Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Physics

Noise performance and stability of a doubly-degenerate unsaturated SUPARAMP

J. Kadlec

Published Oct 1, 1979• 4 citations
Publisher

Abstract

The noise temperature and gain stability of the superconducting unbiased parametric amplifier (SUPARAMP) have been calculated. The results of the analysis suggest that extremely low-noise amplification of signals from cryogenic sources may be achieved. It seems possible to obtain an effective input noise temperature of 1 K for signal frequencies up to 10 GHz, having a stable power gain of 20–30 dB. This paper provides the fundamental design specifications necessary for the construction of a low-noise SUPARAMP.

DOI
10.1063/1.325737

Related papers

Operation of the SUPARAMP at 33 GHz

R. Y. Chiao, P. T. Parrish

A 9-mm degenerate parametric amplifier has been constructed using a linear series array of unbiased Josephson junctions as the active nonlinear element. We used a balanced diode mixer as a synchronous detector, with a single source serving both as the pump and as the mixer local oscillator. A stable net gain of 15 dB in an instantaneous bandwidth (FWHM) of 3.4 GHz has been achieved. We measured a system noise temperature of 220±5 K (DSB) with a SUPARAMP contribution of only 20±10 K. Output saturation, however, has been observed. This complicates the interpretation of our noise-temperature measurements and may render them upper limits. Comparison is made with the results of an earlier 3-cm SUPARAMP. The data are in substantial agreement with theoretical predictions.

Journal of Applied Physics•Jun 1, 1976•33 citations

The thermally saturated SUPARAMP

M. J. Feldman

The superconducting unbiased parametric amplifier can be saturated by low levels of broadband thermal radiation. Saturation increases the fluctuation noise temperature and complicates the determination of the operating parameters of this device. In this paper the theory of the thermally saturated SUPARAMP is presented. It is found that a particular amplifier can be described by a characteristic temperature, its maximum possible output brightness temperature. The implications of this theory for the interpretation of past experiments and for the design of future experiments are discussed.

Journal of Applied Physics•Mar 1, 1977•24 citations

Operation of the SUPARAMP at 33GHz

R. Y. Chiao, P. T. Parrish

A 9mm degenerate parametric amplifier was constructed using a linear, series array of unbiased Josephson junctions as the active, nonlinear element. A balanced diode mixer was used as a synchronous detector, with a single source serving both as the pump and as the mixer local oscillator. A stable, net gain of 15 dB in an instantaneous bandwith (FWHM) of 3.4 GHz was achieved. A system noise temperature of 220 K + or - 5 K (DSB) was measured with a SUPARAMP contribution of only 20 K x or - 10 K. Output saturation was observed and complicates the interpretation of the noise temperature measurements and may render them upper limits. A comparison was made with the results of an earlier 3 cm suparamp. The data is in substantial agreement with theoretical predictions.

NASA STI/Recon Technical Report N•Jan 1, 1975•0 citations

Properties of parametric amplifiers using Josephson junctions with external pumping

L. S. Kuzmin, K. K. Likharev, V. V. Migulin

The signal and noise properties of two basic types of externally pumped parametric amplifiers, using Josephson junctions with low capacitance, are calculated. The first type is a single- frequency nondegenerate amplifier and second one is a two-frequency degenerate amplifier, referred to sometimes as SUPARAMP. Calculations are based on the conventional RSJ model of the Josephson junction. In contrast to the works published earlier, the most realistic open circuit approximation is used for idler combinational frequencies, as well as for the pumping frequency harmonics. A single-frequency amplifier is shown to have relatively low noise temperatures (T_{N} \approx 25T) at signal frequencies of the order of the Josephson junction characteristic frequency ωc. On the other hand, SUPARAMP can have much lower noise but at lower frequencies, and it behaves approximately as a usual parametric amplifier with a critical frequency\omega_{cr} \approx 0.2 \omega_{c}.

IEEE Transactions on Magnetics•Jan 1, 1979•12 citations

Shunted Josephson tunnel junctions: High-frequency, self-pumped low noise amplifiers

Nils P. Calander, T. Claeson, S. Rudner

The high-frequency amplification properties of transformer coupled, resistively shunted Josephson tunnel junctions have been investigated. The importance of the shunt loop inductance is stressed. It allows a high cutoff frequency, of significance for good high-frequency performance. The self-pumped parametric amplifier showed none of the excessive noise rise, which has hitherto plagued the development of externally pumped Josephson junction amplifiers. Around 10 GHz, we estimated a noise temperature less than 30 K for an amplifier pumped by a Josephson oscillation with a frequency well above twice the signal frequency. The corresponding gain of 5 dB may be increased in a better impedance matched circuit. The gain was very stable against variations in the bias conditions. A gain-bandwidth product as high as 0.3 was registered. The experimental results agreed well with the established theory for self-pumped parametric Josephson amplifiers. It should be possible to extend the low noise amplification by this device to mm wave frequencies. A relaxation oscillation occurred at a subharmonic of the Josephson frequency when the shunt loop inductance became large. The amplification in this mode followed closely the predictions of a simple model, where the signal modulated the switching of the sawtooth-like (relatively low frequency) relaxation current. Gains of about 15 dB were measured around 10 GHz, but the amplification was sensitive to bias conditions and noisy in this case where the relaxation frequency fell well below the signal frequency. Much improved properties were registered when the inductance was decreased so that the relaxation frequency approached the Josephson frequency and exceeded twice the signal frequency. The behavior then resembled that of a Josephson mode parametric amplifier, but the high content of harmonics of a relaxation oscillation meant that the amplifier became noisier due to converted noise from the many idler frequencies.

