Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Modern Optics

Two-dimensional infrared and mid-infrared imaging by single-photon frequency upconversion

Ruikai Tang, Wenjie Wu, Xiongjie Li, Haifeng Pan, E Wu, Heping Zeng

Published Mar 17, 2015• 15 citations
Publisher

Abstract

Single-photon frequency upconversion is an effective method of infrared single-photon detection and imaging by converting the long-wavelength photons to shorter wavelengths to match the detector’s spectral response. We realized few-photon level 2D infrared imaging with a coincidence frequency upconversion system in a bulk periodically poled lithium niobate crystal. Moreover, the infrared photons carrying orbital angular momentum were converted to the visible regime with high efficiency, while the orbital angular momentum of the photons was well conserved during the frequency upconversion process. The single-photon frequency upconversion method was also used for mid-infrared imaging at 3.39 µm with high efficiency and low noise.

DOI
10.1080/09500340.2015.1021722

Related papers

New results on single-photon upconversion

Aaron P. VanDevender, Paul G. Kwiat

The process of up-conversion is shown to enable superior single-photon detectors in the infrared, compared to InGaAs and germanium Avalanche Photodiodes (APDs) (normally used for IR single photon detection). After up-converting an infrared photon to a visible one in a non-linear crystal-Periodically Poled Lithium Niobate (PPLN)-we use a silicon APD to efficiently detect the frequency up-shifted IR photon. We have demonstrated this process at the "high-intensity" level and at the single-photon level, where the up-converted state is effectively a superposition of the single photon Fock state and the vacuum state. We achieve an 80% conversion efficiency over the width of the pulse, and show that this process is coherent, a necessary ingredient for many applications.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 19, 2004•1 citation

Quantum information applications of frequency upconversion

Aaron P. VanDevender

We demonstrate the utility of frequency upconversion in a non-linear crystal for quantum information applications. By combining a bright “escort” beam with a signal photon inside of a periodically poled lithium niobate (PPLN) crystal, we are able to achieve near unit conversion efficiency. We use this conversion process to create high-efficiency infrared single-photon detectors by upconverting infrared photons to visible ones and using efficient silicon avalanche photo diodes to detect the upconverted photon. We have achieved a net system detection efficiency of 56%, far superior to previous methods for infrared photon detection. We also demonstrate the phase coherence of the upconversion process, which enables it to convert photonic qubits from one wavelength to another, potentially allowing quantum networks of disparate operating wavelengths to communicate efficiently. This quantum “transduction” feature is observed by upconverting photons passed between two unbalanced Michelson interferometers that create and measure time-bin qubits, similar to those used in many quantum cryptography systems, and verifying that the phase of the qubits is preserved. The Rabi oscillation-like behavior of upconversion is also demonstrated, allowing for the creation and manipulation of highly non-degenerate frequency qubits. These states may be used in conjunction with other degrees of freedom such as polarization, time-bin, or orbital angular momentum states to enlarge the usable single-photon Hilbert space and create a rich vocabulary for transmission of quantum information.

•Jan 1, 2007•0 citations

Ultrashort Laser Pulses for Frequency Upconversion

Kun Huang, E Wu, Xiaorong Gu +2 more

Single-photon frequency upconversion is a nonlinear process where the frequency of the signal photon is translated to the higher frequency with the complete preservation of all the quantum characteristics of the “flying” qubits [1,2]. One promising application of the singlephoton frequency upconversion is converting the infrared photons to the desired spectral regime (usually visible regime) where the high performance detectors are available for sensitive detections [3-6]. The infrared single-photon frequency upconversion detection technique has been successfully used in a variety of applications, including infrared imaging [7] and infrared ultra-sensitive spectroscopy [8,9]. Additionally, such upconversion detector has greatly benefited the applications stringently requiring efficient photon detection in optical quantum computation and communication [10-12]. Furthermore, due to the phase-matching requirement in the frequency upconversion process, the upconversion detectors have some unique features, such as narrow-band wavelength acceptance [13] and polarization sensitivity [14], both of which render them very useful for fiber based quantum systems [15]. In the recent decade, experiments bear that the photon correlation, entanglement, and photon statistics are all well preserved in the coherent frequency upconversion [16-18].

