The system comprised of an atom strongly coupled to photons, known as cavity quantum electrodynamics (QED), provides a rich experimental setting for quantum information processing, both in the implementation of quantum logic gates and in the development of quantum networks. Moreover, studies of cavity QED will help elucidate the dynamics of continuously observed open quantum systems with quantum-limited feedback. To achieve these goals in cavity QED, a neutral atom must be tightly confined inside a high-finesse cavity with small mode volume for long periods of time. Microfabricated wires on a substrate---known as an atom chip---can create a sufficiently high-curvature magnetic potential to trap atoms in the Lamb-Dicke regime. We have recently integrated an optical fiber Fabry-Perot cavity with such a device. The microwires allow the on-chip collection and laser cooling of neutral atoms, and allow the magnetic waveguiding of these atoms to an Ioffe trap inside the cavity mode. Magnetically trapped intracavity atoms have been detected with this cavity QED system. A similar experiment employing microdisks and photonic bandgap cavities is nearing completion. With these more exotic cavities, a robust and scalable atom-cavity chip system will deeply probe the strong coupling regime of cavity QED with magnetically trapped atoms. Atom chips have found great success in producing and manipulating Bose-Einstein condensates and in creating novel atom optical elements. An on-chip BEC has been attained in a miniaturized system incorporating an atom chip designed for atom interferometry and for studies of Josephson effects of a BEC in a double-well potential. Using similar microfabrication techniques, we created and demonstrated a specular magnetic atom mirror formed from a standard computer hard drive. This device, in conjunction with micron-sized charged circular pads, can produce a 1-D ring trap which may prove useful for studying Tonks gases in a ring geometry and for creating devices such as a SQUID-like system for neutral atoms. This thesis describes the fabrication and employment of these atoms chips in experiments at both Caltech and Munich, the latter in collaboration with Professors Theodore Haensch and Jakob Reichel at the Max Planck Institute for Quantum Optics.
The system comprised of an atom strongly coupled to photons, known as cavity quantum electrodynamics (QED), provides a rich experimental setting for quantum information processing, both in the implementation of quantum logic gates and in the development of quantum networks. Moreover, studies of cavity QED will help elucidate the dynamics of continuously observed open quantum systems with quantum-limited feedback. To achieve these goals in cavity QED, a neutral atom must be tightly confined inside a high-finesse cavity with small mode volume for long periods of time. Microfabricated wires on a substrate---known as an atom chip---can create a sufficiently high-curvature magnetic potential to trap atoms in the Lamb-Dicke regime. We have recently integrated an optical fiber Fabry-Perot cavity with such a device. The microwires allow the on-chip collection and laser cooling of neutral atoms, and allow the magnetic waveguiding of these atoms to an Ioffe trap inside the cavity mode. Magnetically trapped intracavity atoms have been detected with this cavity QED system. A similar experiment employing microdisks and photonic bandgap cavities is nearing completion. With these more exotic cavities, a robust and scalable atom-cavity chip system will deeply probe the strong coupling regime of cavity QED with magnetically trapped atoms. Atom chips have found great success in producing and manipulating Bose-Einstein condensates and in creating novel atom optical elements. An on-chip BEC has been attained in a miniaturized system incorporating an atom chip designed for atom interferometry and for studies of Josephson effects of a BEC in a double-well potential. Using similar microfabrication techniques, we created and demonstrated a specular magnetic atom mirror formed from a standard computer hard drive. This device, in conjunction with micron-sized charged circular pads, can produce a 1-D ring trap which may prove useful for studying Tonks gases in a ring geometry and for creating devices such as a SQUID-like system for neutral atoms. This thesis describes the fabrication and employment of these atoms chips in experiments at both Caltech and Munich, the latter in collaboration with Professors Theodore Haensch and Jakob Reichel at the Max Planck Institute for Quantum Optics.