Journal of Applied Physics•Jul 1, 1982•26 citations

A Josephson effect parametric amplifier at 36 GHz

Y. Taur, P. L. Richards

Doubly degenerate parametric amplification by a point contact Josephson junction is observed at 36 GHz. The best amplifier showed a net gain of 11 dB and a noise temperature less than 50 K.

IEEE Transactions on Magnetics•Jan 1, 1977•3 citations
The noise temperature and gain stability of the superconducting unbiased parametric amplifier (SUPARAMP) have been calculated. The results of the analysis suggest that extremely low-noise amplification of signals from cryogenic sources may be achieved. It seems possible to obtain an effective input noise temperature of 1 K for signal frequencies up to 10 GHz, having a stable power gain of 20–30 dB. This paper provides the fundamental design specifications necessary for the construction of a low-noise SUPARAMP.
A 9-mm degenerate parametric amplifier has been constructed using a linear series array of unbiased Josephson junctions as the active nonlinear element. We used a balanced diode mixer as a synchronous detector, with a single source serving both as the pump and as the mixer local oscillator. A stable net gain of 15 dB in an instantaneous bandwidth (FWHM) of 3.4 GHz has been achieved. We measured a system noise temperature of 220±5 K (DSB) with a SUPARAMP contribution of only 20±10 K. Output saturation, however, has been observed. This complicates the interpretation of our noise-temperature measurements and may render them upper limits. Comparison is made with the results of an earlier 3-cm SUPARAMP. The data are in substantial agreement with theoretical predictions.
The superconducting unbiased parametric amplifier can be saturated by low levels of broadband thermal radiation. Saturation increases the fluctuation noise temperature and complicates the determination of the operating parameters of this device. In this paper the theory of the thermally saturated SUPARAMP is presented. It is found that a particular amplifier can be described by a characteristic temperature, its maximum possible output brightness temperature. The implications of this theory for the interpretation of past experiments and for the design of future experiments are discussed.
A 9mm degenerate parametric amplifier was constructed using a linear, series array of unbiased Josephson junctions as the active, nonlinear element. A balanced diode mixer was used as a synchronous detector, with a single source serving both as the pump and as the mixer local oscillator. A stable, net gain of 15 dB in an instantaneous bandwith (FWHM) of 3.4 GHz was achieved. A system noise temperature of 220 K + or - 5 K (DSB) was measured with a SUPARAMP contribution of only 20 K x or - 10 K. Output saturation was observed and complicates the interpretation of the noise temperature measurements and may render them upper limits. A comparison was made with the results of an earlier 3 cm suparamp. The data is in substantial agreement with theoretical predictions.
The signal and noise properties of two basic types of externally pumped parametric amplifiers, using Josephson junctions with low capacitance, are calculated. The first type is a single- frequency nondegenerate amplifier and second one is a two-frequency degenerate amplifier, referred to sometimes as SUPARAMP. Calculations are based on the conventional RSJ model of the Josephson junction. In contrast to the works published earlier, the most realistic open circuit approximation is used for idler combinational frequencies, as well as for the pumping frequency harmonics. A single-frequency amplifier is shown to have relatively low noise temperatures (T_{N} \approx 25T) at signal frequencies of the order of the Josephson junction characteristic frequency ωc. On the other hand, SUPARAMP can have much lower noise but at lower frequencies, and it behaves approximately as a usual parametric amplifier with a critical frequency\omega_{cr} \approx 0.2 \omega_{c}.
The high-frequency amplification properties of transformer coupled, resistively shunted Josephson tunnel junctions have been investigated. The importance of the shunt loop inductance is stressed. It allows a high cutoff frequency, of significance for good high-frequency performance. The self-pumped parametric amplifier showed none of the excessive noise rise, which has hitherto plagued the development of externally pumped Josephson junction amplifiers. Around 10 GHz, we estimated a noise temperature less than 30 K for an amplifier pumped by a Josephson oscillation with a frequency well above twice the signal frequency. The corresponding gain of 5 dB may be increased in a better impedance matched circuit. The gain was very stable against variations in the bias conditions. A gain-bandwidth product as high as 0.3 was registered. The experimental results agreed well with the established theory for self-pumped parametric Josephson amplifiers. It should be possible to extend the low noise amplification by this device to mm wave frequencies. A relaxation oscillation occurred at a subharmonic of the Josephson frequency when the shunt loop inductance became large. The amplification in this mode followed closely the predictions of a simple model, where the signal modulated the switching of the sawtooth-like (relatively low frequency) relaxation current. Gains of about 15 dB were measured around 10 GHz, but the amplification was sensitive to bias conditions and noisy in this case where the relaxation frequency fell well below the signal frequency. Much improved properties were registered when the inductance was decreased so that the relaxation frequency approached the Josephson frequency and exceeded twice the signal frequency. The behavior then resembled that of a Josephson mode parametric amplifier, but the high content of harmonics of a relaxation oscillation meant that the amplifier became noisier due to converted noise from the many idler frequencies.