InTech eBooks•Oct 17, 2012•1 citation

High-efficiency single photon detection via frequency up-conversion

Aaron P. VanDevender, Paul G. Kwiat

We propose a method of single photon detection of infrared (IR) photons at potentially higher efficiencies and lower noise than allowed by traditional IR band Avalanche Photodiodes (APD). By up-converting the photon from IR, e.g., 1550 nm, to a visible wavelength in a nonlinear crystal, we can utilize the much higher efficiency of visible wavelength APDs. We have used a nonlinear crystal -- Periodically Poled Lithium Niobate (PPLN) -- and a pulsed 1064-nm Nd:YAG laser to perform the up-conversion to a 631-nm photon. When properly quasi-phase-matched, PPLN provides a large enough second order nonlinear susceptibility that near unit conversion efficiency of the IR photon into the visible should be possible. We have been able to observe peak conversion efficiencies as high as 80%, and have demonstrated scaling down to the single photon level while maintaining a background of 3 x 10-4 dark counts/count. Since the PPLN only acts on one polarization of the single photon, we also propose a 2-crystal extension of this scheme whereby orthogonal polarizations may be up-converted coherently, thereby enabling complete quantum state transduction.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 5, 2003•8 citations

High-Efficiency Broadband Near-Infrared Single-Photon Frequency Upconversion and Detection*

Jianhui Ma, Huiqin Hu, Yu Chen +3 more

We propose and demonstrate a high efficiency broadband near infrared single-photon upconversion and detection with a broadband pump laser based on sum frequency conversion in the PPLN crystal. By using a pump laser centered at 1040 nm with a spectral bandwidth of 10 nm, the signal single-photons centered at 1562 nm with a broadband bandwidth up to 7.2 nm are frequency-converted from the near infrared to the visible regime. A maximum conversion efficiency of 18.8% is achieved, while the background noise is measured to be only 1.2 × 10−3 counts/pulse. The corresponding spectral linewidth of the upconverted photons is 0.2 nm. This scheme of broadband infrared single-photon upconversion and detection provides potential solutions in infrared laser ranging, broadband infrared imaging and quantum key distribution.

Chinese Physics Letters•Mar 1, 2020•3 citations

High efficiency single photon detection via frequency up-conversion

Aaron P. VanDevender, Paul G. Kwiat

We propose a method of single photon detection of infrared (IR) photons at potentially higher efficiencies and lower noise than allowed by traditional IR band avalanche photodiodes (APDs). By up-converting the photon from the IR, e.g. 1550 nm, to a visible wavelength in a nonlinear crystal, we can utilize the much higher efficiency of silicon APDs at these wavelengths. We have used a periodically poled lithium niobate (PPLN) crystal and a pulsed 1064 nm Nd:YAG laser to perform the up-conversion to a 631 nm photon. We observed conversion efficiencies as high as ∼ 80%, and demonstrated scaling down to the single photon level while maintaining a background of 3 ×s; 10−4 dark counts per count. We also propose a 2-crystal extension of this scheme, whereby orthogonal polarizations may be up-converted coherently, thus enabling complete quantum state transduction of arbitrary states.