We have used a fiber Fabry-Perot cavity on an atom chip to obtain strong, extremely stable atom-cavity coupling for single atoms and Bose-Einstein condensates trapped inside the cavity. The coherent atom-cavity coupling parameter, g0/2pi ~ 209 MHz, is larger than both cavity decay, kappa/2pi ~ 53 MHz and spontaneous emission gamma/2pi ~ 3 MHz. Due to the small mode volume, these values, well inside the strong coupling regime of cavity QED, are realized with a cavity finesse F ~ 36000, which is a moderate value compared to usual strong-coupling cavity QED experiments. The cavity also achieves a very high cooperativity parameter, C=g02/2kappagamma ~ 130.The use of trapped Bose-Einstein condensates (BECs) is a fundamentally new situation for cavity QED, which should enable a new class of experiments, where atoms that share a well-defined internal and external quantum state collectively interact with a quantized mode of the cavity. Besides, as the spatial extension of the BEC assumes the fundamental limit that can be attained for an atom cloud - much smaller than an optical wavelength in our case - an extremely strong, stable and uniform coupling to the cavity mode is achieved. This makes the system interesting for applications such as quantum memories. For single atoms, our combination of high resonator cooperativity with extreme positioning precision enables qubit detection with near-unit efficiency. This realizes a long-awaited milestone for quantum information processing on atom chips.
We review our experiments on quantum information processing with neutral atoms in optical lattices and magnetic microtraps. Atoms in an optical lattice in the Mott insulator regime serve as a large qubit register. A spin-dependent lattice is used to split and delocalize the atomic wave functions in a controlled and coherent way over a defined number of lattice sites. This is used to experimentally demonstrate a massively parallel quantum gate array, which allows the creation of a highly entangled many-body cluster state through coherent collisions between atoms on neighbouring lattice sites. In magnetic microtraps on an atom chip, we demonstrate coherent manipulation of atomic qubit states and measure coherence lifetimes exceeding one second at micron-distance from the chip surface. We show that microwave near-fields on the chip can be used to create state-dependent potentials for the implementation of a quantum controlled phase gate with these robust qubit states. For single atom detection and preparation, we have developed high finesse fiber Fabry-Perot cavities and integrated them on the atom chip. We present an experiment in which we detected a very small number of cold atoms magnetically trapped in the cavity using the atom chip.
Cavity quantum electrodynamics (cavity QED) describes electromagnetic fields in a confined space and the radiative properties of atoms in such fields. The simplest example of such system is a single atom interacting with one mode of a high-finesse resonator. Besides observation and exploration of fundamental quantum mechanical effects, this system bears a high potential for applications quantum information science such as, e.g., quantum logic gates, quantum communication and quantum teleportation. In this thesis I present an experiment on the deterministic coupling of a single neutral atom to the mode of a high-finesse optical resonator. In Chapter 1 I describe our basic techniques for trapping and observing single cesium atoms. As a source of single atoms we use a high-gradient magneto-optical trap, which captures the atoms from background gas in a vacuum chamber and cools them down to millikelvin temperatures. The atoms are then transferred without loss into a standing-wave dipole trap, which provides a conservative potential required for experiments on atomic coherence such as quantum information processing and metrology on trapped atoms. Moreover, shifting the standing-wave pattern allows us to deterministically transport the atoms (Chapter 2). In combination with non-destructive fluorescence imaging of individual trapped atoms, this enables us to control their position with submicrometer precision over several millimeters along the dipole trap. The cavity QED system can distinctly display quantum behaviour in the so-called strong coupling regime, i.e., when the coherent atom-cavity coupling rate dominates dissipation in the system. This sets the main requirements on the resonator's properties: small mode volume and high finesse. Chapter 3 is devoted to the manufacturing, assembling, and testing of an ultra-high finesse optical Fabry-Perot resonator, stabilized to the atomic transition. In Chapter 4 I present the transportation of single atoms into the cavity and their coupling to the cavity mode. The strong coupling manifests itself in a strong reduction of the cavity transmission probed by a weak external laser. The atoms remain trapped and coupled to the cavity mode for several seconds until we move them out of the cavity for final analysis of their number and position.
