nm pumping laser frequency and power at 127°C Cs cell temperature. Both the 1359 nm laser and the 1470 nm laser are working at the deep bad cavity regime, and the ratio between the linewidth of cavity mode and the laser gain bandwidth a ≈ 40 for 1359 nm and 1470 nm lasers. The 1470 nm laser linewidth is measured to be 407.3 Hz. The dual-wavelength bad cavity laser operating on atomic transitions demonstrated here has a potential in the application as a stable optical local oscillator, even an active optical frequency standard directly in the future.

Chinese Physics Letters•Sep 1, 2015•13 citations

Dual-wavelength active optical clock

Zhichao Xu, Duo Pan, Wei Zhuang +1 more

We experimentally realize the dual-wavelength active optical clock for the first time. As the Cs cell temperature is kept between 118 $^{\circ }C$ and 144 $^{\circ }C$, both the 1359 nm and the 1470 nm stimulated emission output of Cs four-level active optical clock are detected. The 1470 nm output linewidth of each experimental setup of Cs four-level active optical clock is measured to be 590 Hz with the main cavity length unstabilized. To stabilize the cavity length of active optical clock, the experimental scheme of 633 nm and 1359 nm good-bad cavity dual-wavelength active optical clock is proposed, where 633 nm and 1359 nm stimulated emission is working at good-cavity and bad-cavity regime respectively. The cavity length is stabilized by locking the 633 nm output frequency to a super-cavity with the Pound-Drever-Hall (PDH) technique. The frequency stability of 1359 nm bad-cavity stimulated emission output is then expected to be further improved by at least 1 order of magnitude than the 633 nm PDH system due to the suppressed cavity pulling effect of active optical clock, and the quantum limited linewidth of 1359 nm output is estimated to be 77.6 mHz.

arXiv:1407.1505•Jul 6, 2014•2 citations
We realize the lasing of cesium active optical clock with 459 nm laser pumping, which operates deep in the optical bad-cavity regime. The ratio between cavity bandwidth and gain bandwidth is 55.08 theoretically. With 459 nm laser pumping, the population inversion occurs between the cesium 7S1/2state and 6P3/2state, and the stimulated radiation between the two states is realized. The 1469.9 nm output signal of cesium active optical clock can reach a power of 8 μW. The output power also shows a threshold character with pumping laser power and can be influenced by the Cs cell temperature. This active optical clock has an advantage in stability over the conventional optical clocks, due to its suppression of cavity pulling effect, which is also demonstrated experimentally.
We experimentally demonstrate the collective emission behavior and suppressed cavity-pulling effect of four-level active optical clock with Cesium atoms. Thermal Cesium atoms in a glass cell velocity selective pumped with a 455.5 nm laser operating at 6S1/2_{1/2}1/2​ to 7P3/2_{3/2}3/2​ transition are used as lasing medium. Population inverted Cesium atoms between 7S1/2_{1/2}1/2​ and 6P3/2_{3/2}3/2​ levels are optical weakly coupled by a pair cavity mirrors working at deep bad-cavity regime with a finesse of 4.3, and the ratio between cavity bandwidth and gain bandwidth is approximately 45. With increased 455.5 nm pumping laser intensity, the output power of cesium active optical clock at 1469.9 nm from 7S1/2_{1/2}1/2​ level to 6P3/2_{3/2}3/2​ level shows a threshold and reach a power of 13 μμμW. Active optical clock would dramatically improve the optical clock stability since the lasing frequency does not follow the cavity length variation exactly, but in a form of suppressed cavity pulling effect. In this letter the cavity pulling effect is measured using a Fabry-Perot interferometer (FPI) to be reduced by a factor of 38.2 and 41.4 as the detuning between the 1469.9 nm cavity length of the Cs active optical clock and the Cs 1469.9 nm transition is set to be 140.8 MHz and 281.6 MHz respectively. The mechanism demonstrated here is of great significance for new generation optical clocks and can be applied to improve the stability of best optical clocks by at least two orders of magnitude.
We are setting up an experiment to investigate an active optical clock scheme in four-level configuration with Cesium atoms. The 1469 nm Cesium active optical clock output in a bad cavity laser regime is generated and the wavelength is measured to be 1469.500 nm by using spectrometer. The 1469 nm lasing threshold and output power is measured when changing 455 nm pumping laser power and frequency. The 1469 nm Cesium active optical clock output multi-threshold is observed when changing bad-cavity length. We also sweep the bad-cavity length and measure the 1469 nm Cesium active optical clock output frequency using a wavelength meter, proving the cavity-pulling reduction due to the bad-cavity effect.
Known as a unique optical clock, active optical clock has prior advantages to surpass the limitation of the conventional optical clock in potential stability. In this paper, we proposed an improved Cesium active Faraday optical frequency standard with 459 nm laser pumping. This scheme reduces the residual Doppler broadening in previous results with 852 nm laser pumping. The transmission is 2.4% and the bandwidth of the transmission peak is 12.3 MHz. It greatly narrows the bandwidth of Faraday anomalous dispersion optical filter and decreases the length of the bad cavity used in Cesium active Faraday optical frequency standard. This will be very helpful for further suppression of cavity pulling effect.
We experimentally realize the dual-wavelength bad cavity laser for the first time. As the Cs cell temperature is kept between 118°C and 144°C, both the 1359 nm and 1470 nm lasing outputs of dual-wavelength bad cavity laser are detected. The laser output power of dual-wavelength bad cavity laser is measured when changing the 455 nm pumping laser frequency and power at 127°C Cs cell temperature. Both the 1359 nm laser and the 1470 nm laser are working at the deep bad cavity regime, and the ratio between the linewidth of cavity mode and the laser gain bandwidth a ≈ 40 for 1359 nm and 1470 nm lasers. The 1470 nm laser linewidth is measured to be 407.3 Hz. The dual-wavelength bad cavity laser operating on atomic transitions demonstrated here has a potential in the application as a stable optical local oscillator, even an active optical frequency standard directly in the future.
We experimentally realize the dual-wavelength active optical clock for the first time. As the Cs cell temperature is kept between 118 ∘C^{\circ }C∘C and 144 ∘C^{\circ }C∘C, both the 1359 nm and the 1470 nm stimulated emission output of Cs four-level active optical clock are detected. The 1470 nm output linewidth of each experimental setup of Cs four-level active optical clock is measured to be 590 Hz with the main cavity length unstabilized. To stabilize the cavity length of active optical clock, the experimental scheme of 633 nm and 1359 nm good-bad cavity dual-wavelength active optical clock is proposed, where 633 nm and 1359 nm stimulated emission is working at good-cavity and bad-cavity regime respectively. The cavity length is stabilized by locking the 633 nm output frequency to a super-cavity with the Pound-Drever-Hall (PDH) technique. The frequency stability of 1359 nm bad-cavity stimulated emission output is then expected to be further improved by at least 1 order of magnitude than the 633 nm PDH system due to the suppressed cavity pulling effect of active optical clock, and the quantum limited linewidth of 1359 nm output is estimated to be 77.6 mHz.