Journal of Modern Optics•Jun 1, 2004•214 citations
Single-photon frequency upconversion is an effective method of infrared single-photon detection and imaging by converting the long-wavelength photons to shorter wavelengths to match the detector’s spectral response. We realized few-photon level 2D infrared imaging with a coincidence frequency upconversion system in a bulk periodically poled lithium niobate crystal. Moreover, the infrared photons carrying orbital angular momentum were converted to the visible regime with high efficiency, while the orbital angular momentum of the photons was well conserved during the frequency upconversion process. The single-photon frequency upconversion method was also used for mid-infrared imaging at 3.39 µm with high efficiency and low noise.
The process of up-conversion is shown to enable superior single-photon detectors in the infrared, compared to InGaAs and germanium Avalanche Photodiodes (APDs) (normally used for IR single photon detection). After up-converting an infrared photon to a visible one in a non-linear crystal-Periodically Poled Lithium Niobate (PPLN)-we use a silicon APD to efficiently detect the frequency up-shifted IR photon. We have demonstrated this process at the "high-intensity" level and at the single-photon level, where the up-converted state is effectively a superposition of the single photon Fock state and the vacuum state. We achieve an 80% conversion efficiency over the width of the pulse, and show that this process is coherent, a necessary ingredient for many applications.
We demonstrate the utility of frequency upconversion in a non-linear crystal for quantum information applications. By combining a bright “escort” beam with a signal photon inside of a periodically poled lithium niobate (PPLN) crystal, we are able to achieve near unit conversion efficiency. We use this conversion process to create high-efficiency infrared single-photon detectors by upconverting infrared photons to visible ones and using efficient silicon avalanche photo diodes to detect the upconverted photon. We have achieved a net system detection efficiency of 56%, far superior to previous methods for infrared photon detection. We also demonstrate the phase coherence of the upconversion process, which enables it to convert photonic qubits from one wavelength to another, potentially allowing quantum networks of disparate operating wavelengths to communicate efficiently. This quantum “transduction” feature is observed by upconverting photons passed between two unbalanced Michelson interferometers that create and measure time-bin qubits, similar to those used in many quantum cryptography systems, and verifying that the phase of the qubits is preserved. The Rabi oscillation-like behavior of upconversion is also demonstrated, allowing for the creation and manipulation of highly non-degenerate frequency qubits. These states may be used in conjunction with other degrees of freedom such as polarization, time-bin, or orbital angular momentum states to enlarge the usable single-photon Hilbert space and create a rich vocabulary for transmission of quantum information.
Single-photon frequency upconversion is a nonlinear process where the frequency of the signal photon is translated to the higher frequency with the complete preservation of all the quantum characteristics of the “flying” qubits [1,2]. One promising application of the singlephoton frequency upconversion is converting the infrared photons to the desired spectral regime (usually visible regime) where the high performance detectors are available for sensitive detections [3-6]. The infrared single-photon frequency upconversion detection technique has been successfully used in a variety of applications, including infrared imaging [7] and infrared ultra-sensitive spectroscopy [8,9]. Additionally, such upconversion detector has greatly benefited the applications stringently requiring efficient photon detection in optical quantum computation and communication [10-12]. Furthermore, due to the phase-matching requirement in the frequency upconversion process, the upconversion detectors have some unique features, such as narrow-band wavelength acceptance [13] and polarization sensitivity [14], both of which render them very useful for fiber based quantum systems [15]. In the recent decade, experiments bear that the photon correlation, entanglement, and photon statistics are all well preserved in the coherent frequency upconversion [16-18].
We propose a method of single photon detection of infrared (IR) photons at potentially higher efficiencies and lower noise than allowed by traditional IR band Avalanche Photodiodes (APD). By up-converting the photon from IR, e.g., 1550 nm, to a visible wavelength in a nonlinear crystal, we can utilize the much higher efficiency of visible wavelength APDs. We have used a nonlinear crystal -- Periodically Poled Lithium Niobate (PPLN) -- and a pulsed 1064-nm Nd:YAG laser to perform the up-conversion to a 631-nm photon. When properly quasi-phase-matched, PPLN provides a large enough second order nonlinear susceptibility that near unit conversion efficiency of the IR photon into the visible should be possible. We have been able to observe peak conversion efficiencies as high as 80%, and have demonstrated scaling down to the single photon level while maintaining a background of 3 x 10-4 dark counts/count. Since the PPLN only acts on one polarization of the single photon, we also propose a 2-crystal extension of this scheme whereby orthogonal polarizations may be up-converted coherently, thereby enabling complete quantum state transduction.
We propose and demonstrate a high efficiency broadband near infrared single-photon upconversion and detection with a broadband pump laser based on sum frequency conversion in the PPLN crystal. By using a pump laser centered at 1040 nm with a spectral bandwidth of 10 nm, the signal single-photons centered at 1562 nm with a broadband bandwidth up to 7.2 nm are frequency-converted from the near infrared to the visible regime. A maximum conversion efficiency of 18.8% is achieved, while the background noise is measured to be only 1.2 × 10−3 counts/pulse. The corresponding spectral linewidth of the upconverted photons is 0.2 nm. This scheme of broadband infrared single-photon upconversion and detection provides potential solutions in infrared laser ranging, broadband infrared imaging and quantum key distribution.
We propose a method of single photon detection of infrared (IR) photons at potentially higher efficiencies and lower noise than allowed by traditional IR band avalanche photodiodes (APDs). By up-converting the photon from the IR, e.g. 1550 nm, to a visible wavelength in a nonlinear crystal, we can utilize the much higher efficiency of silicon APDs at these wavelengths. We have used a periodically poled lithium niobate (PPLN) crystal and a pulsed 1064 nm Nd:YAG laser to perform the up-conversion to a 631 nm photon. We observed conversion efficiencies as high as ∼ 80%, and demonstrated scaling down to the single photon level while maintaining a background of 3 ×s; 10−4 dark counts per count. We also propose a 2-crystal extension of this scheme, whereby orthogonal polarizations may be up-converted coherently, thus enabling complete quantum state transduction of arbitrary states.