Circuit QED is a promising solid-state quantum computing architecture. It also has excellent potential as a platform for quantum control---especially quantum feedback control---experiments. However, the current scheme for measurement in circuit QED is low efficiency and has low signal-to-noise ratio for single-shot measurements. The low quality of this measurement makes the implementation of feedback difficult, and here we propose two schemes for measurement in circuit QED architectures that can significantly improve signal-to-noise ratio and potentially achieve quantum-limited measurement. Such measurements would enable the implementation of quantum feedback protocols and we illustrate this with a simple entanglement-stabilization scheme.
Circuit cavity quantum electrodynamics (QED) is proving to be a powerful platform to implement quantum feedback control schemes due to the ability to control superconducting qubits and microwaves in a circuit. Here, we present a simple and promising quantum feedback control scheme for deterministic generation and stabilization of a three-qubit
W state in the superconducting circuit QED system. The control scheme is based on continuous joint Zeno measurements of multiple qubits in a dispersive regime, which enables us not only to infer the state of the qubits for further information processing but also to create and stabilize the target
W state through adaptive quantum feedback control. We simulate the dynamics of the proposed quantum feedback control scheme using the quantum trajectory approach with an effective stochastic maser equation obtained by a polaron-type transformation method and demonstrate that in the presence of moderate environmental decoherence, the average state fidelity higher than
0.9 can be achieved and maintained for a considerably long time (much longer than the single-qubit decoherence time). This control scheme is also shown to be robust against measurement inefficiency and individual qubit decay rate differences. Finally, the comparison of the polaron-type transformation method to the commonly used adiabatic elimination method to eliminate the cavity mode is presented.