This paper presents a new minimum-weight trellis-based soft-decision iterative decoding algorithm for binary linear block codes. Simulation results for the RM(64,22), EBCH(64,24), RM(64,42) and EBCH(64,45) codes show that the proposed decoding algorithm achieves practically (or near) optimal error performance with significant reduction in decoding computational complexity. The average number of search iterations is also small even for low signal-to-noise ratio.
This paper presents a new minimum-weight trellis-based soft-decision iterative decoding algorithm for binary linear block codes. Simulation results for the RM(64,22), EBCH(64,24), RM(64,42) and EBCH(64,45) codes show that the proposed decoding algorithm achieves practically (or near) optimal error performance with significant reduction in decoding computational complexity. The average number of search iterations is also small even for low signal-to-noise ratio.
This paper presents a new low-weight trellis-based soft-decision iterative decoding algorithm for binary linear block codes. The algorithm is devised based on a set of optimality conditions and the generation of a sequence of candidate codewords for an optimality test. The initial candidate codeword is generated by a simple decoding method. The subsequent candidate codewords, if needed, are generated by a chain of low-weight trellis searches, one at a time. Each search is conducted through a low-weight trellis diagram centered around the latest candidate codeword and results in an improvement over the previous candidate codewords that have been already tested. This improvement is then used as the next candidate codeword for a test of optimality. The decoding iteration stops whenever a candidate codeword is found to satisfy a sufficient condition on optimality or the latest low-weight trellis search results in a repetition of a previously generated candidate codeword. A divide-and-conquer technique is also presented for codes that are not spanned by their minimum-weight codewords. The proposed decoding algorithm has been applied to some well-known codes of lengths 48, 64, and 128. Simulation results show that the proposed algorithm achieves either practically optimal error performance for the example codes of length 48 and 64 or near optimal error performance for the (128, 29, 32) RM code with a significant reduction in computational decoding complexity.
In this paper, reduced-complexity trellis-based soft-input soft-output (SISO) decoding of linear block codes is considered. A new low-weight subtrellis based SISO decoding algorithm for linear block code to achieve near optimal error performance with a significant reduction in decoding complexity is presented. The proposed scheme is suitable for iterative decoding of linear block codes when used as component codes in compound or concatenated coding schemes. It has the following important features. An initial candidate codeword is first generated by a simple decoding method that guarantees a successful decoding. A low-weight subtrellis diagram centered around the candidate codeword is constructed. The maximum a posteriori probability (MAP) algorithm is then applied to the subtrellis. The generated extrinsic information is then used as a priori information to improve the generation of a candidate codeword for the next stage of iteration. Simulation results in the case of the newly introduced generalized irregular low-density (GILD) codes indicate that the proposed algorithm achieves practically optimal performance with a significant reduction in decoding complexity.
For iterative soft-decision decoding algorithms for binary linear block codes, error performance and computational complexity are very important factors.In this thesis, suÆcient conditions of the optimality of decoded codeword and a suÆcient condition which is used for ruling-out some useless iterations of bounded distance decoding which reduces the computational complexity of iterative soft-decision decoding algorithms are shown.New iterative soft-decision decoding algorithms which uses the suÆcient conditions of the optimality of decoded codeword to achievegood error performance with small computational complexity are also shown.First, the suÆcient conditions are derived based on: (1) partial knowledge of the distance pro le of the code, and (2) previously generated candidate codewords.When the numberof previously generated candidate codewords is greater than 1, the conditions presented here are less stringent than those derived by Taipale and Pursley [4] and Kaneko et.al.[5].The condition based on three previously generated candidate codewords is the rst such s u Æ c i e n t condition that has ever been derived.It is shown by computer simulation that these suÆcient condions reduce the computational complexity of iterative decoding algorithms without degradation of error performance.Second, a suÆcient condition to rule-out some useless test error patterns is derived.In an iterative decoding algorithm, such as Chase Type-II decoding algorithm[2] and its improved versions, candidate codewords for a received vector are generated
Based on the notion of supercodes, we propose a two-phase maximum-likelihood (ML) soft-decision decoding (tpMLSD) algorithm for binary linear block codes in this work. The first phase applies the priority-first search algorithm backwardly to a trellis derived from the parity-check matrix of the supercode of the linear block code. Using the information retained from the first phase, the second phase employs the priority-first search algorithm to the trellis corresponding to the linear block code itself, which guarantees to find the ML decision with a constant complexity per information bit at high signal-to-noise ratios (SNRs). Simulations on the extended BCH code of n = 64 and k = 24 show that the proposed two-phase scheme is an order of magnitude more efficient in average decoding complexity than the recursive ML decoding [1] when the SNR per information bit is 8 dB.
This dissertation deals with maximum-likelihood soft-decision decoding as well as suboptimal soft-decision decoding of linear block codes. We present three new decoding algorithms: $MA\sp*D,\ H\sp*,$ and Directed Search. The first algorithm, $MA\sp*D,$ is an instance of Algorithm $A\sp*$ that conducts heuristic search through a code tree of the transmitted code when the decoding problem is transformed into a problem of graph-search through a code tree. $MA\sp*D$ takes into consideration more properties of the code and is considerably more efficient than the original $A\sp*$ decoding algorithm presented by Han, Hartmann, and Chen in 1993. The second algorithm, $H\sp*,$ is a new decoding algorithm that determines the value of every component of a minimum-cost codeword by estimating the cost of the minimum-cost codeword, which has a fixed value at one of the k most reliable, linearly independent bit positions. The suboptimal version of this algorithm is combined with other decoding algorithms to reduce the search space during the decoding process. The third algorithm, Directed Search, is designed to enhance the performance of soft-decision decoding by searching in continuous space. This approach explores the search space between a given vector and the received vector and finds the codeword closest to the received vector in the space explored. We also present a novel and efficient hybrid decoding algorithm for (n, k) linear block codes. It hybridizes $MA\sp*D,\ H\sp*,$ and Directed Search algorithms, utilizing their strengths to make the decoding more efficient. Simulation results for this hybrid algorithm are presented for the (104,52) binary-extended quadratic residue code and for the (128,64), the (256, 131), and the (256, 139) binary-extended BCH codes. This hybrid algorithm can efficiently decode the (104,52) binary extended quadratic residue code and the (128,64) code for any signal-to-noise ratio and has near-optimal to optimal performance. Previously, no practical decoder could decode these two codes with such a performance for all signal-to-noise ratio ranges.
Iterative decoding methods have gained interest, initiated by the results of the so-called "turbo" codes. The theoretical description of this decoding, however, seems to be difficult. Therefore, we study the iterative decoding of block codes. First, we discuss the iterative decoding algorithms developed by Gallager (1962), Battail et al. (1979), and Hagenauer et al. (1996). Based on their results, we propose a decoding algorithm which only uses parity check vectors of minimum weight. We give the relation of this iterative decoding to one-step majority-logic decoding, and interpret it as gradient optimization. It is shown that the used parity check set defines the region where the iterative decoding decides on a particular codeword. We make plausible that, in almost all cases, the iterative decoding converges to a codeword after some iterations. We derive a computationally efficient implementation using the minimal trellis representing the used parity check set. Simulations illustrate that our algorithm gives results close to soft decision maximum likelihood (SDML) decoding for many code classes like BCH codes. Reed-Muller codes, quadratic residue codes, double circulant codes, and cyclic finite geometry codes. We also present simulation results for product codes and parallel concatenated codes based on block codes.