Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal de physique

Optical bistability from surface plasmon excitation through a nonlinear medium

P. Martinot, S. Laval, A. Köster

Published Jan 1, 1984• 33 citations
Publisher

Abstract

The excitation of surface plasmon by attenuated total reflection can be used to get a bistable optical device. As the incident light beam propagates through a nonlinear medium, any intensity variation tunes the plasmon excitation through resonance. Furthermore, the superposition of the incident and reflected beams induces a feedback and allows bistable operation.

DOI
10.1051/jphys:01984004503059700

Related papers

Optical bistability with surface plasmons

Gary Mathew Wysin, Henry J. Simon, Robert T. Deck

We theoretically examine bistable operation in reflection with simultaneous excitation of the surface-plasmon mode at the interface with a nonlinear Kerr medium. Bistability may occur for an incident power an order of magnitude below that reported previously for a grazing-incidence geometry.

Optics Letters•Jan 1, 1981•83 citations

Optical bistability using prism-coupled, long-range surface plasmons

Robert K. Hickernell, Dror Sarid

We consider an attenuated total reflection prism-coupling geometry used to excite surface-plasmon waves along a metal film, bounded by a substrate with an intensity-dependent dielectric constant. Nonlinear wave theory is developed in the infinite incident plane-wave approximation, assuming a dielectric constant proportional to the square of the electric field normal to the film. We calculate the intensity required to observe bistability in the reflected intensity by excitation of the nonlinear, long-range surface plasmon and find it to be 2 orders of magnitude less than that required for the nonlinear, single-surface plasmon. We compare the nonlinear wave analysis with other approaches and illustrate the effects of the sign of the nonlinearity and of a nonlinear coupling layer.

Journal of the Optical Society of America B•Aug 1, 1986•36 citations

Optical bistability of surface plasmon polaritons in nonlinear Kretschmann configuration

Chao Wu, Gang Yong Song, Huili Liu +3 more

Optical bistability based on surface plasmon polaritons in the Kretschmann configuration involving a Kerr nonlinear medium is described by analytical solutions. The conditions of forming the optical bistability with different parameters are explored. The resonant angle of surface plasmon polaritons varying with the incident light intensity also generates the phenomenon of bistability. The system could form optical bistability with the special thickness of the metal film and incident angle. This kind of system has potential application in all-optical networks.

Journal of Modern Optics•Feb 1, 2013•17 citations

Optical Bistability with Surface Plasmons beyond Plane Waves in Nonlinear Dielectric

G. S. Agarwal, Subhasish Dutta Gupta

Wysin et al1 suggested that the local field enhancement near a metal surface which occurs if surface plasmons are excited in a metal film, can be useful for observing optical bistability arising from the nonlinearity of the Kerr medium. Other geometrical arrangements2 have also been suggested. These studies assume plane waves in the nonlinear medium and use the Fresnel formulae for reflection and refraction from a layered medium but with linear refractive index replaced by the nonlinear refractive index. This assumes that the fields in the medium are homogeneous. However if surface plasmons are excited, then the fields are inhomogeneous and one has the problem of reflection and refraction from an inhomogeneous layered medium. The inhomogeneity is to be determined self consistently. Thus a proper treatment of optical bistability with surface plasmons should use the nonlinear solutions of the wave equation in Kerr medium. This is what we do in this paper.

Topical Meeting on Optical Bistability (OB)•Jan 1, 1985•0 citations

Optical Bistability Associated with Surface Plasmon Polariton Excitation

Toshihiro Okamoto, Masanobu Haraguchi, Masuo Fukui

We have theoretically analysed the optical bistability due to the excitation of surface plasmon polaritons (SP's) in samples, prism/metal film/nonlinear optic medium and prism/gap material/metal film/non-linear optic medium, where the non-linear optic medium has an intensity-dependent refractive index. We considered two cases, i.e. non-linearity along the propagation direction of SP's and along the normal to the interface. In the former case, the critical input power for the optical bistability was too high to allow experimental observation, while it was reasonably low for the latter case.

Journal of the Physical Society of Japan•May 15, 1992•2 citations

Bistable optical behavior of a nonlinear attenuated total reflection device: Resonant excitation of nonlinear guided modes

R. Reinisch, P. Arlot, Guy Vitrant +1 more

We study the prism excitation of a nonlinear waveguide. The nonlinear medium is the substrate which exhibits Kerr effect. Our results show that such a device experiences optical bistability. We also show that there exists a close link between optical bistability and resonant excitation of nonlinear guided modes propagating along this nonlinear waveguide.

Applied Physics Letters•Dec 15, 1985•25 citations
The excitation of surface plasmon by attenuated total reflection can be used to get a bistable optical device. As the incident light beam propagates through a nonlinear medium, any intensity variation tunes the plasmon excitation through resonance. Furthermore, the superposition of the incident and reflected beams induces a feedback and allows bistable operation.
We consider an attenuated total reflection prism-coupling geometry used to excite surface-plasmon waves along a metal film, bounded by a substrate with an intensity-dependent dielectric constant. Nonlinear wave theory is developed in the infinite incident plane-wave approximation, assuming a dielectric constant proportional to the square of the electric field normal to the film. We calculate the intensity required to observe bistability in the reflected intensity by excitation of the nonlinear, long-range surface plasmon and find it to be 2 orders of magnitude less than that required for the nonlinear, single-surface plasmon. We compare the nonlinear wave analysis with other approaches and illustrate the effects of the sign of the nonlinearity and of a nonlinear coupling layer.
Optical bistability based on surface plasmon polaritons in the Kretschmann configuration involving a Kerr nonlinear medium is described by analytical solutions. The conditions of forming the optical bistability with different parameters are explored. The resonant angle of surface plasmon polaritons varying with the incident light intensity also generates the phenomenon of bistability. The system could form optical bistability with the special thickness of the metal film and incident angle. This kind of system has potential application in all-optical networks.
Wysin et al1 suggested that the local field enhancement near a metal surface which occurs if surface plasmons are excited in a metal film, can be useful for observing optical bistability arising from the nonlinearity of the Kerr medium. Other geometrical arrangements2 have also been suggested. These studies assume plane waves in the nonlinear medium and use the Fresnel formulae for reflection and refraction from a layered medium but with linear refractive index replaced by the nonlinear refractive index. This assumes that the fields in the medium are homogeneous. However if surface plasmons are excited, then the fields are inhomogeneous and one has the problem of reflection and refraction from an inhomogeneous layered medium. The inhomogeneity is to be determined self consistently. Thus a proper treatment of optical bistability with surface plasmons should use the nonlinear solutions of the wave equation in Kerr medium. This is what we do in this paper.
We have theoretically analysed the optical bistability due to the excitation of surface plasmon polaritons (SP's) in samples, prism/metal film/nonlinear optic medium and prism/gap material/metal film/non-linear optic medium, where the non-linear optic medium has an intensity-dependent refractive index. We considered two cases, i.e. non-linearity along the propagation direction of SP's and along the normal to the interface. In the former case, the critical input power for the optical bistability was too high to allow experimental observation, while it was reasonably low for the latter case.