This thesis reports on the development of an array of plane-concave Fabry-Perot microcavities containing atoms (or other quantum emitters), interconnected by UV-written waveguides on a silica-on-silicon chip. The microcavities are formed by a mirror coated on the end facet of the chip and an array of spherical micromirrors etched on silicon. This is to our knowledge the first attempt at implementing the emerging coupled-cavities QED paradigm. The device we propose possesses a degree of control, flexibility and tuning unmatched in other suggested implementations: The atoms can be manipulated inside the cavity by auxiliary lasers and the cavity-cavity coupling rate as well as the atom-cavity coupling can be tuned. It is highly scalable. Calculation of the complete (classical) optical spectrum of the device is presented. The quantum dynamics that may eventually be observed has also been studied. Waveguide chips containing couplers and phase shifter have been fabricated. We have successfully demonstrated the operation of the elementary sub-systems: the strong optical coupling between a microcavity and a waveguide resonator, and the tunable strong coupling between two evanescently coupled waveguide resonators. No experiments with atoms or other quantum emitters were attempted, because the waveguide propagation loss is so large that no quantum physics can be observed. There is hope that this can be overcome in the future by using other waveguide technologies.
The long-time trap and control of neutral atoms in an optical micro-cavity is a crucial problem in cavity quantum electrodynamics (QED), which greatly restricts the coherent manipulation of the interaction process between single atom and light. In this paper, we design a strongly coupled cavity QED system based on the traditional Fabry-Perot cavity. The parameters of the cavity are 3.5 millimeters in length, about 57000 in fineness, (g0,,)=2 (1.48, 0.375, 2.61) MHz, 1.54 and 0.89 in critical photon and atom number, respectively. The system allows building the magneto-optical trap (MOT) and optical lattice directly inside the cavity, which provides the possibility of long-time trapping deterministic single neutral atom or a number of neutral atoms in the cavity. By setting up a dipole trap and atomic imaging system, the capture, detection and imaging of single atom or several atoms in the cavity can be realized. The system overcomes some difficulties in transferring atoms in the usual cavity QED and has potential applications in robust intracavity atom control for quantum information processing.
The field of atom chips is a relatively new area of research which is rapidly becoming of great interest to the scientific community. It started out as a small branch of cold atom physics which has quickly grown into a multidisciplinary\nsubject. It now encompasses topics from fundamental atomic and quantum theory, optics and laser science, to the engineering of ultra sensitive sensors.\n\nIn this thesis the first steps are taken towards a truly integrated atom chip device for real world applications. Multiple devices are presented that allow the trapping, cooling, manipulation and counting of atoms. Each device presents a new component required for the integration and miniaturisation of atom chips\ninto a single device, capable of being used as a sensor.\n\nInitially, a wire trap was created capable of trapping and splitting a cloud of BoseEinstein condensate (BEC) for use in atom interferometry. Using this chip a BEC has been successfully created, trapped and coherent splitting of this cloud has been achieved.\n\nSubsequently, the integration and simplification of the initial trapping process was approached. In all the experiments to date, atoms are initially collected from a warm vapour by a magneto-optical trap (MOT). This thesis presents a new approach in which microscopic pyramidal MOTs’ are integrated into the chip itself. This greatly reduces the number of optical components and helps to simplify the process significantly.\n\nAlso presented is a method for creating a planar-concave micro-cavity capable of single atom detection. One such cavity consists of a concave mirror fabricated in silicon and the planar tip of an optical fibre. The performance of the resonators\nis highly dependent on the surface roughness and shape profile of the concave mirrors therefore a detailed study into the fabrication technique and its effects on these parameters was undertaken. Using such cavities single atom detection has been shown to be possible. These cavities have also been sccessfully integrated into an atom wire guide.\n\nFinally a co-sputtered amorphous silicon/titanium (a-Si/Ti) nanocomposite material was created and studied for its use as a novel structural material. This material is potentially suitable for integrated circuitry (IC)/Micro-electromechanical-\nsystems (MEMS) integration. The material’s electrical and\nstructural properties were investigated and initial results suggest that a-Si/Ti has the potential to be a compelling structural material for future IC/MEMS integration.\n\nTo build all of these devices, a full range of standard microfabrication techniques was necessary as well as some non standard processes that required considerable process development such as the electrochemical deposition.\n\nThis thesis presents a tool box of fabrication techniques for creating various components capable of different tasks that can be integrated into a single device. Each component has been successfully demonstrated in laboratory conditions. This represents a significant step toward a real world atom chip device.